Th sorption and export models in the water column: A review

Over the past few decades, the radioisotope pair of ²³⁸U / ²³⁴Th has been widely and increasingly used to describe particle dynamics and particle export fluxes in a variety of aquatic systems. The present paper is one of five review articles dedicated to ²³⁴Th. It is focused on the models associated with ²³⁴Th whereas the companion papers (same issue) are focused on present and future methodologies and techniques (Rutgers van der Loeff et al.), C / ²³⁴Th ratios (Buesseler et al.), ²³⁴Th speciation (Santschi et al.) and present and future applications of ²³⁴Th [Waples, J.T., Benitez-Nelson, C.R., Savoye, N., Rutgers van der Loeff, M., Baskaran, M., Gustafsson, Ö., this issue. An Introduction to the application and future use of ²³⁴Th in aquatic systems. Marine Chemistry, FATE special issue]. In this paper, we review current ²³⁴Th scavenging models and discuss the relative importance of the non-steady state and physical terms associated with the most commonly used model to estimate ²³⁴Th flux. Based on this discussion we recommend that for future work the use of models should be accompanied by a discussion of the effect that model and data uncertainty have on the model results. We also suggest that future field work incorporate repeat occupations of sample sites on time scales of 1–4 weeks in order to evaluate steady state versus non-steady state estimates of ²³⁴Th export, especially during high flux events (> ca. 800 dpm m^− 2 d^− 1). Finally, knowledge of the physical oceanography of the study area is essential, particularly in ocean margins and in areas of established upwelling (e.g., Equatorial Pacific). These suggestions will greatly enhance the application of ²³⁴Th as a tracer of particle dynamics and flux in more complicated regimes.     

Irrotational,progressive surface gravity waves near the limiting height

Numerical solutions of irrotational, progressive surface gravity waves in water of a constant depth are obtained by means of an iterative method. Our results suggest that waves with the surface slope angle greater than/6 may exist. The calculated phase velocity of deep water waves near the wave steepness 0.14 is significantly smaller than the value given by the Stokes' fourth approximation.In order to check our method, we apply it to the problem proposed byDavies (1951), which is hypothetical but similar to the present problem, and for which the exact solution is known. In this case our results show good agreement with the exact solution.     

Tectonics of a fast spreading center: A Deep-Tow and sea beam survey on the East Pacific rise at 19°30′ S

Sea Beam and Deep-Tow were used in a tectonic investigation of the fast-spreading (151 mm yr^-1) East Pacific Rise (EPR) at 19°30 S. Detailed surveys were conducted at the EPR axis and at the Brunhes/Matuyama magnetic reversal boundary, while four long traverses (the longest 96 km) surveyed the rise flanks. Faulting accounts for the vast majority of the relief. Both inward and outward facing fault scarps appear in almost equal numbers, and they form the horsts and grabens which compose the abyssal hills. This mechanism for abyssal hill formation differs from that observed at slow and intermediate spreading rates where abyssal hills are formed by back-tilted inward facing normal faults or by volcanic bow-forms. At 19°30 S, systematic back tilting of fault blocks is not observed, and volcanic constructional relief is a short wavelength signal (less than a few hundred meters) superimposed upon the dominant faulted structure (wavelength 2–8 km). Active faulting is confined to within approximately 5–8 km of the rise axis. In terms of frequency, more faulting occurs at fast spreading rates than at slow. The half extension rate due to faulting is 4.1 mm yr^-1 at 19°30 S versus 1.6 mm yr^-1 in the FAMOUS area on the Mid-Atlantic Ridge (MAR). Both spreading and horizontal extension are asymmetric at 19°30 S, and both are greater on the east flank of the rise axis. The fault density observed at 19°30 S is not constant, and zones with very high fault density follow zones with very little faulting. Three mechanisms are proposed which might account for these observations. In the first, faults are buried episodically by massive eruptions which flow more than 5–8 km from the spreading axis, beyond the outer boundary of the active fault zone. This is the least favored mechanism as there is no evidence that lavas which flow that far off axis are sufficiently thick to bury 50–150 m high fault scarps. In the second mechanism, the rate of faulting is reduced during major episodes of volcanism due to changes in the near axis thermal structure associated with swelling of the axial magma chamber. Thus the variation in fault spacing is caused by alternate episodes of faulting and volcanism. In the third mechanism, the rate of faulting may be constant (down to a time scale of decades), but the locus of faulting shifts relative to the axis. A master fault forms near the axis and takes up most of the strain release until the fault or fault set is transported into lithosphere which is sufficiently thick so that the faults become locked. At this point, the locus of faulting shifts to the thinnest, weakest lithosphere near the axis, and the cycle repeats.     

