Classification of Japanese rivers by heavy metals in bottom mud

Bottom mud was collected from the upper and lower reaches of 92 rivers in Japan to determine the distribution of 0.5N-HCI-soluble heavy metals. The average concentrations of Cu, Zn, Pb, and Cd in the mud from the lower reaches were from two to three times higher than those in the upper reaches. Japanese rivers were classified according to the degree of heavy metal pollution by using the values of 0.5N-HCI-soluble metals in the lower reaches of rivers. The content of 0.5N-HCI-soluble heavy metals in the mud of the upper reaches was used as the standard value. The classification of rivers was made by a cluster analysis according to Euclidian distance. As a result, rivers in Japan could be classified into three groups based on the degree of metal pollution, and the classification was in agreement with the pollution index.     

A 100 m laser strainmeter system installed in a 1 km deep tunnel at Kamioka, Gifu, Japan

We have installed a laser strainmeter system in a deep tunnel about 1,000 m below the ground surface at Kamioka, Gifu, Japan. The system consists of three types of independent interferometers: (1) an EW linear strainmeter of the Michelson type with unequal arms, (2) an NS-EW differential strainmeter of the Michelson type with equal arms and (3) a NS absolute strainmeter of the Fabry–Perot type. These are configured in L-shaped vacuum pipes, each of which has a length of 100 m. (1) and (2) are highly sensitive (order of 10⁻¹³ strain) and have wide dynamical range (10⁻¹³–10⁻⁶). Observations with strainmeters (1) and (2) started on June 11, 2003. (3) is a new device for absolute-length measurements of the order of 10⁻⁹ of a long-baseline (100 m) Fabry–Perot cavity by the use of phase-modulated light. This third strainmeter will be ready for operation before the end of 2004. The laser source of strainmeters (1) and (2) is a frequency-doubled YAG laser with a wavelength of 532 nm. The laser frequency is locked onto an iodine absorption line and a stability of 2 × 10⁻¹³ is attained. The light paths of the laser strainmeter system are enclosed in SUS304 stainless steel pipes. The inside pressure is kept to be 10⁻⁴ Pa. Consequently, quantitative measurement of crustal strains of the order of 10⁻¹³ can be attained by employing the laser strainmeter system of (1) and (2) at Kamioka. This resolving power corresponds to that of a superconducting gravimeter. Using the laser strainmeter system, we expect to determine parameters related to fluid core resonance, core modes and core undertone as well as other geodynamic signals such as slow strain changes caused by silent earthquakes or slow earthquakes.     

Muscovite K-Ar ages of the Sanbagawa schists,Japan and argon depletion during cooling and deformation

Seventy muscovites from schists in the Sanbagawa terrain in central Shikoku were dated by the K-Ar method. The muscovite ages are consistently older with increasing metamorphic grade. Within the same zone the ages are significantly younger in schists which have been more severely deformed. These K-Ar age variations could be due to systematic argon depletion during deformation i.e., to the dynamic recrystallization of muscovites during ductile deformation that formed a large-scale recumbent fold during the uplift and cooling. Argon loss was greater in schists that were more extensively deformed and in the lower grade zone that experienced a longer period of low-temperature deformation than the higher grade zone. The relationships between age and grain size in a pelitic schist suggest that coarse-grained muscovites lost more argon than the finegrained ones. There was no significant resetting of ages in the vicinity of major strike-slip faults, such as the Median Tecotonic Line or near thrust faults. The combination of geochronological and geological data constrains the cooling rate of the Sanbagawa schists to 9–12° C/Ma in the oligoclase-biotite zone in central Shikoku, Japan.     

Concentration mechanisms of iron oxides and alumina in deep weathering crusts (Goshikidai, Kagawa, Western Japan)

Concentration of Fe-oxides and alumina in weathering processes are main geological reactions for lateritization and bauxitization, respectively. In western Japan, red-coloured soil formed by weathering processes developed in many places. This soil is composed of hydrous Fe-oxide minerals, hydrous alumina minerals and other minerals. It was formed in the upper part of deep weathering crust by weathering processes under some kind of sub-tropical climate, probably in the Pliocene. One of these occurrences is observed in the upper part of Goshikidai and Konodai, west part of Takamatsu city, northeast Shikoku Island, west Japan. A deep weathering crust is distributed on wide hilly plains ranging from 250 to 400 m a.m.s.l. in the northwestern region of Takamatsu city. Original rock of the weathering crust is bronzite andesite and glassy bronzite andesite, so-called ‘sanukite’. The andesites had been weathered under some special climate, and the geological age of the weathering is the same as above. The mineral assemblage and formation mechanism are similar to those of laterite and bauxite. The weathering crust developing in this region are subdivided into the three following zones: (1) A zone, composed of hydrous Fe-oxides and metahalloysite with small amounts of gibbsite and it is associated with white veins of metahalloysite; (2) B zone, composed of hydrous Fe-oxides and metahalloysite (some material is associated with -cristobalite); and C zone, composed of metahalloysite or halloysite and -cristobalite with relict crystals of feldspar and quartz, and some material is associated with montmorillonite. Chemical analyses of the materials of the three zones show the formation mechanisms of the weathering crust.     

