The effect of seafloor topography in the Southern Ocean on tabular iceberg drifting and grounding

Antarctic tabular icebergs are important active components in the ice sheet-ice shelf-ocean system. Seafloor topography is the key factor that affects the drifting and grounding of icebergs, but it has not been fully investigated. This study analyzes the impact of seafloor topography on the drifting and grounding of Antarctic tabular icebergs using Bedmap-2 datasets and iceberg route tracking data from Brigham Young University. The results highlight the following points. (1) The quantitative distributions of iceberg grounding events and the tracking points of grounded icebergs are mainly affected by iceberg draft and reach their peak values in sea water with depths between 200 m and 300 m. The peak tracking point number and linear velocity of free-drifting icebergs are found in the Antarctic Slope Front (water depth of approximately 500 m). (2) The area of possible grounding regions of small-scale icebergs calved from ice shelf fronts accounts for 28% of the sea area at water depths less than 2000 m outside the Antarctic coastline periphery (3.62 million km²). Their spatial distribution is mainly around East Antarctica and the Antarctic Peninsula. The area of possible grounding regions of large tabular icebergs with long axes larger than 18.5 km (in water depths of less than 800 m) accounts for 74% of the sea area. (3) The iceberg drifting velocity is positively correlated with ocean depth in areas where the depth is less than 2000 m (R=0.85, P<0.01). This result confirms the effect of water depth variations induced by seafloor topography fluctuations on iceberg drifting velocity.     

Numerical simulations of transport of non-ergodic solute plumes in heterogeneous aquifers

Transport of non-ergodic solute plumes by steady-state groundwater flow with a uniform mean velocity, μ, were simulated with Monte Carlo approach in a two-dimensional heterogeneous and statistically isotropic aquifer whose transmissivity, T, is log-normally distributed with an exponential covariance. The ensemble averages of the second spatial moments of the plume about its center of mass, <S _{i i} (t)>, and the plume centroid covariance, R _{i i} (t) (i=1,2), were simulated for the variance of Y=log T, σ _Y ²=0.1, 0.5 and 1.0 and line sources normal or parallel to μ of three dimensionless lengths, 1, 5, and 10. For σ _Y ²=0.1, all simulated <S _{i i} (t)>−S _{i i} (0) and R _{i i} (t) agree well with the first-order theoretical values, where S _{i i} (0) are the initial values of S _{i i} (t). For σ _Y ²=0.5 and 1.0 and the line sources normal to μ, the simulated longitudinal moments, <S ₁₁(t)>−S ₁₁(0) and R ₁₁(t), agree well with the first-order theoretical results but the simulated transverse moments <S ₂₂(t)>−S ₂₂(0) and R ₂₂(t) are significantly larger than the first-order values. For the same two larger values of σ _Y ² but the line sources parallel to μ, the simulated <S ₁₁(t)>−S ₁₁(0) are larger than but the simulated R ₁₁ are smaller than the first-order values, and both simulated <S ₂₂(t)>−S ₂₂(0) and R ₂₂(t) stay larger than the first-order values. For a fixed value of σ _Y ², the summations of <S _{i i} (t)>−S _{i i} (0) and R _{i i} , i.e., X _{i i} (i=1,2), remain almost the same no matter what kind of source simulated. The simulated X ₁₁ are in good agreement with the first-order theory but the simulated X ₂₂ are significantly larger than the first-order values. The simulated X ₂₂, however, are in excellent agreement with a previous modeling result and both of them are very close to the values derived using Corrsin's conjecture. It is found that the transverse moments may be significantly underestimated if less accurate hydraulic head solutions are used and that the decreasing of <S ₂₂(t)>−S ₂₂(0) with time or a negative effective dispersivity, defined as , may happen in the case of a line source parallel to μ where σ _Y ² is small.     

