Kinematics of stars in Kovalsky-Kapteyn figures. II

Rostov State Pedagogical Institute; All-Union Scientific Research Institute Gradient. Translated from Astrofizika, Vol. 33, No. 3, pp. 379–393, November–December, 1990.     

Radiative and free-convection effects on the oscillatory flow past a vertical plate

The interaction of free convection with thermal radiation of the oscillatory flow past a vertical plate is studied. The Rosseland approximation is used to describe the radiative heat flux in the energy equation.     

OTEC cold-water pipe research

Shelf-mounted Ocean Thermal Energy Conversion (OTEC) plants require installation of cold-water pipes (CWP) on slopes of40degto depths of 1000 m. In addition, tower platforms containing OTEC power systems may be located on lesser sloped terrain near shore and exposed to special environmental loading problems affecting foundation design. Shelf-mounted installations require careful attention to site selection and geotechnical considerations for foundation integrity on sloped surfaces. This paper primarily discusses research associated with cold-water pipe and foundation installations on steep slopes, although research continues on tower platforms located on the shelf. At least five nations are in various stages of development of OTEC systems for island applications. Each of their systems is either shelf mounted or land based and requires that a large diameter cold-water pipe be installed on a steep slope to provide cold water from 1000-m depths. In addition to the installation and deployment of the large cold-water pipe, the most significant problem is the design and installation of suitable foundations that will last for several decades. To date there is very little experience in the offshore industry for large installations on steep slopes. A major scale-model research project is underway on the slopes of the island of Hawaii. A section of pipe 2.4 m in diameter and 24 m long was installed using combination concrete foundations and joints. The pipe and foundations are fully instrumented to measure environmental loading forces due principally to currents and waves. Environmental measurements will also be taken in the test area. The measurement data will be used to validate available analytical models for subsequent use in aiding industry in providing more cost-effective designs for OTEC pipes and foundations.     

Range of validity of seismic ray and beam methods in general inhomogeneous media – I. General theory

Summary. The limitations of asymptotic wave theory and its geometrical manifestations are newly formalized and scrutinized. Necessary and sufficient conditions for the existence of acoustic and seismic rays and beams in general inhomogeneous media are expressed in terms of new physical parameters: the threshold frequency ω₀ associated with the P/S decoupling condition, the cut-off frequency ω_c associated with the radiation-zone condition, the total curvature of the wavefront and the Fresnel-zone radius.
The analysis is facilitated with the introduction of a new ancillary functional – the hypereikonal which is capable of representing ordinary as well as evanescent waves. The hypereikonal is the natural extension of the eikonal theory.
With the aid of the above new parameters, simple conditions are obtained for the decoupled far field, the decoupled near field, two point dynamic ray tracing, paraxial wavefields and Gaussian beams.     

The dust coma of periodic comet Churyumov-Gerasimenko (1982 VIII)

The dust coma of Comet P/Churyumov-Gerasimenko was monitored in the infrared (1–20 μm) from September 1982 to March 1983. Maximum dust production rate of ～2 × 10⁵ g/sec occured in December, 1 month postperihelion. The ratio of dust/gas production was higher than that in other short-period comets. No silicate feature was visible in the 8- to 13-μm spectrum on 23 October. The mean geometric albedo of the grains was ～0.04 at 1.25 μm and ～0.05 at 2.2 μm.     

An approximate method for evaluating the shear band thickness in saturated soils

A formula for the thickness of a shear band formed in saturated soils under a simple shear or a combined stress state has been proposed. It is shown that the shear band thickness is dependent on the pore pressure properties of the material and the dilatancy rate, but is independent of the details of the combined stress state. This is in accordance with some separate experimental observations. Copyright © 2004 John Wiley & Sons, Ltd.     

A continuum‐discrete hydromechanical analysis of granular deposit liquefaction

A coupled continuum‐discrete hydromechanical model was employed to analyse the liquefaction of a saturated loose deposit of cohesionless particles when subjected to a dynamic base excitation. The pore fluid flow was idealized using averaged Navier–Stokes equations and the discrete element method was employed to model the solid phase particles. A well established semi‐empirical relationship was utilized to quantify the fluid–particle interactions. The conducted simulations revealed a number of salient micro‐mechanical mechanisms and response patterns associated with the deposit liquefaction. Space and time variation of porosity was a major factor which affected the coupled response of the solid and fluid phases. Pore fluid flow was within Darcy's regime. The predicted response exhibited macroscopic patterns consistent with experimental results and case histories of the liquefaction of granular soil deposits. Copyright © 2004 John Wiley & Sons, Ltd.