Wave energy in surface layers for energy-based damage evaluation

Seismic wave energy in surface layers is calculated based on vertical array records at four sites during the 1995 Hyogo-ken Nambu earthquake by assuming vertical propagation of SH waves. The upward energy generally tends to decrease as it goes up from the base layer to the ground surface particularly in soft soil sites. Theoretical study on 1D multi-layers model to investigate the basic energy flow mechanism indicates that the energy at the ground surface can be smaller on softer soils due to high soil damping during strong shaking even if resonance effect is considered. A simple calculation for a shear-vibrating structure resting on foundation ground shows that induced strain in the structure is directly related to the energy or the energy flux of surface layers. Hence, a general perception that soft soil sites tend to suffer heavier damage than stiff sites should be explained not by greater incident energy but by other reasons such as degree of resonance. Furthermore, it is recommended that not only acceleration or velocity but also S-wave velocity should be specified at a layer where a design seismic motion is given, so that the seismic wave energy can clearly be quantified in seismic design practice.     

Finite element analysis and experimental verification of the scrap tire rubber pad isolator

A new base isolation system using scrap tire rubber pads (STRP) has been introduced for seismic mitigation of ordinary residential buildings. The rubber and the steel reinforcing cords used in manufacturing the tire are the alternative materials of the proposed base isolation system. The steel reinforcing cords represent the steel plates used in conventional laminated rubber bearings. These steel reinforcing cords shall prevent the lateral bulging of the rubber bearing. The proposed base isolation system has no bonding between the superstructure and the foundation beam which allows for rollover deformation. In the first part of the study, the STRP layers were just stacked one on top of another without applying the adhesive. This paper presents loading test as well as finite element analysis (FE analysis) of strip STRP isolators that are subjected to any given combination of static vertical and lateral loads. The results of the static vertical and horizontal loading test conducted on STRP isolators were used to calculate the mechanical properties of the isolators, including stiffness and damping values. The load–displacement relationship of STRP isolators were compared between experimental and FE analysis results and the results were found to be in close agreement. The stress state within the STRP isolators was also analyzed in order to estimate the maximum stress demand in the rubber and steel reinforcing cords. These STRP isolators have several advantages over conventional laminated rubber bearings including superior damping properties, lower incurred cost, light weight and easily available material. This study suggests that using the STRP as low cost base isolation device for ordinary residential buildings is feasible.     

Groundwater-level Changes Due to Pressure Gradient Induced by Nearby Earthquakes off Izu Peninsula, 1997

Anomalous water level changes were observed at two wells associated with seismic swarm activity off Izu Peninsula on March, 1997. These are coseismic water level drops followed by gradual postseismic water level rise at the time of large earthquakes during the swarm activity. The post-seismic water level rises, which can be fitted by an exponential function with a time constant of about six hours, are explained in terms of the horizontal pressure diffusion due to the pressure gradient in the aquifer induced by the coseismic static strain.     

Lithological and physical properties of core samples from the Sagara oil field: Oil occurrence in Sagara core samples

Abstract   A drilling and coring investigation of the Sagara oil field, central Honshu, Japan, was conducted to contribute to the understanding of hydrocarbon migration processes in a forearc basin. Core samples were analyzed to determine lithology, physical properties (specifically gas permeability) and the characteristics of oil occurrence. Gas permeability values greater than approximately 10⁻¹¹ m² constitute the basic precondition for any lithology to serve as a potential fluid conduit or reservoir in the Sagara oil field. Cores recovered from the 200.6-m-deep borehole were primarily composed of alternating siltstone, sandstone and conglomerate, all of which are correlated to the late Miocene Sagara Group. Both sandstone and conglomerate can be classified into two types, carbonate-cemented and poorly to non-cemented, based on matrix material characteristics. Oil stains are generally absent in the former lithology and more common in the latter. Variations in physical properties with respect to gas permeability values are directly related to the presence and character of carbonate cement, with higher permeabilities common in poorly to non-cemented rocks. The relationships between lithology, oil-staining, cementation and permeability indicate that cementation preceded oil infiltration and that cementation processes exerted significant control on the evolution of the reservoir.     

