Calibration shifts in Scintrex CG‐3M gravimeters with an application to detection of microgravity changes at Iwo‐tou caldera,Japan

Calibration shift seriously influences gravity values measured using Scintrex CG‐3M gravimeters. We calibrated three Scintrex CG‐3M gravimeters three times (1999, 2003 and 2006) over eight years, using a calibration line with a gravity difference of 1.38 Gal. The scale factor correction coefficients (calibration factors) obtained here range from 0.9998–1.0005. The calibration factors vary with time by 89 ppm, ?102 ppm and ?126 ppm between the 1999–2003 surveys. The calibration shifts of two of the three gravimeters decreased to about 20 ppm or less in the second interval, the other remained about the same (142 ppm). The results indicate that they shifted at rates on the order of 10 ppm/year even several years after manufacturing. The large shift in calibration factors indicates that they must be corrected using calibrations done before and after the measurements to perform microgravity measurements when gravity differences between a reference gravity site and survey sites are on the order of a hundred milligals (mGal) or more. The results also indicate that the calibration factors change gradually with time, so their interpolation provides a good practical approximation for a specific survey time. We applied the time‐dependent calibration factors to microgravity monitoring at the Iwo‐tou caldera, Japan, where the gravity difference between the base site on the island and the reference site on Honshu (the mainland of Japan) is about 870 mGal mainly due to the 11° latitude difference. Gravity surveys were conducted every two years from 1998–2006. The correction of scale factors estimated from the repeated calibration surveys leads to satisfactory measurements, in which the average of the absolute differences between two Scintrex CG‐3M instruments in five surveys is reduced from 207μGal to 19μGal; for three of those surveys, it is less than 10 μGal. This result demonstrates the importance of repeated calibration surveys.     

白鱀豚哨叫声的研究

于1996年1月,在中国科学院水生生物研究所白暨豚馆人工饲养池和湖北省石首市天鹅洲长江故道,使用频响范围分别为0－100kHz和0－16kHz的磁带记录系统,记录了一头成年雄性和一头成年雌性白暨豚的哨叫声。采用计算机信号分析系统详细分析了哨叫声的结构和声谱图,并与其它鲸类哨叫声进行比较。结果表明,白暨豚哨叫声的最大和最小频率平均值分别为5841Hz和4975Hz,频率变化幅度一般小于1000Hz。哨叫声平均持续时间为907ms。频率随时间变化不连续,且较平缓,起伏很少,有部分重叠现象。白暨豚哨叫声的结构与另一种淡水豚─—亚河豚相近,但相对于一些海洋性种类（如宽吻海豚）则呈现较大的差异,表现出对环境的高度适应性。     

Simulations of measures to control lava flows

We evaluated the quantitative effects of artificial barriers, water-cooling and guiding channels on lava flow using the lava simulation program LavaSIM. Lava flow is basically subject to the topography around the path, effusive rate and viscosity. To prevent damage due to lava flow, we conducted experiments in controlling the flow direction, velocity and temperature. The simulation demonstrated that artificial barriers can successfully change the direction of a lava flow and is more effective when placed nearly parallel to the flow direction at a point where the topography is not very steep, while a barrier placed perpendicular to the flow direction can only stop the flux temporarily, ultimately allowing the solidified crust to accumulate and causing the following mass to go over the barrier. The water-cooling trial was also effective in controlling the direction and temperature, although the amount of water was as much order as 10⁵ m³. The guiding channels successfully control the direction and inundated area but only in local areas.     

Experiment and validation of numerical simulation of coupled thermal,hydraulic and mechanical behaviour in the engineered buffer materials

Evaluation of the coupled heat transfer, water flow and stress changes in the engineered clay barrier is an important issue in the performance assessment of the high‐level radioactive waste disposal. To demonstrate the function of the engineered barrier system, the large‐scale experiment is conducted, which is called Big Bentonite facility (BIG‐BEN). The facility consists of an electric heater surrounded by glass beads, carbon steel overpack, buffer material and man‐made rock. The buffer is a mixture of bentonite and sand. The heater is operated at 0·8 kW. Water is injected from the interface between the buffer and the man‐made rocks at the pressure of 0·05 MPa. The duration of the experiment is 20 months. The change in temperature and swelling pressure are continuously monitored and gravimetric water content is measured by sampling. The coupled thermal, hydraulic and mechanical processes are simulated with a finite element code THAMES, which can simulate the fully coupled phenomena in the saturated and unsaturated clay under anisothermal condition. To examine the validity of the code, all the parameters used in the model are evaluated from the other laboratory tests. The simulated results are compared with the measured ones without calibration of the parameter values using the results from the BIG‐BEN experiment. It can be concluded that the changes in temperature and gravimetric water content within the buffer can be simulated reasonably well and that the mechanical effect such as swelling pressure is difficult to realize. Copyright © 2000 John Wiley & Sons, Ltd.     

