GPS观测在气象中的应用

简述了GPS的组成及发展概况，以及如何利用地面GPS观测探测大气可降水汽量（PWV），从而可以得到高精度，几乎连续和实时的水汽序列，骤报降水量以及监测恶劣天气，为天气预报和气候分析作出贡献。     

中下扬子区二叠系露头层序地层研究

按新近国际年代地层划分方案（ICS，2000），下扬子区二叠纪地层自下向上分为3统，9阶和相对应的华南传统6阶划分。二叠系从阿瑟尔阶至长兴阶（44Ma)共划分出14个三级层序，每个三级层序平均时限约为3.14Ma，其中“紫松阶”）相当阿瑟尔＋2／3萨克马尔阶）1个（船山组中上部）、“隆林阶、（相当1／3萨克马尔阶＋阿丁斯克阶）2个（分别对应船山组上部和梁山组或镇江组）、“栖霞阶”（相当库班甘德阶＋1／3罗德阶）3个（栖霞组），“茅口阶”（相当于2／3罗德阶＋沃德阶＋卡皮丹阶）4个（孤峰组，茅口组，堰桥组，银屏组和武穴组），吴家坪阶2个（龙潭组或吴家坪组），长兴阶2个（长兴组或大隆组）；共归并为4个层序组（sequence set)。     

东南极Lambert冰川-Amery冰架系统平衡通量分布的计算

通过对Lambert冰川盆地(LGB)考察路线上约1 700 km长的LGB剖面和距冰架末端约50 km、长150 km的A剖面, 分别利用GPS冰流速值及雷达测厚值进行冰通量的计算得出:每年流过LGB剖面的冰通量为43.95 Gta-1, 而通过A剖面的冰通量仅为26. 42 Gt*a-1, Amery冰架底部净融化量为7.8 Gt*a-1. 整个Lambert冰川-Amery冰架系统(LAS)地区的表面净物质平衡总量约为90 Gt*a-1; LGB地区的表面净物质平衡总量为46 Gt*a-1. 通过分析得出, 整个LAS地区及LGB地区均处于物质正平衡状态, 而LAS流域的上游区域S'则处于物质负平衡状态.     

高峰公司100号矿体矿床建模与矿山生产动态管理的研究

重点论述高峰锡矿 10 0号矿体的矿床数学经济模型的建立 ,分析模型在采矿、选矿等矿山生产动态管理中的作用及意义     

中国科学院固体地球科学知识创新工程现状与发展态势

回顾了中国科学院国家知识创新试点工程实施以来特别是启动阶段3年里固体地球科学知识创新工程试点各项工作的进展情况，包括项目与经费、创新成果、人才吸引、科研竞争力提升、院地合作推进等方面，分析和总结了中国科学院固体地球科学知识创新工程现状，并展望了固体地球科学知识创新工程若干重要发展态势。     

Division of Gas Accumulation System and Laws Controlling Distribution of Natural Gas in Typical Petroliferous Basins of China

Considering the existing problems of the petroleum system, this paper brings forward the concept of natural gas accumulation system and presents the dividing principles. Then detailed statistics on the accumulation factors of the 32 typical natural gas accumulation systems in China and studies on the laws controlling distribution of gas are collected. The research shows that the petroleum accumulation system is the basic unit controlling petroleum generation, migration and accumulation. Generating intensity, generating amount, accumulating efficiency and migration distance plays an important role in the distribution of natural gas. Through analysis on results of resources evaluation, discovered reserves and residual reserves, potential areas in middle-scaled petroliferous basins in China are forecasted in this paper. Ordos, Sichuan, Tarim and Qaidam basins are found out to be the main basins developing and enriching gas accumulation systems.     

A scanning electron microscope study of the effects of dynamic recrystallization on lattice preferred orientation in olivine

Effects of dynamic recrystallization on lattice preferred orientation (LPO) in olivine were investigated through the combination of two SEM-based techniques, electron backscattered diffraction (EBSD) technique for crystallographic orientation measurement and backscattered electron imaging (BEI) for dislocation observation. Samples are experimentally deformed olivine aggregates in simple shear geometry. In the sample deformed at T=1473 K and high stresses (480 MPa), only incipient dynamic recrystallization is observed along grain-boundaries. Orientations of these small recrystallized grains are more random than that of relict grains, suggesting an important role of grain-boundary sliding at this stage of recrystallization. In the sample deformed at T=1573 K and low stress (160 MPa), dynamic recrystallization is nearly complete and the LPO is characterized by two [100] peaks. One peak is located at the orientation subparallel to the shear direction and is dominated by grains with high Schmid factor. The other occurs at high angles to the shear direction and is due to the contribution from grains with low Schmid factor. Grains with high Schmid factor tend to have higher dislocation densities than those with low Schmid factor. Based on these observations, we identify two mechanisms by which dynamic recrystallization affects LPO: (1) enhancement of grain-boundary sliding due to grain-size reduction, leading to the modification of LPO caused by the relaxation of constraint for deformation; (2) grain-boundary migration by which grains with lower dislocation densities grow at the expense of grains with higher dislocation densities. Based on the deformation mechanism maps and stress versus recrystallized grain-size relation, we suggest that the first mechanism always plays an important role whereas the second mechanism has an important effect only under limited conditions.     

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.     

厚层覆盖区综合物化探方法找金试验研究——以广西兴安金石金矿为例

在兴安金石金矿外围 4号分散流异常区 ,通过地电化学提取金测量法 ,查明测区存在 5个走向规模小于 5 0 m的金异常区 ,W( Au) 最大值为 72 .4× 10 - 9,高出背景值十几倍 ,并藉综合土壤吸附汞测量 ,高精度磁测和激发极化法等多种物化探方法来确定这些异常区的地质、地球化学和地球物理特征 ,提出金矿成矿的有利部位在金的地电提取高异常区、高汞量异常区、高磁性异常区、低视电阻率异常区和中等视极化率异常区的“三高一低一中”的找矿模式。确定测区的北北东角 (右下角 )一带具备有利的金矿成矿条件     

A three-dimensional parametric study of the use of soil nails for stabilising tunnel faces

Applying an effective nailing system at a tunnel heading, not only improves the stability of the tunnel heading and limits deformation at the tunnel face, but it also reduces volume loss during excavation and hence reduces ground surface settlement. The effectiveness of a soil nail system is affected by many factors such as the diameter and stiffness of the nails. In this paper, a systematic parametric study was conducted to study the axial rigidity of a nail, E_nA_n, for improving the stability of tunnel headings and reducing ground movements in stiff clay. The parametric study involved a series of three-dimensional elasto-plastic coupled-consolidation finite element analyses. The stability of the tunnel face is improved with increasing E_nA_n. For a given nail density applied at the tunnel face, an optimum axial rigidity of the nail (E_nA_n)_opt can be identified. The efficiency of the nailing system diminishes when (E_nA_n)_opt is reached. The use of a soil nailing system reduces the magnitude of stress relief at the tunnel heading during excavation. Thus, this reduction of stress relief minimises the amount of soil yielding and excess pore water pressure generated in the soil around the tunnel heading.