A New Equation for the Shear Strength of Cable Bolts Incorporating the Energy Balance Theory

The application of cable bolts as a secondary support system is an increasing trend in underground coal mines worldwide. The performances of cable bolts have been evaluated under both axial and shear loading conditions. Two methods of testing cables for shear, single and double shear, have been recognised. This paper examines the shear behaviour of a variety of cable bolts under different pre-tension loads by double shear testing. Plain, spiral and the combination of both cable types were used in this study. The initial axial load and the type of cable bolts are the main factors affecting their shear strength. By increasing the axial pre-tension load, the peak shear load occurs at lower shear displacement. The failure angle due to cable bending across the joint at different pre-tension loads varied between 41° and 49°. This demonstrates that the ratio of axial and perpendicular displacements is almost constant and on average the failure occurs at about 45°. A novel analytical model is proposed to evaluate the shear behaviour of pre-tensioned fully grouted cable bolts subjected to double shearing. Energy and Fourier Series methods were incorporated in the model to simulate the shear behaviour of cable bolts. The comparison of the experimental results with the proposed model shows a good agreement.     

Phases of the Fe–C–N system as hosts of mantle carbon and nitrogen: Experimental studies at 7.8 GPa and 1350°C

Parts of the Fe–C–N system were studied in experiments at 7.8 GPa and 1350°C. It was shown that the admixture of nitrogen extends considerably the domain of melt stability in the system at temperatures close to the Fe–Fe₃C eutectic temperatures. Nitrogen solubility in cementite in equilibrium with the nitrogen- rich melt is below the detection limit of the EMPA technique applied. The metal melt is the only nitrogen concentrator (up to 4 wt % of N) in the range of compositions considered. The data obtained permit the conclusion that, in the case of complete dissolution of carbon and nitrogen, which might occur in the enriched mantle, native iron at ~250 km depth should either be completely molten or consist of a melt and carbide of iron.     

用Rayleigh面波方位各向异性研究中国大陆岩石圈形变特征

中国大陆地质构造历史非常复杂,岩石圈长期积累的形变较大,而利用地震面波传播的各向异性是研究岩石圈形变特征的强有力手段. 本文利用双台窄带通滤波-互相关方法与基于图像分析的相速度频散曲线提取技术,提取Rayleigh面波相速度频散资料,进而反演中国大陆及邻区20～120 s周期Rayleigh面波相速度方位各向异性空间分布图像. 检测板测试结果显示：中国大陆大部分区域的方位各向异性横向分辨率在5°左右. 各向异性研究结果表明：中国大陆地壳上地幔方位各向异性特征存在显著的空间差异,反映出形变特征的空间差异;104°E以东地区地壳上地幔各向异性弱于西部地区,表明其构造变形总体弱于西部地区. 青藏地块及其东缘地区地壳与上地幔顶部变形最为强烈. 但东部的局部地区如华南地块与珠江口地区、鄂尔多斯盆地西南缘以及秦岭-大别造山带,较强的各向异性显示这些区域在不同时期也经历了强变形. 青藏地块内中短周期快波方向自西向东顺时针旋转变化可能指示板块碰撞与挤压过程中软弱物质的流变方向. 青藏地块西部中下地壳和上地幔形变模式相似,可能处于壳幔耦合状态;而中东部及东缘地区地壳上地幔形变模式存在明显差异,壳幔似乎不具备垂直连贯的形变特征. 位于青藏地块北部的塔里木盆地、柴达木盆地以及祁连褶皱带同样经历了强变形. 包括四川盆地在内的上扬子地块快波方向的变化显示中地壳与下地壳上地幔形变模式不同,而形变特征一致的下地壳与上地幔应为强耦合. 大约以103°E为界,龙门山断裂带可分为南西段和北东段,南西段处于低速区,而北东段位于高速区,且方位各向异性强度明显大于南西段;2008年5月12日汶川M_S8.0级地震沿断裂带的单侧破裂模式除与北东段的高应力积累有关外,还可能与北东段地下介质物性存在密切关系,高速坚硬岩体的发育有利于应变能的积累与集中释放.     

利用卫星长波长地球物理位场对东亚地区深部结构的研究

有研究表明从中国北部经黄海、朝鲜半岛、日本海至日本本州岛存在一个大型断裂带,被称为“北纬40°断裂带”.为了验证该断裂带的存在性,本文通过GRACE和CHAMP卫星的位场数据中的大尺度区域重力和磁力异常来研究该区的大型构造特征.区域性研究范围为24°N~56°N,90°E~150°E,详细研究范围为32°N~42°N,122°E~132°E.2008年Taylor等利用CHAMP卫星2005年6月至12月收集的轨道数据,从测量数据中消除地核和外部产生磁场效应,经化磁极之后得到磁异常图,从中来追踪构造特征,并根据地质和地球物理资料建立了数学模型来进行解释.本文在此基础上,增加了GRACE卫星2003年10月份测量的重力异常场数据.实测差分位场数据利用高斯-勒让德求积法转换为垂向重力异常值,通过减去最新地球重力场模型（EGM96）的场值来去除波长超过1100 km的长波长异常,所得的重力异常数据和磁场数据进行比较.为了能从中得到研究区的共同构造特征,建立一个球面棱柱模型进行正演模拟、并进行重、磁异常场的波数相关性分析.研究发现在重、磁异常中均发现一个呈负相关的纬向构造特征,东亚地区“北纬40°断裂带”横穿了整个朝鲜半岛.     

