环胶州湾公路海上段汽车尾气的环境影响

对类比路段进行连续模拟试验,进行现场调查,给出汽车尾气主要污染物的排污强度,预测了汽车尾气中CO、C_nH_m和NO_x的扩散范围。     

花鲈幼鱼个体代谢与体重关系的初步研究

实验室条件下测定花鲈 ( L ateolabrax japonicus C & V)的代谢率 ,温度为 ( 2 5.2± 0 .5)℃ ,鱼体湿重范围 :4 .64～ 52 .2 8g(平均体重 17.81g± 0 .33g)。饥饿鱼的正常代谢相关于体重的关系式 :Rr=15.37W0 .74 4。( r=0 .934 )。摄食代谢与摄食量呈线性正相关关系 ,摄食代谢水平为正常代谢的 1.8～ 2 .4倍。     

口服免疫药物后中国对虾某些血淋巴因子的测定及方法研究

于１９９１年４－９月，以海捕中国对虾亲虾及养殖中国对虾为材料，运用单向免疫扩散（ＳＲＩＤ）方法测定对虾血淋巴免疫因子，并采用经改进后的Ｈｏｒｏｗｉｔｚ等人的方法测定对虾体内的酚氧化酶（ＰＯ）活性，目的在于运用该两种方法对口服不同免疫药物的养殖对虾的血淋巴免疫因子及ＰＯ活力进行测定。对亲虾和养殖对虾口服不同免疫药物前后的测定结果表明，几种情况下的对虾血淋巴中均存在类似ＩｇＭ的因子，血细胞中存在酚氧化     

Atmospheric forcing of fine-sand transport on a low-energy inner shelf: south-central Louisiana,USA

Hydrodynamic and sediment transport measurements from instrumentation deployed during a 54-day winter period at two sites on the Louisiana inner shelf are presented. Strong extratropical storms, with wind speeds of 7.8 to 15.1 m s^-1, were the dominant forcing mechanism during the study. These typically caused mean oscillatory flows and shear velocities about 33% higher than fair weather (averaging 12.3 and 3.2 cm s^-1 at the landward site, and 11.4 and 2.7 cm s^-1 at the seaward site, respectively). These responses were coupled with mean near-bottom currents more than twice as strong as during fair weather (10.3 and 7.5 cm s^-1 at the landward and seaward sites, respectively). These flowed in approximately the same direction as the veering wind, causing a net offshore transport of fine sand. Weak storms were responsible for little sediment transport whereas during fair weather, onshore sand transport of approximately 25-75% of the storm values appears to have occurred. This contradicts previous predictions of negligible fair-weather sediment movement on this inner shelf.     

好氧颗粒污泥系统快速启动试验研究

采用3组圆柱型SBR反应器进行活性污泥颗粒化培养,接种浓度分别为12 500mg.L-1,4 400mg.L-1和1 800mg.L-1。由于采用逐步缩短沉降时间这一有效措施,系统启动20d后,颗粒污泥初步形成,污泥浓度可达到6 000~8 000mg.L-1,高于普通活性污泥系统,且沉降性能良好,SVI值在50mL.g-1左右。颗粒污泥的平均粒径稳定在0.2~0.25mm。在活性污泥颗粒化的启动试验中,在生物化学条件相同的条件下,逐步缩短沉淀时间可以加快好氧污泥颗粒化系统的启动。     

Tectonic control over topography and channel sedimentation across the forearc slope of the southern Kurile Trench

