Using GB-SAR technique to monitor slow moving landslide

A Ground-Based SAR (GB-SAR) interferometer was employed to measure the surface displacements of a landslide occurring in the Carnian Alps, north-eastern Italy, which has affected a national road and seriously damaged a road tunnel still under construction. Moreover, since the landslide is located on the left bank of the Tagliamento River Valley, it is feared that this mass movement might dam the river, creating a basin that would increase natural hazard for the valley inhabitants. The data collected from December 2002 to July 2005 by a conventional monitoring system, consisting of a GPS network and boreholes equipped with inclinometric tubes, showed that the landslide was moving at a quasi-constant rate of about 3 cm per year. Due to the slow deformation rate of the landslide, a recently developed GB-SAR technique based on the analysis of a restricted ensemble of coherent points was used. Two surveys, each lasting two days, were planned in December 2004 and July 2005, in order to map and measure the surface displacements that occurred over time. The results from the radar were compared with the ones derived from the GPS monitoring network. An agreement was achieved among the data collected, showing the capability of the GB-SAR technique to measure displacements even within a time span of several months between the surveys.     

Correction to: A novel methodological approach for land subsidence prediction through data assimilation techniques

Computational Geosciences - A Correction to this paper has been published: https://doi.org/10.1007/s10596-021-10079-6     

Grazing Management Plans improve pasture selection by cattle and forage quality in sub-alpine and alpine grasslands

Over the last decades, the reduction of manpower for herd management has led to an increase of continuous grazing systems(CGS) in the Italian Alps, which allow cattle to roam freely. Under CGS, due to high selectivity, livestock exploit grasslands unevenly, over-and under-using specific areas at the same time with negative effects on their conservation. To counteract these effects, a specific policy and management tool(i.e. Grazing Management Plan) has been implemented by Piedmont Region since 2010. The Grazing Management Plans are based on the implementation of rotational grazing systems(RGS), with animal stocking rate adjusted to balance it with grassland carrying capacity. A case study was conducted on alpine summer pastures to test the 5-year effects produced by the implementation of a Grazing Management Plan in grasslands formerly managed under several years of CGS on 1) the selection for different vegetation communities by cattle, 2) the abundance of oligo-, meso-, and eutrophic plant species(defined according to Landolt N indicator value), and 3) forage yield, quality, and palatability. A total of 193 vegetation surveys were carried out in 2011 and repeated in 2016. Cows were tracked yearly with Global Positioning System collars to assess their grazing selectivity, and forage Pastoral Value(PV) was computed to evaluate forage yield, quality, and palatability. Five years after RGS implementation, cow selectivity significantly decreased and the preference for the different vegetation communities was more balanced than under CGS. The abundance of meso-and eutrophic species increased, whereas oligotrophic ones decreased. Moreover, the abundance of moderately to highly palatable plant species increased, whereas non-palatable plant species decreased, with a consequent significant enhancement of the PV. Our findings indicate that the implementation of Grazing Management Plans can be considered a sustainable and effective management tool for improving pasture selection by cattle and forage quality in mountain pastures.     

No significant Alpine tectonic overprint on the Cimmerian Strandja Massif (SE Bulgaria and NW Turkey)

We provide the first comprehensive picture of the thermochronometric evolution of the Cimmerian Strandja metamorphic massif of SE Bulgaria and NW Turkey, concluding that the bulk of the massif has escaped significant Alpine-age deformation. Following Late Jurassic heating, the central part of the massif underwent a Kimmeridgian-Berriasian phase of relatively rapid cooling followed by very slow cooling in Cretaceous-to-Early Eocene times. These results are consistent with a Late Jurassic–Early Cretaceous Neocimmerian (palaeo-Alpine) phase of north-verging thrust imbrication and regional metamorphism, followed by slow cooling/exhumation driven by erosion. From a thermochronometric viewpoint, the bulk of the Cimmerian Strandja orogen was largely unaffected by the compressional stress related to the closure of the Vardar–?zmir–Ankara oceanic domain(s) to the south, contrary to the adjacent Rhodopes. Evidence of Alpine-age deformation is recorded only in the northern sector of the Strandja massif, where both basement and sedimentary rocks underwent cooling/exhumation associated with an important phase of shortening of the East Balkan fold-and-thrust belt starting in the Middle–Late Eocene. Such shortening focused in the former Srednogorie rift zone because this area had been rheologically weakened by Late Cretaceous extension.     

