Improving a tree-ring reconstruction from west-central Scandinavia: 900?years of warm-season temperatures

Dendroclimatological sampling of Scots pine (Pinus sylvestris L.) has been made in the province of J?mtland, in the west-central Scandinavian mountains, since the 1970s. The tree-ring width (TRW) chronology spans several thousand years and has been used to reconstruct June?CAugust temperatures back to 1632 bc. A maximum latewood density (MXD) dataset, covering the period ad 1107?C1827 (with gap 1292?C1315) was presented in the 1980s by Fritz Schweingruber. Here we combine these historical MXD data with recently collected MXD data covering ad 1292?C2006 into a single reconstruction of April?CSeptember temperatures for the period ad 1107?C2006. Regional curve standardization (RCS) provides more low-frequency variability than ??non-RCS?? and stronger correlation with local seasonal temperatures (51% variance explained). The MXD chronology shows a stronger relationship with temperatures than the TRW data, but the two chronologies show similar multi-decadal variations back to ad 1500. According to the MXD chronology, the period since ad 1930 and around ad 1150?C1200 were the warmest during the last 900?years. Due to large uncertainties in the early part of the combined MXD chronology, it is not possible to conclude which period was the warmest. More sampling of trees growing near the tree-line is needed to further improve the MXD chronology.     

Thermally induced wind patterns in the Sahelian city of Ouagadougou, Burkina Faso

The urban surface wind field in the dry-tropical city of Ouagadougou, Burkina Faso was studied based on data collected at one urban and one suburban station during early dry season. An intra-urban thermal breeze, creating almost opposite wind directions at the two sites, was found during nights with high atmospheric stability. The high atmospheric stability suggests a decoupling of the surface wind layer from the layer above, allowing the wind system to develop due to the strong intra-urban temperature gradients in the city. Frequent temporary breakdowns of the thermal wind system were noticed, generally generating a turn in wind direction towards that of the regional wind, thus indicating a re-coupling with a stronger wind flow in the wind layer above.     

Modelling a cohesive‐frictional debris flow: an experimental,theoretical, and field‐based study

The rheology of debris flows is difficult to characterize owing to the varied composition and to the uneven distribution of the components that may range from clay to large boulders, in addition to water. Few studies have addressed debris flow rheology from observational, experimental, and theoretical viewpoints in conjunction. We present a coupled rheological‐numerical model to characterize the debris flows in which cohesive and frictional materials are both present. As a first step, we consider small‐scale artificial debris flows in a flume with variable percentages of clay versus sand, and measure separately the rheological properties of sand–clay mixtures. A comparison with the predictions of a modified version of the numerical model BING shows a reasonable agreement between measurements and simulations. As application to a field case, we analyse a recent debris flow that occurred in Fjærland (Western Norway) for which much information is now available. The event was caused by a glacial lake outburst flood (GLOF) originating from the failure of a moraine ridge. In a previous contribution (Breien et al., Landslides, 2008 , 5: 271–280) we focused on the hydrological and geomorphological aspects. In particular we documented the marked erosion and reported the change in sediment transport during the event. In contrast to the laboratory debris flows, the presence of large boulders and the higher normal pressure inside the natural debris flow requires the introduction of a novel rheological model that distinguishes between mud‐to–clast supported material. We present simulations with a modified BING model with the new cohesive‐frictional rheology. To account for the severe erosion operated by the debris flow on the colluvial deposits of Fjærland, we also suggest a simple model for erosion and bulking along the slope path. Numerical simulations suggest that a self‐sustaining mechanism could partly explain the extreme growth of debris flows running on a soft terrain.     

