The Equation of State for Caspian Sea Waters

The density ρ of Caspian Sea waters was measured as a function of temperature (273.15–343.15) K at conductivity salinities of 7.8 and 11.3 using the Anton-Paar Densitometer. Measurements were also made on one of the samples (S = 11.38) diluted with water as a function of temperature (T = 273.15–338.15 K) and salinity (2.5–11.3). These latter results have been used to develop an equation of state for the Caspian Sea (σ = ±0.007 kg m⁻³)

Shear wave velocity prediction using seismic attributes and well log data

Formation’s properties can be estimated indirectly using joint analysis of compressional and shear wave velocities. Shear wave data is not usually acquired during well logging, which is most likely for cost saving purposes. Even if shear data is available, the logging programs provide only sparsely sampled one-dimensional measurements: this information is inadequate to estimate reservoir rock properties. Thus, if the shear wave data can be obtained using seismic methods, the results can be used across the field to estimate reservoir properties. The aim of this paper is to use seismic attributes for prediction of shear wave velocity in a field located in southern part of Iran. Independent component analysis (ICA) was used to select the most relevant attributes to shear velocity data. Considering the nonlinear relationship between seismic attributes and shear wave velocity, multi-layer feed forward neural network was used for prediction of shear wave velocity and promising results were presented.     

Conceptual hydrosalinity model for prediction of salt load from wastewater flows into soil and ground water

Dynamic hydrosalinity models are available, but are not used extensively on a large scale soil which receives wastewater from industrial areas, partly because adequate database are expensive to be obtained. Thus, for this reason, there is an urgent need to assess the salt and other pollutant loads collected in wastewater flows into the soil and/ or ground water systems. A conceptual hydrosalinity model was used on two major underlying principals of mass balance and steady state. This model was initially tested on the 4,117 km² plains west of the Yazd-Ardakan district in the central part of Iran. This model was used at a time when the soil and ground water salinity problem was serious due to the high shortage of water. It was possible to calibrate the model with ± 2 % of the flow volume and total dissolved solids of the industrial wastewater discharge from over 2,000 factories. The verification results were 98 % of the measured values. Moreover, this model was tested for the verification of the model data from the analysis of 36 wells’ water in the area where industrial wastewater discharge was used. The results showed that most of the indices of total dissolved solids, total suspended solids, biological oxygen demand and chemical oxygen demand are above standard levels. The results of the model can be used for the management practice of the reduction of salt pollutant load in the area to achieve sustainable development for location of industries in the study area.     

The influence of preform on the modes of vibrating beams

A theoretical analysis is presented of a vibratory system in which it is possible to eliminate an unwanted mode of vibration by using that mode as an initial deformation of the system. The analysis shows that this is possible in straight beams with end restraints in axial deformation. The mathematical problem leads to an eigenvalue problem of a type not normally encountered. In the paper examples are given for the changes in eigenfrequency and mode shape produced by the initial preformed shape of the beam for cases where the preform is proportional to a mode of the straight beam and when the preform is unrelated to any mode. The analysis shows that, while elimination of a mode in the strict sense is not achieved, the results can be interpreted for practical purposes in this way.     

Drinking quality assessment of some groundwater sources along the stretch of Jhelum River in Kashmir Himalaya

The physicochemical properties and major ion chemistry of the groundwater sources from alluvial aquifers along the stretch (60 km) of Jhelum River in Kashmir Himalaya were determined in order to identify hydro-geochemical processes and their suitability for drinking purposes. The data depicted that calcium and bicarbonates were dominating among the cations and anions. The results indicate the trend of cation dominance as Ca²⁺ > Na⁺ > Mg²⁺ > K⁺, whereas anion dominance was in the order of HCO₃ ^? > Cl^? > SO₄ ^2?. Ratio of calcium to magnesium indicated the dissolution of Ca²⁺ from CaCO₃, which results in an increased levels of Ca²⁺ in the groundwater. Interpretation of Piper Trilinear plot understands the various geochemical processes affecting the groundwater quality and shows groundwater was dominated by Ca–HCO₃ type. The pH was recorded in the slightly alkalinity range 7.2–7.8 and was showing positive correlation with HCO₃ ^?. The chloro-alkaline indices revealed 86% of the sources exchange by a type of base-exchange reactions, rest by cation–anion exchange. Gibbs diagram revealed groundwater sources fall in the category of rock dominance. The concentration of the nitrogen compounds was in the progression of NO₃–N > NH₄–N > NO₂–N, and the PO₄ ^? fluctuated from 0.12 to 0.22 mg/L. Moreover, corrosivity ratio indicated that water from the majority of sources (71%) is safe to supply using pipes without any corrosive effects, while 29% of sources are corrosive in nature and need non-corrosive pipes for transporting and lifting of groundwater. The results revealed, groundwater samples were within permissible limits as prescribed by International and National standards, for drinking purposes. The State government and NGO’s can show their interest in utilizing such water resources to overcome the shortage of drinking water in a sustainable way for the daily consumption of the people living in the vicinity of Jhelum River.     

Modeling of thermal pollution in coastal area and its economical and environmental assessment

The Persian Gulf is one of the aquatic ecosystems which has recently faced with different pollutions. Cooling water discharges due to various industries such as power plants can cause important disorders on present ecosystem balance because of its high temperature. Obviously, due to thermal pollution, a great number of aquatic creatures face with a new situation that they can not tolerate. Thermal pollution leads to their migration, creates a potential for new coming species which in turn can thoroughly change the marine ecosystem feature. The other impacts of this phenomenon are: disorders in reproduction, nourishment and other biological habits. In this research, thermal pollution due to Bandar Abbas Thermal Power Plant (BATP) development plan was modeled using MIKE21 software. In order to avoid a decrease on the power plant efficiency in development plan, the distance between inlet and outlet was determined by comparing the results of different scenarios and economical aspects. After determining the distance between inlet and outlet, the water temperature in the coastal area was compared with standards of Iranian Department of the Environment (DOE). The model results represent that the water temperature, in Bandar Abbas coastal area, exceeds than the permissible limit (3 °C) in a distance equal to 200 m. far from the discharging location, and in order to reduce its harmful impacts, some suggestions are made to reduce the associated thermal pollution.     

Seismic hazard and probability assessment of Kashmir valley,northwest Himalaya,India

Seismic hazard analysis of the northwest Himalayan belt was carried out by using extreme value theory (EVT). The rate of seismicity (a value) and recurrence intervals with the given earthquake magnitude (b value) was calculated from the observed data using Gutenberg–Richter Law. The statistical evaluation of 12,125 events from 1902 to 2017 shows the increasing trend in their inter-arrival times. The frequency–magnitude relation exhibits a linear downslope trend with negative slope of 0.8277 and positive intercept of 4.6977. The empirical results showed that the annual risk probability of high magnitude earthquake M?≥?7.7 in 50 years is 88% with recurrence period of 47 years, probability of M?≤?7.5 in 50 years is 97% with recurrence period of 27 years, and probability of M?≤?6.5 in 50 years is 100% with recurrence period of 4 years. Kashmir valley, located in the NW Himalaya, encompasses a peculiar tectonic and structural setup. The patterns of the present and historical seismicity records of the valley suggest a long-term strain accumulation along NNW and SSE extensions with the decline in the seismic gap, posing a potential threat of earthquakes in the future. The Kashmir valley is characterized by the typical lithological, tectono-geomorphic, geotechnical, hydrogeological and socioeconomic settings that augment the earthquake vulnerability associated with the seismicity of the region. The cumulative impact of the various influencing parameters therefore exacerbates the seismic hazard risk of the valley to future earthquake events.