A high-resolution seismic survey covering more than 2,000 km² has revealed the processes responsible for the slope morphology and channel sedimentation across the forearc slope-basin of the Kurile Arc–NE Japan Arc collision zone, offshore from Tokachi (Hokkaido, Japan). The dominant slope contours parallel the trench but, in the middle and lower reaches of the southern slope, contours are convex-shaped with an offshore trend. This sector of the slope is traversed diagonally by the Hiroo submarine channel. The offshore-trending convex contours and the channel course have developed through the interplay of tectonic and sedimentary processes, including the development of anticlines, anticline-induced lobe sedimentation and channel avulsion. In its upper reaches, the channel is restricted by a topographic low associated with NNW–SSE-trending anticlines which developed within the upper and middle slope sectors during late Miocene uplift. The uplift timing and trend of these anticlines indicate that they resulted from collision, the channel sedimentology and slope morphology of the middle and lower slopes having been influenced by Pliocene uplift of NE–SW-trending anticlines. The trends of these anticlines parallel those of the Kurile Trench. The Pliocene and early Pleistocene strata of the middle and lower slopes consist of ponded lobe sediments deposited along the palaeo-Hiroo submarine channel on the landward side of the anticlines. As a lobe pile accumulated, the channel thalweg shifted to the north of the stack, allowing the channel to bypass the topographic high formed by the growing stack. Thick levee deposits built up along the channel course during the late Pleistocene and Holocene. These levees, along with the Pliocene and early Pleistocene lobes, are reflected in the present-day sigmoid-shaped, convex offshore-trending contours. Thus, the interplay of subduction- and collision-related anticlines, tectonic-related channel ponding, and avulsion has contributed to the slope morphology of the southern Kurile Trench.     

Frequency-selective attenuation of sound propagation and reverberation in shallow water

Ｆｒｅｑｕｅｎｃｙ－ｓｅｌｅｃｔｉｖｅ　ａｔｔｅｎｕａｔｉｏｎ　ｏｆ　ｓｏｕｎｄ　ｐｒｏｐａｇａｉｏｎ　ａｎｄ　ｒｅｖｅｒｂｅｒａｔｉｏｎ　ｉｎ　ｓｈａｌｌｏｗ　ｗａｔｅｒTXＦｒｅｑｕｅｎｃｙ－ｓｅｌｅｃｔｉｖｅａｔｔｅｎｕａｔｉｏｎｏｆｓｏｕｎｄｐ...     

Remote estimation of surficial seafloor properties through the application Angular Range Analysis to multibeam sonar data

The variation of the backscatter strength with the angle of incidence is an intrinsic property of the seafloor, which can be used in methods for acoustic seafloor characterization. Although multibeam sonars acquire backscatter over a wide range of incidence angles, the angular information is normally neglected during standard backscatter processing and mosaicking. An approach called Angular Range Analysis has been developed to preserve the backscatter angular information, and use it for remote estimation of seafloor properties. Angular Range Analysis starts with the beam-by-beam time-series of acoustic backscatter provided by the multibeam sonar and then corrects the backscatter for seafloor slope, beam pattern, time varying and angle varying gains, and area of insonification. Subsequently a series of parameters are calculated from the stacking of consecutive time series over a spatial scale that approximates half of the swath width. Based on these calculated parameters and the inversion of an acoustic backscatter model, we estimate the acoustic impedance and the roughness of the insonified area on the seafloor. In the process of this inversion, the behavior of the model parameters is constrained by established inter-property relationships. The approach has been tested using a 300 kHz Simrad EM3000 multibeam sonar in Little Bay, NH. Impedance estimates are compared to in situ measurements of sound speed. The comparison shows a very good correlation, indicating the potential of this approach for robust seafloor characterization.     

Sea surface temperature variations in the southwestern South China Sea over the past 160 ka

Sea surface temperatures (SSTs) in the southwestern South China Sea have been reconstructed for the past 160 ka using the Uk37 paleothermometer from the core MD01-2392. The temperature differences between glacial times (MISs 6 and 2) and interglacial times (MISs 5.5 and 1) are 2.2~2.5 ℃. Younger Dryas event during the last deglaciation was documented in both the planktonic foraminiferal δ18O and SST records. After MIS 5.5, SSTs displayed a progressive cooling from 28.6 to 24.5 ℃, culminating at the LGM. During this gradual cooling period, warm events such as MISs 5.3, 5.1 and 3 were also clearly documented. By comparison of SST between the study core and Core 17954, a pattern of low or no meridional SST gradients during the interglacial periods and high meridional SST gradients during the glacial periods was exhibited. This pattern indicates the much stronger East Asian winter monsoon at the glacial than at the interglacial periods. Spectral analysis gives two prominent cycles: 41 and 23 ka, with the former more pronounced, suggesting that SSTs in the southern SCS varied in concert with high-latitude processes through the connection of East Asian winter monsoon.     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.