Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Organotemplate silica deposition in Neoproterozoic deep-marine environments: evidence from the Penganga Group, Adilabad, India

Silica in bedded cherts interstratified with manganese carbonates in a deep‐water carbonate ramp succession of the Neoproterozoic Penganga Group, India, displays film‐like, spherical to rod‐shaped, and tubular branching microstructures. The microstructures resemble mineralized extracellular polysaccharides, biofilms and bacterial morphologies. The microstructures suggest silicification by nucleation of silica on organic‐templates or indirectly as sorbed species accumulating on organic templates. Given that similar microstructures have also been documented in Archean cherts it is proposed that organotemplates might have been an important sink for the deposition of silica in Precambrian deep‐water marine environments.     

Sonar cross sections of bodies partially insonified by finite sound beams

An object that is partially insonified by a collimated sound beam may have a scattering cross section sometimes much larger than when the object is totally covered by the incident beam. We quantitatively study this partial insonification problem here, under the classical method of physical optics. The importance of this study stems from the fact that partial coverage of the target by the beam is the situation most likely to occur in many cases of practical importance. We consider several basic target shapes partially insonified by finite beams. These shapes include the spherical, the infinite and finite cylinder, the flat plate, and the capped sphere. High-frequency approximations of the resulting integrals, obtained by means of the saddle-point method, show the relative importance of the scattering centers located at the beam's specular reflection points, or at the edges of the spots that the beam shines on the scatterers. The physical-optics method is extended to obtain formulas for the bistatic cross sections of partially insonified objects. The results are numerically evaluated and graphically displayed in many pertinent instances and compared to the predictions of approaches, such as the Fresnel-zones method and the Geometrical Theory of Diffraction (GTD). The predictions of the physical-optics method have all the advantages and deficiencies of this method and, with very minor modifications, hold equally well for the partial illumination of objects by beams of electromagnetic radiation.     

Fluid production and isograd reactions at contacts of carbonate-rich and carbonate-poor layers during progressive metamorphism

ABSTRACT With increasing temperature during prograde metamorphism reactions will occur first at the lithological contacts of mixed pelite and calcsilicate terranes. At these interfaces, a fluid of lower chemical potential of H₂O and CO₂ than that required to produce a fluid in either layer can be produced whether reaction is caused by fluid infiltration or is initially fluid absent. If the interface region does not allow fluid transport then as temperature increases, a fluid pressure greater than lithostatic can develop. At some degree of over-pressure relative to rock pressure, the fluid hydraulically fractures the rock and a gradient in fluid composition away from the contact can be produced. These phenomena occur at the compositional interfaces whenever univariant reactions in the differing layers cross on a temperature vs. mole fraction of CO₂ diagram with slopes of opposite sign. The first occurrence of these reaction products at lithological contacts delineates an isograd that defines temperature as well as the mole fraction of CO₂ at constant pressure in systems open to fluid transport. These isograds can be contrasted with fluid-producing isograds in closed systems. As an illustration of possible effects, the reactions quartz + clinozoisite + muscovite = anorthite + K-feldspar + H₂O and phlogopite + quartz + calcite = tremolite + K-feldspar + H₂O + CO₂ at 4 kbar are analysed and equations for fluid production and transport are developed.     

SHRIMP U–Pb ages of diagenetic and hydrothermal xenotime from the Archaean Witwatersrand Supergroup of South Africa

SHRIMP dating of xenotime overgrowths on detrital zircon grains can constrain maximum durations since diagenesis and therefore provide minimum dates of sediment deposition. Thus, xenotime dating has significant economic application to Precambrian sediment-hosted ore deposits, such as Witwatersrand Au–U, for which there are no precise depositional ages. The growth history of xenotime in the Witwatersrand Supergroup is texturally complex, with several phases evident. The oldest authigenic xenotime ²⁰⁷Pb/²⁰⁶Pb age obtained in sandstone underlying the Vaal Reef is 2764 ± 5 Myr (1 σ), and most likely represents a mixture of diagenetic and hydrothermal growth. Nevertheless, this represents the oldest authigenic mineral age yet recorded in the sequence and provides a minimum age of deposition. Other xenotime data record a spread of ages that correspond to numerous post-diagenetic thermotectonic events (including a Ventersdorp event at ≈ 2720 Ma) up to the ≈2020 Ma Vredefort event.     

