螺旋CT三维重建在骨盆骨折中的应用

目的：探讨用螺旋CT三维重建评价骨盆骨折的临床应用价值。方法：收集骨盆骨折17例，采用螺旋CT三维重建检查。结果：17例检查均取得清晰立体图像，且可消除某一骨性结构，单独观察骨盆某一组成骨的骨折情况。结论：螺旋CT三维重建在骨盆骨折的诊断、手术方案的设计及教学等有较高价值。     

中国西南及邻区上地幔P波三维速度结构/

利用ISC报告以及中国和NEIC基本测震台网报告中的80974条P波初至到时资料（地震数为7053，台站数为165，且地震和台站都分布在研究区内），对中国西南及邻区（北纬10～36、东经70～110）的深至400km的上地幔三维速度结构进行了研究，分辨率达22．初步结果表明:①研究区速度的横向不均匀性，虽随深度增加而减弱，但至400km深度时仍很明显；②在北纬16和24的纵剖面上，可以看到与印度板块向东和欧亚板块相碰撞挤压相对应的速度结构，以及印度板块与欧亚板块速度结构的差异．在东经90的纵剖面上，与印度板块向北俯冲到欧亚板块（青藏高原）之下相对应的速度结构也比较明显；③在90ｋｍ深度的横剖面上，由缅甸的密支那至越南的洞海的低速条带，可能与红河断裂带有关；④ 提出并使用了能够更为准确直观地描述分辨率好坏的图示方法．      

新疆城市化与经济发展协调性分析

从新疆自20世纪80年代以来城市化水平与经济发展水平、产业结构的变化的吻合度或偏离度，来论述新疆的城市化水平是否与经济发展相协调，求证新疆城市化与经济发展水平之间的相关关系，并预测城市化率；剖析新疆城市化滞后于经济发展的原因，提出新疆正处于城市化由初期向快速发展期的过渡阶段，加快城市化的关键是推进工业化。     

Velocity profile of a sand cloud blowing over a gravel surface

Particle dynamic analyzer (PDA) measurement technology was used to study the turbulent characteristics and the variation with height of the mean horizontal (in the downwind direction) and vertical (in the upward direction) particle velocity of a sand cloud blowing over a gravel surface. The results show that the mean horizontal particle velocity of the cloud increases with height, while the mean vertical velocity decreases with height. The variation of the mean horizontal velocity with height is, to some extent, similar to the wind profile that increases logarithmically with height in the turbulent boundary layer. The variation of the mean vertical velocity with height is much more complex than that of the mean horizontal velocity. The increase of the resultant mean velocity with height can be expressed by a modified power function. Particle turbulence in the downwind direction decreases with height, while that in the vertical direction is complex. For fine sands (0.2–0.3 mm and 0.3–0.4 mm), there is a tendency for the particle turbulence to increase with height. In the very near-surface layer (<4 mm), the movement of blown sand particles is very complex due to the rebound of particles on the bed and the interparticle collisions in the air. Wind starts to accelerate particle movement about 4 mm from the surface. The initial rebound on the bed and the interparticle collisions in the air have a profound effect on particle movement below that height, where particle concentration is very high and wind velocity is very low.     

高速公路下伏某煤矿采空区地质特征及注浆充填法治理研究

煤矿采空区是工程建设中不良地质条件之一，其地质特征评价和如何治理是两个关键问题。笔者结合高速公路建设中某采空区的治理实践，对这两方面进行了探索，对工程建筑中所遇各类采空区的地质特征评价及其治理方法有一定借鉴意义。     

平原河网区域来水组成原理

对于一般树状分布河网，上一级河道总是汇入至下一级河道，位于河道下游断面的流量总是由其上游汇集而至。但对于平原河网地区，特别是人工控制建筑物众多，又受潮汐影响的地区(如太湖流域)，河网错综复杂，水流方向不定，要跟踪某个断面的水流去向，或某个河段的水体、断面流量是从哪里汇集而来的，非常困难。但这样的问题在生产实践中往往对其很感兴趣。例如从常熟枢纽引长江水流进入望虞河后，流向何处?河网各断面流量中或各河段水体中常熟枢纽引江水量占多少比重?对这些问题的研究可以估计常熟枢纽引江的效果和影响范围。因此，平原河网区域来水组成方法在生产实践中具有重要意义。重点介绍了平原河网区域来水组成原理及其在太湖流域的应用。     