Precise photorealistic visualization for restoration of historic buildings based on tacheometry data

This paper puts forward a 3D reconstruction methodology applied to the restoration of historic buildings taking advantage of the speed, range and accuracy of a total geodetic station. The measurements representing geo-referenced points produced an interactive and photorealistic geometric mesh of a monument named ‘Neoria.’ ‘Neoria’ is a Venetian building located by the old harbor at Chania, Crete, Greece. The integration of tacheometry acquisition and computer graphics puts forward a novel integrated software framework for the accurate 3D reconstruction of a historical building. The main technical challenge of this work was the production of a precise 3D mesh based on a sufficient number of tacheometry measurements acquired fast and at low cost, employing a combination of surface reconstruction and processing methods. A fully interactive application based on game engine technologies was developed. The user can visualize and walk through the monument and the area around it as well as photorealistically view it at different times of day and night. Advanced interactive functionalities are offered to the user in relation to identifying restoration areas and visualizing the outcome of such works. The user could visualize the coordinates of the points measured, calculate distances and navigate through the complete 3D mesh of the monument. The geographical data are stored in a database connected with the application. Features referencing and associating the database with the monument are developed. The goal was to utilize a small number of acquired data points and present a fully interactive visualization of a geo-referenced 3D model.     

Evaluation of hydrogeochemical processes and groundwater quality for suitability of drinking and irrigation purposes: a case study in the Aosta Valley region,Italy

The present study aims to discuss the hydrogeochemical processes in the Aosta Valley region and assess the quality of its groundwater for suitability of drinking and irrigation purposes. One hundred twenty-two samples were collected from the Aosta Valley region in the years 2007 and 2008 (61 per year), and analysed for pH, electrical conductivity, total dissolved solids (TDS), total hardness, major cations and anions. The pH of the samples in both years indicated a near-neutral to alkaline nature of the groundwater. The cation and anion chemistry showed the general ionic abundance as: Ca²⁺ > Mg²⁺ > Na⁺ > K⁺ and HCO₃ ^?>SO₄ ^2?>Cl^?>NO₃ ^?>F^? in both years. Ca²⁺-Mg²⁺-HCO₃ ^? and Ca²⁺-Mg²⁺-Cl^?-SO₄ ^2? were the dominant hydrogeochemical facies. The computed saturation indices demonstrated that the groundwater was supersaturated with respect to dolomite and calcite in both years. The groundwater chemistry of the study area was mainly controlled by the dissolution of carbonate, sulphate and silicate minerals, as well as ion exchange processes. A comparison of the groundwater quality in relation to drinking water standards showed that most of the water samples were suitable for drinking and domestic uses. The computed water quality index (WQI) values of the study area groundwater ranged from 24 to 84 in the year 2007 and from 22 to 82 in the year 2008, and all the location fell under the Excellent to Good category. Quality assessment for irrigation uses revealed that the groundwater was good to permissible quality for irrigation; however, locally higher salinity, residual sodium carbonate (RSC) and magnesium hazard (MH) restricted its suitability for irrigation at a few sites. These results will be useful in implementing future measures in groundwater resource management at regional and national level.     

Application of time-frequency transforms to processing of full waveforms from acoustic logs

The paper deals with the application of time-frequency methods, Continuous Wavelet Transform (CWT) and Matching Pursuit algorithm (MP), to acoustic full waveform processing. The goal of the research is to present possible ways of application of these methods, particularly for the precise identification of selected acoustic waves, waveform decomposition into separate waves, and determination of zones of different elastic parameters in the geological profiles. The simulations, developed methodology, and results of each method are discussed in detail. The Continuous Wavelet Transform is used to improve qualitative interpretation. Time-depth-frequency plots for a given frequency are constructed to distinguish the waves and identify gas-bearing zones. The Matching Pursuit has a better resolution in time-frequency space than CWT; thus, it is used to extract individual waves from the whole acoustic waveform, i.e., decompose the signal. For the extracted waves, the slowness is calculated. Results from MP methods are compared with their counterpart parameters obtained from the original waveforms. Additionally, time-frequency decompositions are used for the determination of the frequency content of each wave packet to get unique information about formation in situ.     

