Isotope anomalies in tellurium and palladium from Allende nanodiamonds

Abstract— ‐The elemental and isotopic abundances of Te and Pd have been measured by thermal ionization mass spectrometry in a purified sample of interstellar nanodiamonds from the Allende meteorite, after combustion of the diamonds in an oxygen plasma. Small positive anomalies were found in ¹²⁸Te (4.0 ± 1.5 %0) and ¹³⁰Te (9.3 ± 2.8 %0) from three analyses of the Allende nanodiamond sample EB, and in ¹¹⁰Pd (9.4 ± 5.7 %0) from two analyses of the same sample. No other anomalies of a significant nature were found in either Te or Pd. These results are consistent with the neutron burst model (Meyer et al., 2000), and the r‐process based rapid separation model of Ott (1996) in that ^{128, 130}Te and ¹¹⁰Pd are enhanced relative to their solar abundances. However, in the framework of the neutron burst model, some separation between stable products and radioactive precursors may be required in order to be consistent with the full data set of Te isotopes. In the framework of the rapid separation scenario, our data suggests a separation time of approximately 4000 s, based on the magnitudes of the precursor life‐times for ¹²⁸Te and ¹³⁰Te. The elemental abundance ratio Te‐H/Xe‐H agrees with the prediction of the rapid separation model, provided little fractionation occurred during trapping of the exotic components by the diamonds, but differs significantly from expectations based on the neutron burst model. Differences in the inferred ¹²⁸Te/¹³⁰Te ratio between our work and that of Richter et al. (1998) point to the need for further investigations.     

Radio frequency interference measurements in Indonesia

We report the first measurements of radio frequency spectrum occupancy performed at sites aimed to host the future radio astronomy observatory in Indonesia. The survey is intended to obtain the radio frequency interference (RFI) environment in a spectral range from low frequency 10 MHz up to 8 GHz. The measurements permit the identification of the spectral occupancy over those selected sites in reference to the allocated radio spectrum in Indonesia. The sites are in close proximity to Australia, the future host of Square Kilometre Array (SKA) at low frequency. Therefore, the survey was deliberately made to approximately adhere the SKA protocol for RFI measurements, but with lower sensitivity. The RFI environment at Bosscha Observatory in Lembang was also measured for comparison. Within the sensitivity limit of the measurement equipment, it is found that a location called Fatumonas in the surrounding of Mount Timau in West Timor has very low level of RFI, with a total spectrum occupancy in this measured frequency range being about 1 %, mostly found at low frequency below 20 MHz. More detailed measurements as well as a strategy for a radio quiet zone must be implemented in the near future.     

Climate projections over CORDEX Africa domain using the fifth-generation Canadian Regional Climate Model (CRCM5)

Following the CORDEX experimental protocol, climate simulations and climate-change projections for Africa were made with the new fifth-generation Canadian Regional Climate Model (CRCM5). The model was driven by two Global Climate Models (GCMs), one developed by the Max-Planck-Institut für Meteorologie and the other by the Canadian Centre for Climate Modelling and Analysis, for the period 1950–2100 under the RCP4.5 emission scenario. The performance of the CRCM5 simulations for current climate is discussed first and compared also with a reanalysis-driven CRCM5 simulation. It is shown that errors in lateral boundary conditions and sea-surface temperature from the GCMs have deleterious consequences on the skill of the CRCM5 at reproducing specific regional climate features such as the West African Monsoon and the annual cycle of precipitation. For other aspects of the African climate however the regional model is able to add value compared to the simulations of the driving GCMs. Climate-change projections for periods until the end of this century are also analysed. All models project a warming throughout the twenty-first century, although the details of the climate changes differ notably between model projections, especially for precipitation changes. It is shown that the climate changes projected by CRCM5 often differ noticeably from those of the driving GCMs.     

Concepts and science for coastal erosion management - An introduction to the Conscience framework

The main objective of the Conscience project was to develop and test concepts, guidelines and tools for the sustainable management of erosion along the European coastline, based on the best available scientific knowledge and on existing practical experience. Four concepts are potentially capable of providing the nexus between scientific knowledge and management: coastal resilience, coastal sediment cell, favourable sediment status and strategic sediment reservoir. The project has tested the use of these concepts and found that they are useful, provided that they are positioned and linked within a logical structure that we shall call the Conscience “Frame of Reference”, defined in time and space and supported through data and monitoring. Practical experience in six coastal sites in Europe has shown that the use of this Frame of Reference together with these concepts can make management objectives explicit and transparent. It can therefore support the design of an appropriate, resilience based coastal erosion management practice.     

Revisiting mobile bed tests for beach profile dynamics

The levels of uncertainty for morphodynamic analysis in the present state of art require field measurements and, whenever possible, large scale mobile bed tests to reproduce what happens in Nature under controlled conditions. Following this idea, the paper will revise the procedure to design reduced scale mobile bed tests, including the criteria for scaling and those for selecting an experimental facility.     

