Evidence for microbiological manganese oxidation in the river Tamar Estuary, South West England

Water samples from the Tamar Estuary oxidized manganese when supplemented with Mn²⁺ (2 mgl⁻¹). The rates of oxidation were depressed in the presence of various metabolic inhibitors. The effect of Mn²⁺ and temperature on the rate of manganese oxidation suggested that a biological process was largely responsible for converting Mn²⁺ to Mn⁴⁺. Rates of manganese oxidation were much higher in freshwater (3·32 μgl⁻¹ h⁻¹ in water containing 30 mgl⁻¹ of suspended matter) than in saline water (0·7 μgl⁻¹ h⁻¹ in water of salinity 32‰) containing the same amount of particulate matter. The rate of manganese oxidation was proportional to the particulate load (up to 100 mgl⁻¹ particulates).     

Design of a 3D Chirp Sub-bottom Imaging System

Chirp sub-bottom profilers are marine acoustic devices that use a known and repeatable source signature (1–24 kHz) to produce decimetre vertical resolution cross-sections of the sub-seabed. Here the design and development of the first true 3D Chirp system is described. When developing the design, critical factors that had to be considered included spatial aliasing, and precise positioning of sources and receivers. Full 3D numerical modelling of the combined source and receiver directivity was completed to determine optimal source and receiver geometries. The design incorporates four source transducers (1.5–13 kHz) that can be arranged into different configurations, including Maltese Cross, a square and two separated pairs. The receive array comprises 240 hydrophones in 60 groups whose group-centres are separated by 25 cm in both horizontal directions, with each hydrophone group containing four individual elements and a pre-amplifier. After careful consideration, it was concluded that the only way to determine with sufficient accuracy the source–receiver geometry, was to fix the sources and receivers within a rigid array. Positional information for the array is given by a Real Time Kinematic GPS and attitude system incorporating four antennas to give position, heading, pitch and roll. It is shown that this system offers vertical positioning accuracy with a root-mean-square (rms) error less than 2.6 cm, while the horizontal positioning rms error was less than 2.0 cm. The system is configured so that the Chirp source signature can be chosen by software aboard the acquisition vessel. The complete system is described and initial navigational and seismic data results are presented. These data demonstrate that the approach of using fixed source-receiver geometry combined with RTK navigation can provide complete 3D imaging of the sub-surface.     

Cretaceous metamorphism in the Austroalpine Matsch Unit (Eastern Alps): The interrelation between deformation and chemical equilibration processes

In the polymetamorphic Austroalpine Matsch Unit (European Eastern Alps) Cretaceous upper greenschist facies metamorphism overprinted Variscan and Permian magmatic and metamorphic assemblages. Mineral compositional and (micro-)structural data of metapelites and metapegmatites document different mechanisms of interrelated deformation and (re-)equilibration during Cretaceous overprinting: i) Microfractures in relic garnet represented pathways for material transport, and thus established material exchange between intragranular domains and the matrix. Major element equilibration by fast diffusion along microfractures contrasts with limited volume diffusion in adjacent host garnet. ii) Syn-tectonic breakdown of staurolite initially to paragonite, then chloritoid allows correlating reaction progress with the formation of different fracture sets. iii) Syn-tectonic mineral growth with shape-preferred orientation in foliation domains contrasts with radial growth in microlithons and strain shadows of the mylonitic foliation. iv) Syn-tectonic unmixing of pre-existing oligoclase (an_14–16) produced fine-grained aggregates of two supposedly coexisting plagioclase-phases (an_3–6 and an_20–25) in strain shadows of the oligoclase-clasts. v) Pre-existing deformation-induced heterogeneities in the spatial distribution of phases and their preferred orientation influence the kinetics of phase equilibration. Understanding the mechanisms of the mutual interrelation between deformation and phase equilibration is a prerequisite for deducing PT-constraints from strained metamorphic rocks. New garnet—whole rock Sm-Nd data from metapegmatites indicate their emplacement at 263–280 Ma and provide an important age constraint on the interrelated deformation and re-equilibration processes.     

