Aerial electromagnetic sounding of the lithosphere of Venus

Electromagnetic (EM) investigation depths are larger on Venus than Earth due to the dearth of water in rocks, in spite of higher temperatures. Whistlers detected by Venus Express proved that lightning is present, so the Schumann resonances ～10–40 Hz may provide a global source of electromagnetic energy that penetrates ～10–100 km. Electrical conductivity will be sensitive at these depths to temperature structure and hence thermal lithospheric thickness. Using 1D analytic and 2D numerical models, we demonstrate that the Schumann resonances—transverse EM waves in the ground-ionosphere waveguide—remain sensitive at all altitudes to the properties of the boundaries. This is in marked contrast to other EM methods in which sensitivity to the ground falls off sharply with altitude. We develop a 1D analytical model for aerial EM sounding that treats the electrical properties of the subsurface (thermal gradient, water content, and presence of conductive crust) and ionosphere, and the effects of both random errors and biases that can influence the measurements. We initially consider specified 1D lithospheric thicknesses 100–500 km, but we turn to 2D convection models with Newtonian temperature-dependent viscosity to provide representative vertical and lateral temperature variations. We invert for the conductivity-depth structure and then temperature gradient. For a dry Venus, we find that the error on temperature gradient obtained from any single local measurement is ～100%—perhaps enough to distinguish “thick” vs. “thin” lithospheres. When averaging over thousands of kilometers, however, the standard deviation of the recovered thermal gradient is within the natural variability of the convection models, <25%. A “wet” interior (hundreds of ppm H₂O) limits EM sounding depths using the Schumann resonances to <20 km, and errors are too large to estimate lithospheric properties. A 30-km conductive crust has little influence on the dry-interior models because the Schumann penetration depths are significantly larger. We conclude that EM sounding of the interior of Venus is feasible from a 55-km high balloon. Lithospheric thickness can be measured if the upper-mantle water content is low. If H₂O at hundreds of ppm is present, the deeper, temperature-sensitive structure is screened, but the “wet” nature of the upper mantle, as well as structure of the upper crust, is revealed.     

Advances in pan‐European flood hazard mapping

Flood hazard maps at trans‐national scale have potential for a large number of applications ranging from climate change studies, reinsurance products, aid to emergency operations for major flood crisis, among others. However, at continental scales, only few products are available, due to the difficulty of retrieving large consistent data sets. Moreover, these are produced at relatively coarse grid resolution, which limits their applications to qualitative assessments. At finer resolution, maps are often limited to country boundaries, due to limited data sharing at trans‐national level. The creation of a European flood hazard map would currently imply a collection of scattered regional maps, often lacking mutual consistency due to the variety of adopted approaches and quality of the underlying input data. In this work, we derive a pan‐European flood hazard map at 100 m resolution. The proposed approach is based on expanding a literature cascade model through a physically based approach. A combination of distributed hydrological and hydraulic models was set up for the European domain. Then, an observed meteorological data set is used to derive a long‐term streamflow simulation and subsequently coherent design flood hydrographs for a return period of 100 years along the pan‐European river network. Flood hydrographs are used to simulate areas at risk of flooding and output maps are merged into a pan‐European flood hazard map. The quality of this map is evaluated for selected areas in Germany and United Kingdom against national/regional hazard maps. Despite inherent limitations and model resolution issues, simulated maps are in good agreement with reference maps (hit rate between 59% and 78%, critical success index between 43% and 65%), suggesting strong potential for a number of applications at the European scale. Copyright © 2013 John Wiley & Sons, Ltd.     

Linking biogeochemical processes and historic primary producer communities in a SE USA sinkhole lake from the mid-Holocene to present

Many freshwater resources receive materials from human development causing a decrease in ecological services when compared to pre-disturbance periods. As a result, the understanding of eutrophication and limnological change has increased, but less attention has been given to systems under intense human impact that have not eutrophied so that drivers precluding eutrophication can be documented. The primary objective of this research was to reconstruct allochthonous inputs and in-lake processes for Long Pond, Georgia, USA from the mid Holocene to present and link them to primary producer community changes. Long Pond is a mesotrophic lake located in a highly altered watershed from agricultural and municipal land use and housing developments. A 5 m sediment core was collected from Long Pond, and organic matter, nutrients (C, N, P), metals (Al, Fe, Cu), and photosynthetic pigments were measured. Long Pond existed in three limnological states spanning the past ~6000 years. Prior to modern lacustrine conditions, Long Pond was a wetland/peat system that experienced the highest primary producer abundance recorded in the core. The modern lacustrine state began in the late Holocene and was characterized by increased connectivity with the surrounding watershed and low productivity. Human impacts began around 1900 AD and included high levels of phosphorus and metal deposition but moderate levels of primary producer abundance. As a result, in-lake dynamics are believed to be regulating the trophic status of Long Pond. Low concentrations of available phosphorus in the water column combined with high concentrations of sedimentary phosphorus may imply the binding of phosphorus to the sediments by certain materials such as aluminum and iron. Long Pond serves as an example of the complex in-lake processes that can occur from allochthonous inputs and autochthonous responses in lake systems thus complicating management decisions.     