Development and Application of 2D and 3D GRASS Modules for Simulation of Thermally Driven Slope Winds

The ability to manage and process fully three‐dimensional information has only recently been made available for a few Geographical Information Systems (GIS). An example of integrated and complementary use of 2D and 3D GRASS modules for the evaluation and representation of thermally induced slope winds over complex terrain is presented. The analytic solution provided by Prandtl (1942) to evaluate wind velocity and (potential) temperature anomaly induced by either diurnal heating or nocturnal cooling on a constant angle slope is adopted to evaluate wind and temperature profiles at any point over both idealised and real complex terrain. As these quantities depend on the slope angle of the ground and on the distance from the slope surface suitable procedures are introduced to determine the coordinate n of a point in the 3D volume measured along the direction locally normal to the terrain surface. A new GRASS module has been developed to evaluate this quantity and to generate a 3D raster file where each cell is assigned the value of the cell on the surface belonging to the normal vector. The application of the algorithm implemented in GRASS to an ideal valley and to a real valley close to the city of Trento in the Alps provides results in accordance with data reported in the literature. An extension of Prandtl's (1942) model to take into account humidity and evaporation processes on the soil is also proposed and implemented.     

Optimal low-thrust trajectories to asteroids through an algorithm based on differential dynamic programming

In this paper an optimisation algorithm based on Differential dynamic programming is applied to the design of rendezvous and fly-by trajectories to near Earth objects. Differential dynamic programming is a successive approximation technique that computes a feedback control law in correspondence of a fixed number of decision times. In this way the high dimensional problem characteristic of low-thrust optimisation is reduced into a series of small dimensional problems. The proposed method exploits the stage-wise approach to incorporate an adaptive refinement of the discretisation mesh within the optimisation process. A particular interpolation technique was used to preserve the feedback nature of the control law, thus improving robustness against some approximation errors introduced during the adaptation process. The algorithm implements global variations of the control law, which ensure a further increase in robustness. The results presented show how the proposed approach is capable of fully exploiting the multi-body dynamics of the problem; in fact, in one of the study cases, a fly-by of the Earth is scheduled, which was not included in the first guess solution.     

Detection of Flow Distortions and Systematic Errors in Sonic Anemometry Using the Planar Fit Method

We describe the coordinate transformations that can be used to convert the velocity components measured by a set of sonic anemometers with time-dependent tilt fluctuations into a single, time-independent coordinate system. By applying the planar fit method (PFM) to each anemometer dataset, it is possible, for planar flows, to locate the flow plane at each measurement point and compare its orientation with the topography. Installation on a ship is also considered. An application of this method to intercomparison data has led to the detection of an instrument error due to a misalignment between the assembly of the sonic transducers and the anemometer pedestal. If this error occurs, pedestal levelling does not guarantee that measurements are unbiased. A correction method is proposed and the results of two experiments are shown. Flow planarity at different levels and flow distortion caused by the mast are highlighted. The influence of the error on the evaluation of the Reynolds stresses using PFM or the double rotation method and the triple rotation method is discussed and the tilt corrected stresses calculated using the three methods compared.     

