Impacts of primary deforestation upon limestone slopes in northern Vancouver Island, British Columbia

Effects of deforestation upon slopes in limestones and in volcanic rocks in the Benson River valley, northern Vancouver Island, have been investigated quantitatively. Postlogging soil erosion and vegetal regeneration success were assessed by measuring soil depth, percent bare rock and moss cover, and the numbers and diversity of trees, shrubs, and plants on 25 sampling sites, each containing ten measuring quadrats selected at random. Sixteen sites were on the Quatsino Formation, a well-karstified limestone, and nine on the Karmutsen Formation of basaltic lavas. Eight sites were of virgin forest, 16 were logged between 1970 and 1983, and one (on limestone) was logged in 1911. Both bedrock types were significantly affected by the cutting. There was greater loss of soil and an increase in bare rock on the limestones. Erosion was increased significantly by burning on the limestones but not on the volcanics. Within-group comparisons on the limestones determined that steeper slopes and harder burned areas suffered the most and are slowest to regenerate. Volume of timber on the 1911 site was 19 percent of that in similar uncut forest sites. It appears that complete recovery on the barren limestone slopes will require at least some centuries.     

Lunar Gravity-Assist Maneuver As a Way of Reducing the Orbit Amplitude in the Spectrum–Röntgen–Gamma Project

Spectrum–Röntgen–Gamma (SRG) is a space observatory designed to observe astrophysical objects in the X-ray range of the electromagnetic spectrum. SRG is planned to be launched in 2019 by a Proton-M launch vehicle with a DM3 upper stage. The spacecraft will be delivered to an orbit around the Sun–Earth collinear libration point L2 located at a distance of ~1.5 million km from the Earth. Although the SRG launch scheme has already been determined at present, in this paper we consider an alternative spacecraft transfer scenario using a lunar gravity-assist maneuver. The proposed scenario allows a oneimpulse transfer from a low Earth orbit to a small-amplitude orbit around the libration point to be performed while fulfilling the technical constraints and the scientific requirements of the mission.     

Sedimentological analysis of two drill cores through the crater moat‐filling breccia,Flynn Creek impact structure,Tennessee

Sedimentological (line‐logging) analysis of two drill cores, FC77‐3 and FC67‐3, situated, respectively, in the northwestern and southeastern quadrants of the Flynn Creek impact structure's crater‐moat area reveals that the ~27 m thick crater moat‐filling breccia consists of three subequal parts. These parts, which were deposited during early modification stage of this marine‐target impact structure, are distinguished on the basis of vertical trends in sorting, grain size, and counts of clasts per meter in comparison with other well‐known marine‐target impact structures, namely Lockne, Tvären, and Chesapeake Bay. The lower part is interpreted to represent mainly slump deposits, and the middle part is interpreted to represent a stage intermediate between slump and marine resurge, that is, a traction flow driven by overriding suspension flow. The upper part (size graded, and relatively well sorted and fine grained) is interpreted to represent marine resurge flow only. The upper part is capped by a relatively thin and relatively fine‐grained calcarenite to calcisiltite deposit.     

An inter-comparison of tidal solutions computed with a range of unstructured grid models of the Irish and Celtic Sea Regions

Three finite element codes, namely TELEMAC, ADCIRC and QUODDY, are used to compute the spatial distributions of the M₂, M₄ and M₆ components of the tide in the sea region off the west coast of Britain. This region is chosen because there is an accurate topographic dataset in the area and detailed open boundary M₂ tidal forcing for driving the model. In addition, accurate solutions (based upon comparisons with extensive observations) using uniform grid finite difference models forced with these open boundary data exist for comparison purposes. By using boundary forcing, bottom topography and bottom drag coefficients identical to those used in an earlier finite difference model, there is no danger of comparing finite element solutions for “untuned unoptimised solutions” with those from a “tuned optimised solution”. In addition, by placing the open boundary in all finite element calculations at the same location as that used in a previous finite difference model and using the same M₂ tidal boundary forcing and water depths, a like with like comparison of solutions derived with the various finite element models was possible. In addition, this open boundary was well removed from the shallow water region, namely the eastern Irish Sea where the higher harmonics were generated. Since these are not included in the open boundary, forcing their generation was determined by physical processes within the models. Consequently, an inter-comparison of these higher harmonics generated by the various finite element codes gives some indication of the degree of variability in the solution particularly in coastal regions from one finite element model to another. Initial calculations using high-resolution near-shore topography in the eastern Irish Sea and including “wetting and drying” showed that M₂ tidal amplitudes and phases in the region computed with TELEMAC were in good agreement with observations. The ADCIRC code gave amplitudes about 30 cm lower and phases about 8° higher. For the M₄ tide, in the eastern Irish Sea amplitudes computed with TELEMAC were about 4 cm higher than ADCIRC on average, with phase differences of order 5°. For the M₆ component, amplitudes and phases showed significant small-scale variability in the eastern Irish Sea, and no clear bias between the models could be found. Although setting a minimum water depth of 5 m in the near-shore region, hence removing wetting and drying, reduced the small-scale variability in the models, the differences in M₂ and M₄ tide between models remained. For M₆, a significant reduction in variability occurred in the eastern Irish Sea when a minimum 5-m water depth was specified. In this case, TELEMAC gave amplitudes that were 1 cm higher and phases 30° lower than ADCIRC on average. For QUODDY in the eastern Irish Sea, average M₂ tidal amplitudes were about 10 cm higher and phase 8° higher than those computed with TELEMAC. For M₄, amplitudes were approximately 2 cm higher with phases of order 15° higher in the northern part of the region and 15° lower in the southern part. For M₆ in the north of the region, amplitudes were 2 cm higher and about 2 cm lower in the south. Very rapid M₆ tidal-phase changes occurred in the near-shore regions. The lessons learned from this model inter-comparison study are summarised in the final section of the paper. In addition, the problems of performing a detailed model–model inter-comparison are discussed, as are the enormous difficulties of conducting a true model skill assessment that would require detailed measurements of tidal boundary forcing, near-shore topography and precise knowledge of bed types and bed forms. Such data are at present not available.     