数字化气氡观测干扰因素的分析研究

在进行地下流体数字化气氡观测及将观测资料应用于震情分析的过程中 ,发现某些干扰因素对数字化气氡观测和水氡的影响不同。在目前所用观测仪器和方法的条件下 ,气温对气氡值的影响系数为 - 0 4 % /℃ ;气压对气氡测值的影响系数为 0 1% /hPa ;不同类型的气水分离装置对气氡观测的影响很显著 ;同一含水层的井 (泉 )出水量的短期变化可引起观测水井流量的变化 ,但对气氡测值影响不显著 ;气氡测值对逸出气流量的变化反映不明显 ;逸出气含有杂质及气路泄漏等均会引起测值的下降。结合仪器的工作原理 ,对干扰产生的机制以及排除的方法进行了讨论     

Principle and mathematical method for inverting stress State of a medium from the remote sensing data

It has been proved through experiments that the electromagnetic radiation energy of a substance will vary when stress acts on the substance. This moment, the electromagnetic radiation energy (observation value) received by the remote sensor is triggered not only by the substance temperature and also by the stress. Separating quantitatively these two kinds of electromagnetic radiation energy and then inversing the actual temperature state and stress state of a medium is a matter with practical significance in earthquake prediction and stability monitoring for the large-scale geotechnical engineering. In this paper the principle and the mathematical method for inversing stress by using multiband remote sensing data are discussed in detail. A calculation example is listed.     

Flexural subsidence by 29 Ma on the NE edge of Tibet from the magnetostratigraphy of Linxia Basin, China

This study provides a detailed magnetostratigraphic record of subsidence in the Linxia Basin, documenting a 27 Myr long sedimentary record from the northeastern edge of the Tibetan Plateau. Deposition in the Linxia Basin began at 29 Ma and continued nearly uninterruptedly until 1.7 Ma. Increasing rates of subsidence between 29 and 6 Ma in the Linxia Basin suggest deposition in the foredeep portion of a flexural basin and constrain the timing of shortening in the northeastern margin of the plateau to Late Oligocene–Late Miocene time. By Late Miocene–Early Pliocene time, a decrease in subsidence rates in the Linxia Basin associated with thrust faulting and a 10° clockwise rotation in the basin indicates that the deformation front of the Tibetan plateau had propagated into the currently deforming region northeast of the plateau.     

System identification of linear structures based on Hilbert–Huang spectral analysis. Part 2: Complex modes

A method, based on the Hilbert–Huang spectral analysis, has been proposed by the authors to identify linear structures in which normal modes exist (i.e., real eigenvalues and eigenvectors). Frequently, all the eigenvalues and eigenvectors of linear structures are complex. In this paper, the method is extended further to identify general linear structures with complex modes using the free vibration response data polluted by noise. Measured response signals are first decomposed into modal responses using the method of Empirical Mode Decomposition with intermittency criteria. Each modal response contains the contribution of a complex conjugate pair of modes with a unique frequency and a damping ratio. Then, each modal response is decomposed in the frequency–time domain to yield instantaneous phase angle and amplitude using the Hilbert transform. Based on a single measurement of the impulse response time history at one appropriate location, the complex eigenvalues of the linear structure can be identified using a simple analysis procedure. When the response time histories are measured at all locations, the proposed methodology is capable of identifying the complex mode shapes as well as the mass, damping and stiffness matrices of the structure. The effectiveness and accuracy of the method presented are illustrated through numerical simulations. It is demonstrated that dynamic characteristics of linear structures with complex modes can be identified effectively using the proposed method. Copyright © 2003 John Wiley & Sons, Ltd.