An analysis of mixing in the frontal zone of South and North Atlantic Central Water off North-West Africa

Multi-parameter mixing analysis is applied to 26 stations of Auftrieb 75, a joint expedition of R.R.S. Discovery and FS Meteor. North Atlantic Central Water (NACW) and South Atlantic Central Water (SACW) are represented by two water types each, and phosphate, silicate and nitrate are all used as an additional parameter with temperature and salinity, yielding three sets of independent solutions. Solutions from different parameters show similar vertical distributions but can differ considerably in absolute terms. This is believed to be caused by insufficient knowledge of nutrient values of pure NACW and SACW and by low range/precision ratios of nutrient determination.It is shown that isopycnal mixing analysis correctly describes the water mass distribution to lowest order, i.e. there is agreement between results from isopycnal and multi-parameter analysis at most stations within the error bounds which are inherent in the method and which are presently very high. Significant non-isopycnal mixing could be confirmed for only one station, situated on the continental slope in the area of the undercurrent of the Canary Current upwelling regime, and may be caused by active upwelling, increased lateral and vertical shear in the under-current, or internal waves interacting with the bottom. Five stations do not yield oceanographically acceptable solutions, and an attempt is made to include a coastal water mass in the analysis in order to improve the result for these stations, i.e. three-parameter analysis for NACW and SACW is replaced by four-parameter analysis for NACW, SACW and coastal water by combining temperature and salinity with phosphate and silicate or with nitrate and silicate simultaneously (the combination phosphate and nitrate is degenerate because both nutrients are linearly correlated). This indeed improves the results, indicating the presence of coastal water at those stations, but accumulation of errors inhibits quantitative conclusions.     

Seasonality and selectivity in the feeding ecology and reproductive biology of deep-sea bathyal holothurians

Chlorophyll and carotenoid pigments were determined from the gut sediments of five species of bathyal holothurian in the NE Atlantic, sampled shortly after the spring/summer phytoplankton bloom in 2001 and prior to the spring bloom in 2002. Three species, Laetmogone violacea, Paroriza pallens and Bathyplotes natans, sampled within a similar depth range (900–1100 m) in the summer of 2001 showed significant differences in their chlorophyll and carotenoid pigment concentrations. This suggests they may select for slightly different components from the available food resource. Four species sampled in early spring 2002, Laetmogone violacea, Paroriza pallens, Benthogone rosea and Benthothuria funebris, also had significant differences in their pigment concentrations. These species were sampled over a wider depth range (1000–3100 m) showing a bathymetric trend in pigment concentrations. There was a distinct seasonal change in the composition and concentration of the pigments, linked to a reduction in the availability of fresh organic material during autumn and winter periods.Ovarian tissue was also examined. The carotenoid pigments found in the ovary also occurred in the OM ingested by the holothurians. The dominant gonadal carotenoid pigments were β-carotene, echinenone and zeaxanthin. The potential for using these carotenoids to gain a competitive advantage through selectivity of chlorophyll and carotenoid pigment biomarkers are discussed in relation to competition for food resources by deposit-feeders. The results were also compared with selectivity in abyssal species.     

象牙海岸Issia地区铌钽砂矿的研究(英文)

在西非的象牙海岸Issia地区分布着许多铌钽矿床,包括原生矿和砂矿。原生矿产在分带很好的伟晶岩中。这个地区发育着许多花岗岩和花岗伟晶岩。伟晶岩可分为:(1)分异不好的伟晶岩,无矿化;(2)含Be伟晶岩,分带较好,见绿柱石;(3)含Be-Nb-Ta的伟晶岩,分带很好,是矿体;(4)Be-Nb-Ta-Li伟晶岩,分带很好,是矿体。除了10多个原生矿外,还有许多砂矿。砂矿有两种类型:一种近原生矿的坡积砂矿,另一种是经河流冲刷搬运后的冲积砂矿。我们选择了Etienne-Meguhe砂矿作为近原生矿的坡积砂矿的代表,Bemadi矿作为河流冲积型的砂矿的代表,对这两种类型的砂矿的风化、搬运、沉积机理进行了比较研究。研究发现不同的搬运距离和搬运模式对铌钽砂矿的主要矿物——铌钽铁矿的化学性质没有什么影响,而其物理形态则发生了变化。坡积型砂矿的铌钽铁矿常与石英、长石等矿物连生,其颗粒大小与原生的Nb-Ta伟晶岩中的铌钽铁矿一致;经河流冲积而形成的砂矿中,铌钽铁矿颗粒变小、轮廓变得圆滑,几乎无连生矿物,但矿体集中,常在河流的冲积扇中分布,易开采。     

Interactive 3-D computation of fault surfaces using level sets

Deformable implicit surfaces, implemented with level set methods, have demonstrated a great potential in the computational sciences for applications such as modeling, simulation, and segmentation. They allow implicit handling of complex topologies deformed by operations where large changes can occur without destroying the level set representation. The use of level set techniques for the computation and segmentation of plane-like and high positive curvature features is nontrivial. We present a technique for representing and extracting fault surfaces from 3-D seismic attribute data such that 2-manifolds can be interactively computed and segmented. We present our approach as an interactive workflow that generates highly accurate fault surfaces.     