Application and verification of fuzzy algebraic operators to landslide susceptibility mapping

The aim of this study was to apply and to verify the use of fuzzy logic to landslide susceptibility mapping in the Gangneung area, Korea, using a geographic information system (GIS). For this aim, in the study, a data-derived model (frequency ratio) and a knowledge-derived model (fuzzy operator) were combined. Landslide locations were identified by changing the detection technique of KOMPSAT-1 images and checked by field studies. For landslide susceptibility mapping, maps of the topography, lineaments, soil, forest, and land cover were extracted from the spatial data sets, and the eight factors influencing landslide occurrence were obtained from the database. Using the factors and the identified landslide, the fuzzy membership values were calculated. Then fuzzy algebraic operators were applied to the fuzzy membership values for landslide susceptibility mapping. Finally, the produced map was verified by comparing with existing landslide locations for calculating prediction accuracy. Among the fuzzy operators, in the case in which the gamma operator (λ = 0.975) showed the best accuracy (84.68%) while the case in which the fuzzy or operator was applied showed the worst accuracy (66.50%).     

Warning and evacuation in response to sediment-related disasters

On July 19, 2006, several sediment-related disasters (debris flows and landslides) occurred in Okaya and Suwa, Nagano Prefecture, Japan. In Okaya, neither the municipal government nor the residents had expected such a disaster, and they were unprepared. No evacuation of the population took place prior to the disaster, and two debris flows killed eight people. Another debris flow struck a retirement home. Fortunately, the first-floor residents could be evacuated to the second floor. In contrast, the nearby town of Suwa was evacuated voluntarily before the debris flow struck, and no fatalities occurred. This paper describes the situation at the time of the disaster, the evacuations in Okaya and in Suwa, and their consequences from the point of view of disaster-prevention personnel and retirement-home staff. Factors that should be considered in formulating warning and evacuation systems in response to sediment-related disasters are discussed.     

Lava tube shatter rings and their correlation with lava flux increases at Kīlauea Volcano,Hawai‘i

Shatter rings are circular to elliptical volcanic features, typically tens of meters in diameter, which form over active lava tubes. They are typified by an upraised rim of blocky rubble and a central depression. Prior to this study, shatter rings had not been observed forming, and, thus, were interpreted in many ways. This paper describes the process of formation for shatter rings observed at Kīlauea Volcano during November 2005–July 2006. During this period, tilt data, time-lapse images, and field observations showed that episodic tilt changes at the nearby Pu‘u ‘Ō‘ō cone, the shallow magmatic source reservoir, were directly related to fluctuations in the level of lava in the active lava tube, with periods of deflation at Pu‘u ‘Ō‘ō correlating with increases in the level of the lava stream surface. Increases in lava level are interpreted as increases in lava flux, and were coincident with lava breakouts from shatter rings constructed over the lava tube. The repetitive behavior of the lava flux changes, inferred from the nearly continuous tilt oscillations, suggests that shatter rings form from the repeated rise and fall of a portion of a lava tube roof. The locations of shatter rings along the active lava tube suggest that they form where there is an abrupt decrease in flow velocity through the tube, e.g., large increase in tube width, abrupt decrease in tube slope, and (or) sudden change in tube direction. To conserve volume, this necessitates an abrupt increase in lava stream depth and causes over-pressurization of the tube. More than a hundred shatter rings have been identified on volcanoes on Hawai‘i and Maui, and dozens have been reported from basaltic lava fields in Iceland, Australia, Italy, Samoa, and the mainland United States. A quick study of other basaltic lava fields worldwide, using freely available satellite imagery, suggests that they might be even more common than previously thought. If so, this confirms that episodic fluctuation in lava effusion rate is a relatively common process at basaltic volcanoes, and that the presence of shatter rings in prehistoric lava flow fields can be used as evidence that such fluctuations have occurred.