Observation of mixed Rossby-gravity waves in the Western equatorial Pacific

During the IOP (Intensive Observation Period) of TOGA/COARE (Tropical Ocean and Global Atmosphere/Coupled Ocean Atmosphere Response Experiment) from December 1992 to February 1993, four Japanese moored ADCPs (Acoustic Doppler Current Profilers) measured vertical profiles of three-component velocities at the stations 2S (2°S, 156°E), 2N (2°N, 156°E), 154E (0°N, 154°E) and 147E (0°N, 147°E). Power spectra of the surface current showed a pronounced peak having a period of around 14 days for both the zonal and meridional velocities at the stations 2S and 2N near the equator, and for only the meridional velocity at the equator. This 14-day phenomenon is considered to be a kind of equatorial wave of the first baroclinic mode, from a comparison of the result of the vertical mode analysis and the vertical distribution of the standard deviation of band-pass filtered velocity fluctuations. A dispersion relationship obtained from the horizontal mode analysis of this wave confirmed that the 14-day phenomenon is a mixed Rossby-gravity wave with the westward propagating phase speed and eastward propagating group velocity. From the cross-spectral analysis of velocity data, the average phase speed and wavelength of the wave were estimated as 3.64 m s⁻¹ and 3939 km, respectively, for station pair 2S∼147E. These values were in good agreement with the average phase speed and wavelength of 3.58 m s⁻¹ and 3836 km estimated from the dispersion curve and the observed period. A northerly wind burst blew over all the mooring sites during the middle of the observation period. The mixed Rossby-gravity wave, which is anti-symmetric for the zonal velocity about the equator, is likely to be forced by this northerly wind burst crossing the equator. Generation of the oceanic mixed Rossby-gravity wave of the first baroclinic mode is discussed in association with the atmospheric Rossby wave having the same period.     

Recent Dasycladales (Chlorophyta) in Okinawa Jima in the Central Ryukyus,southwestern Japan: Paleontological implications

Recent dasycladalean algae (Dasycladales, Chlorophyta) are classified into two families, 11 genera, and 44 species, and inhabit the tropical to warm‐temperate waters of the world. Twelve species of dasycladalean algae occur in Okinawa Jima, Ryukyu Islands. In this paper, the present‐day dasycladalean species and their distributions in Okinawa Jima are reported and their paleontological implications are discussed. Dasycladalean algae grow mainly on coral rubble and rocks, often forming large meadows in calm shallow lagoons. However, Dasycladus vermicularis occurs in deeper waters, at depths of 15–89 m, around Okinawa Jima. Neomeris annulata is found at water depths of 0–30 m. These data throw doubt on the interpretation that the occurrence of dasycladalean algae is linked to warm shallow habitats.     

Pumpellyite from zeolite facies metabasites of the Horokanai ophiolite in the Kamuikotan zone,Hokkaido, Japan

Pumpellyite occures in zeolite facies metabasites of the Horokanai ophiolite in the Kamuikotan zone, Hokkaido, Japan, filling veins or amygdules, replacing igneous plagioclase or clinopyroxene or olivine, and occupying the matrix. Its composition and pleochroism vary greatly even within a single sample, but appear to be related to its mode of occurrence. Thus, the most Al-rich pumpellyite with pale green to green pleochroism develops in pseudomorphs after plagioclase, whereas the most Fe^*-rich variety with deep green to brown pleochroism occurs in the matrix. In low-grade metamorphic rocks which commonly contain relict minerals, chemical equilibrium is attained only locally. This results in the correlation of the composition of pumpellyite with its mode of occurrence, such as the precursor phases which are replaced by pumpellyite. On the other hand, among pumpellyites occurring in similar mode and coexisting with Ca-zeolite (laumontite or wairakite), epidote, chlorite and quartz, the Al content tends to be enriched in the wairakite-bearing metabasites over the laumontite-bearing metabasites. It follows that the composition of pumpellyite is also dependent upon the temperature of metamorphism.     

Probabilistic estimates of recent changes in temperature: a multi-scale attribution analysis

The role of anthropogenic forcings in temperature changes during recent decades is investigated over a range of spatial scales. Changes in the annual mean surface temperature and also in the warmest night of the year, which has implications for human health, are considered. Distributions of regional trends with and without the effect of human activity are produced, using constraints from a global optimal detection analysis. Anthropogenic forcings are estimated to have more than doubled the likelihood of mean warming in all regions considered except central North America, where results are more model dependent. The likelihood of warming of the warmest night has also increased, but the estimated change is more uncertain. Inferences on sub-continental scales are indicative rather than definitive because of the absence of locally important forcings and processes in model simulations, as well as model biases. As model inconsistencies may impact regional analyses, a multi-model approach is essential.     

Adaptation to climate change impacts on urban storm water: a case study in Arvika, Sweden

Already today, the functionality of many sewer and storm water systems are not up to the required standards and consequently flooding problems are experienced in case of heavy storms. System upgrades are required, which are however complicated by the expected future increase in short-term rainfall intensities as a result of climate change. In this case study, focusing on the town of Arvika, Sweden, this issue is investigated in three main steps. In the first, extreme value analyses of 30-min rainfall from an ensemble of climate projections are carried out to estimate the future increase and generate a future design storm. In the second, the existing system’s response to both today’s and future design storms are simulated by a coarse sewer model setup (MOUSE) and a detailed coupled surface-sewer model setup (TSR). In the third and final step, system upgrades are designed and evaluated by both models. The results indicate an increase by 10–30 % of today’s short-term rainfall extremes by the end of the century. Upgrading the system to achieve a satisfactory performance for the future design storm would cost approximately twice as much as an upgrade based on today’s design storm.