A Model of Conductive Heat Flow in Forest Edges and Fragmented Landscapes

Although the creation of edges during forest fragmentation can have important abiotic and biotic impacts, especially under conditions of future climate change, mechanistic models of edge effects have not been forthcoming. A simple numerical model of two-dimensional heat flow is developed and applied to a vertical forest/clearcut edge profile and to simulated fragmented landscapes. Height-specific thermal diffusivity and conductivity in the forest were assumed to vary in proportion to foliage densities measured in the central Amazon. In the edge profile, the clearcut that abutted the edge served as a heat source and its temperature was maintained at a constant value higher than in the initially cooler forest. In the fragmented landscapes, simulated treefall gaps were heat sources whose temperature varied with sun movements during the day. Gap frequency was varied so as to approximate the gap coverage observed in selectively logged forests. In one set of simulations, temperature in the openings was systematically varied; in another, thermal diffusivity of the forest was varied. Along the edge profile, high temperatures in the clearcut were rapidly transmitted into the upper canopy due to additive edge effects. Temperatures in the forest understory were also very sensitive to clearcut temperatures due to relatively sparse understory foliage. An overall increase in forest diffusivity led to markedly higher temperatures close to the edge and a more even temperature distribution among height strata. In fragmented landscapes, total gap coverage and additivity from neighboring gaps strongly influenced forest temperatures. At low conductivities, heat flowed only into the forest close to the gaps and hence forest temperature increased almost linearly with gap area. However, at high conductivities, heat flowed far into the forest and forest temperature varied as a function of gap density in the surrounding neighborhood. Because of these additive effects, slight increases in total gap area led to disproportionate changes in the thermal profile of the landscape. These results have important implications for the conservation of forest ecosystems.     

An improved Ewing heat probe frame

The standard Ewing heat probe frame has been improved through the design of a new takedown model whose parts are held together by lynch pins. When a 600 lb (272 kg) unit of this type is taken apart, the heaviest single piece of the dismantled unit weighs only 75 lb (34 kg).This makes it feasible for one person to handle, transport, and assemble the new unit. A central, main support member of a heat probe using this frame can be suspended over the side of a research vessel while the heavier temperature recorder and ballast weights are attached by means of the quickaction lynch pins. This makes it possible to use this device on relatively small vessels which are not designed for coring work, having a minimum of free deck space and without launching platforms or hydraulic A-frame booms.     

Limited differences among habitats in deep‐sea macro‐infaunal communities off New Zealand: implications for their vulnerability to anthropogenic disturbance

The spread of human activities into the deep sea may pose a high risk to benthic communities and affect ecosystem integrity. The deep sea is characterized by physical and biological heterogeneity and different habitat types are likely to differ in their vulnerability to anthropogenic impacts. However, across‐habitat comparisons are rare, and no comprehensive ecological risk assessment has yet been developed. To address this gap in our knowledge, we compared macro‐infaunal community structure in four habitats (slope, canyons, seamounts and methane seeps) at depths between 700 and 1500 m in the Hikurangi Margin and Bay of Plenty regions off New Zealand. The most striking contrast in community structure was between the two study regions, due to an order of magnitude difference in macro‐infaunal abundance that we believe was caused by differences in surface productivity and food availability at the sea bed. We found differences in structural and functional attributes of macro‐infaunal communities among some habitats in the Hikurangi Margin (slope, canyon and seep), but not in the Bay of Plenty. We posit that differences between canyon and slope communities on the Hikurangi Margin are due to enhanced food availability inside canyons compared with adjacent slope habitats. Seep communities were characterized by elevated abundance of both symbiont‐bearing and heterotrophic taxa, and were the most distinct, and variable, among the habitats that we considered on the Hikurangi Margin. Communities of seamounts were not distinct from slope or canyon communities on the Hikurangi Margin, probably reflecting similar environmental conditions in these habitats. The communities of deep‐sea canyon and seep habitats on the Hikurangi Margin were sufficiently dissimilar from each other and from slope habitats to warrant separate management consideration. By contrast, the low dissimilarity between communities of canyon and slope habitats in the Bay of Plenty suggests that habitat‐based management is not required in this region, for macro‐infauna at least. Although the two study regions share similar species pools, populations of the Hikurangi Margin region may be less vulnerable than the sparser populations of the Bay of Plenty due to the higher availability of potential colonizers and faster population growth. Thus regions, and habitats in some regions, should be subject to separate ecological risk assessment to help identify the key risks and consequences of human activities, and to inform options for reducing or mitigating impacts.     

Trace Metal Solid State Speciation in Aerosols of the Northern Levantine Basin,East Mediterranean

