Interpretation of a special fine structure in type-IV solar radio bursts

A special fine structure (slowly drifting chains of narrowband fiber bursts), firstly observed during the solar type-IV radio burst on April 24, 1985, is interpreted as the radio signature of whistler waves periodically excited by a switch-on/switch-off process of a loss-cone instability in a localized wave packet of the fast magnetoacoustic mode.     

Coalification in Carboniferous sediments from the Lötschberg base tunnel

Vitrinite reflectance (Rr), proximate analysis and carbon isotope composition (δ¹³C) have been used to characterise coal samples from two zones of Late Carboniferous sediments (Gastern and Ferden) in the Aar massif where they are penetrated by the Lötschberg base tunnel (constructed between 1999 and 2005). Samples are characterised by variable ash yields (21.7–93.9%; dry basis); those with ash yields of less than ~50% and with volatile matter content (V;dry ash-free basis) within the limits 2 < V% ≤ 8 are anthracite. Values of Rr range from 3.89% to 5.17% and indicate coalification to the rank of anthracite and meta-anthracite in both Gastern and Ferden Carboniferous zones. Samples of anthracite and shale from the Gastern Carboniferous exhibit a relatively small range in δ¹³C values (–24.52‰ to –23.38‰; mean: –23.86‰) and are lighter than anthracite samples from the Ferden Carboniferous (mean: –22.20‰). The degree of coalification in the Gastern and Ferden Carboniferous zones primarily depends on the maximum rock temperature (T) attained as a result of burial heating. Vitrinite reflectance based estimates of T range from ~290° –360 °C. For a proposed palaeogeothemal gradient of 25 ° C/km at the time of maximum coalification the required overburden is attributable to relatively thin autochtonous Mesozoic/Cenozoic sedimentary cover of the Aar massif and Gastern granite and deep tectonic burial beneath advancing Helvetic, Ultrahelvetic and Prealpine (Penninic) nappes in Early Oligocene to Miocene.     

Global comparison of the regional rainfall results of enhanced greenhouse coupled and mixed layer ocean experiments: Implications for climate change scenario development

The extent of agreement amongst current global climate models (GCMs) on the global pattern of rainfall change simulated under enhanced greenhouse conditions is assessed. We consider the results of five experiments which use a simple mixed layer ocean formulation and five which use a fully dynamic ocean model (coupled experiments). For many regions of the northern hemisphere there is strong agreement amongst both mixed layer and coupled experiments on the sign of simulated rainfall change. However, in the southern hemisphere there are large, and apparently systematic, differences between the coupled and mixed layer experiments. In particular, whereas the mixed layer experiments agree on simulated rainfall increase in summer in the tropics and subtropics of the Australian sector, the coupled experiments agree (although more weakly) on rainfall decreases. These differences appear to relate to the much reduced warming simulated by the coupled experiments in the high latitudes of the southern hemisphere. However, recent oceanographie evidence suggests that this suppressed warming may be considerably overestimated. We conclude therefore that despite the in-principle advantages of coupled models, it may be too soon to base some regionally specific climate change scenarios solely on the results of coupled experiments.     

Fluid-rock interaction between syenites and marbles at Stephen Cross Quarry,Québec,Canada: petrological and stable isotope data

Grenville dolomitic marbles and calc-silicates at Stephen Cross Quarry, Québec, underwent contact metamorphism and metasomatism associated with the intrusion of the Wakefield syenite at ambient pressures of 0.4GPa at 1090–1070Ma. Fluid infiltration produced exoskarns, calcite+periclase+forsterite±diopside±orthoclase assemblages in the marbles, and quartz±calcite±wollastonite±diopside±anorthite assemblages in the calc-silicates. Phase-equilibria in the CaO–MgO–Al₂O₃–SiO₂–H₂O–CO₂ system suggest that fluid infiltration occurred close to the thermal peak of contact metamorphism (715–815°C) and that the fluids hadXCO₂0.15. In the metasediments, ¹⁸O values of calcite (Cc) are as low as 8.6, suggesting that the fluids were in isotopic equilibrium with the syenites (¹⁸O =8.8–10.2). Marble ¹³C(Cc) values are-0.1 to-3.2; the lack of correlation between ¹³C(Cc) and ¹⁸O(Cc) is consistent with the infiltration of water-rich fluids. The resetting of stable isotopes and the mineralogical changes can be explained by time-integrated fluid fluxes of up to 110 m³/m² (4×10⁶ mol/m²), corresponding to actual fluxes of 3×10^-11 to 3×10^-12 m³/m²-s and intrinsic permeabilities of 10^-18 to 10^-20 m² for fluid flow lasting 0.1-1Ma. Marble ¹⁸O(Cc) values do not correlate well with distance from the syenite, and fluids were probably channelled across lithological layering. The correlation between the degree of resetting of marble ¹⁸O(Cc) values with the abundance of submillimetre-wide veins, suggests that fluid focussing may have resulted from variations in fracture density. Late, lower temperature (<500°C), fluid flow formed serpentine (Serp) and brucite (Br) from periclase and forsterite. ¹⁸O(Br) and ¹⁸O(Scrp) values correlate with ¹⁸O(Cc), suggesting that retrogression involved only limited volumes of fluid. The observation that ¹⁸O(Cc-Br) and ¹⁸O(Cc-Serp) values are higher in marbles that have lower ¹⁸O(Cc) values is interpreted as indicating that fluid flow persisted to lower temperatures in those rocks due to higher intrinsic permeabilities. Calcite in the syenite was also formed by the influx of fluids during cooling. Syenite ¹⁸O(Cc) values are approximately in isotopic equilibrium with the high-temperature silicate minerals, suggesting that again only minor volumes of fluid were involved. In detail fluid flow was prolonged and complex, creating problems for the application of quantitative fluid flow models.This paper is a contribution to IGCP 304, Lower Crustal Processes     