Fossil carotenoids and paleolimnology of meromictic Mahoney Lake,British Columbia,Canada

Vertical distribution of fossil carotenoids in a sediment core from meromictic Mahoney Lake was studied. Besides okenone and demethylated okenone, lutein and zeaxanthin and-carotene isomers were identified. No carotenoids typical for purple nonsulfur or green sulfur bacteria were detected. The ratio of zeaxanthin to lutein (above 1:1 in all samples) indicates a dominance of cyanobacteria over green algae in the phytoplankton assemblages of the past. Okenone, which is found exclusively in Chromatiaceae, was the dominating carotenoid in all sediment zones.The oldest sediment layers containing okenone were deposited 11 000 years ago. Between 9000 and 7000 and since 3000 years b.p., Chromatiaceae reached a considerable biomass in the lake. Vertical changes in okenone concentration were not related to changes of paleotemperatures. In contrast, okenone concentrations decreased during periods of volcanic ash input. During most of the lake history, however, mean okenone concentrations were positively correlated with sedimentation rates. This indicates that vertical changes of okenone concentration in the sediment reflect past changes of purple sulfur bacterial biomass in the lake.According to these results, the past limnology of Mahoney Lake resembled that of the present with a sulfide-containing monimolimnion and a well-developed population of okenone-bearing purple sulfur bacteria.     

Structural similarity and variety at the tips in a wide range of strike–slip faults: a review

Strike–slip faults are often accompanied by a variety of structures, particularly at their tips. The zones of additional fracturing are classified as tip‐damage zones. These zones can be subdivided into several different damage patterns based on the nature and orientation of faults and fractures developed. Damage zones at the ends of small strike–slip faults (mode II tips) develop wing cracks, horsetail splays, antithetic faults, synthetic branch faults and solution surfaces. Similar tip‐damage patterns are also commonly observed at larger (regional) scales, but with a dominance of faulting over tensile cracks and solution surfaces. Wing cracks and horsetail splays developed at small‐scale faults are replaced by normal faults in large‐scale faults. Antithetic faults and synthetic branch faults are observed at small and large scales. Thrust faults are developed at large scales, in a similar pattern to solution surfaces at a small scale. All these structures may show slightly different angular relationships to the master fault at small and large scale, but develop in response similar stress distribution and mechanics around the fault. Thus, mode II tip‐damage zones show similar patterns over a wide range of fault scales.     

Food Deserts in the Prairies? Supermarket Accessibility and Neighborhood Need in Edmonton,Canada*

The U.S. and U.K. literatures have discussed “food deserts,” reflecting populated, typically urban, low‐income areas with limited access to full‐service supermarkets. Less is known about supermarket accessibility within Canadian cities. This article uses the minimum distance and coverage methods to determine supermarket accessibility within the city of Edmonton, Canada, with a focus on high‐need and inner‐city neighborhoods. The results show that for 1999 both of these areas generally had higher accessibility than the remainder of the city, but six high‐need neighborhoods had poor supermarket accessibility. We conclude by examining potential reasons for differences in supermarket accessibility between Canadian, U.S., and U.K. cities.     

Structural damage detection using the optimal weights of the approximating artificial neural networks

This work presents a novel neural network‐based approach to detect structural damage. The proposed approach comprises two steps. The first step, system identification, involves using neural system identification networks (NSINs) to identify the undamaged and damaged states of a structural system. The partial derivatives of the outputs with respect to the inputs of the NSIN, which identifies the system in a certain undamaged or damaged state, have a negligible variation with different system errors. This loosely defined unique property enables these partial derivatives to quantitatively indicate system damage from the model parameters. The second step, structural damage detection, involves using the neural damage detection network (NDDN) to detect the location and extent of the structural damage. The input to the NDDN is taken as the aforementioned partial derivatives of NSIN, and the output of the NDDN identifies the damage level for each member in the structure. Moreover, SDOF and MDOF examples are presented to demonstrate the feasibility of using the proposed method for damage detection of linear structures. Copyright © 2001 John Wiley & Sons, Ltd.     

A mathematical hysteretic model for elastomeric isolation bearings

An analytical model for high damping elastomeric isolation bearings is presented in this paper. The model is used to describe mathematically the damping force and restoring force of the rubber material and bearing. Ten parameters to be identified from cyclic loading tests are included in the model. The sensitivity of the ten parameters in affecting the model is examined. These ten parameters are functions of a number of influence factors on the elastomer such as the rubber compound, Mullins effect, scragging effect, frequency, temperature and axial load. In this study, however, only the Mullins effect, scragging effect, frequency and temperature are investigated. Both material tests and shaking table tests were performed to validate the proposed model. Based on the comparison between the experimental and the analytical results, it is found that the proposed analytical model is capable of predicting the shear force–displacement hysteresis very accurately for both rubber material and bearing under cyclic loading reversals. The seismic response time histories of the bearing can also be captured, using the proposed analytical model, with a practically acceptable precision. Copyright © 2002 John Wiley & Sons, Ltd.     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.