Attenuation behaviour of tuffaceous sandstone and granite during microfracturing

Laboratory measurements of ultrasonic wave propagation in tuffaceous sandstone (Kimachi, Japan) and granite (Iidate, Japan) were performed during increasing fracturing of the samples. The fracturing was achieved by unconfined uniaxial compression up to and beyond the point of macrofracture of the specimen using a constant low strain rate. The observed variation of wave velocity (up to 40 per cent) due to the development of micro- and macrofractures in the rock is interpreted by rock models relating velocity changes to damage and crack density. The calculated density of the newly formed cracks reaches higher values for the sandstone than for the granite. Using the estimated crack densities, the attenuation behaviour is interpreted in terms of different attenuation mechanisms; that is, friction and scattering. Rayleigh scattering as described by the model of Hudson (1981 ) may explain the attenuation qualitatively if the largest plausible crack dimensions are assumed in modelling.     

Short term variability of Particle fluxes and its relation to variability in sea surface temperature and chlorophylla field detected by Ocean Color and Temperature Scanner (OCTS) off Sanriku, northwestern North Pacific in the spring of 1997

A sediment trap experiment was carried out in conjunction with an over flight of Ocean Color Temperature Scanner (OCTS) on board Advanced Earth Observing Satellite (ADEOS) at 40°N, 143°E off Sanriku in April to May 1997. Short term variability of particle fluxes was examined at depths of 450 m and 600 m from April 6 to May 1 with a sampling interval of two days, and at 450 m with one day interval from 2nd to 10th May. Daily averaged mass flux at 450 m and 600 m was 815 mg m⁻²d⁻¹ and 862 mg m⁻²d⁻¹, respectively. A sharp increase in mass flux was observed during the period from April 26 to April 29 with the highest mass flux of 8 g m⁻²d⁻¹. About 85% of the total mass flux for the entire duration (26 days) was collected within these 4 days. Trapped material during the peak flux period was mainly composed of diatoms dominated byThalassiosira spp. and resting spores ofChaetoceros spp. This suggested that the peak flux was the result of (a) diatom bloom(s) in the euphotic column. Current meter records at 420 m showed that on April 26 and 27, the period when the peak flux was observed, the southwestward current had diminished in strength and changed its direction northwestward. Low current speeds appeared to have enhanced trap efficiency to help form the peak flux. A time series of OCTS Intensive-LAC (Local Area Coverage: Region B) images from mid-March to early May was examined todetect phytoplankton bloom(s). In the March 26th Chl image, high concentration region was restricted to the southwest off Cape Erimo, but spread around the warm core ring (WCR) 93A by April 10. East of the WCR93A, high Chl concentration remained steady until May, but to the west of the WCR93A, Chl decreased rapidly before the 19th of April. From this observation we suspect that the peak flux observed at the end of April originated from a bloom, which ceased on the 17th or 18th of April, in the region north of 40°N and west of 143°E. Taking the current meter records into account, the source region for the trapped material is most likely around southwest of the Cape Erimo.     

A pair of Langmuir cells in two laboratory tanks (II) on generation mechanism

Vertical and cross-wind profiles of mean currents were measured systematically in vertical cross-sections of two wind-wave tanks with aspect ratios of order one to study the secondary flow in the tanks. A pair of Langmuir cells turned out to be driven by a close combination of the pressure gradient along the tank and the side-wall effects. That is, part of the adverse pressure gradient produced a parabolic cross-wind profile with the smallest downwind current at the centerline and the largest current along the two sidewalls. As a result, upwelling occurred in the center zone where the return flow was strongest, probably because of the entrainment action of the wind-driven current. In order to compensate for this upwelling, downwelling occurred along the two side-walls from the flow continuity. The resulting vertical circulation formed a pair of Langmuir circulations across the span and served to maintain the parabolic profile formed by the pressure gradient. A positive feedback mechanism is thus found between the primary and secondary circulations through upwelling of the return flow in the center zone. Vertical shears of the span-averaged downwind current measured in two tanks were found to be systematically different from each other. This difference seems to depend on the magnitude of the advective Reynolds stresses in the two tanks.     

Possible change in distribution of seaweed, Sargassum horneri, in northeast Asia under A2 scenario of global warming and consequent effect on some fish

Global warming effects on seaweed beds are already perceptible. Their geographical distributions greatly depend on water temperatures. To predict future geographical distributions of brown alga, Sargassum horneri, forming large beds in the northwestern Pacific, we referred to future monthly surface water temperatures at about 1.1° of longitude and 0.6° of latitude in February and August in 2050 and 2100 simulated by 12 organizations under an A2 scenario of global warming. The southern limit of S. horneri distribution is expected to keep moving northward such that it may broadly disappear from Honshu Island, the Chinese coast, and Korean Peninsula in 2100, when tropical Sargassum species such as Sargassum tenuifolium may not completely replace S. horneri. Thus, their forests in 2100 do not substitute those of S. horneri in 2000. Fishes using the beds and seaweed rafts consisting of S. horneri in East China Sea suffer these disappearances.     