川西地区台阵环境噪声瑞利波相速度层析成像

2006年中国地震局地质研究所地震动力学国家重点实验室在川西地区(26°N~32°N,100°E~105°E)布设了由297台宽频带数字地震仪组成的流动观测台阵.利用该密集台阵29°N以北156个台站2007年1~12月份的地震环境噪声记录和互相关技术,我们得到了所有台站对的面波经验格林函数和瑞利波相速度频散曲线,并进一步反演得到了观测台阵下方2~35 s周期的瑞利波相速度分布图像．本文结果表明,观测台阵覆盖的川滇地块、松潘-甘孜地块和四川盆地的地壳速度结构存在显著差异,具体表现为：(1)短周期（2~8 s）相速度分布与地表构造特征相吻合,作为川滇地块、松潘-甘孜地块和四川盆地之间的边界断裂,龙门山断裂带和鲜水河断裂带对上述三个地块上地壳的速度结构具有明显的控制作用,四川盆地前陆低速特征表明相应区域存在较厚的（约10 km）沉积盖层;(2)中周期（12~18 s）相速度分布表明,川滇地块和松潘-甘孜地块中上地壳速度结构存在明显的不均匀横向变化,并形成了尺度不同且高、低速相间的分块结构,而四川盆地中地壳整体上已经表现出相对高速;(3)长周期（25~35 s）相速度分布表明,松潘-甘孜地块,特别是川滇地块中下地壳表现为广泛的明显低速异常,意味着它们的中下地壳相对软弱,而四川盆地的中下地壳呈现整体性的相对高速,意味着四川盆地具有相对坚硬的中下地壳,并且以汶川地震的震中为界,龙门山断裂带的地壳结构显示了北段为高速异常,南段为低速异常的分段特征．     

Evidence for low viscosity garnet-rich layers in the upper mantle

The rheological properties of upper mantle rocks play an important role in controlling the dynamics of the lithosphere and mantle convection. Experimental studies and microstructures in naturally deformed mantle rocks usually imply that olivine controls the upper mantle rheology. Here we show for the first time evidence from the geometry of folded compositional layers in mantle rocks from Western Norway that garnet-rich rocks can have lower solid-state viscosities than olivine-rich rocks. Modeling of melt-free and dry rheology of garnet and olivine confirms that the reversed viscosity contrast between garnet-rich and olivine-rich layers for this folding event can be achieved over a relatively wide range of temperatures at low stress conditions when the fine-grained garnet deforms by diffusion creep while the coarse-grained olivine deforms by dislocation creep and/or diffusion creep.In general, modeling of the fold viscosity contrast shows that in the stable subcontinental lithospheric mantle or convecting mantle such a reversed viscosity contrast can be formed due to diffusion creep processes in fine-grained garnets in a dry mantle environment or at conditions where the garnet-pyroxene layer is partially molten, i.e. close to solidus–liquidus conditions in the upper mantle. Alternatively in cold plate tectonic settings, e.g. in subduction zones, some water-weakening is a feasible mechanism to create the reversed viscosity contrast between garnet and olivine.     

Seismic interferometry,intrinsic losses and Q‐estimation*

Seismic interferometry is the process of generating new seismic traces from the cross‐correlation, convolution or deconvolution of existing traces. One of the starting assumptions for deriving the representations for seismic interferometry by cross‐correlation is that there is no intrinsic loss in the medium where the recordings are performed. In practice, this condition is not always met. Here, we investigate the effect of intrinsic losses in the medium on the results retrieved from seismic interferometry by cross‐correlation. First, we show results from a laboratory experiment in a homogeneous sand chamber with strong losses. Then, using numerical modelling results, we show that in the case of a lossy medium ghost reflections will appear in the cross‐correlation result when internal multiple scattering occurs. We also show that if a loss compensation is applied to the traces to be correlated, these ghosts in the retrieved result can be weakened, can disappear, or can reverse their polarity. This compensation process can be used to estimate the quality factor in the medium.     

Long-term changes in coral assemblages under natural and anthropogenic stress in Jakarta Bay (1920-2005)

Coral reefs in Jakarta Bay have been subjected to scientific studies since the 1920s. Also from that time on biological collections were made. The reefs in the Jakarta Bay have been under long-term natural and anthropogenic stress. With the biological collections and historical documents the coral species richness in Jakarta Bay around 1920 was reconstructed. New data from this bay and the adjacent offshore Thousand Islands archipelago were obtained during a 2005 research expedition. A comparison of the coral assemblages between 1920 and 2005 reveals a clear decline in species numbers. The most prominent results include the near-shore disappearance of species belonging to the families Acroporidae, Milleporidae, and to a lesser extent Poritidae. The overall coral species composition of the reefs has changed considerably, which is partly reflected in a strong decline in coral species richness. About half the number of species recorded in 1920 was found again in 2005.     

Flood effects on phosphorus immobilisation in a river water filled pit lake—Case study Lake Goitsche (Germany)

Between 1999 and 2002, a former open-cast mine was filled with river water forming the recent Lake Goitsche. During filling initially acid water was neutralised. Phosphorus (P) imported from Mulde River was nearly completely removed from the water column by co-precipitation with iron (Fe) and aluminium (Al) and deposited in the sediment.During extremely high waters of the Mulde River in 2002, a dike breach facilitated a second high import of P into Lake Goitsche with suspended and dissolved matter. The analysis of total phosphorus (TP), however, showed that P again had been eliminated from the water body a few months after the flood event. Sediment investigations before filling with river water, during filling, and after the flood event were used to analyse the process of P immobilisation in a lake with acid mine drainage history.The ratios of Fe to soluble reactive P (SRP) of sediment pore water were up to three orders of magnitudes higher than in natural lakes and can serve as an indicator for potential internal P loading from sediments. The SRP concentrations at the oxic/anoxic boundary were near or below the limit of quantification (< 0.2 μmol/L). Fe and manganese (Mn) redox cycling were responsible for hindering P dissolution from sediment to lake water.Finally it can be stated, that the risk of eutrophication for such a lake seems to be low.