Production of rhamnolipids by Pseudomonas aeruginosa growing on carbon sources

Arhamnolipid producing bacterium, Pseudomonas aeruginosa was previously isolated from Iranian oil over years. Isolated strain was identified by morphological, biochemical, physiological and 16 sr RNA (1). Glycolipid production by isolated bacterium using sugar beet molasses as a carbon and energy source was investigated. Biosurfactant production was quantified by surface tension reduction, Critical Micelle Dilution (CMD), Emulsification Capacity (EC), and Thin Layer Chromatogeraphy. biosurfactants during growth on waste Dates as the primary carbon and nitrogen sources, respectively. After 48 h of growth the culture supernatant fluid had a rhamnose concentration of 0.18 g/L and surface tension was reduced to 20 mN/m ( %).( reduced the interfacial tension against crude oil from 21 mN/m to 0,47 mN/m) Result from the study showed that the growth of the bacteria using molasses as carbon sources is growth-associated. The specific production rate of rhamnolipid with 2 %, 4 %, 6 %, 8 % and 10 % of molasses are 0.00065; 4.556; 8.94; 8.85; and 9.09. respectively The yield of rhamnolipid per biomass with 2%,4%,6%,8% and 10% molasses are 0.003;0.009;0.053;0.041 and 0.213 respectively. The production of rhamnolipid (0.0531 g rhamnolipid/g biomass) is higher compare to the culture grown in aerobic condition (0.04 g rhamnolipid/g biomass).The rhamnolipids were able to form stable emulsions with n-alkanes, aromatics, crude oil and olive oil. These studies indicate that renewable, relatively inexpensive and easily available resources can be used for important biotechnological processes.     

Slow arsenic poisoning of the contaminated groundwater users

This paper gives impact of Arsenic contaminated water on human health as well as overview of the extent and severity of groundwater arsenic contamination in Bangladesh. Scalp hair is the most important part of the human body to monitor the accumulation of this type of poison. Therefore, an experiment has been carried out by Neutron Activation Analysis (NAA) at Atomic Energy Research Establishment (AERE), Savar, Dhaka, Bangladesh on human hair of corresponding tube well water users of these areas to determine the total accumulation of arsenic to their body. Hair samples collected from the region where the groundwater was found highly contaminated with arsenic. The obtained results of arsenic concentration in the lower age (Hb) categories of users (below 12 years of age users) is in the range of 0.33 to 3.29 /gmg/g (ppm) and that in the Hu categories (upper 12 years of age users) is 0.47 to 6.64 μg/g (ppm). Where as maximum permissible range is 1 ppm certified from WHO. Results show that the peoples are highly affected where the groundwater is highly contaminated with arsenic and acts as the primary source of arsenic poisoning among the peoples of those areas. The results indicate that human population is affected with arsenic locally using the contaminated water for a long time.     

The removal of color and COD from wastewater containing water base color by coagulation process

In this study acrylic water base color was removed from synthetic wastewater using coagulation process. Experiments were conducted on the sample containing 100 mg/L and 400 mg/L of acrylic water base color. Destruction of color by means of coagulation/flocculation techniques using ferrous sulfate, alum, lime and polyelectrolyte (cationic, anionic and non ionic). The study was performed in a systematic approach searching optimum values of alum and FeSO₄ concentration, pH and temperature. All the experiments were run in a laboratory scale.The obtained results show that treatment with alum and ferrous sulfate alone proved to be very effective in removing the color (> 99 %) and part of COD (60–70 %) from aqueous solution. Lime alone did not significant change on COD and color removal.     

Variability in Early Amazonian Tharsis stress state based on wrinkle ridges and strike-slip faulting

We present evidence for a decrease in the magnitude of Tharsis-circumferential compressive stress during the Late Hesperian to the Middle Amazonian based on chronologic changes in the predominant style of faulting in southern Amazonis Planitia. Using high-resolution MOLA topography, we identify a population of strike-slip faults that exhibit Middle Amazonian-aged displacements of regional chrono-stratigraphic units. These strike-slip faults are adjacent to an older population of previously documented Late Hesperian-aged thrust faults (wrinkle ridges). Along-strike orientations of these thrust and strike-slip faults reveal the Tharsis-radial stress to be the area's most compressive remote principal stress and that this stress orientation and magnitude persisted throughout the Late Hesperian to the Middle Amazonian. We show that the change in the predominant style of faulting from thrust faulting to strike-slip faulting during this time requires a decrease of the Tharsis-circumferential compressive stress to a magnitude less than lithostatic load, with negligible change in stress orientation.     