Significance of quaternary sea-level fluctuations for delta construction along the Brazilian coast

Many important areas of Quaternary deltaic sedimentation along the Brazilian coast are practically unknown in the geologic literature, especially outside Brazil. Our studies show that these areas, previously considered as highly destructive wave-dominated deltas of Holocene age, were affected by a wave-dominated phase during the Pleistocene, succeeded by highly constructive, intralagoonal stage in the Holocene, in turn followed by wave-dominated deltaic sedimentation that continues until today. The geologic evolution of these coastal plains is exemplified here by the Doce River mouth area, State of Espírito Santo, where relative sea-level fluctuations during the Quaternary played an important role in the construction of the deltaic complex.     

A new bathymetric model for the central Fram Strait

Based on data from R/V Polarstern multibeam sonar surveys between 1984 and 1997 high resolution bathymetry has been generated for the central Fram Strait. The area insonified covers approx. 36,500 km² between 78–80°N and 0–7.5°E allowing the creation of a Digital Terrain Model (DTM) with 100 m grid spacing. The DTM was utilized for contouring and generation of a new series of bathymetric charts (AWI Bathymetric Charts of the Fram Strait, AWI BCFS) at a scale of 1:100,000. The paper starts with a brief introduction to the regional setting of the study area comprising information on the local links between bathymetry, sea ice transport and water mass exchange. The bathymetric feature names used in this article and how they were chosen is outlined. Next, the input data and processing applied are described. Thereafter the newly created grid and contour data are put into context with existing data sets. Finally the main bathymetric features of the area are characterized and the generated data products available for public disposal are specified.     

Particle-bound phosphorus along an urbanized coastal plain estuary

The distribution of particle-bound phosphorus in the suspended sediment of the Delaware Estuary was examined with a sequential chemical leaching technique. The phosphorus content of particles was highest in the tidal river (140–250 μmol g⁻¹) near major anthropogenic inputs. Despite this enrichment of river particles with phosphorus, suspended particles within the salinity gradient had a phosphorus content more similar to the world's average. Sequential chemical leaches revealed that particulate phosphorus was associated with organic matter, aluminum oxides, iron oxides, and apatite in all areas of the estuary. However, ‘excess’ particle-bound phosphorus in the tidal river was associated mainly with iron oxides (27%), aluminum oxides (23%), and organic matter (50%). Within the salinity gradient, particulate phosphorus associated with iron oxides, aluminum oxides, and apatite all decreased with increasing salinity. Estuarine mixing was simulated to determine whether the observed decreases in particle-bound phosphorus pools in field samples were due to release into solution. During simulated mixing, particulate phosphorus associated with iron and aluminum oxides decreased, but no change was observed in apatite-bound phosphorus. The results of the mixing study combined with the observed particle-bound phosphorus distributions suggest that phosphate concentrations along the Delaware Estuary may be partially ‘buffered’ by aluminum and iron oxide phases.     

Selenium distribution in the Rhône delta and the Gulf of Lions

Total dissolved selenium and selenium species have been measured in the Rhône river delta and the Gulf of Lions within the framework of the EROS-2000 project. The Rhône river concentration of total selenium averages 2.30 nM with important variations related to river discharge. During estuar-ine mixing, the concentrations of total dissolved selenium, selenite and selenate (calculated as the difference between total dissolved and selenite) decrease linearly with increasing salinity, without significant interconversion between selenium species. In the open Mediterranean waters of the Gulf of Lions the total dissolved selenium increases from 0.5 nM in the surface waters to 0.9 nM in the deep waters. Organic selenium has been observed in Mediterranean deep water, an observation which is different from those from the Atlantic and the Pacific Oceans. The distributions of total inorganic selenium (Σ5e), selenite and selenate are strongly related to phosphate and silicate concentrations as observed previously for the major oceans.