Hydrogeochemical assessment of groundwater in Kashmir Valley,India

Groundwater samples (n = 163) were collected across Kashmir Valley in 2010 to assess the hydrogeochemistry of the groundwater in shallow and deep aquifers and its suitability for domestic, agriculture, horticulture, and livestock purposes. The groundwater is generally alkaline in nature. The electrical conductivity (EC) which is an index to represent the total concentration of soluble salts in water was used to measure the salinity hazard to crops as it reflects the TDS in groundwater ranging from 97 to 1385 μS/cm, except one well in Sopore. The average concentration of major ions was higher in shallow aquifers than in deeper aquifers. In general, Ca²⁺ is the dominant cation and HCO \(_{3}^{-}\) the dominant anion. Ca–HCO₃, Mg–HCO₃, Ca–Mg–HCO₃, Na–HCO₃ were the dominant hydrogeochemical facies. High concentration of HCO₃ and pH less than 8.8 clearly indicated that intense chemical weathering processes have taken place in the study area. The groundwater flow pattern in the area follows the local surface topography which not only modifies the hydrogeochemical facies but also controls their distribution. The groundwater in valley flows into four directions, i.e., SW–NE, NE–W, SE-NW and SE–NE directions. The results suggest that carbonate dissolution is the dominant source of major ions followed by silicate weathering and ion-exchange processes. The concentrations of all the major ions determined in the present study are within the permissible limits of WHO and BIS standards. The results of Total Hardness, SAR, Na%, Kelly Index, USDA classification, Magnesium absorption ratio, residual sodium carbonate, and PI suggested that groundwater is good for drinking, livestock, and irrigation purposes.     

Pervasive melt percolation reactions in ultra-depleted refractory harzburgites at the Mid-Atlantic Ridge, 15° 20′N: ODP Hole 1274A

ODP Leg 209 Site 1274 mantle peridotites are highly refractory in terms of lack of residual clinopyroxene, olivine Mg# (up to 0.92) and spinel Cr# (∼0.5), suggesting high degree of partial melting (>20%). Detailed studies of their microstructures show that they have extensively reacted with a pervading intergranular melt prior to cooling in the lithosphere, leading to crystallization of olivine, clinopyroxene and spinel at the expense of orthopyroxene. The least reacted harzburgites are too rich in orthopyroxene to be simple residues of low-pressure (spinel field) partial melting. Cu-rich sulfides that precipitated with the clinopyroxenes indicate that the intergranular melt was generated by no more than 12% melting of a MORB mantle or by more extensive melting of a clinopyroxene-rich lithology. Rare olivine-rich lherzolitic domains, characterized by relics of coarse clinopyroxenes intergrown with magmatic sulfides, support the second interpretation. Further, coarse and intergranular clinopyroxenes are highly depleted in REE, Zr and Ti. A two-stage partial melting/melt–rock reaction history is proposed, in which initial mantle underwent depletion and refertilization after an earlier high pressure (garnet field) melting event before upwelling and remelting beneath the present-day ridge. The ultra-depleted compositions were acquired through melt re-equilibration with residual harzburgites. Electronic supplementary material Supplementary material is available in the online version of this article at and is accessible for authorized users.     

Content and distribution of trace metals in surface sediments from the northern Bering Sea, Chukchi Sea and adjacent Arctic areas

Concentrations of trace metals (Zn, Cr, Cu, V, Cd and Pb), total organic carbon (TOC), black carbon (BC) and their granulometry were examined in 25 surface sediment samples from the northern Bering Sea, Chukchi Sea and adjacent areas. Trace metal concentrations in the sediments varied from 21.06-168.21 mg kg(-1) for Zn, 8.91-46.94 mg kg(-1) for Cr, 2.69-49.39 mg kg(-1) for Cu, 32.46-185.54 mg kg(-1) for V, 0.09-0.92 mg kg(-1) for Cd, and 0.95-15.25 mg kg(-1) for Pb. The geoaccumulation index (Igeo) indicated that trace metal contamination (Zn and Cd) existed in some stations of the study area. The distribution of grain size plays an important role in influencing the distribution of trace metals (Zn, Cr, Cu, V, and Pb) in sediments from the Chukchi Sea and adjacent areas.     

