Steady state hodographs in a baroclinic boundary layer

If the steady-state geostrophic wind vector varies exponentially with height in the planetary boundary layer, calculated hodographs of the 24-hour mean wind resemble the classic Ekman spiral distorted by thermal effects. For such an assumed distribution, Lettau's (1967) conclusion that the effects of thermal influence on the steady-state boundary-layer winds can be linearly superimposed on the effects of internal friction is justified.The minimum value of the cross-isobar angle of the surface wind for a given magnitude of the thermal wind vector occurs when that vector points about 345° to the right of the surface geostrophic wind vector and the maximum value occurs when it points at an azimuth of about 120° relative to the surface geostrophic wind vector. The range of values of the cross-isobar angle is almost directly proportional to the magnitude of the thermal wind vector.Hodographs resulting from the assumed variation of the geostrophic wind have approximately the same shape as 24-hour mean hodographs at two locations over the Great Plains.This work is part of a thesis submitted to the University of Wisconsin in partial fulfillment of the requirements for the Ph.D. Degree, written under the supervision of Professor H. Lettau, Department of Meteorology.     

Sedimentology and kinematics of a large, retrogressive growth-fault system in Upper Carboniferous deltaic sediments, western Ireland

Growth faulting is a common feature of many deltaic environments and is vital in determining local sediment dispersal and accumulation, and hence in controlling the resultant sedimentary facies distribution and architecture. Growth faults occur on a range of scales, from a few centimetres to hundreds of metres, with the largest growth faults frequently being under‐represented in outcrops that are often smaller than the scale of feature under investigation. This paper presents data from the exceptionally large outcrops of the Cliffs of Moher, western Ireland, where a growth‐fault complex affects strata up to 60 m in thickness and extends laterally for ≈ 3 km. Study of this Namurian (Upper Carboniferous) growth‐fault system enables the relationship between growth faulting and sedimentation to be detailed and permits reconstruction of the kinematic history of faulting. Growth faulting was initiated with the onset of sandstone deposition on a succession of silty mudstones that overlie a thin, marine shale. The decollement horizon developed at the top of the marine shale contact for the first nine faults, by which time aggradation in the hangingwall exceeded 60 m in thickness. After this time, failure planes developed at higher stratigraphic levels and were associated with smaller scale faults. The fault complex shows a dominantly landward retrogressive movement, in which only one fault was largely active at any one time. There is no evidence of compressional features at the base of the growth faults, thus suggesting open‐ended slides, and the faults display both disintegrative and non‐disintegrative structure. Thin‐bedded, distal mouth bar facies dominate the hangingwall stratigraphy and, in the final stages of growth‐fault movement, erosion of the crests of rollover structures resulted in the highest strata being restricted to the proximity of the fault. These upper erosion surfaces on the fault scarp developed erosive chutes that were cut parallel to flow and are downlapped by the distal hangingwall strata of younger growth faults.     

Trace element distributions in aquatic sediments of Danang – Hoian area, Vietnam

 Distribution of the trace elements Cr, Cu, Ni, Pb and Zn in surficial sediments of the river/sea environment in Danang – Hoian area (Vietnam) was investigated to examine the degree of metal pollution caused by anthropogenic activities. Point sources from domestic and industrial wastes are identified as dominant contributors of trace element accumulation. Surficial sediments of Hoian River show extremely high total concentrations of Cu (Average Concentration 295 μg/g), Ni (AC 112 μg/g), Pb (AC 396 μg/g) and Zn (AC 429 μg/g) that exceed assigned safety levels ER-M. Similarly, the sediments of Han River show high Pb (AC 188 μg/g) and Zn (AC 282 μg/g) contents. In marine sediments of Thanhbinh beach Pb is also enriched (138 μg/g) above guideline levels. In contrast the sediments of the Cude River are dominated by trace element concentrations close to background values. Received: 17 December 1998 · Accepted: 6 May 1999     

Ice flow direction during late Paleozoic glaciation in western Paraná Basin, Brazil

The recent discovery of ice-striated surfaces associated with the late Paleozoic Aquidauana Formation suggests that glaciers coming from southwest Africa reached westernmost parts of the Paraná Basin in central Brazil. Abrasion features were developed by glaciers moving from SSE towards NNW, mainly on an unconsolidated bed. These records expand to about 1,050,000 km², the coverage of the late Paleozoic glaciation in the region of the Paraná Basin in Western Gondwana.

