Apparent downward CO2 flux observed with open-path eddy covariance over a non-vegetated surface

Summary The open-path eddy covariance (EC) method often shows unlikely downward CO₂ fluxes in late winter and early spring over drained paddy fields with few active plants. To understand why, we carried out intensive measurements in a bare paddy field from 9 to 11 April 2003, simultaneously using open- and closed-path EC methods; aerodynamic and dynamic closed-chamber methods were also used. During this period, the open-path EC method showed downward daytime CO₂ fluxes ranging from 0 to −5.9 μmol m⁻² s⁻¹, even after application of the WPL correction (density correction) and ordinary quality control tests. Because the closed-path EC and aerodynamic methods showed upward CO₂ fluxes, the downward CO₂ fluxes observed with open-path EC appear not to represent true CO₂ transport. Diurnal variations in the downward daytime CO₂ fluxes appeared to be correlated with increases in solar radiation during the day, and also with increases in sensible heat flux in weak winds but not under strongly windy conditions. The daytime 10-Hz time series data of vertical wind and CO₂ mixing ratio demonstrated that updrafts were CO₂ depleted in the open-path system, whereas the same updrafts were CO₂ enriched in the closed-path system. Careful examination of the discrepancies between the open- and the closed-path EC measurements revealed that the amplitudes of the 10-Hz temperature signals from the sonic anemometer and the resultant sensible heat fluxes were too small to compensate for the discrepancies observed during the daytime. The open-path EC method with the conventional application of the WPL correction is not necessarily appropriate for measuring small magnitudes of CO₂ flux (≤5 μmol m⁻² s⁻¹) under such surface and atmospheric conditions that the magnitude of the WPL correction is as great as that of the uncorrected CO₂ flux itself. Author’s addresses: Keisuke Ono, 3-1-3 Kannondai, Tsukuba, Ibaraki 305-8604, Japan; Akira Miyata, Tomoyasu Yamada, National Institute for Agro-Environmental Sciences, Tsukuba, Japan     

Study of the effect of water-soluble fractions of heavy-oil on coastal marine organisms using enclosed ecosystems,mesocosms

Mesocosm facilities composed of 4 experimental and 2 reservoir tanks (1.5 m in diameter, 3.0 m in depth and 5 tons in capacity) made of FRP plastics, were constructed in the concrete fish rearing pond in the Fisheries Laboratory, The University of Tokyo. The water-soluble fraction of Rank A heavy residual oil was formed by mixing 500 g of the oil with 10 l of seawater, which was introduced to the 5000 l-capacity tanks. Experimental Run 4 was conducted from May 31 to June 7, 2000. Oil concentrations in the tanks were 4.5 microg/l called LOW, and 13.5 microg/l, called HIGH tank. Bacterial growth rates very quickly accelerated in the HIGH tank just after the loading of oil which corresponded with a high increase of bacterial cells in the same tank after 2 days. Later, bacterial numbers in HIGH tank rapidly decreased, corresponding with the rapid increase of heterotrophic nano-flagellates and virus numbers on the same day. Sediment traps were deployed at the bottom of the experimental tanks, and were periodically retrieved. These samples were observed both under light microscope and epi-fluorescent microscope with UV-excitation. It was observed that the main components of the vertical flux were amorphous suspended matter, mostly originating from dead phytoplankton and living diatoms. It was further observed from the pictures that vertical transport of oil emulsions were probably conducted after adsorption to amorphous suspended matter and living diatoms, and were settling in the sediment traps at the bottom of the tanks. This means that the main force which drives the soluble fraction of oil into bottom sediment would be vertical flux of such amorphous suspended particles and phytoplankton. Further incubation of the samples revealed that the oil emulsions were degraded by the activity of autochtonous bacteria in the sediment in aerobic condition.     

Impact Experiments on Porous Icy-Silicate Cylindrical Blocks and the Implication for Disruption and Accumulation of Small Icy Bodies

Impact strength and cratering ejecta were studied for porous targets of pure ice and icy-silicate mixture in order to clarify the accumulation and destruction (shattering) condition of small icy bodies. The icy projectile impacted on the cylindrical targets with the porosity up to 55% at a velocity of 150 to 670 m/s at −10°C. The porosity dependence of the impact strength and that of the maximum ejecta velocity were measured in each type of these targets. As a result, the maximum ejecta velocity normalized by the impact velocity (V_e-max/V_i) is found to depend only on the porosity (φ), irrespective of the target type; a relationship is derived to be V_e-max/V_i=−2.17φ+1.29. The impact strength of pure ice increased with increased target porosity, but that of mixture target had an opposite trend; that is, the strength decreased with increased porosity. These porosity dependencies of the impact strength could be explained by the porosity dependence of the physical parameters such as impact pressure, pressure decay, and static strength. Finally, the accumulation of small icy bodies is discussed to show that the collisional events can be divided into three types by the porosity and the collision velocity according to our experimental results: mass loss, rubble pile formation, and regolith formation (compaction).     