Displacement-length scaling relations for faults on the terrestrial planets

Displacement-length (D/L)scaling relations for normal and thrust faults from Mars, and thrust faults from Mercury, for which sufficiently accurate measurements are available, are consistently smaller than terrestrial D/L ratios by a factor of about 5, regardless of fault type (i.e. normal or thrust). We demonstrate that D/L ratios for faults scale, to first order, with planetary gravity. In particular, confining pressure modulates: (1) the magnitude of shear driving stress on the fault; (2) the shear yield strength of near-tip rock; and (3) the Young's (or shear) modulus of crustal rock. In general, all three factors decrease with gravity for the same rock type and pore-pressure state (e.g. wet conditions). Faults on planets with lower surface gravities, such as Mars and Mercury, demonstrate systematically smaller D/L ratios than faults on larger planets, such as Earth. Smaller D/L ratios of faults on Venus and the Moon are predicted by this approach, and we infer still smaller values of D/L ratio for faults on icy satellites in the outer solar system. Collection of additional displacement-length and down-dip height data from terrestrial normal, strike-slip, and thrust faults, located within fold-and-thrust belts, plate margins, and continental interiors, is required to evaluate the influence of fault shape and progressive deformation on the scaling relations for faults from Earth and elsewhere.     

An electrochemical study of pyrite oxidation in the presence of carbon coatings in cyanide medium

The anodic and cathodic behaviour of pyrite with clay and different carbon coatings of activated carbon, graphite and carbonaceous matter in cyanide medium was investigated using the potentiodynamic method. The presence of clay coating did not change the polarisation curve appearance for either the anodic oxidation of pyrite or the cathodic reduction of oxygen or the potential of the current plateau, but only decreased the plateau current especially at a higher coating thickness. The presence of the carbon coatings marginally shifted the rest potential for pyrite to a more anodic position and slightly changed the polarisation curve appearance for pyrite oxidation. The current density for pyrite oxidation largely increased in the presence of the carbon coatings, the potential at the plateau shifted to more cathodic positions, and the plateau width became smaller. These effects became more noticeable at a higher coating thickness. The activated carbon, graphite and carbonaceous matter coatings performed similarly in affecting pyrite oxidation at a similar thickness. The carbon coatings significantly increased the limiting current densities for oxygen reduction on pyrite, and the limiting current plateau became steeper at a higher coating thickness. The carbon coatings increased the limiting current density for oxygen reduction to a similar extent at a low coating thickness, but increased to varied extents at a higher coating thickness. The carbon coatings also greatly increased the cathodic current density for gold reduction on pyrite. The enhancement of pyrite oxidation and oxygen or gold reduction on pyrite by the carbon coatings was likely attributed to the electrochemical interaction between pyrite and the carbon materials with electron-rich surfaces and high conductivity. The presence of the carbon coatings significantly increased the oxidation of pyrite in aerated cyanide solutions and the preg-robbing of pyrite especially at a higher coating thickness.     

Paleoproterozoic (2155–1970 Ma) evolution of the Guiana Shield (Transamazonian event) in the light of new paleomagnetic data from French Guiana

We present a comprehensive paleomagnetic study on Paleoproterozoic (2173–2060 Ma) plutonic and metamorphic rocks from French Guiana, representative of the full range of the main Transamazonian tectonothermal steps. Twenty-seven groups of directions and poles were obtained from combination of 102 sites (613 samples) based on age constraint, similar lithology and/or geographical proximity. Paleomagnetic results show variations between rocks of different ages which are supposed to be characteristic of magnetizations acquired during uplift and cooling of successive plutonic pulses and metamorphic phases. This is also reinforced by positive field tests (baked contact and reversal tests). Recent U/Pb and Pb/Pb on zircon and complementary ⁴⁰Ar/³⁹Ar on amphibole and biotite allow questioning the problem of magnetic ages relative to rock formation ages. Estimated magnetic ages, based on amphibole dating as a proxy, enable us to construct a Guiana Shield apparent polar wander path for the 2155–1970 Ma period. It is also possible to present paleolatidudinal evolution and continental drift rates related to specific Transamazonian tectonic regimes.French Guiana and probably the Guiana Shield were located at the Equator from ca. 2155 to 2130 Ma during the Meso-Rhyacian D1 magmatic accretion phase, related to subduction of Eorhyacian oceanic crust. After closure of the Eorhyacian Ocean and collision of West African and Amazonian plates, the Guiana Shield moved. The first evolution towards 60° latitude, occurs after 2080 Ma, during the Neorhyacian D2a post collisional sinistral transcurrent phase. During the Late Rhyacian D2b phase, up to 2050 Ma, the Guiana Shield reaches the pole and starts to move to lower latitudes on an opposite meridian. By the Orosirian D2c phase, from ca. 2050 to 1970 Ma, the Guiana Shield reaches the Equator.Based on the amphibole ⁴⁰Ar/³⁹Ar dates, we estimate the continental drift between 12 and 16 cm/y for the Meso to Late Rhyacian period followed by a lower rate between 9 and 14 cm/y up to Orosirian time. This study highlights rock ages and magnetic ages are prerequisite to any continental reconstruction especially when it is shown continental drift is important for a 100–200 Ma time period. Our results confirm the possibility of APWP construction on Paleoproterozoic plutonic rocks but suggest improvement will rely on the combination with multidisciplinary approaches such as structural geology and multi-method radiometric dating.     

