Effect of particle density and inflow concentration of suspended sediment on bedload transport in rill flow

Laboratory flume experiments were carried out to evaluate the effect of particle density on bedload transport of sand‐sized particles and the effect of a suspended load of clay particles (kaolinite) on bedload transport of sand‐sized particles in rill flow conditions. Three materials in the range 400–600 µm were selected to simulate bedload transport of primary particles and aggregates: sand (2650 kg/m³), crushed brick (2450 kg/m³) and anthracite (1300–1700 kg/m³). In the two first experiments, two different methods were applied to determine bedload transport capacity of coarse particles for various conditions of flow discharge (from 2 to 15 L/min) and slope (2.2, 3 and 4%). In the third experiment, clear water was replaced with kaolinite–water mixture and bedload transport capacity of crushed brick particles was determined for a 4% slope and different concentrations of kaolinite (0, 7, 41 and 84 g/L). The results showed that bedload transport increased significantly with the decrease in particle density but the effect of particle density on transport rates was much less important than flow discharge. Velocity measurements of clear flow, flow mixed with coarse particles and coarse particles confirmed the existence of a differentiation between suspended load and bedload. In these experimental conditions, suspended load of kaolinite did not affect bedload rates of crushed brick particles. Three transport capacity formulae were tested against observed bedload rates. A calibration of the Foster formula revealed that the shear stress exponent should be greater than 1.5. The Low and the Govers unit stream power (USP) equations were then evaluated. The Low equation was preferred for the prediction of bedload rates of primary particles but it was not recommended in the case of aggregates of low density because of the limited experimental conditions applied to derive this equation. Copyright © 2008 John Wiley & Sons, Ltd.     

Contrasting regional discharge evolutions in the Amazon basin (1974–2004)

Former hydrological studies in the Amazon Basin generally describe annual discharge variability on the main stem. However, the downstream Amazon River only represents the mean state of the Amazonian hydrological system. This study therefore uses a new data set including daily discharge in 18 sub-basins to analyze the variability of regional extremes in the Amazon basin, after recalling the diversity of the hydrological annual cycles within the Amazon basin. Several statistical tests are applied in order to detect trends and breaks in the time series. We show that during the 1974–2004 period, the stability of the mean discharge on the main stem in Óbidos is explained by opposite regional features that principally involve Andean rivers: a decrease in the low stage runoff, particularly important in the southern regions, and an increase in the high stage runoff in the northwestern region. Both features are observed from the beginning of the nineties. These features are also observed in smaller meridian sub-basins in Peru and Bolivia. Moreover we show that the changes in discharge extremes are related to the regional pluriannual rainfall variability and the associated atmospheric circulation as well as to tropical large-scale climatic indicators.     

Deterministic sensitivity analysis for a model for flow in porous media

A deterministic method for sensitivity analysis is developed and applied to a mathematical model for the simulation of flow in porous media. The method is based on the singular value decomposition (SVD) of the Jacobian matrix of the model. It is a local approach to sensitivity analysis providing a hierarchical classification of the directions in both the input space and of those in the output space reflecting the degree of sensitiveness of the latter to the former. Its low computational cost, in comparison with that of statistical approaches, allows the study of the variability of the results of the sensitivity analysis due to the variations of the input parameters of the model, and thus it can provide a quality criterion for the validity of more classical probabilistic global approaches. For the example treated here, however, this variability is weak, and deterministic and statistical methods yield similar sensitivity results.     

Estimating suspended sediment concentrations from turbidity measurements and the calibration problem

In situ turbidity meters are being increasingly used to generate continuous records of suspended sediment concentration in rivers. However, the usefulness of the information obtained depends heavily on the existence of a close relationship between fluctuations in suspended sediment concentration and turbidity and the calibration procedure that relates suspended sediment concentration to the turbidity meter's signal. This study assesses the relationship between suspended sediment concentration and turbidity for a small (1·19 km²) rural catchment in southern Brazil and evaluates two calibration methods by comparing the estimates of suspended sediment concentration obtained from the calibrated turbidity readings with direct measurements obtained using a USDH 48 suspended sediment sampler. With the first calibration method, the calibration relationship is derived by relating the turbidity readings to simultaneous measurements of concentration obtained from suspended sediment samples collected from the vicinity of the turbidity probe during flood events. With the second method, the calibration is based on the readings obtained from the turbidity meter when the probe immersed in samples of known concentration prepared using soils collected from the catchment. Overall, there was a close link between fluctuations in suspended sediment concentration and turbidity in the stream at the outlet of the catchment, and the estimates of sediment concentration obtained using the first calibration method corresponded closely with the conventionally measured sediment concentrations. However, use of the second calibration method introduced appreciable errors. When the estimated sediment concentrations were compared with the measured values, the mean errors were ± 122 mg l^?1 and + 601 mg l^?1 for the first and second calibration procedures respectively. Copyright © 2007 John Wiley & Sons, Ltd.     

