On the origin of rock fragment mulches on Vertisols: A case study from the Ethiopian highlands

Many Vertisols in Tigray, Ethiopia, typically carry a discontinuous rock fragment (RF, size 0.5–> 40 · 10^− 2 m) cover with 10 to 100 RFs m^− 2. Such RF mulches are of agricultural and environmental significance because they influence the water balance in the underlying soils and the crop yield. Natural RF concentrations are mostly considered as eolian or hydraulic lag deposits, or as the result of lateral transport over the soil surface from a rock outcrop, upslope. In cultivated areas RF mulches can develop by tillage.This paper presents the case of a natural RF mulch whose lithology indicates that the RFs are up-squeezed by the local Vertisol. The study site is located in the pass of Enda Maryam, Tigray, Northern Ethiopia (39°8′ E and 13°36′ N). A circular area of 10 m diameter, about 200 m away from the water divide in the valley has been cleared annually between 01/1999 and 05/2003. During this period, 625 RFs, 17 being > 7.5 · 10^− 2 m in size, totalling a mass of nearly 62 kg, have been collected. After correction for measurement procedures, the rate of RF up-warping by the Vertisol at Enda Maryam is assessed at 5 RFs m^− 2 in 3 years. At this rate of appearance, the formation of current RF concentrations on top of active valley Vertisols is only a matter of 10^1–2 years, provided the availability of RFs below the soil surface.Although important underground displacements were measured in the Vertisol between 01/1999 and 05/2002, the supposed link between up-squeezing of RFs and plastic deformations of ‘chimney’, ‘diapir’ or ‘intrusion’-like type in the Vertisol could not be evidenced. Instead, RFs are clearly concentrated on the soil surface as well as in depth, along the existing vertical desiccation cracks, often > 1 m deep which display polygonal configurations at the soil surface. Further, bundles of slickensides containing some RFs, have been mapped at the base of the Vertisol. The slickenside configuration suggests that the RF-bearing substrate is being scraped off.While the underground displacement of RFs along active slickensides seems normal, the process of RFs ascending in ‘upright’ position in the edge of desiccation cracks needs explanation. The closure of a desiccation crack is a peristaltic-like movement, following ascent or descent of the capillary fringe. It is hypothesized that this movement gradually pushes the RF to the surface or to another place or level in the soil profile where the crack closes in last instance.The apparent young age of the valley Vertisol mulches in Ethiopia might indicate the very recent formation of yearly recurrent desiccation cracks of Vertisols in the area. Available information confirms that most valleys in the study area used to be perennially marshy. Under these conditions no movements of RFs in the soil profile are expected to occur. Gullying, leading to pronounced seasonal desiccation of the Vertisols, started in several cases not more than 50 years ago.     

Quantification of karst aquifer discharge components during storm events through end-member mixing analysis using natural chemistry and stable isotopes as tracers

Karst aquifer components that contribute to the discharge of a water supply well in the Classical Karst (Kras) region (Italy/Slovenia) were quantitatively estimated during storm events. Results show that water released from storage within the epikarst may comprise as much as two-thirds of conduit flow in a karst aquifer following rainfall. Principal components analysis (PCA) and end-member mixing analysis (EMMA) were performed using major ion chemistry and the stable isotopes of water (δ¹⁸O, δ²H) and of dissolved inorganic carbon (δ¹³C_DIC) to estimate mixing proportions among three sources: (1) allogenic river recharge, (2) autogenic recharge, and (3) an anthropogenic component stored within the epikarst. The sinking river most influences the chemical composition of the water-supply well under low-flow conditions; however, this proportion changes rapidly during recharge events. Autogenic recharge water, released from shallow storage in the epikarst, displaces the river water and is observed at the well within hours after the onset of precipitation. The autogenic recharge end member is the second largest component of the well chemistry, and its contribution increases with higher flow. An anthropogenic component derived from epikarstic storage also impacts the well under conditions of elevated hydraulic head, accounting for the majority of the chemical response at the well during the wettest conditions.     

Geometry and accuracy of reflecting points in bistatic satellite altimetry

The analysis of the time and space distribution of specular (reflecting) points in bistatic altimetry between GPS and CHAMP satellites or SAC-C (taken as examples) is extended from Wagner and Klokočník (2003 J. Geod 77: 128–138). We demonstrate a significantly higher number and density of reflecting points in bistatic altimetry in comparison with traditional monostatic altimetry. After an outline of our older accuracy assessment for the vertical position of the reflecting point, we add a new independent derivation and compare both approaches. We account for orbit errors of both the transmitters (GPS) and receiver (CHAMP) satellites, and the measurement (delay) error. We found that the accuracy of the vertical position of the reflecting point decreases only slowly with increasing off-nadir angle and that the orbit errors must be accounted for if decimeter and better accuracy is required. In this paper, we do not study errors such as state of the ocean, technical parameters of the receiving system, and atmospheric corrections.     

