The vulnerability of karst springs—a case study of the Hubelj spring (SW Slovenia)

The hydraulic behaviour of the karst aquifer in the Hubelj spring catchment area (SW Slovenia) was studied by using an indirect research method based on natural tracers. The variations of natural tracers (in precipitation and in groundwater) during the storm event made possible the separation of the Hubelj spring storm hydrograph by the three-component separation technique. The results produced information on the aquifer recharge, storage and discharge processes, as well as on the mechanisms that affected them. They verified the so-called epikarst hypothesis presuming that an important part of a karst aquifer recharge reaches rapidly and intensively from the epikarst zone. It was demonstrated that epikarst water could occupy up to 50% of the spring discharge during precipitation events. This phenomenon could have important consequences on protection and management of the problems of karst aquifers, including engineering problems in karst areas. With this respect the results could give way to new engineering ideas.     

Geometry and accuracy of reflecting points in bistatic satellite altimetry

The analysis of the time and space distribution of specular (reflecting) points in bistatic altimetry between GPS and CHAMP satellites or SAC-C (taken as examples) is extended from Wagner and Klokočník (2003 J. Geod 77: 128–138). We demonstrate a significantly higher number and density of reflecting points in bistatic altimetry in comparison with traditional monostatic altimetry. After an outline of our older accuracy assessment for the vertical position of the reflecting point, we add a new independent derivation and compare both approaches. We account for orbit errors of both the transmitters (GPS) and receiver (CHAMP) satellites, and the measurement (delay) error. We found that the accuracy of the vertical position of the reflecting point decreases only slowly with increasing off-nadir angle and that the orbit errors must be accounted for if decimeter and better accuracy is required. In this paper, we do not study errors such as state of the ocean, technical parameters of the receiving system, and atmospheric corrections.     

Strike-slip fault bridge fluid pumping mechanism: insights from field-based palaeostress analysis and numerical modelling

We present a finite-element study of stress perturbation in evolving compressive and extensional strike-slip fault bridges. The results are compared with a fracture study of a compressive bridge at St Donats, UK. Horizontally interbedded calcareous mudstone and bioclastic calcilutite at St Donats have a distinct vertical permeability anisotropy. This sedimentary sequence behaves as a set of horizontal aquifers. The fluid flow in these aquifers is sensitive to mean stress gradients. Paleostress analysis of field fracture data, verified by finite-element modelling, indicates a rotation of σ₁ towards parallelism with boundary faults inside the growing compressive bridge. Boundary faults and bridge faults recorded numerous fluid flow events. The modelled mean stress pattern shows a regional maximum within the bridge and local maxima/minima pairs at boundary fault tips.Finite-element modelling of an extensional bridge indicates that σ₃ rotates towards parallelism with boundary faults. The mean stress pattern is similar to the pattern in compressive bridge but with maxima and minima locations interchanged. The stress patterns are reestablished by each stress build-up preceding the rupturation of the boundary faults throughout the development stages of strike-slip fault bridges. Mean stress gradients developed pre-failure control the fluid flow in fractures of the strike-slip fault system at and after the end of each stress build-up and the fluid flow in boundary faults post-failure. Fracture reactivation and new fracture generation within an evolving bridge is a process consisting of multiple successive events that retain the storage capacity of the bridge. Rupture and sealing of the main bounding-faults is a step-wise process that opens and closes fluid conduits between areas with different pressures.     

Thermal expansion and crystal structure of FeSi between 4 and 1173 K determined by time-of-flight neutron powder diffraction

The thermal expansion and crystal structure of FeSi has been determined by neutron powder diffraction between 4 and 1173?K. No evidence was seen of any structural or magnetic transitions at low temperatures. The average volumetric thermal expansion coefficient above room temperature was found to be 4.85(5)?×?10^?5?K^?1. The cell volume was fitted over the complete temperature range using Grüneisen approximations to the zero pressure equation of state, with the internal energy calculated via a Debye model; a Grüneisen second-order approximation gave the following parameters: θ_D=445(11)?K, V ₀=89.596(8)?ų, K ₀′=4.4(4) and γ′=2.33(3), where θ_D is the Debye temperature, V ₀ is V at T=0?K, K ₀′ is the first derivative with respect to pressure of the incompressibility and γ′ is a Grüneisen parameter. The thermodynamic Grüneisen parameter, γ_th, has been calculated from experimental data in the range 4–400?K. The crystal structure was found to be almost invariant with temperature. The thermal vibrations of the Fe atoms are almost isotropic at all temperatures; those of the Si atoms become more anisotropic as the temperature increases.     