Malta: macropolitical threats

Despite constitutional neutrality and non-alignment, for the last decade Malta has dabbled in Western security circles. By pledging commitment to the European CFSP and forging closer associations with NATO the government consummated allegiances with the hegemonic flank of their region and the only remaining superpower. However, Maltese security in the post-Cold War era is about more than just power fealty. Whilst not overlooking the still highly relevant military threats to security, this paper elucidates three macropolitical threats that are too impetuous for the worlds most powerful security organizations to handle. Indeed, future Maltese membership of the WEU or closer ties with NATO may even exacerbate these menaces.     

Observations of cosmic gamma-ray bursts

The occasional occurrence of brief but intense bursts of cosmic gamma-rays was disclosed through a systematic search of data acquired from the Vela satellites. Confirmation of the nature of the events and additional detail of their characteristics has subsequently been provided by 15 other groups of experimenters with instruments on 13 spacecraft. Thirty-nine such events have been identified from data spanning a period of four and a half years. The record of intensity as a function of time varies considerably for different events, with total durations ranging from 0.1 to 60s. Time-integrated flux density ranges from 10^–6 to 10^–3 erg cm^–2. Spectral measurements have been accomplished by several groups of experimenters, showing a broad maximum in the energy distribution at about 150 keV. The distribution of source directions implies either near galactic or extragalactic locations. The existing data are not sufficient to distinguish between the various models proposed to explain the phenomenon; no model is completely consistent with all observed characteristics.Work performed under the auspices of the United States Energy Research and Development Administration.Paper presented at the COSPAR Symposium on Fast Transients in X-and Gamma-Rays, held at Varna, Bulgaria, 29–31 May, 1975.     

Influence of oxygen fugacity on mineral compositions in peralkaline melts: The Katzenbuckel volcano, Southwest Germany

The igneous rocks of the Katzenbuckel, Southwest Germany, represent a unique and unusual alkaline to peralkaline association within the European Volcanic Province. The magmatic activity can be subdivided into two main phases. Phase I comprises the main rock bodies of phonolite and nepheline syenite, which were later intruded by different peralkaline dyke rocks (tinguaites and alkali feldspar syenite dykes) of phase II. The dyke assemblage was accompanied by magnetite and apatite veins and was followed by a late-stage pneumatolytic activity causing autometasomatic alterations.

As is typical for alkaline to peralkaline igneous rocks, early mafic minerals of phase I rocks comprise olivine, augite and Fe–Ti oxides, which are substituted in the course of fractionation by Na-amphibole and Na-pyroxene. For the early magmatic stage, calculated temperatures range between 880 and 780 °C with low silica activities (0.4 to 0.6) but high relative oxygen fugacities between 0.5 and 1.9 log units above the FMQ buffer. Even higher oxygen fugacities (above the HM buffer) are indicated for the autometasomatic alteration, which occurred at temperatures between 585 and 780 °C and resulted in the formation of pseudobrookite and hematite.

The unusually high oxygen fugacities (even during the early magmatic stage) are recorded by the major element compositions of the mafic minerals (forsterite content in olivine between 68 and 78 mol%, up to 6.2 wt.% ZrO₂ and 8.5 wt.% TiO₂ in clinopyroxene), the unusual mineral assemblages (pseudobrookite, freudenbergite) and by the enrichment of Fe³⁺ in the felsic minerals (up to 2.8 wt.% Fe₂O₃ in alkali feldspar and up to 2.6 wt.% Fe₂O₃ in nepheline). These observations point to a metasomatically enriched and highly oxidized lithospheric mantle as a major source for the Katzenbuckel melts.     

