一种胶体光子晶体修饰的光纤

设计了一种胶体光子晶体修饰的光纤. 采用恒温快速蒸发法直接在经切割刀处理后的光纤端面生长胶体晶体,再与另一根切割后的光纤在毛细玻璃管中完成对接,制备成胶体光子晶体修饰的光纤. 用扫描电子显微镜和光谱分析仪对样品的形貌、结构以及光学特性进行分析. 实验结果表明,粒径为640 nm、体积分数约为0.5%的SiO₂胶体微球溶液在60 ℃的情况下沉积,大约12 h后可得到质量较高的胶体光子晶体. 在SEM下,观察到端面的胶体晶体为面心立方(fcc)结构. 透射光谱证明,该结构在(111)面上     

增强型AlGaN/GaN高电子迁移率晶体管高温退火研究

深入研究了两种增强型AlGaN/GaN高电子迁移率晶体管(HEMT)高温退火前后的直流特性变化.槽栅增强型AlGaN/GaN HEMT在500 ℃ N₂中退火5 min后,阈值电压由0.12 V正向移动到0.57 V,器件Schottky反向栅漏电流减小一个数量级.F注入增强型AlGaN/GaN HEMT在 400 ℃ N₂中退火2 min后,器件阈值电压由0.23 V负向移动到-0.69 V,栅泄漏电流明显增大.槽栅增强型器件退火过程中Schottky有效势垒     

The ground-state entanglement in the spin-XX chain with a magnetization current

The ground-state entanglement in a transverse spin-1/2 XX chain with a magnetization current is studied. By introducing a magnetization current to the system, a quantum phase transition to current-carrying phase may be presented with the variation of the driving field λ for the magnetic field h>1; and the ground-state entanglement arises simultaneously at the critical point of quantum phase transition. In our model, the introduction of magnetization current may result in more entanglement between any two nearest-neighbour spins.     

Stable 85Rb micro vapour cells: fabrication based on anodic bonding and application in chip-scale atomic clocks

We describe the microfabrication of ⁸⁵Rb vapour cells using a glass-silicon anodic bonding technique and in situ chemical reaction between rubidium chloride and barium azide to produce Rb. Under controlled conditions, the pure metallic Rb drops and buffer gases were obtained in the cells with a few mm³ internal volumes during the cell sealing process. At an ambient temperature of 90 ℃ the optical absorption resonance of ⁸⁵Rb D1 transition with proper broadening and the corresponding coherent population trapping (CPT) resonance, with a signal contrast of 1.5% and linewidth of about 1.7 kHz, have been detected. The sealing quality and the stability of the cells have also been demonstrated experimentally by using the helium leaking detection and the after-9-month optoelectronics measurement which shows a similar CPT signal as its original status. In addition, the physics package of chip-scale atomic clock (CSAC) based on the cell was realized. The measured frequency stability of the physics package can reach to 2.1×10^-10 at one second when the cell was heated to 100 ℃ which proved that the cell has the quality to be used in portable and battery-operated devices.     

Formation of saddle dolomites in Upper Cambrian carbonates, western Tarim Basin (northwest China): Implications for fault-related fluid flow

The saddle dolomites occur more intensely in cores closely to fault than that in cores far away from the fault in Upper Cambrian carbonate of western Tarim basin, suggesting that formation of the saddle dolomites is likely related to fault-controlled fluid flow. They partially fill in fractures and vugs of replacement dolomite. The saddle dolomites exhibit complex internal textures, commonly consisting of core and cortex. In comparison with the matrix dolomites, the saddle dolomites show lower Sr-content and ⁸⁷Sr/⁸⁶Sr ratios, higher Fe- and Mn-content, and more negative δ¹⁸O values. Combined with high Th (100–130 °C) of primary fluid inclusions, it is suggested that the saddle dolomites precipitated from hydrothermal fluid derived from the deep evaporite-bearing Middle Cambrian strata, and the magnesium source may be due to dissolution of host dolomite during hydrothermal fluid migration. Fault activity resulted in petrographic and geochemical difference of the core and cortex of the saddle dolomites. The cores precipitated from the formation water mixed by deep brines at the early stage of fault activity, and the cortexes precipitated from the deep fluid with higher temperatures through the Middle Cambrian later. In summary, the formation of the saddle dolomites implies a hydrothermal fluid event related to fault activity, which also resulted in high porosity in Upper Cambrian carbonate in western Tarim Basin.     

红海湾水域溶解氧、pH值、盐度和营养盐分布特征及相互关系研究

通过１９９８年６月对广东省红海湾海水养殖水域环境因子的调查,阐述了海水中溶解氧、盐度、ｐＨ值和营养盐的分布特征及其变化规律,并讨论了它们之间的相互关系,结果表明,溶解氧及海水ｐＨ值随温度由北（除１５￣１７号站）向南（除６号站）增高而增高。同时证实了光合作用是导致溶解氧含量和ｐＨ值增高的主要原因。而营养盐与盐度呈密度的负相关,浮游植物总量随营养盐由北向南降低而明显增高。     

大亚湾大鹏澳养殖海区水化学指标的变化及营养状况分析

根据 １９９４年 ７月和 １０月、１９９５年 １月和 ４月对大亚湾大鹏澳养殖海区的现场调查,统计了各水化学指标的变化范围和平均值;讨论了Ｎ／Ｐ值的季节变化;以ＣＯＤ、ＴＩＮ、ＰＯ~３－_４－Ｐ和Ｃｈｌ－ａ为分析指标,用营养状态质量指数（ＮＱＩ）分析了该海区的营养状态;并用叶绿素法估算了养殖海区的初级生产力。     

池养长毛对虾体长与体重的关系

本文报道池养长毛对虾体长在６．８－１２３．９ｍｍ范围内的体长与体重的关系。池养长毛对虾雌、雄群体的生长特点是雌虾快于雄虾。由雌雄混合、雌虾、雄虾群体的体重对体长的相关曲线都很接近。     

发展海洋循环经济浅析

文章从分析我国海洋经济发展存在的问题入手,尝试借鉴循环经济的理念,探讨海洋经济可持续发展的实现途径。通过对发展海洋循环经济的内涵、原则和实现途径等内容的探索式研究,提出发展海洋循环经济的对策与建议。     

假晴东方鲀人工育苗研究

假晴东方鲀人工育苗获得４１．８ｍｍ种苗３５１０００尾，每立方水体出 苗８６０尾。越冬成活率９１．６％，增重率６１．８％。利用室内水泥池及养虾土池 养成商品鱼，分别获得１９６９ ｇ／ｍ３和 ２０８ ｋｇ／亩的收成。