Photometry of pluto in the last decade and before: evidence for volatile transport?

Photometric observations of Pluto in the BVR filter system were obtained in 1999 and in 1990-1993, and observations in the 0.89-μm methane absorption band were obtained in 2000. Our 1999 observations yield lightcurve amplitudes of 0.30 ± 0.01, 0.26 ± 0.01, and 0.21 ± 0.02 and geometric albedos of 0.44 ± 0.04, 0.52 ± 0.03, and 0.58 ± 0.02 in the B, V, and R filters, respectively. The low-albedo hemisphere of Pluto is slightly redder than the higher albedo hemisphere. A comparison of our results and those from previous epochs shows that the lightcurve of Pluto changes substantially through time. We developed a model that fully accounts for changes in the lightcurve caused by changes in the viewing geometry between the Earth, Pluto, and the Sun. We find that the observed changes in the amplitude of Pluto’s lightcurve can be explained by viewing geometry rather than by volatile transport. We also discovered a measurable decrease since 1992 of ∼0.03 magnitudes in the amplitude of Pluto’s lightcurve, as the model predicts. Pluto’s geometric albedo does not appear to be currently increasing, as our model predicts, although given the uncertainties in both the model and the measurements of geometric albedo, this result is not firm evidence for volatile transport. The maximum of methane-absorption lightcurve occurs near the minimum of the BVR lightcurves. This result suggests that methane is more abundant in the brightest regions of Pluto. Pluto’s phase coefficient exhibits a color dependence, ranging from 0.037 ± 0.01 in the B filter to 0.032 ± 0.01 in the R filter. Pluto’s phase curve is most like those of the bright, recently resurfaced satellites Triton and Europa. Although Pluto shows no strong evidence for volatile transport now (unlike Triton), it is important to continue to observe Pluto as it moves away from perihelion.     

Effect of spatial variation characteristics on contouring of design storm depth

The ordinary kriging method, a geostatistical interpolation technique, was applied for developing contour maps of design storm depth in northern Taiwan using intensity–duration–frequency (IDF) data. Results of variogram modelling on design storm depths indicate that the design storms can be categorized into two distinct storm types: (i) storms of short duration and high spatial variation and (ii) storms of long duration and less spatial variation. For storms of the first category, the influence range of rainfall depth decreases when the recurrence interval increases, owing to the increasing degree of their spatial independence. However, for storms of the second category, the influence range of rainfall depth does not change significantly and has an average of approximately 72 km. For very extreme events, such as events of short duration and long recurrence interval, we do not recommend usage of the established design storm contours, because most of the interstation distances exceed the influence ranges. Our study concludes that the influence range of the design storm depth is dependent on the design duration and recurrence interval and is a key factor in developing design storm contours. Copyright © 2003 John Wiley & Sons, Ltd.     

Initial interpretation of Titan plasma interaction as observed by the Cassini plasma spectrometer: Comparisons with Voyager 1

The Cassini plasma spectrometer (CAPS) instrument made measurements of Titan's plasma environment when the Cassini Orbiter flew through the moon's plasma wake October 26, 2004 (flyby TA). Initial CAPS ion and electron measurements from this encounter will be compared with measurements made by the Voyager 1 plasma science instrument (PLS). The comparisons will be used to evaluate previous interpretations and predictions of the Titan plasma environment that have been made using PLS measurements. The plasma wake trajectories of flyby TA and Voyager 1 are similar because they occurred when Titan was near Saturn's local noon. These similarities make possible direct, meaningful comparisons between the various plasma wake measurements. They lead to the following: (A) The light and heavy ions, H⁺and N⁺/O⁺, were observed by PLS in Saturn's magnetosphere in the vicinity of Titan while the higher mass resolution of CAPS yielded H⁺ and H₂⁺as the light constituents and O⁺/CH₄⁺ as the heavy ions. (B) Finite gyroradius effects were apparent in PLS and CAPS measurements of ambient O⁺ ions as a result of their absorption by Titan's extended atmosphere. (C) The principal pickup ions inferred from both PLS and CAPS measurements are H⁺, H₂⁺, N⁺, CH₄⁺ and N₂⁺. (D) The inference that heavy pickup ions, observed by PLS, were in narrow beam distributions was empirically established by the CAPS measurements. (E) Slowing down of the ambient plasma due to pickup ion mass loading was observed by both instruments on the anti-Saturn side of Titan. (F) Strong mass loading just outside the ionotail by a heavy ion such as N₂⁺ is apparent in PLS and CAPS measurements. (G) Except for the expected differences due to the differing trajectories, the magnitudes and structures of the electron densities and temperatures observed by both instruments are similar. The high-energy electron bite-out observed by PLS in the magnetotail is consistent with that observed by CAPS.     

On the cause of total irradiance variations observed by the CCD solar surface photometer

Spatially-resolved precise photometric observations of the whole Sun at wavelengths of 545nm (FWHM 40nm) were carried out by using the CCD solar surface photometer. Bright parts of photospheric network have contrast of several tenths of percent, and their contribution to the total irradiance is approximately half that of active region faculae. The solar irradiance variations estimated from sunspots, faculae and active network (contrast>0.3%) agreed with the ACRIM data. The quiet Sun irradiance used in the present results was different from the total irradiance at the solar minimum observed by the ACRIM, which indicates unmeasured components (contrast>0.1%) cause the 11-year cycle irradiance variation.     