Coliform Bacteria in New Jersey Domestic Wells: Influence of Geology,Laboratory, and Method

Following passage of the New Jersey Private Well Testing Act, 50,800 domestic wells were tested between 2002 and 2007 for the presence of total coliform (TC) bacteria. Wells containing TC bacteria were further tested for either fecal coliform or Escherichia coli (FC/E. coli) bacteria. Analysis of the data, generated by 39 laboratories, revealed that the rate of coliform detections in groundwater (GW) was influenced by the laboratory and the method used, and also by geology. Based on one sample per well, TC and FC/E. coli were detected in wells located in bedrock 3 and 3.7 times more frequently, respectively, than in wells located in the unconsolidated strata of the Coastal Plain. In bedrock, detection rates were higher in sedimentary rock than in igneous or metamorphic rock. Ice‐age glaciers also influenced detection rates, most likely by removing material in some areas and depositing thick layers of unconsolidated material in other areas. In bedrock, coliform bacteria were detected more often in wells with a pH of 3 to 6 than in wells with a pH of 7 to 10 whereas the reverse was true in the Coastal Plain. TC and FC/E. coli bacteria were detected in 33 and 9.5%, respectively, of sedimentary rock wells with pH 3 to 6. Conversely, for Coastal Plain wells with pH 3 to 6, detection rates were 4.4% for TC and 0.6% for FC/E. coli.     

Effective anisotropic velocity model from surface monitoring of microseismic events

We develop a methodology to obtain a consistent velocity model from calibration shots or microseismicity observed on a buried array. Using a layered 1D isotropic model derived from checkshots as an initial velocity model, we invert P‐wave arrival times to obtain effective anisotropic parameters with a vertical axis of symmetry (VTI). The nonlinear inversion uses iteration between linearized inversion for anisotropic parameters and origin times or depths, which is specific to microseismic monitoring. We apply this technique to multiple microseismic events from several treatments within a buried array. The joint inversion of selected events shows a largely reduced RMS error indicating that we can obtain robust estimates of anisotropic parameters, however we do not show improved source locations. For joint inversion of multiple microseismic events we obtained Thomsen anisotropic parameters ε of 0.15 and δ of 0.05, which are consistent with values observed in active seismic surveys. These values allow us to locate microseismic events from multiple hydraulic fracture treatments separated across thousands of metres with a single velocity model. As a result, we invert the effective anisotropy for the buried array region and are able to provide a more consistent microseismicity mapping for past and future hydraulic fracture stimulations.     

Possible northward extension of the Philippine Fault Zone offshore Luzon Island (Philippines)

The Philippine Fault Zone, a system of left-lateral strike-slip faults traversing the length of the Philippine Islands, is associated with the oblique convergence between the Philippine Sea Plate (PSP) and the Eurasian Plate (EP). Although it is a major deformational structure within the diffuse PSP–EP convergent boundary, some of its segments, particularly its marine extensions, are not well studied. To investigate the crustal deformation in the marine prolongation of the Philippine Fault Zone offshore Luzon Island, multi-channel seismic (MCS) data, gravity data and centroid moment tensor solutions were used in this study. Focal mechanism solutions from the Global CMT catalog were inverted to determine the average principal stress directions and consequently understand the prevailing stress regime in the study area. The stress inversion results indicate that the direction of maximum compression (σ1) is 321°N, which coincides with the PSP–EP convergence direction. From the MCS profiles, the study area was subdivided into deformation zone and a relatively stable zone. Thrust faulting, folding and general uplift are observed in the deformation zone. This zone is further subdivided into the active and inactive segments. In the active segment, uplift is occurring in the submarine ridge. This deformation pattern can be related to the ongoing uplift in some regions bisected by the PFZ. The inactive segment, characterized by intense folding of the sequences and faulting of the basement and overlying sequences, is suggested as the precursor of the Philippine Fault Zone. Deformation appears to be recently shifted to the east as delineated by an uplifted N-NW trending submarine ridge offshore NW Luzon Island.     

ESTUARINE AND COASTAL SEDIMENTATION PROBLEMS

This keynote lecture addresses engineering sedimentation problems in estuarine and coastal environments and practical solutions of these problems based on the results of field measurements, laboratory scale models and numerical models. The three most basic design rules are: (1) try to understand the physical system based on available field data; perform new field measurements if the existing field data set is not sufficient (do not reduce on the budget for field measurements); (2)try to estimate the morphological effects of engineering works based on simple methods (rules of thumb, simplified models, analogy models, i.e. comparison with similar cases elsewhere); and (3)use detailed models for fine-tuning and determination of uncertainties (sensitivity study trying to find the most influencial parameters). Engineering works should be designed in such a way that side effects (sand trapping, sand starvation, downdrift erosion) are minimum. Furthermore, engineering works should be designed and constructed or built in harmony rather than in conflict with nature. This ‘building with nature‘ approach requires a profound understanding of the sediment transport processes in morphological systems.     

Understanding Causes and Impacts of the Dinoflagellate, Cochlodinium polykrikoides, Blooms in the Chesapeake Bay

During August and September 2007, the lower Chesapeake Bay and its tributaries experienced a massive bloom of Cochlodinium polykrikoides Margalef (>10⁴ cells per milliliter) that persisted for over a month, was extremely patchy, and at times penetrated into the Atlantic Ocean. The onset of the bloom coincided with a period of intense rainfall and stormwater runoff after a protracted summer drought period. Genetic evidence showed this species to be distinct from many Asian strains but similar to other North American strains. Populations dominated by C. polykrikoides took up a variety of nitrogenous compounds to support their growth and were able to mobilize additional sources of organic nutrients through peptide hydrolysis. Bioassays determined that C. polykrikoides exerted a lethal affect on juvenile fish and shellfish, causing 100% mortality of juvenile fish (Cyprinodon variegates) in less than 24 h and 20% mortality in juvenile American oysters (~21 mm; Crassostrea virginica) within 72 h.