Depositional ice nucleation on NX illite and mixtures of NX illite with organic acids

Mineral dust particles are known to be efficient ice nuclei in the atmosphere. Previous work has probed heterogeneous ice nucleation on various laboratory dust samples including Arizona Test Dust, kaolinite, montmorillonite, and illite as atmospheric dust surrogates. However, it has recently been suggested that NX illite may be a better representation of atmospheric dust. Hiranuma et al. (2015) performed a laboratory comparison for immersion ice nucleation on NX illite, but here we focus on depositional ice nucleation because of its importance in low temperature cirrus cloud formation. A Raman microscope setup was used to examine the ice-nucleating efficiency of NX illite. Organic coatings on the NX illite particles were also investigated using a mixture of 5 dicarboxylic acids (M5). The ratio of NX illite to M5 was varied from 1:10 to 100:1. It was found that NX illite efficiently nucleates ice with S_ice = 1.07 ± 0.01 at ?47 °C, with S_ice slightly increasing at lower temperatures. In contrast, pure M5 is a poorer ice nucleus with S_ice = 1.30 ± 0.02 at ?40 °C, relatively independent of temperature. Further, it was found that M5 coatings on the order of several monolayers thick hindered the ice nucleating ability of NX illite. Optical images suggest that at colder temperatures (< ?50 °C) 1:1 NX illite:M5 particles and pure M5 particles nucleate ice depositionally, while at warmer temperatures (> ?50 °C) subsaturated immersion ice nucleation dominates. These experiments suggest that mineral dust particles may become less active towards ice nucleation as they age in the atmosphere.     

哈达门沟金矿床地质特征及其形成时代研究

哈达门沟金矿床位于华北地台北缘西段,产于太古代乌拉山岩群变质碉系中,矿床以发育一系列含金钾长石－石英脉为特征,这些钾长石－石英脉沿近东西向的韧、脆性叠加断裂成 出。钾长石化是最发的近矿围为。采用离子探针（ＳＨＲＩＭＰ）对矿体边部的钾长石化蚀变岩锆石Ｕ－Ｐｂ定年结果表明：矿化钾长石化蚀变岩的年龄为１３２±２Ｍａ。由于钾长石化夺本身被金矿化,因此金矿化年龄小于或接近于１３２±２Ｍａ,为燕山晚期成矿。     

A novel index of susceptibility of rivers and their catchments to acidification in regions subject to a maritime influence

A simple, unifying approach to classifying quantitatively the susceptibility of catchment soils and surface waters to acidification is suggested. In areas subject to a strong maritime influence, such as the UK and substantial parts of NW Europe, wherever soil mineral weathering rates are low and soils are unfertilised, atmospherically derived base cations of maritime origins have a greater effect than those derived from biogeochemical weathering on the exchangeable soil base cations. This is directly reflected in the relative base cation concentrations of the associated drainage waters, which become increasingly Na-dominated. Using 10 sub-catchments of the River Dee in north-eastern Scotland, it is shown here that the extent of Na dominance, the ratio of Na⁺ to ΣNa⁺+Ca²⁺+Mg²⁺, at any point in a river provides a quantitative index of the upstream weathering rate and thus of the susceptibility of the river concerned to acidification under diverse flow conditions. Data from a further 58 sub-catchments from the same river system, and from 4 other catchments from around Scotland, were used to validate this theory.     

