β-环糊精包合态三氟氯氰杀虫剂的制备

为了进一步提高三氟氯氰菊酯农药的防治效果。寻找适宜的农药新剂型，我们用液相法制备了三氟氯氰菊酯－β－环糊精包合物，并以水为基质进行了稳定性观察，同时又以差热分析法和气相色谱法确认了包合物的形成，以旋光度法证明两者间的包合比。结果表明，三氟氯氰菊酯与β-环糊精可形成1：1型包合物，该包合物稳定性高，具有一定的水溶性，而且在水中稳定，所以有望通过环糊 包合作用将三氟氯氰菊酯帛成水剂；当以气相法测试包合态三氟氯氰菊酯含量时，必须将其解络，使之成为游离状态，然后按常规方法进行含量测定。     

松辽盆地后五家户气田沉积相特征与控气作用

本文对松辽盆地东南部后五家户气田划分出22种沉积微相,建立7种相层序,分析了扇三角洲及三角洲沉积环境对天然气成藏的控制作用。指出了扇三角洲前缘砂体和三角洲前缘砂体较为发育,沉积物源来自气田东北部和东南部两个方向。后五家户气田多为构造—岩性气藏和岩性气藏。     

Discussion on the feature of strong earthquake: Orderly distribution in time, space and intensity before the Western Kunlun Mountain Pass M=8.1 earthquake

Introduction The Western Kunlun Mountain Pass M=8.1 earthquake occurred on November 14, 2001 is the other M=8 earthquake occurred 50 years after Dangxiong, Tibet M=8.0 earthquake in Chinese mainland. The earthquake has caused the attention of the seismologists in the following aspects: 1) The fracture length is more than 400 km, which is far away from the estimated length by the statistic empirical function between the magnitude and the fracture length (WANG, et al, 2002); 2) The aftersh…     

Parameters affecting maximum fluid transport in large aperture fractures

We present results of laboratory experiments to study the behavior of liquids moving in unsaturated wide-aperture fractures. A 5-mm-thick glass plate cut with a 1.7-mm aperture was used as a fractured rock analog to study behavior of film and capillary droplet flow modes. Flow rates ranged between 0.6 and 6.0 ml/min. Variability in the ambient barometric pressure, resulting from weather conditions, seemed to play a role in the natural selection of flow mode. For droplet mode, constant input conditions resulted in highly variable transport properties within the fracture. The advancing meniscus exhibited a dynamic contact angle that was a function of the droplet speed and much larger than the static contact angle. Flow rate was reduced due to the larger contact angle. Analytical expressions for droplet velocity and flow capacity are presented as a function of the dynamic rather than the static contact angle.     

盆地岩石圈结构与油气成藏及分布

本文综述了大陆岩石圈研究现状和克拉通盆地、裂谷盆地和前陆盆地的岩石圈结构特征,指出在古裂谷、褶皱带或区域性深断裂等陆壳构造薄弱带上发育起来的多期叠合盆地,具有很好的含油气前景。大型含油气盆地往往存在地幔上隆、地壳减薄和地壳内低速层,盆地基底沉降与盖层沉积厚度较大。适度的后期构造活动改造和岩浆活动有利于沉积盆地内油气生成与保存。     

The tectonic regime in Italy inferred from borehole breakout data

In Italy, the horizontal stress directions are well constrained in many regions, but the tectonic regime is not well known because the stress magnitudes are unknown. Our intention is to improve the knowledge of crustal stress in Italy, both at shallow depth and in low seismicity areas. Therefore, we inferred the tectonic regime from the comparison between the depth of breakout occurrence and the physical properties of the rocks in 20 boreholes. The critical value of the maximum horizontal stress, for which the effective tangential stress at the borehole wall overcomes the rock strength to form breakouts, could be computed from rock strength and density. Comparing the theoretical stress distributions for different tectonic regimes with the depth distribution of breakout occurrence, it is possible to infer the tectonic regime that fits best to the breakout depth distribution. We investigated boreholes up to 6 km deep located in different tectonic environments over the Italian peninsula: the Po Plain, the Apenninic chain, the Adriatic foredeep and the Tyrrhenian Quaternary volcanic region. These wells are characterised by breakout data of good quality (A, B and C, according to World Stress Map quality ranking system). The results are in general agreement with the style of faulting derived from earthquake focal mechanisms and other stress indicators. Our results show a predominance of a normal faulting (NF) regime in the inner Apennines and both normal faulting and strike–slip faulting (SS) style in the surrounding regions, possibly also associated with changes in the tectonic regime with depth.