Resumen

A recente descoberta de superfícies estriadas associadas à Formação Aquidauana, de idade permocarbonífera, sugere que as geleiras provenientes do sudoeste da África alcançaram as porções ocidentais da Bacia do Paraná, na região central do Brasil. As feições de abrasão foram geradas pelo deslocamento de geleiras de SSE para NNW, principalmente sobre substrato inconsolidado. Estes novos registros evidenciam que a glaciação neopaleozóica cobriu uma área de pelo menos de 1.050.000 km² na região ocupada pela Bacia do Paraná no Gondwana Ocidental.     

MINI-MACtm—A new generation dual—Band surveyor

Summary Litton Divisions presently produce both high accuracy GPS surveyors and low—cost GPS navigation sets. Aero Service'sMACROMETER ^R Interferometric Surveyors, have become the standard against which GPS surveying equipment is measured. Litton Aero Products has developed a highly digitized, low costL ₁,C/A code GPS card set. The integration of these technologies had led to the development of a low-cost, high-precision, GPS survey system which can be configured with or without a codelessL ₂ capability. TheMINI-MAC surveying system is the first member of the new generation of GPS survey systems resulting from this joint development. The system design is described in this paper, and initial survey test results using a prototypeMINI-MAC surveying system are presented.     

Frost risk mapping for landscape planning: A methodology

Summary Minimum air temperatures were measured during three winters with a network of stations in open, undulating terrain. It was observed that the change in minimum air temperature with elevation could be predicted from mean nighttime windspeed, total nighttime net radiation loss and a hill-top reference minimum temperature. It was also found that the deviation of temperatures at individual sites could be predicted from a local terrain parameter which reflects the extent of cold air accumulations. Thus a methodology for frost risk mapping has been developed which is based on regional weather dataand local terrain analysis. This paper describes the model and illustrates the regional weather and terrain effects with three-dimensional block diagrams.With 8 Figures     

Magnetic Anisotropy as an Aid to Identifying CRM and DRM in Red Sedimentary Rocks

To further evaluate the potential of magnetic anisotropy techniques for determining the origin of the natural remanent magnetization (NRM) in sedimentary rocks, several new remanence anisotropy measurement techniques were explored. An accurate separation of the remanence anisotropy of magnetite and hematite in the same sedimentary rock sample was the goal.In one technique, Tertiary red and grey sedimentary rock samples from the Orera section (Spain) were exposed to 13 T fields in 9 different orientations. In each orientation, alternating field (af) demagnetization was used to separate the magnetite and hematite contributions of the high field isothermal remanent magnetization (IRM). Tensor subtraction was used to calculate the magnetite and hematite anisotropy tensors. Geologically interpretable fabrics did not result, probably because of the presence of goethite which contributes to the IRM. In the second technique, also applied to samples from Orera, an anisotropy of anhysteretic remanence (AAR) was applied in af fields up to 240 mT to directly measure the fabric of the magnetite in the sample. IRMs applied in 2 T fields followed by 240 mT af demagnetization, and thermal demagnetization at 90°C to remove the goethite contribution, were used to independently measure the hematite fabric in the same samples. This approach gave geologically interpretable results with minimum principal axes perpendicular to bedding, suggesting that the hematite and magnetite grains in the Orera samples both carry a depositional remanent magnetization (DRM). In a third experiment, IRMs applied in 13 T fields were used to measure the magnetic fabric of samples from the Dome de Barrot area (France). These samples had been demonstrated to have hematite as their only magnetic mineral. The fabrics that resulted were geologically interpretable, showing a strong NW-SE horizontal lineation consistent with AMS fabrics measured in the same samples. These fabrics suggest that the rock's remanence may have been affected by strain and could have originated as a DRM or a CRM.Our work shows that it is important to account for the presence of goethite when using high field IRMs to measure the remanence anisotropy of hematite-bearing sedimentary rocks. It also shows that very high magnetic fields (>10 T) may be used to measure the magnetic fabric of sedimentary rocks with highly coercive magnetic minerals without complete demagnetization between each position, provided that the field magnetically saturates the rock.     

Age and source material of the Kingash ultramafic-mafic massif,East Sayan

The REE distribution patterns and Nd whole-rock and mineral isotope ratios of the Kingash ultramafic-mafic massif enabled us to propose a multistage history for its evolution at 1410 and 875 Ma. These stages reflect the magmatic evolution of the Siberian paleocontinent margin during the Late Precambrian. The age of metamorphism of the massif during collision and accretion in the Early Paleozoic (∼500 Ma) was obtained based on a Sm-Nd mineral isochron from rheomorphic veined albitite. The Nd and Sr isotopic compositions of rocks from the Kingash massif suggest mantle sources for picritic and basic magmas, which are thought to have originated by mixing of different proportions of depleted (PREMA or DM) and enriched (EM) melts. The initial isotope ratios of the parental melts transformed during interaction with Sr-rich material from the host metasedimentary complexes.