The effects of differential subsidence and coastal topography on high-order transgressive-regressive cycles: Pliocene nearshore deposits of the Val d'Orcia Basin, Northern Apennines, Italy

This study focuses on the lowstand and early transgressive systems tracts of a basin-fill sequence of lower Pliocene nearshore deposits in the Val d'Orcia Basin of the Northern Apennines, Italy. The basin at that time was a semi-enclosed marine embayment, and, in the study area, its margin was subject to highly variable subsidence along the depositional strike, attributed to a decrease in tectonic displacement. The nearshore succession in the more rapidly-subsiding segment of the basin is around 20 m thick, comprising three storeys of laterally-stacked Gilbert-type delta lobes overlain by a shoal-water delta, whereas the nearshore succession in the adjacent, more slowly-subsiding segment, is up to 9 m thick. This succession is characterised by alternation of shoreface and offshore deposits, moderately wave-worked and covered by shoal-water deltaic facies.These coeval nearshore successions consist of several transgressive-regressive cyclothems. The development and lateral variation of the cyclothems was controlled by the local subsidence rate and coastal topographic gradient. Some of the cyclothems are considered to be higher-order sequences and others to be parasequences, with the former passing laterally into the latter in the area where the sea-level fall was countered by fast local subsidence. Some of the bounding surfaces are of limited lateral extent, with two parasequences passing laterally into a single one.Coastal topography controlled particularly the thickness of transgressive deposits. In the low-gradient setting of a delta plain, the relative sea-level rises caused major landward shifts of the shoreline and reduced fluvial sediment supply, with the formation of a transgressive lag in sediment-starved conditions. In the high-gradient coastal setting of the non-deltaic zone, the shoreline shift was minimal and had relatively little impact on local sediment supply, which promoted an accretionary transgression.At the end of the lowstand stage, the rate of sediment accumulation in the non-deltaic nearshore zone was lower, allowing the onset of subsequent transgression to be recorded considerably earlier than in the deltaic nearshore zone. This diachroneity suggests that facies criteria alone may not necessarily be a reliable basis for the recognition of systems tract boundaries.     

Land uplift due to subsurface fluid injection

The subsurface injection of fluid (water, gas, vapour) occurs worldwide for a variety of purposes, e.g. to enhance oil production (EOR), store gas in depleted gas/oil fields, recharge overdrafted aquifer systems (ASR), and mitigate anthropogenic land subsidence. Irrespective of the injection target, some areas have experienced an observed land uplift ranging from a few millimetres to tens of centimetres over a time period of a few months to several years depending on the quantity and spatial distribution of the fluid used, pore pressure increase, geological setting (depth, thickness, and area extent), and hydro-geomechanical properties of the injected formation. The present paper reviews the fundamental geomechanical processes that govern land upheaval due to fluid injection in the subsurface and presents a survey of some interesting examples of anthropogenic uplift measured in the past by the traditional levelling technique and in recent times with the aid of satellite technology. The examples addressed include Long Beach, Santa Clara Valley, and Santa Ana basin, California; Las Vegas Valley, Nevada; Cold Lake and other similar sites, Canada; Tokyo and Osaka, Japan; Taipei, Taiwan; Krechba, Algeria; Upper Palatinate, Germany; Chioggia and Ravenna, Italy.     

Evidence of a full West Antarctic Ice Sheet back to the early Oligocene: insight from double dating of detrital apatites in Ross Sea sediments.

The West Antarctic Ice Sheet is the most unstable component of the Antarctic cryosphere. Its fluctuations are well documented since the Pliocene, but its behaviour over the last 35 Ma is more controversial, particularly during periods of past high global pCO₂ values similar to those predicted in future global climate scenarios. Here, we present new U–Pb dating of detrital apatite grains (previously dated by the fission‐track method) from Cape Roberts Project Oligocene to Pliocene marine sediments in the Ross Sea. Two past ice‐flow patterns were identified: one formed by outlet glaciers sourcing short‐travelled apatites and one, northerly directed, bringing far‐travelled apatite grains. The latter provides the first robust physical evidence for the presence and repeated expansion of an Oligocene West Antarctic Ice Sheet.