An optimized sequential extraction scheme for molybdenum association in environmental samples

By comparing three sequential extraction procedures, a new optimized extraction scheme for the molybdenum association in environmental samples was proposed. Five operational steps were described as exchangeable (KH₂PO₄ + K₂HPO₄: including water-soluble), associated with organic matter (NaOH), Fe–Mn oxides and/or carbonates (HCl), sulfides (H₂O₂) and residue (HNO₃ + HF + H₂O₂). An optimized extraction scheme was compared with Tessier’s procedure and the Commission of European Communities Bureau of Reference (BCR) was applied to black shales. Results showed Tessier’s procedure gave the lowest concentration values for exchangeable molybdenum and the highest values for the residual molybdenum, which could not present the efficiency of the extraction reagents. BCR’s procedure showed the highest values in oxidizable molybdenum and presented four fractions of molybdenum, which did not demonstrate the fractions of molybdenum in the black shales in detail. The optimized extraction scheme demonstrated a certain improvement on extraction efficiency over Tessier’s procedure for the lowest residual molybdenum, and revealed more featured fraction information of molybdenum in black shales than BCR’s. Therefore, after a comparison with other two extraction procedures, the optimized extraction scheme proved suitable for the molybdenum in black shales and it also showed an accurate determination of the molybdenum in the fractions and source of bioavailable Mo.     

Tide-Induced Variations in the Fatty Acid Composition of Estuarine Particulate Organic Matter

The particulate organic matter (POM) in hydrodynamically variable habitats such as the lower reaches of estuaries can change in its content and quality on very short time scales (example, hourly), and these changes can potentially influence higher-level consumers in river-estuary-marine systems. Estuarine water samples were collected hourly for 12 h downstream in a small river to evaluate the fatty acid composition of POM over a tidal cycle. Fatty acid constituents of POM collected during the flood tide were dominated by the saturated, higher plant and bacterial fatty acids, whereas unsaturated, polyunsaturated, essential, and diatom-associated fatty acids dominated the POM collected during the ebb tide. Elevated algal biomass (as indicated by high chlorophyll a concentrations), diatom, and freshness indices in the POM indicated enhanced fresh autochthonous-origin materials that dominated the mixed organic pool during the ebb tide compared to more degraded detritus during the flood tide. Tidal retention of organic matter and algal primary production were the most influential factors that differentiated the fatty acid composition of estuarine POM over the short time scale. The results of this study have important implications on the quality of POM at the time of sampling, especially in estuaries where mixed organic pools have multiple inputs and are strongly influenced by tidal cycles.     

Using inverse modeling and hierarchical cluster analysis for hydrochemical characterization of springs and Talkhab River in Tang-Bijar oilfield,Iran

Hierarchical cluster analysis (HCA) and inverse modeling (PH REdox EQuilibrium (in C language) (PHREEQC)) were simultaneously useful approaches in interpreting surface water hydrochemistry within Talkhab River in the Tang-Bijar oilfield, Iran, where large uncertainties exist in the understanding of the water quality system. Q-mode HCA applied to the data revealed three major surface water associations distinguished on the basis of the major causes of variation in the hydrochemistry. The three water groups were classified as upstream waters (group 1: Ca–SO₄), intermediate waters (group 2: Ca–SO₄–Cl), and downstream waters (group 3: Na–Cl). Geochemical reaction models were constructed using PHREEQC to establish the reactions associated with the different mineral phases through inverse modeling. The hydrochemical compositions of the water groups and the mass balance calculations indicate that the dominant processes and reactions responsible for the hydrochemical evolution in the system are (1) dissolution of evaporites, (2) precipitation of carbonate minerals, (3) silicate weathering reactions, (4) limited mixing with saline water, and (5) ion exchange.     

Hydrogeological assessment of the Tabarteh fault zone by physicochemical analysis and multivariate statistical methods

Hydrogeologically, faults may impede, conduit, exert no influence, or may play a combination of these roles on groundwater flow. The object of this paper is to study the hydrogeological role of the Tabarteh fault, which is located on the border of Zagros and Central Iran tectonic zones in an alluvial aquifer. The recorded data of water table levels, chemical parameters, and discharge rate of wells, in addition to geological maps and geophysical results, were collected and evaluated. The outcrop of travertine in limited areas and the emergence of a few small springs within the alluvium show a barrier role of the fault in the groundwater flow. The spatial analysis of chemical components, head time series, and groundwater flow direction assessment demonstrated that the fault acts as both a barrier and a non-barrier in different sections. The multivariate statistical methods of cluster and discriminant analyses also confirm the dual role of the fault.     

Three-dimensional supervirtual seismic refraction interferometry

Improved supervirtual interferometry (SVI) method that enhance the signal-to-noise ratio (SNR) of noisy seismic refraction data is presented. This 3D supervirtual algorithm is helpful in removal of side lobes caused by convolution in the conventional 3D SVI method. In this study, we extend the supervirtual seismic refraction interferometry method to 3D geometries commonly used in active seismic exploration. To achieve this objective, synthetic 3D seismic refraction data were created using single patch orthogonal geometry. Simple two-layers velocity model was used. A zero phase wavelet was convolved with the refraction travel time to create the seismic wiggle trace. The refraction arrival is computed using the equation for horizontal refractor case and is not adapted for dipping refractor. Noise of Gaussian distribution with zero mean and 0.25 standard deviation was added to simulate a case of moderate ambient noise. The supervirtual algorithm, consisting of crosscorrelation, alignment, summation, and first arrival calculation is performed. By aligning and summation of all the correlogram, the stationary position of source-receiver pairs as required in the 2D supervirtual method are eliminated in this case. Synthetic data presented in this study shows accurate first arrivals after the application of the 3D SVI and traces with much better SNR than the actual traces.     