Bifurcation of the Pacific North Equatorial Current in a wind-driven model: response to climatological winds

The sensitivity of the bifurcation of the North Equatorial Current in the Pacific to different wind products is investigated. Variations of the bifurcation latitude with season is simulated in a purely wind-driven model and is found to be in agreement with recent observations. The seasonal cycle is nearly independent of the wind climatology, but the annual average latitude depends on the wind stress curl. It is also shown that in the upper ocean, the poleward shift in bifurcation latitude with depth is realistic in our simple model. This implies that given a stratification close to the observed, it is primarily the wind forcing that determines the location of the bifurcation and its seasonal variation.     

Modeling and observations of high-frequency flow variability and internal waves at a Caribbean reef spawning aggregation site

The characteristics and forcing mechanisms of high-frequency flow variations (periods of minutes to days) were investigated near Gladden Spit, a reef promontory off the coast of Belize. Direct field observations and a high-resolution (50-m grid size) numerical ocean model are used to describe the flow variations that impact the initial dispersion of eggs and larvae from this site, which serves as a spawning aggregation site for many species of reef fishes. Idealized sensitivity model experiments isolate the role of various processes, such as internal waves, wind, tides, and large-scale flow variations. The acute horizontal curvature and steep topography of the reef intensify the flow, create small-scale convergence and divergence zones, and excite high-frequency oscillations and internal waves. Although the tides in this area are relatively small (∼10-cm amplitude), the model simulations show that tides can excite significant high-frequency flow variations near the reef, which suggests that the preference of fish to aggregate and spawn in the days following the time of full moon may not be coincidental. Even small variations in remote flows (2–5 cm s⁻¹) due to say, meso-scale eddies, are enough to excite near-reef oscillations. Model simulations and the observations further suggest that the spawning site at the tip of the reef provides initial strong dispersion for eggs, but then the combined influence of the along-isobath flow and the westward wind will transport the eggs and larvae downstream of Gladden Spit toward less turbulent region, which may contribute to enhanced larval survival.     

Mechanical compaction and ultrasonic velocity of sands with different texture and mineralogical composition

This study presents the results of experimental compaction while measuring ultrasonic velocities of sands with different grain size, shape, sorting and mineralogy. Uniaxial mechanical compaction tests up to a maximum of 50 MPa effective stress were performed on 29 dry sand aggregates derived from eight different sands to measure the rock properties. A good agreement was found between the Gassmann saturated bulk moduli of dry and brine saturated tests of selected sands. Sand samples with poor sorting showed low initial porosity while sands with high grain angularity had high initial porosity. The sand compaction tests showed that at a given stress well‐sorted, coarse‐grained sands were more compressible and had higher velocities (Vp and Vs) than fine‐grained sands when the mineralogy was similar. This can be attributed to grain crushing, where coarser grains lead to high compressibility and large grain‐to‐grain contact areas result in high velocities. At medium to high stresses the angular coarse to medium grained sands (both sorted sands and un‐sorted whole sands) showed high compaction and velocities (Vp and Vs). The small grain‐to‐grain contact areas promote higher deformation at grain contacts, more crushing and increased porosity loss resulting in high velocities. Compaction and velocities (Vp and Vs) increased with decreasing sorting in sands. However, at the same porosity, the velocities in whole sands were slightly lower than in the well‐sorted sands indicating the presence of loose smaller grains in‐between the framework grains. Quartz‐poor sands (containing less than 55% quartz) showed higher velocities (Vp and Vs) compared to that of quartz‐rich sands. This could be the result of sintering and enlargement of grain contacts of ductile mineral grains in the quartz‐poor sands increasing the effective bulk and shear stiffness. Tests both from wet measurements and Gassmann brine substitution showed a decreasing Vp/Vs ratio with increasing effective stress. The quartz‐rich sands separated out towards the higher side of the Vp/Vs range. The Gassmann brine substituted Vp and Vs plotted against effective stress provide a measure of the expected velocity range to be found in these and similar sands during mechanical compaction. Deviations of actual well log data from experimental data may indicate uplift, the presence of hydrocarbon, overpressure and/or cementation. Data from this study may help to model velocity‐depth trends and to improve the characterization of reservoir sands from well log data in a low temperature (<80–100^o C) zone where compaction of sands is mostly mechanical.     