N and O isotope effects during nitrate assimilation by unicellular prokaryotic and eukaryotic plankton cultures

In order to provide biological systematics from which to interpret nitrogen (N) and oxygen (O) isotope ratios of nitrate (¹⁵N/¹⁴N, ¹⁸O/¹⁶O, respectively) in the environment, we previously investigated the isotopic fractionation of nitrate during its assimilation by mono-cultures of eukaryotic algae (Granger et al., 2004). In this study, we extended our analysis to investigate nitrate assimilation by strains of prokaryotic plankton. We measured the N and O isotope effects, ¹⁵ε and ¹⁸ε, during nitrate consumption by cultures of prokaryotic strains and by additional eukaryotic phytoplankton strains (where ε is the ratio of reaction rate constants of the light vs. heavy isotopologues, ^lightk and ^heavyk; ε = ^lightk/^heavyk − 1 × 1000, expressed in per mil). The observed ¹⁵ε ranged from 5‰ to 8‰ among eukaryotes, whereas it did not exceed 5‰ for three cyanobacterial strains, and was as low as 0.4‰ for a heterotrophic α-protoeobacterium. Eukaryotic phytoplankton fractionated the N and O isotopes of nitrate to the same extent (i.e., ¹⁸ε ∼ ¹⁵ε). The ¹⁸ε:¹⁵ε among the cyanobacteria was also ∼1, whereas the heterotrophic α-proteobacterial strain, which showed the lowest ¹⁵ε, between 0.4‰ and 1‰, had a distinct ¹⁸ε:¹⁵ε of ∼2, unlike any plankton strain observed previously. Equivalent N vs. O isotope discrimination is thought to occur during internal nitrate reduction by nitrate reductase, such that the cellular efflux of the fractionated nitrate into the medium drives the typically observed ¹⁸ε:¹⁵ε of ∼1. We hypothesize that the higher in the ¹⁸ε:¹⁵ε of the α-proteobacterium may result from isotope discrimination by nitrate transport, which is evident only at low amplitude of ε. These observations warrant investigating whether heterotrophic bacterial assimilation of nitrate decreases the community isotope effects at the surface ocean.     

Facies Structure and Quantitative Parameters of Pleistocene Sediments of the Bering Sea

Lithofacies zoning is described for the first time for the Neo- and Eopleistocene of the Bering Sea. Four lithofacies sedimentation zones are distinguished: (I) terrigenous; (II) siliceous–terrigenous; (III) siliceous, and (IV) volcanoterrigenous ones. Corresponding maps were treated using Ronov volumetric method to quantify sedimentation parameters for distinguished lithofacies zones (subzones) and types of Pleistocene sediments. It was revealed that terrigenous sediments predominate over other sediments. Accumulation of the terrigenous sediments was more intense (by 1.4 times) in the Neopleistocene than in the Eopleistocene. The sedimentation rate of siliceous sediments of the Bowers Ridge in the Eopleistocene was two times higher than in the Neopleistocene.     

Rockburst research at Falconbridge's Strathcona Mine,Sudbury, Canada

Microseismic systems at five mines in the Sudbury Basin provide the basic data for Falconbridge Limited's rockburst research. Daily and long-term analysis of this data as well as underground observations have confirmed the fault-slip mechanism at three mines. A detailed analysis of the complete history of Falconbridge Mine is being conducted and Distinct Element numerical models are being used to simulate both the stick-slip behaviour of faults and the dynamic effects of the induced vibrations on rock and backfill. University research includes acoustic tomographic imaging of the rock mass based on seismic wave propagation and collection of full microseismic waveforms to allow application of advanced seismic and statistical analysis techniques.Formerly with Mines Technical Services, Falconbridge Limited, Sudbury Operations, Falconbridge , Ont., P0M 1S0.Presented at the Fred Leighton Memorial Workshop on Mining Induced Seismicity, Montreal, Canada, August 30, 1987.     

Influence of wind upon water quality in Liverpool Bay

Comprehensive distribution patterns of physical and chemical characteristics have been obtained from a series of cruises in Liverpool Bay. The marked feature of these distributions was their temporal variability, suggesting that the surface residual circulation is also temporally variable. The influence of wind stress upon the circulation pattern and hence water quality of this sea area is illustrated.