Characteristics of groundwater flow field after land creation engineering in the hilly and gully area of the Loess Plateau

In order to study the degree of influence and control mechanism to groundwater flow field caused by land creation engineering in the hilly and gully area of the Loess Plateau, based on the geological and engineering conditions of the first stage project of Yan’an new district in China, numerical simulation of groundwater flow is carried out by the Feflow and GIS technologies. From the simulation, punning measure relatively reduces infiltration recharge and artificial gravel drain increases groundwater seepage. The basic characteristics of groundwater flow field is controlled by the old and new topographies in the whole study area, and artificial gravel drain plays an auxiliary role in accelerating groundwater drawdown upstream and promotes groundwater rise downstream. According to differences of groundwater level and declining percentages of hydraulic gradient in the main and secondary gullies, dewatering of artificial gravel drain in the secondary gully is more effective than that in the main gully, which will yet play an important role in the future. The study results will make contributions to understand groundwater response to land creation engineering and will be beneficial to take necessary measures to prevent collapse of loess and failure of building foundation in the hilly and gully area of the Loess Plateau.     

Stochastic groundwater modeling of a sedimentary aquifer: evaluation of the impacts of abstraction scenarios under conditions of reduced recharge

A transient finite difference groundwater flow model has been calibrated for the Nasia sub-catchment of the White Volta Basin. This model has been validated through a stochastic parameter randomization process and used to evaluate the impacts of groundwater abstraction scenarios on resource sustainability in the basin. A total of 1500 equally likely model realizations of the same terrain based on 1500 equally likely combinations of the data of the key aquifer input parameters were calibrated and used for the scenario analysis. This was done to evaluate model non-uniqueness arising from uncertainties in the key aquifer parameters especially hydraulic conductivity and recharge by comparing the realizations and statistically determining the degree to which they differ from each other. Parameter standard deviations, computed from the calibrated data of the key parameters of hydraulic conductivity and recharge, were used as a yardstick for evaluating model non-uniqueness. All model realizations suggest horizontal hydraulic conductivity estimates in the range of 0.03–78.4 m/day, although over 70 % of the area has values in the range of 0.03–14 m/day. Low standard deviations of the horizontal hydraulic conductivity estimates from the 1500 solutions suggest that this range adequately reflects the properties of the material in the terrain. Lateral groundwater inflows and outflows appear to constitute significant components of the groundwater budgets in the terrain, although estimated direct vertical recharge from precipitation amounts to about 7 % of annual precipitation. High potential for groundwater development has been suggested in the simulations, corroborating earlier estimates of groundwater recharge. Simulation of groundwater abstraction scenarios suggests that the domain can sustain abstraction rates of up to 200 % of the current estimated abstraction rates of 12,960 m³/day under the current recharge rates. Decreasing groundwater recharge by 10 % over a 20-year period will not significantly alter the results of this abstraction scenario. However, increasing abstraction rates by 300 % over the period with decreasing recharge by 10 % will lead to drastic drawdowns in the hydraulic head over the entire terrain by up to 6 m and could cause reversals of flow in most parts of the terrain.     

Textural characteristics of sediments along the southern Red Sea coastal areas,Saudi Arabia

A lack of understanding exists of the origin and textural characteristics of Saudi Arabian Red Sea coastal sediments. This paper concerns the southern coastline of Jizan on the Saudi Red Sea. It is some 160 km long characterised by either narrow rocky headlands with intermittent pocket beaches or wide low-lying beaches dissected by wadis. Granulometric testing of samples from 135 locations showed that beach sand size was mainly very fine to medium grained (M _z = 3.93 Ø), sorting ranged from 1.65 to 0.41 and skewness values from ?051 to 0.39, being mainly negative; dune sands were medium to fine grained (M _z = 1.13 Ø; average sorting 2.8), while skewness variations within dune samples indicated symmetrical to fine skewed values (б _Ι = 0.55 to 0.89). Most foreshore samples were derived from wadis. Wadi mud levels can be high, e.g. Baysh (84%), and wadi Samrah (90%) with mean grain size ranging from very fine to medium sand (M _z = 3.9 Ø), sorting being well to poor (0.45 to 1.52) due to sediment influxes. Sabkha had a wide range of sand/mud and significantly higher carbonate percentages than other environments. Sediment source differences and littoral reworking contributed to grain size variation. The carbonate content varied between 1.5 and 31.5% due to hinterland contributions, and spatial analysis showed increasing quantities of carbonate minerals towards the south. On the wider geographical front, findings from Jizan are similar to those of the Northern United Arab Emirates (UAE), including sabkhas, being composed of sand, skeletal carbonate, fine fluvial material and wind-blown silt and clay components of wadi origin. Further work on the northeastern Red Sea edge can hopefully confirm these findings.     

Performance of seismic arrays in the presence of weathering layer variations

Near-surface layer variations can degrade the desired response of seismic arrays which are typically used to attenuate horizontally traveling coherent noise and enhance vertically traveling signal. We investigate the effect of variations in the near-surface layer thickness on the performance of arrays by studying their impulse and wavelet responses. The models considered include the topographic variations and a channel in the base of weathering layer. The topographic variations include a dipping surface layer as well as a surface layer that follows a sine wave. The geological channel is assumed to be present under the entire receiver array as well as partially under a few receivers. We use Ricker wavelet and model plane wavefronts with incidence angles (90, 70, 45, 20, and 5 °) on a 12-element equally weighted array for the weathering layer models. We found that the array responses are more degraded for near-vertically traveling waves in all cases. The array responses are also found to be more degraded when channel variations are present underneath a few receivers as compared to the entire array length. We recommend designing a spatial filter or using single-sensor records after correcting for intra-array statics to preserve the reflection amplitudes in the presence of weathering layer variations.