Discharge of H2 from the Atotsugawa and Ushikubi Faults,Japan, and its relation to earthquakes

The concentration of H₂ in soil gases has been measured weekly at five stations on the Atotsugawa and Ushikubi faults in northern central Main Island, Japan, since 1981 in search of possible relationship with earthquakes. The observed H₂ concentration varies from lower than 1 ppm to 7.8% in time and place. When a large earthquake (M: 7.7, epicenter distance: 486 km) occurred on 26 May 1983, an outstanding discharge of H₂ was observed at all five stations, preseismically at three of them, and coseismically at the other two. Simultaneous H₂ emission was also observed at some stations in seven other occasions. These periods of unusual H₂ discharge nearly coincided with occurrences of major earthquakes in Japan, but not of local minor earthquakes along the Atotsugawa fault. This fault, being a deep fracture zone, may be sensitive to large-scale crustal stress changes which incidentally cause the major earthquakes. Increased H₂ may be produced by rock fracture caused by the increased stresses on the fault and by the earthquakes themselves. Local minor earthquakes along Atotsugawa fault with magnitude lower than 3 may be unable to cause sufficient rock fracture to produce significant H₂.     

Induction of female‐to‐male sex change in a large protogynous fish,Choerodon schoenleinii

Most behavioral studies on hermaphroditic fishes have focused on small‐sized species, which are tractable for research. Although many species of large hermaphroditic fishes are important fishery resources, their proximate mechanisms (visual, chemical and/or behavioral cues) in the social regulation of sex change have not been determined. Determination of these would inform resource management and aquaculture. In order to get closer to understanding the proximate mechanisms underlying the social regulation of female‐to‐male sex change in large hermaphroditic fishes, this study reports situations that induced female‐to‐male sex change in black‐spot tuskfish, Choerodon schoenleinii, a species of large protogynous fish, in massive laboratory tanks. The situations differed in the possibility of male‐to‐female tactile contact and in the group sex ratio, enabling us to infer plausible proximate mechanisms underlying sex change induction. Tactile contact between individuals is suspected to be closely related to the incidence of female‐to‐male sex change in C. schoenleinii. Visual and chemical cues alone may be insufficient to inhibit such sex changes. Male‐to‐female tactile contact may have an important influence on female‐to‐male sex change, i.e., inhibition of this sex change, in this species. The effect of sex ratio of a social group on the incidence of sex change may be due to the relative frequency and intensity of male tactile contact with each female, which may vary with the number of females. In the absence of a dominant male, tactile contact among females may affect the incidence of sex change, as well as determine which individuals change sex.     

Mg-Fe partitioning between olivine and ultramafic melts at high pressures

Precise determination of the partitioning of Mg and Fe²⁺ between olivine and ultramafic melt has been made at pressures from 5 to 13 GPa using a MA-8 type multi-anvil high-pressure apparatus (PREM) installed at Earthquake Research Institute, University of Tokyo. A very short rhenium capsule (<100 μm sample thickness) was adopted to minimize temperature variation within the sample container. Synthetic gels with the composition of the upper mantle peridotite were used as starting materials to promote the homogeneity. Analyses of quenched melts and coexisting olivines were made with an electron probe microanalyzer. The obtained partition coefficient, K_D [=(FeO/MgO)^ol/(FeO/MgO)^melt], decreases from 0.35 to 0.25 with increasing pressure from 5 to 13 GPa, suggesting a negative correlation between pressure and K_D above 5 GPa. Our result is consistent with a parabolic relationship between K_D and degree of polymerization (NBO/T) of melts reported by previous studies at lower pressures. The negative correlation between pressure and K_D suggests that olivine crystallizing in a magma ocean becomes more Mg-rich with depth and that primary magmas generated in the upper mantle become more Fe-rich with depth than previously estimated.     

Thermoelastic properties of the high-pressure phase of SnO2 determined by in situ X-ray observations up to 30 GPa and 1400 K

 In situ synchrotron X-ray experiments in the system SnO₂ were made at pressures of 4–29 GPa and temperatures of 300–1400 K using sintered diamond anvils in a 6–8 type high-pressure apparatus. Orthorhombic phase (α-PbO₂ structure) underwent a transition to a cubic phase (Pa3ˉ structure) at 18 GPa. This transition was observed at significantly lower pressures in DAC experiments. We obtained the isothermal bulk modulus of cubic phase K ₀= 252(28) GPa and its pressure derivative K ^′=3.5(2.2). The thermal expansion coefficient of cubic phase at 25 GPa up to 1300 K was determined from interpolation of the P-V-T data obtained, and is 1.7(±0.7) × 10⁻⁵ K⁻¹ at 25 GPa. Received: 7 December 1999 / Accepted: 27 April 2000