Estimation of soil hydraulic properties and their uncertainty through the Beerkan infiltration experiment

The Beerkan method based on in situ single‐ring water infiltration experiments along with the relevant specific Beerkan estimation of soil transfer parameters (BEST) algorithm is attractive for simple soil hydraulic characterization. However, the BEST algorithm may lead to erroneous or null values for the saturated hydraulic conductivity and sorptivity especially when there are only few infiltration data points under the transient flow state, either for sandy soil or soils in wet conditions. This study developed an alternative algorithm for analysis of the Beerkan infiltration experiment referred to as BEST‐generalized likelihood uncertainty estimation (GLUE). The proposed method estimates the scale parameters of van Genuchten water retention and Brooks–Corey hydraulic conductivity functions through the GLUE methodology. The GLUE method is a Bayesian Monte Carlo parameter estimation technique that makes use of a likelihood function to measure the goodness‐of‐fit between modelled and observed data. The results showed that using a combination of three different likelihood measurements based on observed transient flow, steady‐state flow and experimental steady‐state infiltration rate made the BEST‐GLUE procedure capable of performing an efficient inverse analysis of Beerkan infiltration experiments. Therefore, it is more applicable for a wider range of soils with contrasting texture, structure, and initial and saturated water content. Copyright © 2015 John Wiley & Sons, Ltd.     

Discharge of weathering products from acid sulfate soils after a rainfall event, Tweed River, eastern Australia

The oxidation of the iron sulfide, pyrite, in acid sulfate soil floodplains generate substantial acidity and this acid has caused further weathering of the soil profile. The movement of groundwater from these soils is an important geochemical control on surface water quality. The flux of acidified and metal-rich water during a wet season rainfall event has been examined at two study catchments on the Tweed River in eastern Australia. At the sites, 81 kg/ha and 60 kg/ha of oxidisable acidity are exported, along with Al, Fe and Zn during the flood event. The main contributors to the acid flux are H⁺, Fe and Al at the first site and whilst Fe and Al are present in the drainage waters at the second site, the main contributor is likely to be H⁺. The different flux characteristics at the sites may be caused by different surface soil hydraulic conductivities and oxidation history.     

Genetic variation in Avicennia marina in three estuaries of Sydney (Australia) and implications for rehabilitation and management

In order to ensure conservation of mangroves, genetic diversity in remaining populations must be explored. Both morphological and isozyme analyses were used and compared in investigating the intra- and inter-estuarine variation in Avicennia marina in Sydney, the most urbanised area in Australia. Sediment characteristics, metal levels, tree attributes, leaf morphology and isozyme/allozyme analyses were conducted. Tree characteristics did not prove to be adequate genetic markers, but leaf morphology may be of use in this species. Isozyme/allozyme analyses indicated that genetic distance corresponded with geographic distance, although habitat metal levels may indicate local selection pressures. High levels of heterozygote deficiencies were displayed in each estuary, which could threaten future viability. The results hold implications for management as periodic isozyme analysis may be useful in indicating management needs. The identification of metal-tolerant types may also be useful. Transplantation among estuaries may assist in increasing genetic diversity, if considered desirable. Whatever the management aims, isozyme/allozyme analyses are shown to be useful for revealing genetic diversity in this species.     

Stream Temperature Modeling and Fiber Optic Temperature Sensing to Characterize Groundwater Discharge

The Ngongotaha Stream was used as a case study to assess the applicability of fiber optic distributed temperature sensing (FODTS) to identify the location of springs and quantify their discharge. Thirteen springs were identified, mostly located within a 115 m reach, five discharged from the right bank and eight from the left bank. To quantify groundwater discharge, a new approach was developed in which the one-dimensional transient heat transport model was fitted to the FODTS measurements, where the main calibration parameters of interest were the unknown spring discharges. The spatial disposition of the groundwater discharge estimation problem was constrained by two sources of information; first, the stream gains ∼500 L/s as determined by streamflow gauging. Second, the temperature profiles of the left and right banks provide the spatial disposition of springs and their relative discharges. FODTS was used to measure stream temperature near the left and right banks, which created two temperature datasets. A weighted average of the two datasets was then calculated, where the weights reflected the degree of mixing between the right and left banks downstream of a spring. The new approach in this study marks a departure from previous studies, in which the general approach was to use the steady-state thermal mixing model (Selker et al. 2006a; Westhoff et al. 2007; Briggs et al. 2012) to infer groundwater discharge, which is then used as an input into a transient model of the general form of equation to simulate stream temperature (Westhoff et al. 2007).     

Melilitite at Fort Portal, Uganda: Another dimension to the carbonate volcanism

Because the calciocarbonatite lavas at Fort Portal were the first ever described they have received great attention, with the pyroclastic rocks being relatively neglected. Volumetrically the lavas are minute, and the major deposit is a 2 m thick blanket of “flaggy” tuffs, long regarded as carbonatite tuff with crustal debris. Fresh examination shows these tuffs to contain melilitite previously unreported from Fort Portal. The rock is a mix of crust and mantle debris with near-isotropic lapilli, set in a matrix composed predominantly of carbonate. The low birefringence parts of the lapilli are devitrified melilitite glass. Compound lapilli are abundant, containing aggregates of globules, together with xenolithic/crystic fragments. In some, there are concentric zones of more carbonate rich material alternating with melilitite: tangential phlogopite flakes mark the outer zones, in marked contrast to their planar distribution through the enclosing rock matrix. Euhedral titano-magnetite (10–15%) is the most obvious cognate mineral. Devitrified melilitite contains abundant small crystals and microlites of melilite, apatite, magnetite, and carbonates, mostly formed during disequilibrium quench crystallisation. Because of this, and widespread fine grained accidental debris, a precise bulk melt composition is hard to obtain, but the average is close to melilitite with high P₂O₅. Mantle debris is largely disaggregated magnetite–phlogopite clinopyroxenite, which could give a bulk composition close to the melt. Low Mg and high Mg calcite are present in the melilitite lapilli, and in the enclosing carbonate rich matrix. Previously, high Mg calcite was reported only as cement in lapilli tuffs, while the lavas contain only low Mg calcite in the assemblage calcite–periclase (consistent with low pressure carbonate melt crystallisation). Carbonatite–melilitite magma left the mantle carrying restite debris. Melt fragmentation took place in the deep crust, with rapidly quenched droplets enclosing crust debris. Chemical covariations within the flaggy tuffs are uniform and explicable as carbonatite–melilitite plus a thoroughly mixed combination of crust and mantle debris. New links are indicated with the alkaline ultramafic-carbonate volcanism to the south, in Uganda, and parallels with that in Italy.