Validation of Landslide Susceptibility Maps; Examples and Applications from a Case Study in Northern Spain

A procedure for validating landslide susceptibility maps wasapplied in a study area in northern Spain and the results obtained compared. Validationwas used to carry out sensitivity analysis for individual variables and combinationsof variables. The validity of different map-making methods was tested, as well as theutility of different types of Favourability Functions. The results obtained show thatvalidation is essential to determine the predictive value of susceptibility maps. Italso helps to better select the most suitable function and significant variables, thus improving the efficiency of the mapping process. Validation based on a temporal strategy makes it possible to derive hazard maps from susceptibility maps.     

Influence of the Load Wavelength on the Permeability of a Viscosity Interface in the Mantle

Assuming a radially stratified Newtonian mantle in a steady-state approximation, we demonstrate that the permeability of a viscosity interface at 660-km depth strongly depends on the wavelength of buoyancy forces driving the flow. The flow induced by long-wavelength loads penetrates through the boundary freely even if the viscosity increases by two orders. In contrast, the boundary is practically impermeable for short-wavelength loads located in the upper mantle. Thus, a stepwise increase of viscosity is a significant obstacle for small descending features in the upper mantle, but huge upper mantle downwellings, or upwellings formed in the-lower mantle can overcome it easily. This indicates that certain care is necessary in interpreting the seismic structure of the mantle by means of flow models. The global tomographic image includes only the first few degrees of the harmonic series and, consequently, its interpretation in terms of a present-day flow field results in a predominantly whole-mantle circulation even for extreme viscosity contrasts.     

Remote sensing detection of atmospheric pollutants by differential absorption LIDAR 510M/SODAR PA2 mobile system

Summary Air pollution problem in the Czech Republic is very complex due to large number of factors as turbulent dispersion and chemical reactions concurring in the status of the PBL. For this 3D distribution of pollutants is a key information that cannot be given by conventional monitoring stations. Combined use of DIAL lidar and sodar can give access to such information. Case studies of air pollutants transport are presented using 3D concentration fields of NO₂ and ozone measured by lidar and meteorological conditions monitored by Doppler Sodar.     

Accuracy analysis, dem generation and validation using russian tk-350 stereo-images

TK-350 stereo-scenes of the Zonguldak testfield in the north-west of Turkey have been analysed. The imagery had a base-to-height ratio of 0·52 and covered an area of 200 km × 300 km, with each pixel representing 10 m on the ground. Control points digitised from 1:25 000 scale topographic maps were used in the test. A bundle orientation was executed using the University of Hanover program BLUH and PCI Geomatica OrthoEngine AE software packages. Tests revealed that TK-350 stereo-images can yield 3D geopositioning to an accuracy of about 10 m in planimetry and 17 m in height. A 40 m resolution digital elevation model (DEM) was generated by the PCI system and compared against a reference DEM, which was derived from digitised contour lines provided by 1:25 000 scale topographic maps. This comparison showed that accuracy depends mainly on the surface structure and the slope of the local terrain. Root mean square errors in height were found to be about 27 and 39 m outside and inside forested areas, respectively. The matched DEM demonstrated a systematic shift against the reference DEM visible as an asymmetric shift in the frequency distribution. This is perhaps caused by the presence of vegetation and buildings.     

Preliminary study on the occurrence of geothermal systems in the tectonic compressional regions: an example from the Derman geothermal field in the Biga Peninsula, Turkey

There are numerous hot springs with temperatures ranging from 30 to 100 °C in Biga peninsula and they occur throughout the peninsula. The result of this study shows that the region is under a tectonic compressional regime. The investigation of the faults and fractures in the region indicates that the region has been affected first by N–S and then E–W compression since the Middle Miocene. Opening fractures and antithetic and synthetic faults due to the compressional movements provide paths for the deep circulation of water. In addition, the tectonic movements, granitic intrusion and volcanic activity have also played important roles as heat sources for the geothermal systems.     

Upper Pleistocene and Holocene paleosalinity and trophic state changes in relation to sea level variation in Rocha Lagoon, southern Uruguay

Paleolimnological data are presented on trophic development in relation to sea level variation in Rocha Lagoon, a 72 km² coastal lagoon in southern Uruguay. Using sediment cores that extended to ∼20,000 yr BP, analyses of grain size, organic matter, carbonate, total carbon, nutrients, and diatoms allowed us to infer changes in trophic state and paleosalinities, which were closely related to Holocene relative sea level variation. Higher trophic states were observed during regressive events, most probably due to increases in runoff and erosion as regressions progressed. Diatom Association Zones (DAZ) were identified in both cores. Those DAZ corresponding to transgressive events were dominated by marine/brackish taxa and relatively low organic matter and nutrient values, while those DAZ corresponding to regressive events showed increases in brackish/freshwater diatoms and both organic matter and nutrients. Although the lagoon formed after the first Holocene marine transgression, our data indicate the existence of a marine/brackish aquatic system during upper Pleistocene (i.e., before 15,000 yr BP), but by ∼20,000 yr BP, the system was still likely to be a semi-arid terrestrial system.     

Effect of melt composition on the partitioning of trace elements between titanite and silicate melt

Isobaric and isothermal experiments were performed to investigate the effect of melt composition on the partitioning of trace elements between titanite (CaTiSiO₅) and a range of different silicate melts. Titanite-melt partition coefficients for 18 trace elements were determined by secondary ion mass spectrometry (SIMS) analyses of experimental run products. The partition coefficients for the rare earth elements and for Th, Nb, and Ta reveal a strong influence of melt composition on partition coefficients, whereas partition coefficients for other studied monovalent, divalent and most quadrivalent (i.e., Zr, Hf) cations are not significantly affected by melt composition. The present data show that the influence of melt composition may not be neglected when modelling trace element partitioning.It is argued that it is mainly the change of coordination number and the regularity of the coordination space of trace elements in the melt structure that controls partition coefficients in our experiments. Furthermore, our data also show that the substitution mechanism by which trace elements are incorporated into titanite crystals may be of additional importance in this context.     

Partitioning of trace elements between rutile and silicate melts: Implications for subduction zones

Mineral/melt trace element partition coefficients were determined for rutile (TiO₂) for a large number of trace elements (Zr, Hf, Nb, Ta, V, Co, Cu, Zn, Sr, REE, Cr, Sb, W, U, Th). Whilst the high field strength elements (Zr, Hf, Nb, Ta) are compatible in rutile, other studied trace elements are incompatible (Sr, Th, REE). In all experiments we found D_Ta > D_Nb, D_Hf > D_Zr and D_U > D_Th. Partition coefficients for some polyvalent elements (Sb, W, and Co) were sensitive to oxygen fugacity. Melt composition exerts a strong influence on HFSE partition coefficients. With increasing polymerization of the melt, rutile/melt partition coefficients for the high field strength elements Zr, Hf, Nb and Ta increase about an order of magnitude. However, D_Nb/D_Ta and D_Hf/D_Zr are not significantly affected by melt composition. Because D_U ? D_Th, partial melting of rutile-bearing eclogite in subducted lithosphere may cause excesses of ²³⁰Th over ²³⁸U in some island arc lavas, whereas dehydration of subducted lithosphere may cause excesses of ²³⁸U over ²³⁰Th. From our partitioning results we infer partition coefficients for protactinium (Pa) which we predict to be much lower than previously anticipated. Contrary to previous studies, our data imply that rutile should not significantly influence observed ²³¹Pa-²³⁵U disequilibria in certain volcanic rocks.