Shape and distribution analysis of Merensky Reef potholing, Northam Platinum Mine, western Bushveld Complex: implications for pothole formation and growth

Syn-magmatic removal of the cumulate pile during the formation of the Bushveld Complex resulted in “potholes”. Erosion progressed downward in the cumulate pile, resulting in a series of steep, transgressive contacts between locally conformable potholed reefs in the regional pothole sub-facies of the Swartklip Facies in the western limb of the Bushveld Complex. The deepest of these potholes, “third-order” or “FWP2” potholing, occurs where the base of the Merensky Cyclic Unit transgresses the Upper Pseudo-Reef Chromitite marker horizon. The base of a FWP2 pothole on Northam Platinum Mine consists of an unconformable stringer Merensky Chromitite overlain by a medium-grained, poikilitic orthopyroxenite and underlain by either a pegmatitic harzburgite or the medium-grained Lower Pseudo-Reef Anorthosite. Detailed shape and distribution analysis of FWP2 potholes reveals underlying patterns in their shape and distribution which, in turn, suggest a structural control. The ratio between pothole short vs long axes is 0.624 (N=1,385), although the ratio increases from 0.48 to 0.61 in the long axis range 10 to 60 m, then decreases from 0.61 to 0.57 from 61 to 100 m, increasing again from 0.57 to 0.61 from 101 to 400 m, suggesting that there is not a simple relationship between pothole shape and size. Shape (circularity, eccentricity, and dendricity) analysis of a subset of 638 potholes indicates that potholes with long axes <100 m have an elliptical, average normalized shape, elongate on a 120–150° orientation. Potholes with long axis lengths >100 m have an average normalized shape that is bilobate and elongate on a 120° orientation. The average aspect ratio (short axis length divided by long axis length) of potholes is highest for potholes with long axis lengths >100 m and lowest for potholes with long axis lengths between 35 and 60 m. The most common long axis orientation for potholes with long axis lengths <100 m is 150° but 120° for long axis lengths >100 m. Fractal analysis indicates that the distribution of pothole centers is controlled neither by a single nor several interacting fractal dimensions. Autocorrelation (Fry) analysis of the distribution of pothole centers shows recurring pothole distribution trends at 038, 070, and 110° for potholes over the full range of long axis lengths, while the trends of 008 and 152° occur in potholes with long axes lengths between 60 and 100 m. Chi-squared (X ²) analysis of the locations of pothole centers suggests that the distribution of small potholes is highly non-uniform but becomes exponentially more uniform with increasing pothole size. The model which best fits the observed shape and distribution analysis is a combination of protracted independent growth and “nearest neighbor” merging along specific orientations. For instance, the clustered distribution of original pothole centers resulted in merged potholes with long axes lengths of up to 60 m, exhibiting short vs long axes ratios of 0.61, preferred orientations of 150°, and alignment along 010 and 150° trends. Further independent growth allowed for merging of similar-sized (and smaller) neighboring potholes, generating potholes with long axes of up to 100 m in length, a preferred long axis orientation of 150°, and alignment along 010, 040, 075, and 150°. Subsequent preferential merging occurred along a 120° trend, thereby preserving a bilobate form. This implies that while pothole initiation and enlargement may be driven by a “top-down” (i.e., possibly thermomechanical) process, an underlying linear or structural catalyst/control is revealed in changes in pothole shape during enlargement and, furthermore, in the preferred trends along which potholes merged over a considerable period, possibly concomitant with adjustment of major structures in the footwall to the Bushveld Complex and pulses into the magma chamber.     

Stratigraphy, sedimentology and bulk organic geochemistry of black shales from the Proterozoic Vindhyan Supergroup (central India)

Four organic-rich shale units of the Proterozoic Vindhyan sedimentary succession have been scanned to reveal their origin and hydrocarbon potential. The wavy-crinkly nature of the carbonaceous laminae is suggestive of a microbial mat origin of the shales. These shales are thus different from Phanerozoic black shales which typically exhibit planar laminae. The hydrocarbon potential of the black shale units has been evaluated by Rock-Eval pyrolysis. Total organic carbon content of many of the shales exceeds 1%. The meanT _max for the black shales translate to a vitrinite reflectance range of 2.05-2.40% Rm based on standard conversion techniques. These shales have reached the catagenetic stage near the beginning of anthracite formation.