Tectonostratigraphy and sedimentary architecture of rift basins, with reference to the northern North Sea

A tectonostratigraphic model for the evolution of rift basins has been built, involving three distinct stages of basin development separated by key unconformities or unconformity complexes. The architecture and signature of the sediment infill for each stage are discussed, with reference to the northern North Sea palaeorift system. The proto-rift stage describes the rift onset with either doming or flexural subsidence. In the case of early doming, a proto-rift unconformity separates this stage from the subsequent main rift stage. Active stretching and rotation of fault blocks during the rift stage is terminated by the development of the syn-rift unconformity. Where crustal separation is accomplished, a break-up unconformity commonly marks the boundary to the overlying thermal relaxation or post-rift stage. Tabular architectures, thickening across relatively steep faults, characterize the proto-rift stage. Syn-rift architectures are much more variable. Depending on the ability of the sediment supply to fill the waxing and waning accommodation created during rotation and subsidence, one-, two- or three-fold lithosome architectures are likely to develop. During the post-rift stage, an early phase with coarse clastic infilling of remnant rift topography often precedes late stage widening of the basin and filling with fine-grained sediments.     

Calculation of ship collision avoidance manoeuvres: A simplified approach

The moment at which in a two-ship encounter a collision avoidance manoeuvre should be initiated in order to achieve a specific distance at the closest point of approach has been calculated. The calculations were based on the kinematics of encounter and simplified equations of motion. Mathematical equations which relate the maneouvring distance, the turning direction and the extent of course change for any desired passing distance and any given turning rate are determined. Knowledge of these quantities is essential for the safe conduct of the ship with automatic, computer-assisted navigation as well as with ordinary, manual navigation if the navigator no longer contents himself with estimates but wishes to know precisely in advance the outcome of any specific manoeuvre he chooses.     

Optimization of an ocean thermal energy conversion system

The optimum performance of a simple Rankine cycle ocean thermal energy conversion plant is investigated analytically. It is shown that the ratio of maximum net power output to heat exchanger surface area varies as H(Δt − t₀)² where H describes the overall heat transfer properties of the evaporator and condenser, Δt is the temperature difference between the warm and cold sea water supplies, and t₀ is a parameter depending primarily upon the pressure drops across the warm and cold sea water pumping systems. The model is relatively insensitive to the choice of working fluid, although ammonia is used as the illustrative example.     

The Structure of A Turbulent Jet in A Crossflow-Effect of Jet-Crossflow Velocity

A comprehensive numerical study on the three-dimensional structure of a turbulent jet in crossflow is performed. The jet-to-crossflow velocity ratio (R) varies in the range of 2 - 16; both vertical jets and inclined jets without excess streamwise momentum are considered. The numerical results of the Standard two-equation k-ε model show that the turbulent structure can be broadly categorised according to the jet-to-crossflow velocity ratio. For strong to moderate jet discharges, i.e. R> 4, the jet is characterized by a longitudinal transition through a bent-over phase during which the jet becomes almost parallel with the main freestream, to a sectional vortex-pair flow with double concentration maxima; the computed flow details and scalar mixing characteristics can be described by self-similar relations beyond a dimensionless distance of around 20-60. The similarity coefficients are only weakly dependent on R. The cross-section scalar field is kidney-shaped and bifurcated, vvith distinct double concentr     

Bannock Basin,Sirte Abyssal Plain and Conrad Spur: structural relationships between Mediterranean Ridge and its western foreland and implications on the character of the accretionary complex (eastern Mediterranean)

In previous publications, the relationship between the Sirte Abyssal Plain as foreland and the Mediterranean Ridge as accretionary complex was considered to be simple: the foreland is undeformed, the accretionary complex consumes the foreland, the Messinian evaporites control the internal structure of the growing complex. The compilation of our own and published data results in a more complex tectonic pattern and a new geodynamic interpretation. The Sirte Abyssal Plain is imprinted by extensional tectonics which originated independently from and prior to the approaching process of accretion. The structural setting of the pre-Messinian and Messinian Sirte Abyssal Plain is responsible for the highly variable thickness of Messinian evaporites. The foreland setting in the Sirte Abyssal Plain also controls the internal structure of the Mediterranean Ridge, at least between the deformation front and Bannock Basin, following sediment deformation within the accretionary wedge with a dominating inherited SW-NE orientation. The taper angle of the post-Messinian Mediterranean Ridge is unusually small compared with other accretionary wedges. In the studied area, within a distance of about 45 km from the deformation front, there is no appreciable dip in the décollement. Therefore, the slope of the outer 45 km of the Mediterranean Ridge is considered to be caused only by gravitational spreading of Messinian evaporites deposited on the slope of pre-Messinian accretionary wedge. As a consequence, the Mediterranean Ridge underlying such slope is interpreted to belong to the foreland. The allochthonous evaporites overlie autochthonous evaporites of the Sirte Abyssal Plain. The NE-dipping décollement (and thus of the true tectonically driven deformation front) is expected to initiate at about the present position of Bannock Basin. The Sirte Abyssal Plain, the adjacent Cyrene Seamount and neighbouring seafloor relief on the African continental margin are considered to be the product of tectonic segmentation of the continental crust.