First- and second-order adaptation to natural hazards and extreme events in the context of climate change

This paper deals with coping and adaptation processes to natural hazards and (potential) climate change impacts. Selected response measures to natural hazards are critically reviewed with respect to the actual and potential consequences that these measures might imply for additional adaptation needs and changes within social-ecological systems. In this context, the author introduces the concept of first- and second-order adaptation processes in order to underline the cascade process that adaptation implies, the potentials for failure, and the limits of adaptation. Important aspects of first- and second-order adaptation processes as well as the issue of the limits of adaptation are illustrated based on observations and empirical work conducted in Vietnam. In its final part, the paper discusses the findings in light of selected theoretical approaches that might help to understand how stabilization and destabilization processes are influenced or even triggered by adaptation measures.     

Conservation planning, boundary-making and border terrains: The desire for forest and order in the Gran Sabana, Venezuela

Conflicts surrounding protected area management often emerge from contested processes of boundary-making. Such productions of bounded conservation spaces are contingent in part on processes of identity formation, where some social groups are legitimized as belonging to conservation units, while others are constructed as out-of-place. This article draws on the literature in postmodern geopolitics and the political ecology of fire to interrogate processes of boundary-making and identity formation in the savanna landscape of Canaima National Park, Venezuela. The institutional culture of the environmental management agency EDELCA is in part premised on narratives of history and indigeneity coupled with a desire for an imagined, forested landscape. Because of the social constructions shaping this institutional culture, the agency maintains an approach to fire management that emphasizes fire suppression. However, an ecological field study suggests that fire suppression is leading to increased fuel loads, especially in ecologically significant boundaries between grasslands and forest. Although these boundary zones are the focus of indigenous practices of prescribed burning, they fall in-between the state management categories of forest and ecotone. As a result, these interstitial spaces become theaters for performances of domination and resistance, leading to contradictory and inconsistent approaches to fire management that place gallery forests at risk.     

Experimental study of the carbonation of partially serpentinized and weathered peridotites

Carbonation of partially serpentinized and weathered peridotites was studied experimentally under hydrothermal conditions (T: 200 °C, P_CO2: 130-180 bars). Experiments were performed in a closed system using whole rock drill core samples (height: 1 cm, diameter: 1 cm) as starting material. The initial samples were composed mainly of meshwork serpentine, relicts of primary olivine and an olivine weathering product (deweylite assemblage). Two types of solutions, each with a total salt content corresponding to that of average seawater (35 g/L dissolved salts), were used: (1) a Na-Ca-Cl solution (12.5 g/L CaCl₂ + 22.5 g/L NaCl) and (2) a NaCl solution (35 g/L NaCl). After 15-25 days of experimental treatment, the samples were partly covered with carbonates. In addition, noticeable carbonation reactions had occurred below the sample surfaces within zones with thicknesses up to 250 μm. In the Na-Ca-Cl solution, both the olivine relicts and the deweylite assemblage were partly replaced by calcite along the surrounding serpentine veins. However, the extent of calcitization was found to be considerably larger for the deweylite assemblage than for the olivine. Bulk fluid analyses show an increase in the Mg and Si concentrations with reaction time. In the NaCl solution, the deweylite assemblage was partly dissolved resulting in large voids within the reaction zone. In contrast, the olivine was replaced by magnesite. Under the conditions of our experiments, the meshwork serpentine was not reactive, but aided fluid infiltration into the rock samples. The experimentally produced microtextures closely resemble those found in natural examples. Our study elucidates the mechanisms by which carbonates form in ultramafic rocks under relatively high P_CO2-T conditions and particularly in the presence of Ca-bearing aqueous solutions. The existence of a serpentine meshtexture and the presence of weathering products formed from primary Mg-silicates may have significant beneficial effects on in situ CO₂ mineral sequestration in ultramafic rocks.