Laboratory based continuous bedload monitoring in a model retention basin: Application of time domain reflectometry

In this study, we applied time domain reflectometry (TDR) to determine the deposition height and porosity of sediment at a fine spatiotemporal resolution, and developed a continuous bedload monitoring method that can be applied to pools in steep mountain rivers. The TDR monitoring system consisted of sensor probes, a cable tester, multiplexers and coaxial cables. When the embedded probes penetrated both water and sediment, the boundaries of the sediment and water were consistent with the transition points in the observed waveforms of each TDR measurement. A semi‐automatic analysis of the recorded TDR waveforms, which did not require calibration or parameter fitting, was conducted to establish continuous monitoring. In addition, a flume experiment was performed to test the monitoring system in a model retention basin connected to a flume, with sand of uniform grain size (1.4 mm diameter) supplied for 30 min. The sediment volume in the container representing the model basin was monitored using a load cell underlying the container and eight sensor probes, with a length of almost 0.27 m. The sediment thickness determined by the TDR indicated a gradual deposition, and was consistent with manual measurements. Despite a marginal overestimation of 13% for a sand feed of 30 kg, the sediment volume in the model retention basin and the bedload transport rate were successfully estimated. A combination of our monitoring system and other indirect methods, such as geophones, can potentially serve as useful tools for better understanding bedload transport processes in steep mountain streams. Copyright © 2018 John Wiley & Sons, Ltd.     

Horizontal distribution and population dynamics of the dominant mysid Hyperacanthomysis longirostris along a temperate macrotidal estuary (Chikugo River estuary, Japan)

The estuarine turbidity maximum (ETM) that develops in the lower salinity areas of macrotidal estuaries has been considered as an important nursery for many fish species. Mysids are one of the dominant organisms in the ETM, serving as a key food source for juvenile fish. To investigate the horizontal distribution and population dynamics of dominant mysids in relation to the fluctuation of physical conditions (temperature, salinity, turbidity, and freshwater discharge), we conducted monthly sampling (hauls of a ring net in the surface water) along the macrotidal Chikugo River estuary in Japan from May 2005 to December 2006. Hyperacanthomysis longirostris was the dominant mysid in the estuary, usually showing peaks of density and biomass in or close to the ETM (salinity 1–10). In addition, intra-specific differences (life-cycle stage, sex, and size) in horizontal distribution were found along the estuary. Larger males and females, particularly gravid females, were distributed upstream from the center of distribution where juveniles were overwhelmingly dominant. Juveniles increased in size toward the sea in marked contrast with males and females. The findings suggest a possible system of population maintenance within the estuary; gravid females release juveniles in the upper estuary, juveniles grow during downstream transport, young males and females mature during the upstream migration. Density and biomass were primarily controlled by seasonal changes of temperature, being high at intermediate temperatures (ca. 15–25 °C in late spring and fall) and being low at the extreme temperatures (ca. 10 °C in midwinter and 30 °C in midsummer). High density (up to 666 ind. m⁻³) and biomass (up to 168 mg dry weight m⁻³) of H. longirostris were considered to be comparable with those of copepods in the estuary.     

Quantitative evaluation of the performance of a permit auction system in reducing bycatch of sea turtles in the Hawaii Swordfish longline fishery

Many authors have suggested the use of a cap and trade auction system to help reduce bycatch—the incidental take of species by fishing gear targeting other species—of sea turtles in the Hawaii-based swordfish longline fishery. However, we know of no quantitative evaluations of the method. We present a simple mathematical model to serve as a framework to evaluate bycatch auction systems quantitatively. We conclude that cap and trade auction systems have the potential to reduce sea turtle bycatch by creating a financial incentive, while keeping permit costs down to 2–3% of total revenues. While stringent regulations aimed at conserving endangered sea turtles would still be essential, implementation of an auction for issuing transferable bycatch permits would likely enhance the economic efficiency of the fleet. Sea turtle mortality could be reduced further if a shrinking cap on total turtle mortality was introduced, taking advantage of the incentives for reducing turtle mortality that are introduced by the cap and trade auction system.     

云南下侏罗统禄丰组恐龙足迹的发现和张北足迹属新观察

记述了云南省禄丰县腰站乡下侏罗统禄丰组2个恐龙足迹,命名了棋盘张北足迹（Changpeipus pareschequier ichnosp. nov.）一新种。这是在禄丰组中首次发现恐龙足迹化石,重新观察并修订了张北足迹一属的属征。滦平张北足迹（Changpeipus luanpingeris）应为石炭张北足迹（Changpeipus carbonicus）的亚成年个体,为同物异名。此前被认为是石炭张北足迹（Changpeipus carbonicus）前足迹的IVPP V2472 2a,应为其未成年体的后足迹。张北足迹与卡岩塔足迹（Kayentapus）类似。综合种种特征,棋盘张北足迹（新种）的造迹恐龙很可能为禄丰组的腔骨龙类（Coelophysoidea）