Structurally controlled gold and sulfosalt mineralization: the Altenberg example, Salzburg Province, Austria

Summary ?In the south-eastern Altenbergkar–Silbereck area in the eastern Tauern window (Lungau, Salzburg) structurally controlled precious-metal (Au–Ag) mineralization is hosted in marbles of the Permo(?)-Mesozoic Silbereck Formation and in the underlying Variscan Central gneiss. During the Alpine otogeny both lithologies were affected by ductile deformation (shearing, D1; folding, D2/D3) and subsequent brittle deformation (tension gashes, D4; normal faulting, D5) related to the uplift and exhumation of the Tauern window. Mineralization is controlled by brittle D4 structures. NE–SW trending steeply dipping tension gashes of the “Tauerngoldgang” type occur within the Central gneiss. Three different marble-hosted ore types following fracture systems as well as foliation and bedding planes can be distinguished: 1) metasomatic replacement ores, 2) ores in tension gashes and 3) ores in talc-bearing structures, often containing high-grade gold and silver mineralization (native gold in association with Ag–Pb–Bi–sulfosalts). Four stages of mineralization can be distinguished which occur in all ore types: arsenopyrite–pyrite–pyrrhotite (first stage), Au–(Ag–Pb–Bi–sulfosalts) (second stage), base-metal sulfides and tetrahedrite–tennantite (third stage) and Ag-rich galena (fourth stage). Preliminary fluid inclusion data indicate temperatures of ore formation well above 300 °C (346 °C mean) for the second stage within the Central gneiss and temperatures between 310 and 230 °C for the second and third stages in the marble. Received October 12, 2001; revised version accepted September 5, 2002 Published online March 10, 2003     

Rare earth, major and trace elements in Jurassic manganese shales of the Northern Calcareous Alps: hydrothermal versus hydrogenous origin of stratiform manganese deposits

Summary ?The rare earth, major and trace element geochemistry of Jurassic deep marine manganese shales allow insight into their environment of deposition. We present data of 24 samples from the Northern Calcareous Alps (Eastern Alps), collected from Late Jurassic strata of the Tennengebirge and from Early Jurassic strata of the Karwendel Mts. Whereas major and trace element geochemistry is controlled by the detrital input, rare earth element data and the relationship between total organic carbon and (pyritic) sulfur can be used to constrain the origin of the manganese accumulation. The data of this study are compatible with a hydrogenous precipitation of manganese by strongly varying redox-conditions at the sediment–water interface of a slope basin. Received December 21, 2001; revised version accepted February 18, 2002     

Evidence for the loss of snow-deposited MSA to the interstitial gaseous phase in central Antarctic firn

We have examined several MSA (methanesulfonic acid) records from the upper 200 m of the Antarctic ice sheet and in particular the new Dome F profile. At all the four sites studied, concentration profiles exhibit similar patterns as a function of depth. They suggest that snow metamorphism and solid phase migration are responsible for a marked release of gaseous MSA to interstitial firn air as well as probably to the free atmosphere, in particular at extremely low accumulation sites. Snow acidity can also modify MSA concentration. It is proposed that, below the upper few metres where the communication with the free atmosphere is possible, gaseous MSA may remain in the firn layers and be entrapped later in air bubbles at pore close-off, i.e. when firn is transformed into ice. Chemical measurements on the firn core do not take into account the MSA released to the gaseous phase, but this fraction is measurable in ice samples. In spite of these alterations occurring in the firn layers, relative changes of the atmospheric MSA concentration in the past are probably still there deep within the Antarctic ice sheet. However, for glacial periods, different processes have to be considered in relation to modified aerosol properties.