Ocean bottom refraction seismograph (OBRS)

This paper describes a pop-up ocean bottom seismograph designed primarily for refraction surveys both on the continental shelf and in deep sea. Its development is the extension of our system based on seismic detectors located on the sea floor with radio transmission of seismic signals and used for seismic refraction studies on the continental shelf. The seismic detectors (vertical geophone or hydrophone and two orthogonally mounted horizontal geophones) are located outside of the pressure vessel on the main frame. Optionally, the seismic sensors may be decoupled from the main frame assembly. This decoupling is performed by a mobile arm positioning the separate three component sensor package on the sea floor.Contribution No. 455 of the Département Scientifique, Centre Océanologique de Bretagne.     

Estimation of the leeway drift of small craft

Small craft (<6·4 m) leeway is determined as a function of the wind speed in the range of 5–20 knots (3·6–10·3 m/sec). Leeway is calculated relative to the surface current by measurement of the separation distance of the small craft from a dyed patch of surface water at sea, using time-sequenced aerial photography. Leeway increases linearly with wind speed for small craft equipped with or without a sea anchor in the wind range studied. Leeway for small craft without sea anchor can be calculated from the equation U_L = 0.07 U_W + 0.04 where U_W is the wind speed at 2 m elevation. Leeway for small craft drifted off the be calculated from the equation U_LD = 0·05 U_W − 0·12. The small craft drifted off the downwind direction in about 80% of the experiments. The drift angle is variable and difficult to predict.     

Improved in situ gamma-ray transmission densitometer for marine sediments

The first-generation University of Illinois gamma-ray transmission densitometer, designed for the in situ measurement of sediment bulk density, was modified by incorporating in the detector probe (1) an Americium-241 alpha particle pulser and an anti-walk gain stabilization control to maintain better temperature stability and (2) a small power supply and a IC preamplifier to eliminate the need for a high-voltage coaxial cable between the detector and external signal conditioning electronics package. This second-generation Lehigh University system has been successfully deployed since 1971 in routine use from ships and submersibles in the Atlantic and Pacific Oceans and the Gulf of Mexico. Results are presented of system operations to (1) measure bulk density over the range of 1.2–1.8 Mg/m³ in the Hudson Canyon, (2) penetrate 1.9 m into the seafloor in the San Diego trough and, (3) be lowered to a water depth of 3.6 km in the Gulf of Mexico.     

Paleomagnetic events in the brunhes and Matuyama epochs identified from magnetic profiles reduced to the pole

Eleven oceanic magnetic profiles associated with the paleomagnetic time scale younger than the beginning of the Matuyama epoch (2.43 my) have been reduced to the pole, altered to conform to a 3 cm yr^-1 spreading rate, and then all halves added and averaged to obtain a representative symmetric magnetic profile. This final stacked profile emphasizes the subtle anomalies associated with minor paleomagnetic events and minimizes randomly occurring anomalies. The axial anomaly of the stacked profile shows no evidence of the Laschamp event (centered at 0.025 my); however, a minimum at 0.15 my may correspond to the Blake event. A physical model of the stacked magnetic profile consists of a thin, highly magnetized layer with a 40% magnetization decrease at 10 km from the profile center. Magnetization values were modified from Irving and Talwani and the Blake event included. The stacked profile shows two minor anomalies centered at 1.97 my and 2.17 my. The younger anomaly corresponds with the younger Olduvai event (centered at 1.965 my) on the Cox time scale and the W anomaly (centered at 1.99 my) of Emilia and Heinrichs. The older anomaly lies between the older Olduvai event (2.12 my) of Cox and the X anomaly of Heirtzler, and Emilia and Heinrichs; additional work is required to assess the significance of this older event.This material was presented at the Fall Annual Meeting of the American Geophysical Union, December 8, 1971.     

The influence of the gulf’s geometry on seiche oscillations in an enclosed basin

The finite-elements technique is applied to study the effect of a basin’s geometry (bays, harbours) and location of the characteristics of seiche oscillations in the basin and in the gulf proper. An increase of the length of the bay is shown to contribute to the periods of natural oscillations and to cause their restructuring. Translated by Vladimir A. Puchkin.     

Transverse vibrations of a rectangular cantilever plate with thickness varying in a discontinuous fashion

A numerical solution is obtained for the title problem by means of the popular finite element method. An experimental investigation of the problem is also presented for plates of square planform. The agreement between theoretical and experimental values is very good in the case of the fundamental frequency, and reasonably good when the second and third normal modes of transverse vibration are considered. It is concluded that beneficial effects are obtained in the sense that one generates a lighter structural element with higher fundamental frequency of transverse vibration. Hence, dynamic stiffening is achieved.     

Dereverberation of marine reflection seismic data by a spatial combination of predictive deconvolution and velocity filtering

Contamination of seismic reflection records at early times by first-order water reverberations can be especially severe during survey operations over hard and flat sea floors on the continental shelf or in lake environments. A new dereverberation scheme based on two classical techniques — predictive deconvolution and velocity filtering — has been developed to address this problem. The techniques are combined spatially to take advantage of their complementary offset- and time-dependent properties. Stage I of the scheme consists of applying predictive deconvolution at short offset. The data are previously conditioned by a normal moveout correction with the water velocity which restores the periodicity of the reverberations in the offset-time plane and enhances the performance of deconvolution. Stage II of the scheme involves velocity filtering in the common-midpoint domain which is particularly effective at long offset where the moveout difference between primary reflections and reverberations is largest. The dereverberation scheme is well suited for the initial processing of large volumes of data due to the general availability of cost-effective deconvolution and velocity filtering algorithms in seismic processing software packages. Practical implementation issues are illustrated by a field example from the GLIMPCE survey in Lake Superior.Lithoprobe Publication No. 475.     

Experimental investigation of the combustive sound source

In this paper, we describe a unique low frequency underwater sound source called the combustive sound source (CSS). In this device, a combustible gas mixture is captured in a combustion chamber and ignited with a spark. The ensuing combustion produces expanding gases which in turn produce high intensity, low frequency acoustic pulses. With high-speed motion pictures of the CSS event, we relate the motion of the bubble to the acoustic waveform. We also compare the measured first bubble period in the CSS pressure signature with the predictions of the Rayleigh-Willis equation, including the dependence of the radiated acoustic waveform on the volume and depth of the bubble. Measurements of the first bubble period agree with Rayleigh-Willis theory in trend, but not in absolute value. In addition, we discuss the variation of the acoustic output with the fuel/oxygen mixture. Finally, several other factors that affect the acoustic output of CSS are discussed. These include the shape of the CSS combustion chamber, the type of oxidizer and fuel, and the ignition source     

The directional radiation of long waves from bottom deformations of finite duration

The process of generation of two-dimensional (2D) wave motions during small elliptical displacements of the bottom which occur for a finite time interval is considered within the framework of the linear theory of long waves in a basin of constant depth. The spatial structure and the amplitudinal and energy characteristics of the emerging directional surface wave are analysed for bottom deformations of a special form.Translated by Mikhail M. Trufanov.