Resonance capacity method for earthquake response analysis of hysteretic structures

The Resonance Capacity Method is proposed for the earthquake response analysis of hysteretic structures. Resonance Capacity is a physical quantity of structures which is related to the hysteretic energy absorbed by structures in one cycle and is equated to the acceleration, velocity and displacement amplitudes α₀, d₀ and d₀ of earthquake ground motions at resonance.¹ According to the idealized trapezoidal approximation of earthquake ground motions in the logarithmic period–velocity plane as proposed by Veletsos and Newmark,⁸ the Resonance Capacity property applies in each period range, short, medium and long, where α₀, v₀ and d₀ respectively are approximately constant. In the medium range of periods, the energy dissipated in hysteretic loops and the deformation amplitudes of a single-degree system with elasto–plastic force–deformation relationships are calculated for the case of El Centro 1940, 18 May earthquake, by this Resonance Capacity Method. The result is compared with results from conventional numerical response analyses obtained by Berg and Thomaides,¹⁴ Kato and Akiyama¹² and Veletsos and Newmark,⁸ and the general agreement is seen to be good. Therefore, it may be possible to apply this Resonance Capacity Method over the entire range of periods. By means of this method the earthquake response analysis of hysteretic systems can be performed easily, and the hysteretic energy and fatigue characteristics of structures may be taken into account directly, up to the point of fracture.     

Symmetrical fft technique and its applications to earthquake engineering

The objective of this paper is to propose an FFT technique symmetrical for time and frequency, in which the symmetrization is done by introducing generating functions. By the symmetrical treatment, it becomes possible to derive several complementary relations in the time and frequency domains. Based on the idea of the symmetrical FFT technique, the phase problem of seismic waves is discussed not only in the frequency domain but also in the time domain. Furthermore, the deconvolution technique to evaluate the minimum-phase-shift and all-pass functions of seismic waves, which is not discussed sufficiently in earthquake engineering, is developed in the two domains. Numerical examples to present these basic ideas are also illustrated in the symmetrical framework.     

Variation of rare earth concentrations in pigeonitic and hypersthenic rock series from Izu-Hakone region,Japan

The abundances of rare earth elements in 5 each of aphyric volcanic rocks of pigeonitic and hypersthenic rock series from Izu-Hakone region have been determined by neutron activation analysis. Pigeonitic rock series show rare earth patterns with relative depletion of lighter rare earths (low lanthanum type) and large increase in rare earth abundances with differentiation. Hypersthenic rock series show higher lanthanum abundances (high lanthanum type) compared with pigeonitic rock series. The differences in rare earth patterns between two rock series are compatible with the theory of independent magmatic generation of these two series. Variation of rare earth patterns in both series have been examined by a model of magmatic differentiation based on the observed rare earth partition coefficients.     

ESR diagram: a method to distinguish vitrinite macerals

It has been found that samples consisting of a homogeneous vitrinite show a good ESR correlation of spin concentration with geothermal parameters and that a graph of ESR line width vs g-value can be useful in the identification of the maceral and the determination of the coalification rank.     

A note on the averaging method

When time-averaged equations are used to discuss the secular behavior of dynamical systems, the action-angle variables conjugate to the action variables of the unperturbed motion of the system should be chosen as dependent variables; otherwise, the results are not correct.Presented at the Division of Dynamical Astronomy Meeting of the American Astronoming Society, Chapel Hill, N.C., U.S.A., December 4, 1976.     

Microearthquakes and faulting in the southern Okinawa Trough

Southern Okinawa Trough represents an early stage of back-arc rifting and is characterized by normal faulting and microearthquakes. Earthquake distribution and deep structure of fault was investigated to clarify active rifting in the southern Okinawa Trough, where two parallel grabens are located. A network of ocean bottom seismometers (OBSs) that displayed the hypocenters of 105 earthquakes were observed for a period of 4 days in southern-graben (SG). Most of the microearthquakes occurred in a cluster about 7 km wide, which on a cross-section striking N45°E dips 48° to the southwest. Relocated hypocenters, which are recorded by a local seismic network, show scattered distribution around the southern-graben. There are no remarkable surface faults in the southern-graben. On the other hand, the recalculation of hypocenter locations of 1996 earthquakes swarm recorded by a local seismic network suggests that the swarm is associated with normal faulting on the southern side of northern-graben (NG). Thus, the undeveloped southern-graben is located to the south of the developed northern-graben. Southward migration of rifting, which may be caused by migration of volcanism, could thus be occurring in the southern Okinawa Trough. The extension rate computed for the southern Okinawa Trough from the fault model of the northern-graben is 4.6 cm/year, which is 59–102% of the extension rate (GPS measurements). This result indicates that the majority of extensional deformation is concentrated within the center of the northern-graben in the Okinawa Trough.