石河子地区降水资源分析

分析了石河子地区位于不同海拔高度的3个观测站的降水资料，结果表明，石河子地区各地降水量分布不均，石河子年降水量最多，其次是炮台，最少是莫索湾。3站季节变化一致，均以春夏季降水量居多，约占全年63％，冬季降水量最少，约占全年的13％。降水量年际变化一致，70年代降水量偏少，80年代以后降水量偏多。出现丰水年和干旱年的降水趋势一致，且出现丰水或干旱时大面积发生的机率较大。     

Thermal expansion and crystal structure of FeSi between 4 and 1173 K determined by time-of-flight neutron powder diffraction

The thermal expansion and crystal structure of FeSi has been determined by neutron powder diffraction between 4 and 1173?K. No evidence was seen of any structural or magnetic transitions at low temperatures. The average volumetric thermal expansion coefficient above room temperature was found to be 4.85(5)?×?10^?5?K^?1. The cell volume was fitted over the complete temperature range using Grüneisen approximations to the zero pressure equation of state, with the internal energy calculated via a Debye model; a Grüneisen second-order approximation gave the following parameters: θ_D=445(11)?K, V ₀=89.596(8)?ų, K ₀′=4.4(4) and γ′=2.33(3), where θ_D is the Debye temperature, V ₀ is V at T=0?K, K ₀′ is the first derivative with respect to pressure of the incompressibility and γ′ is a Grüneisen parameter. The thermodynamic Grüneisen parameter, γ_th, has been calculated from experimental data in the range 4–400?K. The crystal structure was found to be almost invariant with temperature. The thermal vibrations of the Fe atoms are almost isotropic at all temperatures; those of the Si atoms become more anisotropic as the temperature increases.     

Petrology and geochemistry of orthoamphibolites from the Variscan metamorphic sequences of the South Tisia in Croatia – an overview with geodynamic implications

In the southern Pannonian Basin, the Variscan Barrovian- and overprinted Abukuma-type progressive metamorphic sequences of the South Tisia in Slavonian Mts. (SM) and Mt. Moslava)ka Gora (MG) are interlayered with orthoamphibolites. These sequences represent part of a disrupted Variscan belt that extends southeastwards of the Bohemian Massif through the Carpathians to the Caucasus. Orthoamphibolites contain hornblende (Mg-hornblende, tschermakite, pargasite, and edenite), plagioclase An_48-98 (MG) and An_26-35 (SM), biotite, grossular (MG) and almandine (SM) enriched garnet, diopside (MG), with accessory ilmenite, titanite, and clinozoisite. Based on major and trace element analyses and CIPW norms, these orthoamphibolites, which originally were olivine tholeiites to slightly alkalic basalts, can be correlated with tholeiites of consuming plate margins. '¹⁸O of orthoamphibolites varies from 5.8 to 7.1‰, the measured ⁸⁷Sr/⁸⁶Sr ratio from 0.70435 to 0.70665, which indicates slight continental crust contamination, and the calculated ratio from 0.70262 to 0.70535, indicating an upper mantle origin of the original basaltic melts. For associated penecontemporaneous I-type granitoids, the calculated initial ⁸⁷Sr/⁸⁶Sr ratio also have upper mantle values ranging between 0.70293 and 0.70368. Geochemical data for orthoamphibolites and the associated penecontemporaneous I-type granites, and the occurrence of alpine-type ultramafic bodies within the Barrovian sequence, indicate that they have many features in common with orogenic associations related to recent subduction-related settings. Some characteristic element ratios suggest back-arc basin environments and the Ce/K vs. Ce diagram suggests a pargasite-lherzolite source. Its partial melting gave primitive basaltic melts of olivine tholeiite to slight alkalic affinities that produced at first differentiated mafic rocks by olivine fractionation (future orthoamphibolites) and, afterwards, a strongly differentiated suite of I-type granitoids by amphibole fractionation. Magma emplacement and subsequent AFC processes took place in subduction environments preceding the main Variscan deformational metamorphic event during which orthoamphibolites were generated. This interpretation is compatible with geodynamic modeling of this part of the Paleotethys.     

Improved NMO correction with a specific application to shallow-seismic data

The application of traditional NMO‐correction techniques in the processing of seismic data may result in severe distortion. This distortion is observed as a decrease in frequency content (NMO stretch) or even a total loss of data for steep velocity gradients. It is shown that the specific nature of the observed distortion is introduced by the particular implementation of the traditional NMO‐correction technique. It is also shown that other techniques that have been proposed in the literature suffer from similar artefacts. An alternative approach is suggested, based on the correction of tapered blocks of seismic data, followed by a coherence filter to compensate for the specific artefacts thus introduced. Correction of seismic amplitudes (e.g. geometrical spreading and attenuation) is implemented as an integral part of the NMO‐correction method thus allowing for both dynamic and kinematic reconstruction of interfering events. From the application of this method to synthetic and field data, it is concluded that the proposed technique may be particularly useful in the processing of shallow seismic (shear‐wave) data. Although not illustrated in this paper, it is emphasized that application of the proposed method is by no means restricted to shear waves; application to P‐wave data will prove equally useful, although the stretch effects involved may not be as severe as in the examples given in this paper.