Comparison of garnet-biotite, calcite-graphite, and calcite-dolomite thermometry in the Grenville Orogen; Ontario, Canada

The Elzevir Terrane of the Grenville Orogen in southern Ontario contains metapelites and abundant graphitic marbles that were regionally metamorphosed from the upper greenschist to upper amphibolite facies. Comparative thermometry was undertaken with widely used calibrations for the systems garnet-biotite, calcite-dolomite, and calcite-graphite. Temperatures that are obtained from matrix biotites paired with prograde garnet near-rim analyses are usually consistent with those determined using calcite-graphite thermometry. However, calcite-graphite thermometry occasionally yields low temperatures due to lack of equilibration of anomalously light graphite. Application of calcite-graphite and garnet-biotite systems may yield temperatures up to 70 °C higher than calcite-dolomite in amphibolite facies rocks. Calcite-dolomite temperatures most closely approach those from calcite-graphite and garnet-biotite when the samples contain a single generation of dolomite and calcite grains contain no visible dolomite exsolution lamellae. However, some of these samples yield temperatures considerably lower than temperatures calculated from calcite-graphite and garnet-biotite thermometry, indicating that the calcite-dolomite thermometer may have been partially reset during retrogression. Estimated peak metamorphic temperatures of regional metamorphism between Madoc (upper greenschist facies) and Bancroft (upper amphibolite facies) range from 500 to 650 °C. These results place the chlorite-staurolite isograd at 540 °C, the kyanite-sillimanite isograd at 590 °C, and the sillimanite-K-feldspar isograd at 650 °C. Although each thermometer may have an absolute uncertainty of as much as ±50 °C, the 50 to 60 °C temperature differences between the isograds are probably accurate to 10 to 20 °C. An incomplete picture of the thermal gradients can result from the application of only one thermometer in a given area. Simultaneous application of several systems allows one to recognize and overcome the inherent limitations of each thermometer. Received: 26 March 1997 / Accepted: 15 April 1998     

Development of a distributed hydrological model to facilitate watershed management

To facilitate precise and cost-effective watershed management, a simple yet spatially and temporally distributed hydrological model (DHM-WM) was developed. The DHM-WM is based on the Mishra-Singh version of the curve number method, with several modifications: The spatial distribution of soil moisture was considered in moisture updating; the travel time of surface runoff was calculated on a grid cell basis for routing; a simple tile flow module was included as an option. The DHM-WM was tested on a tile-drained agricultural watershed in Indiana, USA. The model with the tile flow module performed well in the study area, providing a balanced water budget and reasonable flow partitioning. The daily coefficient of determination and Nash-Sutcliffe coefficient were 0.58 and 0.56, for the calibration period, and 0.63 and 0.62 for the validation period. The DHM-WM also provides detailed information about the source areas of flow components, the travel time and pathways of surface runoff.

EDITOR A. Castellarin; ASSOCIATE EDITOR F.-J. Chang     

Dissolved organic matter variations in coastal plain wetland watersheds: The integrated role of hydrological connectivity,land use,and seasonality

Dissolved organic matter (DOM) is integral to fluvial biogeochemical functions, and wetlands are broadly recognized as substantial sources of aromatic DOM to fluvial networks. Yet how land use change alters biogeochemical connectivity of upland wetlands to streams remains unclear. We studied depressional geographically isolated wetlands on the Delmarva Peninsula (USA) that are seasonally connected to downstream perennial waters via temporary channels. Composition and quantity of DOM from 4 forested, 4 agricultural, and 4 restored wetlands were assessed. Twenty perennial streams with watersheds containing wetlands were also sampled for DOM during times when surface connections were present versus absent. Perennial watersheds had varying amounts of forested wetland (0.4–82%) and agricultural (1–89%) cover. DOM was analysed with ultraviolet–visible spectroscopy, fluorescence spectroscopy, dissolved organic carbon (DOC) concentration, and bioassays. Forested wetlands exported more DOM that was more aromatic‐rich compared with agricultural and restored wetlands. DOM from the latter two could not be distinguished suggesting limited recovery of restored wetlands; DOM from both was more protein‐like than forested wetland DOM. Perennial streams with the highest wetland watershed cover had the highest DOC levels during all seasons; however, in fall and winter when temporary streams connect forested wetlands to perennial channels, perennial DOC concentrations peaked, and composition was linked to forested wetlands. In summer, when temporary stream connections were dry, perennial DOC concentrations were the lowest and protein‐like DOM levels the highest. Overall, DOC levels in perennial streams were linked to total wetland land cover, but the timing of peak fluxes of DOM was driven by wetland connectivity to perennial streams. Bioassays showed that DOM linked to wetlands was less available for microbial use than protein‐like DOM linked to agricultural land use. Together, this evidence indicates that geographically isolated wetlands have a significant impact on downstream water quality and ecosystem function mediated by temporary stream surface connections.