The influence of gas bubbles on sediment acoustic properties: in situ, laboratory, and theoretical results from Eckernförde Bay, Baltic sea

Acoustic turbidity caused by the presence of gas bubbles in seafloor sediments is a common occurrence worldwide,but is as yet poorly understood. The Coastal Benthic Boundary Layer experiment in the Baltic off northern Germany was planned to better characterize the acoustic response of a bubbly sediment horizon. In this context, in situ measurements of compressional wave speed and attenuation were made over the frequency range of 5–400 kHz in gassy sediments of Eckernförde Bay. Dispersion of compressional speed data was used to determine the upper limit of the frequency of methane bubble resonance at between 20 and 25 kHz. These data, combined with bubble size distributions determined from CT scans of sediments in cores retained at ambient pressure, yield estimates of effective bubble sizes of 0.3–5.0 mm equivalent radius. The highly variable spatial distribution of bubble volume and bubble size distribution is used to reconcile the otherwise contradictory frequency-dependent speed and attenuation data with theory. At acoustic frequencies above resonance (>25 kHz) compressional speed is unaffected by bubbles and scattering from bubbles dominates attenuation. At frequencies below resonance (<1 kHz) ‘compressibility effects’ dominate, speed is much lower (250 m s^-1) than bubble-free sediments, and attenuation is dominated by scattering from impedance contrasts. Between 1.5 and 25 kHz bubble resonance greatly affects speed and attenuation. Compressional speed in gassy sediments (1100–1200 m s^-1) determined at 5–15 kHz is variable and higher than predicted by theory (<250 m s^-1). These higher measured speeds result from two factors: speeds are an average of lower speeds in gassy sediments and higher speeds in bubble-free sediments; and the volume of smaller-sized bubbles which contribute to the lower observed speeds is much lower than total gas volume. The frequency-dependent acoustic propagation is further complicated as the mixture of bubble sizes selectively strips energy near bubble resonance frequencies (very high attenuation) allowing lower and higher frequency energy to propagate. It was also demonstrated that acoustic characterization of gassy sediments can be used to define bubble size distribution and fractional volume.     

Geological and archaeological evidence for post– Roman earthquake surface faulting at Cibyra,SW Turkey

Abstract

The NE-SW-trending Burdur–Fethiye fault zone is one of the major active fault zones of southwestern Turkey and the ancient city of Cibyra is located on this zone. Segments of the Burdur–Fethiye fault zone have ruptured in the historical period and during the 20th century. A detailed investigation in the ancient city of Cibyra showed the presence of faults sinistrally offset sitting rows of the stadium up to 50 cm. In addition, there are broken corners of blocks, collapsed walls, broken columns, and tilted and toppled blocks in existing major buildings in the city centre. Field observations showed that fractures and associated damage at Cibyra Produced by a post-Roman earthquake, possibly during the 417-A.D.-earthquake which had an intensity of 9 on the MSK scale. © 2001 Éditions scientifiques et médicales Elsevier SAS.     

Validation and Application of Plants as Biomonitors of Trace Element Atmospheric Pollution – A Co-Ordinated Effort in 14 Countries

The International Atomic Energy Agency (IAEA) organized a co-ordinated research project (CRP) on Validation and application of plants as biomonitors of trace element atmospheric pollution analysed by nuclear and related techniques involving 14 participating countries. The CRPs objective was to identify appropriate bioindicators for local and/or regional application and validate them for general air pollution monitoring. Activities included quantification studies, research into spatial and time resolution for particular organisms, and physiological studies. A number of suitable bioindicators were identified in different parts of the globe and tested during the CRP. Sampling strategies were reviewed and the recommended approach adopted by the group. Appropriate sample preparation procedures were assessed and harmonised to the degree allowed by different geographic and climatic conditions in the participating countries. Two interlaboratory comparison exercises were carried out on lichen and moss materials. Results confirmed definite improvement in analytical performance of the participating laboratories, but also revealed possible inconsistencies due to different sample processing procedures. Several monitoring surveys were carried out and consequently pollution maps drawn for extended areas or countries. Overall results confirmed applicability of lower plants for assessing the degree of atmospheric pollution and provided several countries with effective monitoring tools not used before.     

A new semi-quantitative Surface-Enhanced Raman Spectroscopy (SERS) method for detection of maleimide (2,5-pyrroledione) with potential application to astrobiology

Nitrogen-containing heterocyclic compounds are fundamental biochemical components of all life on Earth and, presumably, life elsewhere in our solar system. Dete...     

Areal extent of the 1988 flood in Bangladesh: How much did the satellite imagery show?

This paper presents the methods and results of visual interpretation of satellite imagery for estimating areal extent of the 1988 flood in Bangladesh. The main limitation of this method was that cloud-free images were not available for the peak flood period in the first week of September. Relatively cloud-free images on three selected dates in the last three weeks of September showed that areas of inundation on those dates ranged from 44000 to 60000 km² ± 5% (31 to 42% of Bangladesh). The Government of Bangladesh official estimates of the areal extent of flooding were tentative in nature, since these were based on a choropleth map of relative proportions (percentages) of flooding in different parts of the country. The official estimate of the maximum extent of flooding was 82000 km² (57% of Bangladesh), i.e. 15 to 26% larger than the area shown on satellite imagery. The actual extent of flooding was certainly larger than the estimates from satellite imagery but, perhaps, smaller than the official estimates, since a reduction of 15 to 26% of flood area in one to three weeks seemed unlikely. An alternative method of mapping flood-affected areas by using newspaper-interpreted data was attempted, but the method had limited values because of reporting bias.     