Subsidence of the Miyako‐Sone submarine carbonate platform,east of Miyako‐jima Island,northwestern Pacific Ocean

Bathymetric mapping and observations of the seafloor using a remotely operated vehicle (ROV, Hyper‐Dolphin 3K) were carried out on the slopes of the Miyako‐Sone submarine platform, east of Miyako‐jima in the Ryukyu Islands, northwestern Pacific Ocean. The bathymetric map indicates that terraces are present at water depths of approximately 140 m, 330 m, 400 m, and 680 m on the northwestern slope of the platform. A number of NW–SE trending lineaments, probably faults, extend perpendicular to the axis of the Ryukyu Island Arc. Two ROV surveys were conducted at water depths ranging from 519 m (on the slope) to 121 m (shallowest part of the platform). The surveys revealed that well‐indurated carbonate rocks are exposed at terrace margins and on upper slopes, and that the lower slopes are covered with modern sediments consisting of unconsolidated, coarse‐sand‐sized bioclastic carbonates. Calcareous nannofossils from the well‐indurated carbonate rocks indicate a Middle–Late Pleistocene age, which suggests that the rocks correlate with the Quaternary reef and fore‐reef deposits of the Ryukyu Group (Ryukyu Limestone) on the Ryukyu Islands. No siliciclastic deposits corresponding to the upper Miocene–lower Pleistocene Shimajiri Group (as exposed on Okinawa‐jima and Miyako‐jima islands) were recovered during the surveys. Coeval well‐indurated carbonate rocks, all of which formed in a similar sedimentary environment, have been downthrown towards the west due to displacements on the western sides of normal faults. Subsidence of the Miyako‐Sone submarine platform was the result of large vertical displacements on such normal faults. The timing of initial subsidence cannot be tightly constrained, but the presence of the youngest limestone at progressively lower levels towards the west suggests the subsidence continued until after 0.265 Ma.     

Spatial distribution of sister species of vesicomyid bivalves Calyptogena okutanii and Calyptogena soyoae along an environmental gradient in chemosynthetic biological communities in Japan

Vesicomyid bivalves have a substantial biomass in deep-sea chemosynthetic biological communities in the Pacific. Using a novel multiplex-PCR (mPCR) method to identify the co-occurring vesicomyids in Sagami Bay, we analyzed the distribution of Calyptogena okutanii and Calyptogena soyoae along environmental gradients. All the known distributions of C. okutanii indicated the different preferences in salinity and temperature to those of C. soyoae, and in Sagami Bay, depth seemed to be an important environmental factor, too. Although the concentration of hydrogen sulfide in sediment was not examined, our results showed that the distributions of these two Calyptogena clams were affected by salinity and temperature.     

Bed morphology and grain size characteristics around a spur dyke

This paper presents an experimental study on the local bed morphology and grain size characteristics around an impermeable spur dyke.A series of experiments are conducted with different types of sedime...     

Seismic vertical array analysis for phase decomposition

We propose a vertical array analysis method that decomposes complex seismograms into body and surface wave time histories by using a velocity structure at the vertical array site. We assume that the vertical array records are the sum of vertically incident plane P and S waves, and laterally incident Love and Rayleigh waves. Each phase at the surface is related to that at a certain depth by the transfer function in the frequency domain; the transfer function is obtained by Haskell's matrix method, assuming a 1-D velocity structure. Decomposed P , S and surface waves at the surface are estimated from the vertical array records and the transfer functions by using a least-squares method in the frequency domain; their time histories are obtained by the inverse Fourier transform. We carried out numerical tests of this method based on synthetic vertical array records consisting of vertically incident plane P and S waves and laterally incident plane Love and Rayleigh waves. Perfect results of the decomposed P , S , Love and Rayleigh waves were obtained for synthetic records without noise. A test of the synthetic records in which a small amount of white noise was added yielded a reasonable result for the decomposed P , S and surface waves. We applied this method to real vertical array records from the Ashigara valley, a moderate-sized sedimentary valley. The array records from two earthquakes occurring at depths of 123 and 148 km near the array (epicentral distance of about 31 km) exhibited long-duration later phases. The analysis showed that duration of the decomposed S waves was a few seconds and that the decomposed surface waves appeared a few seconds after the direct S -wave arrival and had very long duration. This result indicated that the long-duration later phases were generated not by multireflected S waves, but by basin-induced surface waves.     

Internal differentiation of Kutsugata lava flow from Rishiri Volcano,Japan: Processes and timescales of segregation structures' formation

Internal differentiation processes in a solidifying lava flow were investigated for the Kutsugata lava flow from Rishiri Volcano in northern Japan. In a representative 6-m thick lava flow that was investigated in detail in this study, segregation products darker than the host lavas manifested mainly in the form of pipes (vesicle cylinders) and layers (vesicle sheets), occurring around 0.5–2.3 m and 2.0–4.0 m above the base, respectively. Both the cylinders and sheets are significantly richer in incompatible elements such as TiO₂ and K₂O than the host lavas, which suggest that these products essentially represent residual melt produced during solidification of the lava flow. Field observation and the geochemical features of the lavas suggest that the vesicle cylinders grew upward from near the base of the flow by continuous feeding of residual melt from the neighboring host lavas to the heads of the cylinders. On the other hand, the vesicle sheets were produced in situ in the solidifying lava flow as fracture veins caused by horizontal compression. The vesicle cylinders have a remarkably higher MgO content (up to 8 wt.%) than the host lava (< 6 wt.%), whereas the vesicle sheets display MgO depletion (as low as 3.5 wt.%). The relatively high MgO content of the vesicle cylinders cannot be explained solely by the mechanical mixing of olivine phenocrysts with the residual melt. It is suggested that the vesicle cylinders were produced by the extraction of olivine-bearing interstitial melt from an augite-plagioclase network in the host lava, whereas the vesicle sheets were formed by the migration of the residual melt from a crystal network consisting of plagioclase, augite, and olivine in the host lava into platy fractures. We infer that this selective crystal fractionation for forming the vesicle cylinders resulted from processes in which abundant vesicles rejected from the upward-migrating floor solidification front prevented olivine crystals from being incorporated into the crystal network in the host lava. The vesicle cylinders are considered to have formed in ∼ 1 day after the lava flow came to rest, while relatively large vesicle sheets (> 1 cm thick) appeared much later (after ∼ 9 days). The formation of these segregation products was essentially complete within 20 days after the lava emplacement.