Developments in the characterisation of waste materials for environmental impact assessment purposes

The characterisation of waste is entering a new phase with the latest developments of characterisation leaching tests and associated modelling capabilities. The currently applied too simple testing approaches lead to poor choices in waste management. With the increased insight in release controlling processes chemical speciation aspects can be addressed even in the most complex and heterogeneous waste materials. From a composition perspective materials may be highly variable, but often materials are far more consistent in their leaching behaviour. This aspect should be exploited more extensively as it holds the key to treat waste materials in such a way that long term solutions are achieved rather than reaching temporary gains.     

The bimodal rift-related Juscelândia volcanosedimentary sequence in central Brazil: Mesoproterozoic extension and Neoproterozoic metamorphism

The Barro Alto Complex and Juscelândia volcanosedimentary sequence are exposed in the central part of the Neoproterozoic Brasília belt of central Brazil. The former is a large (approximately 150 km long), boomerang-shaped, mafic-ultramafic, layered complex formed by two different intrusions metamorphosed under granulite facies. These rocks are tectonically overlain by rocks of the Juscelândia volcanosedimentary sequence, represented mainly by biotite-gneiss and amphibolite, or amphibolite facies metamorphic equivalents of rhyolite and basalt, respectively. New SIMS U–Pb zircon data and Sm–Nd isochron data presented herein help clarify the igneous and metamorphic evolution of the Juscelândia volcanosedimentary sequence, as well as its relationship with the Barro Alto Complex. Zircon grains from two biotite gneisses were analyzed by SIMS (SHRIMP) and indicate Mesoproterozoic dates, approximately 1.28 Ga, interpreted as the time of bimodal volcanism in a tectonic setting transitional between a continental rift and an ocean basin. Metamorphism is constrained by Sm–Nd garnet-whole-rock isochrons for garnet amphibolite and pelitic schists of the Juscelândia sequence, as well as for clinopyroxene-garnet amphibolite and garnet granulite of the Barro Alto Complex, which give ages between 0.74 and 0.76 Ga, in agreement with SIMS dates for metamorphic zircon rims. These new data are significant, because they establish that a single metamorphic event affected both the Barro Alto Complex and the Juscelândia sequence. Based on these new data, we present a modified tectonic model for the Brasília belt.     

The seismic hazard assessment of the Dead Sea rift, Jordan

The Dead Sea fault system and its branching faults represent one of the most tectonically active regions in the Middle East. The aim of this study is to highlight the degree of hazards related to the earthquake activities associated with the Dead Sea rift, in terms of speculating the possible future earthquakes. The present investigation mainly is based on available data and vertical crustal modeling of Jordan and the Dead Sea model for the Dead Sea basin with particular emphasis of the recent earthquake activities, which occurred on December 31st, 2003 (Mc = 3.7), February 11th, 2004 (strongest Mc = 4.9 R), and March 15th, 2004 (Mc = 4). The present research examines the location of the strong events and correlates them with the various tectonic elements in the area. The source mechanism of the main shock and the aftershock events is also examined. The analyses were based on the available short period seismogram data, which was recorded at the Natural Resources Authority of Jordan, Seismological Observatory. The seismic energy appears to have migrated from the south to the north during the period from December 31st up to March 12th, where the released seismic energy showed a migration character to the southern block of the eastern side of the Dead Sea, which led the seismic event to occur on March 15th.