北方劳德藻配子和复大孢子的产生

于１９８６年１０月在厦门近岸采集北方劳德藻，从培养中观察其有性生殖和光对生殖的影响。结果表明，该藻只有宽度为２６－４０μｍ的细胞能形成配子和复大孢子；在光照条件下每昼夜只发生１次性化；雌雄配子以不同发育方式形成，配子发生呈现一定的时间程序；强光照和１６ｈ光周期最适于性化。由此得知，引起性化既依赖适当的细胞大小，又依赖光诱导的外部因素；产生两种精子数目是与精原孢囊的体积大小紧密相关；性化与光强度之间     

Paraconchoecia diacanthus n. sp., a new species of planktonic Ostracoda

Ｐａｒａｃｏｎｃｈｏｅｃｉａｄｉａｃａｎｔｈｕｓｎ．ｓｐ．,ａｎｅｗｓｐｅｃｉｅｓｏｆｐｌａｎｋｔｏｎｉｃＯｓｔｒａｃｏｄａ￥ＣｈｅｎＲｕｉｘｉａｎｇａｎｄＬｉｎＪｉｎｇｈｏｎｇ（ＲｅｃｅｉｖｅｄＡｐｒｉｌ１６,１９９３１ａｃｃｅｐｔｅｄＪｕｌｙ２０...     

周期浅析

本文分析了滑动平均的数据处理方法对周期分析结果产生的影响。提出了过程变量同号积分的数据处理方法,并对亚洲西风指数序列进行了试验分析。分析结果表明,周期的长短与振幅的大小有密切关系,亚洲逐日西风指数的周期振荡具有明显的季节特征。     

Interfacial geochemistry of barium in suspension and sediment from Zhujiang Estuary

Chemical forms of Ba are determined in samples of suspension and sediment from the Zhujiang Estuary. Their interfacial geochemical processes are discussed. Total suspended Ba content is between 2. 4 and 40. 4 μg/L, and mostly exists in the crystalline form (43. 5%), secondly in the Fe-Mn oxidative form (23.1%). Percentages of organic, carbonate and exchangeable forms are 14. 8%, 11. l%and 7.4%, respectively. Total content of Ba in the sediment is between 158. 6 and 48. 0 ug/g. Percentages of crystalline form, Fe-Mn oxidative form and carbonate form are 78. 4% ,13. 5%and 8. 2%, respectively. Organic and exchangeable forms are not detected. The study on the mechanism of interfacial movement suggests that the salinity range of 10 is the turning point for the varied distribution of Ba. The subsidence of crystalline form affects the decrease of Ba content in suspension. The decrease mostly takes place in the salinity range lower than 10, which corresponds to the high value of Ba content in the sediment. The     

On the recovery of surface wave by pressure transfer function

Except the commonly selected pressure transfer function derived from the linear wave theory, a previous study on the pressure transfer function for recovering surface wave from underwater pressure transducer suggested that the pressure transfer function is a function of frequency parameter only. With careful analysis, this study showed that the pressure transfer function should include a transducer submergence parameter as that given by the linear theory. It was found that the previously suggested empirical formula should be restricted to measurements with the pressure transducer close to the surface; otherwise overestimation of wave height would result. Field measurements were carried out with an acoustic wave gauge and a synchronized pressure transducer located at various depths with submergence parameter close to 1 (near the sea floor). It was shown that the previous one-parameter empirical formula might overestimate the significant wave height by more than 30%. This study found that with deep-water wave bursts excluded, the transfer function based on the linear wave theory provided a fairly good estimation on the significant wave heights, with an average deviation of 3.6%.     

Measurement of stress effects (scope for growth) and contaminant levels in mussels (Mytilus edulis) collected from the Irish Sea