Elastic solutions for stresses in a transversely isotropic half‐space subjected to three‐dimensional buried parabolic rectangular loads

In many areas of engineering practice, applied loads are not uniformly distributed but often concentrated towards the centre of a foundation. Thus, loads are more realistically depicted as distributed as linearly varying or as parabola of revolution. Solutions for stresses in a transversely isotropic half‐space caused by concave and convex parabolic loads that act on a rectangle have not been derived. This work proposes analytical solutions for stresses in a transversely isotropic half‐space, induced by three‐dimensional, buried, linearly varying/uniform/parabolic rectangular loads. Load types include an upwardly and a downwardly linearly varying load, a uniform load, a concave and a convex parabolic load, all distributed over a rectangular area. These solutions are obtained by integrating the point load solutions in a Cartesian co‐ordinate system for a transversely isotropic half‐space. The buried depth, the dimensions of the loaded area, the type and degree of material anisotropy and the loading type for transversely isotropic half‐spaces influence the proposed solutions. An illustrative example is presented to elucidate the effect of the dimensions of the loaded area, the type and degree of rock anisotropy, and the type of loading on the vertical stress in the isotropic/transversely isotropic rocks subjected to a linearly varying/uniform/parabolic rectangular load. Copyright © 2002 John Wiley & Sons, Ltd.     

The influence of a non‐associated flow rule on the calculation of the factor of safety of soil slopes

This paper presents a method that incorporates a non‐associated flow rule into the limit analysis to investigate the influence of the dilatancy angle on the factor of safety for the slope stability analysis. The proposed method retain's the advantage of the upper bound method, which is simple and has no stress involvement in the calculation of the energy dissipation and the factor of safety. Copyright © 2001 John Wiley & Sons, Ltd.     

Abundance and isotopic composition of noble gases in metal and graphite of the Bohumilitz IAB iron meteorite

Abstract— Abundances and isotopic compositions of noble gases in metal and graphite of the Bohumilitz IAB iron meteorite were measured. The abundance ratios of spallogenic components in metal reveal a ³He deficiency which is due to the diffusive loss of parent isotopes, that is, tritium (Tilles, 1963; Schultz, 1967). The diffusive loss likely has been induced by thermal heating by the Sun during cosmic‐ray exposure (～160 Ma; Lavielle et al, 1999). Thermal process such as impact‐induced partial loss may have affected the isotopic composition of spallogenic Ne. The ¹²⁹Xe/¹³¹Xe ratio of cosmogenic components in the metal indicates an enhanced production of epi‐thermal neutrons. The abundance ratios of spallogenic components in the graphite reveal that it contained small amounts of metal and silicates. The isotopic composition of heavy noble gases in graphite itself was obtained from graphite treated with HF/HCl. The isotopic composition of the etched graphite shows that it contains two types of primordial Xe (i.e., Q‐Xe and El Taco Xe). The isotopic heterogeneity preserved in the Bohumilitz graphite indicates that the Bohumilitz graphite did not experience any high‐temperature event and, consequently, must have been emplaced into the metal at subsolidus temperatures. This situation is incompatible with an igneous model as well as the impact melting models for the IAB‐IIICD iron meteorites as proposed by Choi et al. (1995) and Wasson et al (1980).     

Radar observations of Itokawa in 2004 and improved shape estimation

Abstract— We present June 2004 radar images of asteroid 25143 Itokawa (1998 SF36) that improve upon the longitude‐latitude coverage of images obtained in 2001 by Ostro et al. (2004) and use the 2001–2004 data to refine that paper's constraints on Itokawa's shape. The 2004 images, the first of the asteroid's southern side, look distinctly different from the 2001 images, revealing leading edges that are much more curved and rugged than the nearly convex leading edges seen at northern latitudes in 2001. Itokawa is shaped like a slightly asymmetrical, bent, lumpy ellipsoid with dimensions along the principal axes within 10% of 594 times 320 times 288 m. To illustrate the uncertainty space associated with shape reconstruction from images with suboptimal orientational coverage, we present two alternative three‐dimensional models of the object.     

Determination of physical parameters of NGC 2023 using the hyperfine NH3 spectrum

An improved approach is given for deriving the physical parameters of a molecular cloud by its NH₃ rotation-inversion hyperfine spectra. The optical depth τ₀(1, 1) of NH₃ (1,1) is obtained by considering the blending effect of the magnetic hyperfine spectral lines, the (1-1) excitation temperature T_ex (1, 1) is calculated by a two level model, the effect of different collision rate and the thermalization of the (1, 1) inversion lines are discussed, the rotation temperature T_R ( 2, 1) between the NH₃ levels (2, 2) and (1, 1) and the column density N( 1, 1) of the NH₃ (1, 1) inversion level are derived, the results of the total column density from different assumptions for the abundance ratio of ortho-NH₃ and para-NH₃ are also discussed.

This approach is used for the molecular cloud NGC 2023 by using the relevant observed data and its optical depth and other physical parameters are obtained.