Correlated Nd,Sr and Pb isotope variation in Walvis Ridge basalts and implications for the evolution of their mantle source

Basement intersected in DSDP holes 525A, 528 and 527 on the Walvis Ridge consists of submarine basalt flows and pillows with minor intercalated sediments. These holes are situated on the crest and mid and lower northwest flank of a NNW-SSE-trending ridge block which would have closely paralleled the paleo mid-ocean ridge [13, 14]. The basalts were erupted approximately 70 m.y. ago, an age equivalent to that of immediately adjacent oceanic crust in the Angola Basin and consistent with formation at the paleo mid-ocean ridge [14]. The basalt types vary from aphyric quartz tholeiites on the ridge crest to highly plagioclase phyric olivine tholeiites on the ridge flank. These show systematic differences in incompatible trace element and isotopic composition. Many element and isotope ratio pairs form systematic trends with the ridge crest basalts at one end and the highly phyric ridge flank basalts at the other.The low ¹⁴³Nd/¹⁴⁴Nd (0.51238), ²⁰⁶Pb/²⁰⁴Pb (17.54), ²⁰⁸Pb/²⁰⁴Pb (15.47), ²⁰⁸Pb/²⁰⁴Pb (38.14) and high⁸⁷Sr/⁸⁶Sr (0.70512) ratios of the ridge crest basalts suggest derivation from an old Nd/Sm-, Rb/Sr- and Pb/U-enriched mantle source. This isotopic signature is similar to that of alkaline basalts on Tristan de Cunha but offset to significantly lower Nd and Pb isotopic ratios. The isotopic ratio trends may be extrapolated beyond the ridge flank basalts with higher¹⁴³Nd/¹⁴⁴Nd (0.51270), ²⁰⁶Pb/²⁰⁴Pb (18.32), ²⁰⁷Pb/²⁰⁴Pb (15.52), ²⁰⁸Pb/²⁰⁴Pb (38.77) and lower ⁸⁷Sr/⁸⁶Sr (0.70417) ratios in the direction of increasingly Nd/Sm-, Rb/Sr- and Pb/U-depleted source compositions. These isotopic correlations are equally consistent with mixing od depleted and enriched end member melts or partial melting of an inhomogenous, variably enriched mantle source. However, observe ZrBaNbY interelement relationships are inconsistent with any simple two-component model of magma mixing, as might result from the rise of a lower mantle plume through the upper mantle. Incompatible element and Pb isotopic systematics also preclude extensive involvement of depleted (N-type) MORB material or its mantle sources. In our preferred petrogenetic model the Walvis Ridge basalts were derived by partial melting of mantle similar to an enriched (E-type) MORB source which had become heterogeneous on a small scale due to the introduction of small-volume melts and metasomatic fluids.     

Volcanogenic massive sulfide deposits of ophiolite associations

Volcanogenic massive sulfide deposits in ophiolite complexes are usually attributed to the Cyprus type. They associate with basaltic volcanics that are formed in mid-ocean or back-arc spreading centers and much less frequently in intra-plate settings. The deposits are characterized by copper or copper-zinc ores that are enriched in Ni, Co, and in places Mn and As, but are very poor in Pb and demonstrate a low to moderate content of Ag and Au. Typically, the deposits are low to very low in ore and metal reserves. Cyprus-type deposits were irregularly distributed during geological history. The most ancient of them were formed in the Neoproterozoic, while the bulk of the deposits are Ordovician or Cretaceous in age. Their possible Paleoproterozoic analogues can be found in the Svecofennian belt (Outokumpu ore district), while modern ones are confined to the Explorer and Endeavour Ridges and southern segment of the Juan de Fuca Ridge.     

Formation of atoll garnets in the UHP eclogites of the Tso Morari Complex,Ladakh, Himalaya

The eclogites of the Tso Morari Complex, Ladakh, NW Himalayas preserve both garnets with spectacular atoll textures, as well as whole porphyroblastic garnets. Whole garnets are euhedral, idiomorphic and enclose inclusions of amphibole, phengite and zoisite within the cores, and omphacite and quartz/coesite towards the rims. Detailed electron microprobe analyses and back-scattered electron images show well-preserved prograde zoning in the whole garnets with an increase in Mg and decrease in Ca and Mn contents from the core to the rim. The atoll garnets commonly consist of euhedral ring over island/peninsular core containing inclusions of phengite, omphacite and rarely amphibole between the core and ring. Compositional profiles across the studied atoll grains show elemental variations with higher concentrations of Ca and Mn with low Mg at the peninsula/island cores; contrary to this low Ca, Mn and high Mg is observed at the outer rings. Temperature estimates yield higher values at the Mg-rich atoll garnet outer rings compared to the atoll cores. Atoll garnet formation was favoured by infiltration of fluid formed due to breakdown of hydrous phases, and/or the release of structurally bounded OH from nominally anhydrous minerals at the onset of exhumation. Infiltration of fluids along pre-existing fracture pathways and along mineral inclusion boundaries triggered breakdown of the original garnet cores and released elements which were subsequently incorporated into the newly-grown garnet rings. This breakdown of garnet cores and inward re-growth at the outer ring produced the atoll structure. Calibrated geo-thermobarometers and mineral equilibria reflect that the Tso Morari eclogites attain peak pressures prior to peak temperatures representing a clockwise path of evolution.