The objective of this research was to quantify the impact of pollution along the coastlines of the Irish Sea. Pollution assessment was based on the combined measurement of scope for growth (SFG), and chemical contaminants in the tissues of mussels (Mytilus edulis) collected from 38 coastal sites around the Irish Sea during June-July in 1996 and 1997. On the UK mainland coast, the SFG showed a general trend with a significant decline in water quality in the Liverpool and Morecambe Bay region. High water quality was recorded along the west coast of Wales, as well as southwest England and northwest Scotland (clean reference sites outside the Irish Sea). Along the coast of Ireland there was a similar trend with reduced SFG within the Irish Sea region. SFG was generally low north of Duncannon and then improved north of Belfast. The poor water quality on both sides of the Irish Sea is consistent with the prevailing hydrodynamics and the spatial distribution of contaminants associated with urban/ industrial development. The decline in SFG of mussels on both sides of the Irish Sea was associated with a general increase in contaminant levels in the mussels. Certain contaminants, including PAHs, TBT, sigmaDDT, Dieldrin, gamma-HCH, PCBs, and a few of the metals (Cd, Se, Ag, Pb), showed elevated concentrations. Many of these contaminants were particularly elevated in the coastal margins of Liverpool Bay, Morecambe Bay and Dublin Bay. A quantitative toxicological interpretation (QTI) of the combined tissue residue chemistry and SFG measurements indicated that at the majority of coastal sites, c. 50 to > 80% of the observed decline in SFG was due to PAHs as a result of fossil fuel combustion and oil spills. TBT levels were highest at major ports and harbours, but these concentrations only made a minor contribution to the overall reduction in SFG. At no sites were individual metals accumulated to concentrations that could cause a significant effect on SFG. The study identified many sites where the observed reduction in SFG was far greater than predicted from the limited number of chemical contaminants analysed, thus indicating the presence of additional 'unknown toxicants'. Sewage (containing domestic, agricultural and industrial components) appears to be an important contributor to reduced SFG and linear alkylbenzenes (LABs) and As may provide suitable 'sewage markers'. There was a highly significant positive correlation between SFG and As (P < 0.001). This relationship may be due to reduced As uptake by algal food material and mussels at sites with elevated P04 concentrations (e.g. at sites with sewage inputs). Phosphate is a known competitive inhibitor of As accumulation, at least in algae. The results highlight that further research is required on 'sewage markers' in mussels. The SFG approach therefore provides a rapid, cost-effective and quantitative measure of pollution impact, as well as a means of identifying the causes through a QTI of tissue contaminants levels. It also serves to identify the presence of unidentified toxicants and areas that require further study.     

Sensitivity to stress of the estuarine bivalve Macoma balthica from areas between the Netherlands and its southern limits (Gironde)

Variation in the sensitivity to stress of Macoma balthica was measured in several French and Dutch estuaries. For adult and juvenile Macoma balthica exposed to copper under conditions of starvation, differences in mortality rate, condition, glycogen, burrowing rate and copper content were assessed. No significant differences were observed between adults and juveniles; the influence of treatment and origin was always evident. Animals from the most southern estuaries, Loire and Gironde, near to the species's southern limit of distribution, showed, in the field, the strongest deviations for the ecophysiological traits measured, and were in the experiments the most sensitive to stress.     

Three-dimensional Layer-integrated Modelling of Estuarine Flows with Flooding and Drying

Details are given of the refinement and application of a thee-dimensional (3-D) layer-integrated numerical model of tidal circulation, with the aim of simulating severe tidal conditions for practical engineering applications. The mode splitting strategy has been used in the model. A set of depth-integrated 2-D equations are first solved to give the pressure gradient, and the layer-integrated 3-D equations are then solved to obtain the vertical distributions of the flow velocities. Attention has been given to maintaining consistency of the physical quantities derived from the 2-D and 3-D equations. A TWO=layer mixing length turbulence model for the vertical shear stress distribution has been included in the model. Emphasis has been focused on applying the model to a real estuary, which is geometrically complicated and has large tidal ranges giving rise to extensive flooding and drying. The model has been applied to three examples, including: wind-driven flow in a rectangular lake, tidal circulation in a model rectangular harbour, and tidal circulation in a large estuary. Favourable results have been obtained for both the simple and complex flow beds.     

Virgin rock temperatures from well logs — accuracy analysis for some advanced inversion models

Temperature data from 18 measurement series obtained during logging of the Oseberg field in the northern North Sea are presented. Because the measurement series are taken at approximately the same depth, they should give identical temperatures after depth correction, and are suitable for assessing the performance of different models used to determine virgin rock temperatures from well log information.We have used this data set to test the properties of the different models given by Shen and Beck (1986). Although these models were built to simulate closely the thermal recovery of a well and are unbiased, the uncertainties in the temperature estimates when applied to real data are found to be no less than those from simpler (biased) models. This fact confirms the conclusion of Hermanrud (1989a) who showed that physical factors other than those presently accounted for significantly influence the thermal recovery of a borehole.     

Measurements of higher harmonic wave forces on a vertical truncated circular cylinder

Wave forces on a vertical truncated circular cylinder in Stokes waves with the wave slopes ranging from 0.06 to 0.24, are measured in a wave tank. The higher harmonic wave forces are compared with the available values from theories of the FNV (Faltisen–Newman–Vinje) model and Varyani solution. The first harmonic horizontal forces measured are much larger than the theoretical values from the FNV model, while the first harmonic vertical forces are well predicted by the Varyani theory. It was also found that the FNV model significantly overpredicts the second harmonic horizontal forces in high frequency waves, but under predicts the third harmonic forces. The differences between the actual measurement and the theory, in the second and third harmonic horizontal forces, become smaller at low wave frequencies as the wave slope increases. In addition, the transverse instabilities in the incoming waves with high wave slope were observed, which is due to the nonlinear modulation. Measurements were, thus, carried out before the instability occurred.