Evidence for fullerenes in solid bitumen from pillow lavas of Proterozoic age from Mítov (Bohemian Massif, Czech Republic)

Andesitic pillow lavas containing biogenic, solid bitumen (SB) are a constituent of a Neoproterozoic volcanosedimentary sequence (Teplá-Barrandian unit, Bohemian Massif) in the Mítov area of the Czech Republic. A black shale formation that is crosscut by these andesitic basalts is 565 Ma old. Carbon disulfide extracts of two powdered samples of SB contain 0.2 and 0.3 ppm of C₆₀, respectively, as determined by high-pressure liquid chromatography. The peak assignment based on retention time is fully supported by high-resolution electron ionization mass spectrometry (EI-MS). No C₇₀ was detected, nor was C₆₀ found in two other SB samples from this locality. Other investigated carbonaceous samples from Bohemia (coals and anthracites of Upper Paleozoic age and anthraxolite, graphitoids, and graphite of Upper Proterozoic age) did not contain fullerenes at concentrations above the detection limit of 0.01 ppm. The absence of C₆₀ in these samples was confirmed by EI-MS. The proposed mechanism of fullerene formation involves a primary algal phase, generation of a hydrocarbonaceous mixture in the course of thermal evolution of the sedimentary series, and their high-temperature transformation related to the extrusion of basalt. An important feature for fullerene conservation was the enclosure of fullerenes in SB with a structure similar to glasslike carbon, where the fullerene was protected against oxidation.     

Preliminary seismic hazard maps of Slovenia

The preparation of the preliminary seismic hazard maps of the territory of Slovenia has been based on an expansion of the basic approach laid out by Cornell in 1968. Three seismic source models were prepared. Two of them are based mainly on the earthquake catalogue using the Poissonian probability model. A map of seismic energy release and a map of earthquake epicenter density are used to delineate seismic sources in these models. The geometry of the third model which is based on a rough estimate of seismotectonic setting is taken from the probabilistic seismic hazard analysis of a nuclear power plant in Slovenia. Published ground motion attenuation models based on strong motion records of recent strong earthquakes in Italy are used. Test maps for variable and uniform b-values are presented. The computer program, Seisrisk III, developed by the U.S. Geological Survey is used.     

Croatia — a coastal and maritime country

Croatia, through its geographic position, is a Mediterranean/Adriatic and Central European/Danube state. As an Adriatic coastal state, it has a long maritime tradition, which is apparent in its well-developed shipping (2.4 million GT), the high-quality ship-building industry (among the top six in the world) and through its numerous sea ports, of which many were established in ancient times. The leading national port is Rijeka, which is at the same time an important transit port for Austria, Hungary, Slovakia and the Czech Republic.The exceptionally indented Croatian Adriatic coast with its attractive archipelagos and favorable climatic and oceanographic conditions in the coastal sea offers very advantageous conditions for comprehensive tourist utilization. This is particularly true of nautical tourism, which is complimented by a larger number of constructed and well-equipped yachting ports/marinas on the coast and islands.     

Repeated Geodetic Measurements in the West Bohemia Seismoactive Region: Period 1993 - 1996

The western part of the Bohemian Massif is characterized by repeated occurrences of intraplate earthquake swarms. To study surface deformations of this anomalous region, a network covering about 2000 square kilometres for repeated geodetic measurements was established in 1993 - 1994. The positions of the individual points of the network were carefully picked with respect to local tectonic structure and earthquake foci distribution. GPS and precise levelling measurements were performed 1-2 times a year. The GPS data were processed by Bernese GPS software. No tendency to any displacement - either horizontal or vertical - of geological blocks was derived from the geodetic data for the period 1993 - 96. Only displacements of less than 5 mm/year in average could occur in the whole region in that period; larger displacements would have been revealed by our measurements.