Design of stable drainage networks in upland forestry plantations

Erosion of man-made, forestry drainage channels occurs when the plough cuts through the surface peat layer into the underlying erodible mineral soil. A procedure is developed, based on hydraulic considerations, which will allow the drainage engineer to design stable drainage networks in upland forestry plantations. An example design chart is given for an erodible sandy loam type soil.     

A simulation tool for high data-rate acoustic communication in ashallow-water, time-varying channel

The paper discusses the development of a simulation tool to model high data-rate acoustic communication in shallow water. The simulation tool is able to generate synthetic time series of signals received at a transducer array after transmission across a shallow-water communication channel. The simulation tool is suitable for testing advanced signal processing techniques for message recovery. A channel model has been developed based on the physical aspects of the acoustic channel. Special emphasis has been given to fluctuations of the signal transmission caused by time-varying multipath effects. At shorter ranges, the temporal variations are dominated by acoustic scattering from the moving sea surface. Therefore, the channel model produces a coherence function which may be interpreted as a time-varying reflection coefficient for the surface scattered acoustical path. A static, range-independent ray model identifies the significant multipaths, and the surface path is modulated with the time-varying reflection coefficient. The advantages and limitations of the channel model are discussed and assumptions necessary to overcome the limitations are emphasised. Based on the assumptions, an algorithm has been developed and implemented to model how a binary message will be modulated when transmitted by a transducer, is distorted in the channel and finally is received by a transducer array     

OSCR wave measurements-some preliminary results

OSCR is an HF radar system that has been developed for high spatial resolution coastal surface current measurement. This paper describes preliminary results that demonstrate that wave measurement can be successfully obtained from suitably processed OSCR data. Comparisons with data from a WAVEC directional buoy are presented and show encouraging agreement. Some of the limitations to the measurement process are discussed and indicate a maximum range of about 20 km. Surface current variability on short time scales presents the most serious obstacle to wave measurement. This appears to be more of a problem when the mean currents are large, in that in these circumstances the data fail initial quality control criteria. However, in lower mean currents, the effect is often still present and leads to errors in long wave measurement     

A new stereo‐analytical method for determination of removal blocks in discontinuous rock masses

The paper provides a new stereo‐analytical method, which is a combination of the stereographic method and analytical methods, to separate finite removable blocks from the infinite and tapered blocks in discontinuous rock masses. The methodology has applicability to both convex and concave blocks. Application of the methodology is illustrated through examples. Addition of this method to the existing block theory procedures available in the literature improves the capability of block theory in solving practical problems in rock engineering. Copyright © 2003 John Wiley & Sons, Ltd.     

Infiltration at the Tai rain forest (Ivory Coast): Measurements and modelling

Infiltration experiments have been performed at three sites along a well-known catena under virgin tropical rain forest using a portable sprinkling infiltrometer. Experimentally determined infiltration curves are presented. Infiltration curves are also simulated on the basis of the Mein-Larson equation. The parameters for this model have been obtained from the infiltration curves (saturated conductivity) and simple soil moisture determinations (fillable porosity). The agreement between experimentally determined and modelled infiltration is reasonable, provided (a) saturated conductivity as derived from the experimental data is corrected, (b) a storage parameter, also derived from the experimental data, is added to the Mein-Larson model, and (c) the decline in soil porosity with depth is either small or occurs abruptly at shallow depth. Comparison of observed infiltration rates with rainfall intensity shows that Horton Overland Flow has to occur naturally at least on the middle and lower section of the catena. Despite the fact that most parameters can be estimated in principle from basic soil data, it remains advisable to obtain sprinkling infiltrometer field measurements, because of soil variability due to dynamic surface conditions, macroporosity, air entrapment, and irregularity of the wetting front.     

Hysteresis‐based analysis of overland metal transport

Introducing a concept of equivalent mass depth of flow, this study describes the phenomenon of non‐point source pollutant (metal) transport for pavement (or overland) flow in analogy with wave propagation in wide open channels. Hysteretic and normal mass rating curves are developed for runoff rate and mass of 12 dissolved and particulate‐bound metal elements (pollutants) using the rainfall‐runoff and water quality data of the 15 × 20 m² instrumented pavement in Cincinnati, USA. Normal mass rating curves developed for easy computation of pollutant load are found to be of a form similar to Manning's, which is valid for open channel flows. Based on the hysteresis analysis, wave types for dissolution and mixing of particulate‐bound metals are identified. The analysis finds that the second‐order partial‐differential equation normally used for metal transport does not have the efficacy to describe fully the strong non‐linear phenomena such as is described for various metal elements by dynamic waves. In addition, the proportionality concept of the popular SCS‐CN concept is extended for determining the potential maximum metal mass M_p of all the 12 elements transported by a rain storm and related to the antecedent dry period (ADP). For the primary metal zinc element, M_p is found to increase with the ADP and vice versa. Copyright © 2003 John Wiley & Sons, Ltd.     

Swimming with…Devonian fish

Armoured jawless fish, or 'ostracoderms', lived 450–360 million years ago, and display unusual morphologies, unlike any modern fish group. Since they left no living descendants, their mode of swimming has, until recently, remained speculative, although this is a crucial question as the first true pectoral fins evolved within the 'ostracoderms'. The discovery of the oldest-known fish trails, from the Early Devonian (400 million year old) 'Lower Old Red Sandstone' of south-east Wales offers new insights into the swimming behaviour of these early fish, notably the osteostracan 'ostracoderms' (or cephalaspids), whose horseshoe-shaped head and paddle-shaped pectoral fins have remained a functional riddle.     

A rope-shaped solar filament and a IIIb flare

On September 14–18, 2000, a medium-small solar active region was observed at Ganyu Station of Purple Mountain Observatory. Its spots were not large, but it had a peculiar active filament. On Sep.16, a flare of importance III_b with rather intense geophysical effects was produced. Our computation of the magnetic structure of the active region reveals that the rope-shaped filament was concerned with a low magnetic arc close to magnetic neutral line. An intense shear of magnetic field occurred near magnetic rope. The QSL analysis shows that a 3-D magnetic reconnection might appear in the vicinity of filament, and this can be used to interpret the formation of a large flare.