An established three stage sequential leach scheme was applied to a series of selected high volume aerosol samples (n = 35) collected from the Turkish Eastern Mediterranean coastline (Erdemli). Samples were selected according to their air mass back trajectory history to reflect the contrasting mixtures of aerosol material present in the Eastern Mediterranean marine aerosol. Two populations were adopted, those samples which were classed as “anthropogenic” and those which were “Saharan” dominated aerosol populations. Applying the three stage leach it was possible to define the proportion for each of the considered metals (Al, Fe, Cu, Pb, Cd, Zn and Mn) present in the (a) “exchangeable” (b) “carbonate / oxide” and (c) “refractory” phases, representing novel solid state aerosol speciation data for this marine system. Clear trends were established, conforming with data from previous studies with mainly crustal derived metals (Al and Fe) being present in the refractory phases (Al > 88%; Fe > 84%) and those influenced by anthropogenic sources being dominating in the exchangeable phase, although for these metals the variability was comparatively high (12–64%; 19–85%; 40–100% for Zn, Pb and Cd, respectively). For the majority, greater exchangeable fractions were present the lower the crustal source contribution to the aerosol population, whereas the “refractory” fraction exhibited contrasting behaviour. This was illustrated by the novel application of the mixing diagram, presenting each of the three speciation stages against the corresponding percent anthropogenic contribution to each collected sample. Zn, Pb and Cd all illustrated progressive decrease in the percent exchangeable with increasing crustal contribution to the aerosol population. The percent exchangeable was discussed in terms of its use to represent the upper limit of the bioavailable fraction of metal associated with the aerosol, post deposition. The mixing diagram approach enabled the prediction of the residual fractions for Cd, Pb and Zn (41 ± 4%; 62 ± 4% and 82 ± 5%, respectively,) in Saharan end-member material.     

Tree-mycorrhiza symbiosis accelerate mineral weathering: Evidences from nanometer-scale elemental fluxes at the hypha-mineral interface

In soils, mycorrhiza (microscopic fungal hypha) living in symbiosis with plant roots are the biological interface by which plants obtain, from rocks and organic matter, the nutrients necessary for their growth and maintenance. Despite their central role in soils, the mechanism and kinetics of mineral alteration by mycorrhiza are poorly constrained quantitatively. Here, we report in situ quantification of weathering rates from a mineral substrate, (0 0 1) basal plane of biotite, by a surface-bound hypha of Paxillus involutus, grown in association with the root system of a Scots pine, Pinus sylvestris. Four thin-sections were extracted by focused ion beam (FIB) milling along a single hypha grown over the biotite surface. Depth-profile of Si, O, K, Mg, Fe and Al concentrations were performed at the hypha-biotite interface by scanning transmission electron microscopy-energy dispersive X-ray spectroscopy (STEM-EDX). Large removals of K (50-65%), Mg (55-75%), Fe (80-85%) and Al (75-85%) were observed in the topmost 40 nm of biotite underneath the hypha while Si and O are preserved throughout the depth-profile. A quantitative model of alteration at the hypha-scale was developed based on solid-state diffusion fluxes of elements into the hypha and the break-down/mineralogical re-arrangement of biotite. A strong acidification was also observed with hypha bound to the biotite surface reaching pH < 4.6. When consistently compared with the abiotic biotite dissolution, we conclude that the surface-bound mycorrhiza accelerate the biotite alteration kinetics between pH 3.5 and 5.8 to ∼0.04 μmol biotite m⁻² h⁻¹. Our current work reaffirms that fungal mineral alteration is a process that combines our previously documented bio-mechanical forcing with the μm-scale acidification mediated by surface-bound hypha and a subsequent chemical element removal due to the fungal action. As such, our study presents a first kinetic framework for mycorrhizal alteration at the hypha-scale under close-to-natural experimental conditions.     

Equilibrium coexistence of three amphiboles

Electron probe and wet chemical analyses of amphibole pairs from the sillimanite zone of central Massachusetts and adjacent New Hampshire indicated that for a particular metamorphic grade there should be a restricted composition range in which three amphiboles can coexist stably. An unequivocal example of such an equilibrium three amphibole rock has been found in the sillimanite-orthoclase zone. It contains a colorless primitive clinoamphibole, space group P2₁/m, optically and chemically like cummingtonite with blue-green hornblende exsolution lamellae on (100) and (¯101) of the host; blue-green hornblende, space group C2/m, with primitive cummingtonite exsolution lamellae on (100) and (¯101) of the host; and pale pinkish tan anthophyllite, space group Pnma, that is free of visible exsolution lamellae but is a submicroscopic intergrowth of two orthorhombic amphiboles. Mutual contacts and coarse, oriented intergrowths of two and three host amphiboles indicate the three grew as an equilibrium assemblage prior to exsolution. Electron probe analyses at mutual three-amphibole contacts showed little variation in the composition of each amphibole. Analyses believed to represent most closely the primary amphibole compositions gave atomic proportions on the basis of 23 oxygens per formula unit as follows: for primitive cummingtonite (Na_0.02Ca_0.21 ^– Mn_0.06Fe²⁺ _2.28Mg_4.12Al_0.28) (Al_0.17Si_7.83), for hornblende (Na_0.35Ca_1.56Mn_0.02Fe_1.71Mg_2.85Al_0.92) (Al_1.37Si_6.63), and for anthophyllite (Na_0.10Ca_0.06Mn_0.06Fe_2.25Mg_4.11Al_0.47) (Al_0.47Si_7.53). The reflections violating C-symmetry, on X-ray single crystal photographs of the primitive cummingtonite, are weak and diffuse, and suggest a partial inversion from a C-centered to a primitive clinoamphibole. Single crystal photographs of the anthophyllite show split reflections indicating it is an intergrowth of about 80% anthophyllite and about 20% gedrite which differ in their b crystallographic dimensions. Split reflections are characteristic of all analyzed orthorhombic amphiboles so far examined from Massachusetts and New Hampshire except the most aluminous gedrites, and the relative intensity of the gedrite reflections is roughly proportional to the degree of Na and Al substitution. Thin sections of a few of these anthophyllite specimens show lamellae parallel to (010) that are just resolved with a high power objective.Publication approved by the Director, U.S. Geological Survey.