Deriving characteristic parameters of the convective boundary layer from sodar measurements of the vertical velocity variance

This paper deals with the derivation of the convective mixing height and the characteristic convective velocity w _* from profiles of _w measured by sodar. The parameters were obtained by fitting an analytical profile to the observed data. Results were compared with values obtained by the meteorological preprocessor of a dispersion model and from noon radiosoundings. In addition, a Monte Carlo method was applied to study the influence of measurement errors. It turned out that it is inherently difficult to determine the depth of deep mixed layers from sodar measurements with a limited range, although the determination of w _* should be possible. However, a significant underestimation of _w , and thus w _*, was found, which is probably due to disproportional sampling of updrafts and downdrafts.     

Simulation of daily energy budget and mean soil temperatures at an arid site

Summary Soil temperature is often inadequately based upon relatively few measurements at widely dispersed locations. Within arid regions, such as the desert southwestern United States, soils, microclimates, and thus soil temperature may be markedly heterogeneous. Because extensive measurement of soil temperature is often not feasible, models are needed that simulate soil temperature based on readily available soil survey and above-ground weather information. This paper describes a simple energy-budget based model for simulating daily mean temperatures within a bare arid land soil. The model requires basic information on soil physical properties, and daily weather data including air temperature, windspeed, rainfall, and solar radiation to calculate daily surface energy budget components and surface temperature. One of two alternative numerical methods is then used to calculated subsurface temperatures. Tests of the model using 1987 daily temperature data from an arid site at Yuma, Arizona resulted in root mean square deviations within 1.4°C between daily modeled and measured temperatures at both 0.05 and 0.10 m depths. Sensitivity analysis showed modeled temperatures at 0.05 m depth to be most sensitive to parameters affecting the surface energy balance such as air temperature and solar radiation. Modeled temperatures at 1.0m depth were relatively more sensitive to initial temperature conditions and to parameters affecting distribution of energy within the profile such as thermal conductivity.With 3 Figures     

TheF N method for solving radiative-transfer problems in plane geometry

TheF _N method of solving problems in radiative transfer for plane-parallel media with anisotropic scattering is established. The method utilizes properties of the exact solution and leads to final equations that are particularly concise and easy to use.     

GGR Critical Review of Analytical Developments in 2004–2005

In 2005 Geostandards and Geoanalytical Research embarked upon a new initiative for its readers. Key researchers in various fields of geoanalytical technique development and their application were identified and invited to provide reviews pertinent to their expertise. As noted in the first of these publications "…instead of revisiting the historical context or decades of development in each analytical technique, the goal here has been to capture a snapshot of "hot topics" across a range of fields as represented in the… literature" (Hergt et al . 2005). Rather than prepare an annual review, a decision was taken earlier this year to provide a biennial summary of progress and accomplishments, in this case for the years 2004–2005. The principal techniques employed in Earth and environmental sciences are covered here, and include laser ablation and multicollector ICP-MS, ICP-AES, thermal ionisation and secondary ion mass spectrometry, as well as neutron activation analysis, X-ray fluorescence and atomic absorption spectrometry. A comprehensive review of the development of reference materials, often essential to these techniques, is also provided. The contributions assembled serve both to keep readers informed of advances they may be unfamiliar with, but also as a means of showcasing examples of the breadth and depth of work being conducted in these fields.     

Reference Materials in Geoanalytical Research -Review for 2004 and 2005

This review gives an overview of the use and development of reference materials of geochemical and environmental interest in the literature of the years 2004 and 2005. In these years the performance of existing methods has been improved and new geochemical applications using new techniques have been developed. Accordingly, there was an increasing need for new reference materials, especially for in situ microanalysis and for precise stable isotope measurements. In addition, there was a notable trend for further characterisation of existing reference materials, mainly for the platinum-group elements. This review focuses on five topics: reference materials for platinum-group elements, reference glasses for in situ microanalysis, zircon reference materials, isotopic reference materials, and the development and certification of reference materials.