Bacterial dominance of phototrophic communities in a High Arctic lake and its implications for paleoclimate analysis

The phototrophic communities in meromictic, perennially ice-covered Lake A, on Ellesmere Island in the Canadian High Arctic, were characterized by pigment analysis using high performance liquid chromatography. Samples were taken to determine the vertical changes down the water column as well as a variation between years. These analyses showed that Lake A had distinct phototrophic communities in its oxic and anoxic layers. The pigment analyses indicated that phototrophic biomass in the upper, oxic waters was dominated by picocyanobacteria, while in the lower, anoxic layer photosynthetic green sulphur bacteria were dominant. Interannual variation in pigment concentrations was related to the penetration of photosynthetically active radiation in the water column, suggesting that light availability may be limiting the net accumulation of photosynthetic bacterial biomass in Lake A. Pigment analysis of the surface sediments indicated that deposition was dominated by the photosynthetic sulphur bacterial contribution. The sedimentary record of bacterial pigments in polar meromictic lakes offers a promising tool for the reconstruction of past changes in ice cover and therefore in climate.     

Late-Holocene equatorial environments inferred from deposition processes,carbon isotopes of organic matter,and pollen in three shallow lakes of Gabon,west-central Africa

Seven vibro-cores were collected from three shallow lakes of the Gabon (Kamalété, Nguène, Maridor) along a 300-km west–east transect close to the Equator. These lakes are located in very distinct landscapes: coastal forest-savanna mosaic, rain forest and savanna with colonising forest, respectively. Core chronologies were established by radiocarbon dating. Study of these lacustrine archives (textural variables, clay minerals, organic matter components, δ¹³C, pollen) allowed comparison of late Holocene environmental changes recorded at each site and with results from other studies. Lake Kamalété indicates minor climatic deterioration (increased drying and greater seasonality) between 1,410 and 500 cal. years BP, which is also recognised in southern Cameroon and east-central Africa. Lake Nguène was surrounded by dense moist forest throughout the last 4,110 years, but shows significant deterioration from ~2,800 cal. years BP, a phenomenon seen at nearby sites. Lake Maridor shows a decline of forest initiated a little after 3,800 cal. years BP, which indicates timing that is distinct from the two other sites. This was probably a response to local conditions (i.e. outlet damming). Although the three lakes display generally parallel climatic trends perhaps linked to SST oscillations, there is not perfect coherence between these three sites. Differences among the three basins may be attributable to local factors like groundwater hydrology and slope instabilities of such shallow lake systems in this equatorial region.     

Evolution of the late Pleistocene Mojanda–Fuya Fuya volcanic complex (Ecuador), by progressive adakitic involvement in mantle magma sources

The Mojanda–Fuya Fuya Volcanic Complex consists of two nearby volcanoes, Mojanda and Fuya Fuya. The older one, Mojanda volcano (0.6 to 0.2 Ma), was first constructed by andesites and high-silica andesites forming a large stratovolcano (Lower Mojanda). This edifice was capped by a basaltic andesite and andesitic cone (Upper Mojanda), which collapsed later to form a 3-km-wide summit caldera, after large phreatomagmatic eruptions. The Lower Fuya Fuya edifice was constructed by the extrusion of viscous Si-rich andesitic lavas and dacitic domes, and the emission of a thick sequence of pyroclastic-flow and fallout deposits which include two voluminous rhyolitic layers. An intermediate construction phase at Fuya Fuya is represented by a mainly effusive cone, andesitic in composition (San Bartolo edifice), the construction of which was interrupted by a major sector collapse in the Late Pleistocene. Finally, a complex of thick siliceous lavas and domes was emplaced within the avalanche amphitheatre, forming the Upper Fuya Fuya volcanic centre. This paper shows that the general evolution from an effusive to an explosive eruptive style is related to a progressive adakitic contribution to the magma source. Although all the rocks of the complex are included in the medium-K field of continental arcs, the Fuya Fuya suite (61–75 wt.% SiO₂) shows depletion in Y and HREE and high Sr/Y and La/Yb values, compared to the less silicic Mojanda suite (55–66.5 wt.% SiO₂). The Mojanda calc-alkaline suite was generated by partial melting of an adakite-metasomatised mantle source that left a residue with 2% garnet, followed by fractional crystallization of dominant plagioclase + pyroxene + olivine at shallow, intra-crustal depths. For Fuya Fuya, geochemical and mineralogical data suggest either (1) partial melting of a similar metasomatised mantle with more garnet in the residue (4%), followed by fractional crystallization involving plagioclase, amphibole and pyroxene, or (2) mixing of mafic mantle-derived magma from the Mojanda suite and slab melts, followed by the same fractional crystallization process.