Strontium-calcium ratios in Cenozoic planktonic foraminifera

The $\text{Sr}\text{Ca}$ ratio and other parameters have been measured in fossil planktonic foraminifera from the Atlantic and Pacific Ocean basins in order to evaluate the $\text{Sr}\text{Ca}$ ratio of seawater during the last 75 million years. Results on well-preserved samples indicate that the ratio has increased to its present value by 10–15% during the Cenozoic, and that minima occurred between 55-45 Ma and 10-5 Ma, when the ratio was 15–25% less than at present. The long-term increase may reflect either decreasing deposition of aragonite with a high $\text{Sr}\text{Ca}$ ratio in shallow seas, or decreasing seafloor spreading rates and consequently decreasing hydrothermal supply of Ca during the Cenozoic. Other geologic evidence suggests that the Eocene minimum (near 50 Ma) may have resulted from increased aragonite sedimentation, while the Late Miocene minimum (between 10-5 Ma) may have been caused by an increased rate of seawater-basalt exchange when seafloor spreading rates increased on the East Pacific Rise near 10 Ma.     

An iterative method for boundary element solution of large offshore structures using the GMRES solver

The GMRES approach is used to solve complex matrix solution arising from boundary element analysis of large offshore structures. This makes it possible to solve problems with large numbers of panels on a workstation with a much smaller memory than typical high performance computers. The speed of the solver is compatible with direct solvers when the enough RAM is available. Otherwise, an iteration procedure can be used. By using an out-of-core treatment, typical RAM requirement is reduced to a size approximately linearly proportional to the panel number n instead of being proportional to n². The code is first verified with direct solver for cases with small number of panels. The applicability to large offshore structure of the model is demonstrated for a TLP case.     

Small Format Digital Cameras for Aerial Survey: Where Are We Now?

This paper introduces the subject of digital sensors for aerial survey by reviewing the use made of small format digital cameras in such an application. The major advantages and disadvantages of employing such consumer technology for aerial survey are highlighted. Finally, a specification is proposed for a minimum requirement for a digital solution based on a single area array sensor.     

Hooker's sea lions in southern New Zealand

The discovery at Stewart Island of a hauling‐out ground regularly used by Hooker's sea lions (Phocarctos hooked) is described, and recent sightings of sea lions in southern New Zealand are reported. An attempted copulation between a male Hooker's sea lion and a dead female fur seal (Arctocephalus forsteri) is also described.     

Sieve‐bucket for rapid field separation of macrofauna from bottom samples (note)

A lidded, 18‐litre sieve bucket was used to separate benthic macroinvertebrates from samples of mud taken with an Ekman grab. The device is operated in shallow water near the shore, and an entire Ekman grab sample (up to 10 litres) can be sieved in 5–10 min.     

Seasonality and duration in extreme value distributions of significant wave height

This paper presents a statistical model to characterize the long-term extreme value distribution of significant wave height, conditioning to the duration of the storm and accounting for seasonality. A time-dependent version of the peak over threshold (POT) approach is used to build the model, which is then applied to specific reanalysis time series and NOAA buoy records. The model considers the annual and semiannual cycles which are parameterized in terms of harmonic functions. The inclusion of seasonal variabilities substantially reduces the residuals of the fitted model. The information obtained in this study can be useful to design maritime works, because (a) the model improves the understanding of the variability of extreme wave climate along a year and (b) the model accounts for the duration of the storm, which is a key parameter in several formulations for rubble mound breakwater design.     

Determination of phospholipid fatty acid structures and stable carbon isotope compositions of deep-sea sediments of the Northwest Pacific, ODP site 1179

Sediment samples ranging from 0.05 to 278 m below sea floor (mbsf) at a Northwest Pacific deep-water (5564 mbsl) site (ODP Leg 191, Site 1179) were analyzed for phospholipid fatty acids (PLFAs). Total PLFA concentrations decreased by a factor of three over the first meter of sediment and then decreased at a slower rate to approximately 30 mbsf. The sharp decrease over the first meter corresponds to the depth of nitrate and Mn(IV) reduction as indicated by pore water chemistry. PLFA-based cell numbers at site 1179 had a similar depth profile as that for Acridine orange direct cell counts previously made on ODP site 1149 sediments which have a similar water depth and lithology. The mole percentage of straight chain saturated PLFAs increases with depth, with a large shift between the 0.95 and 3.95 mbsf samples. PLFA stable carbon isotope ratios were determined for sediments from 0.05 to 4.53 mbsf and showed a general trend toward more depleted δ¹³C values with depth. Both of these observations may indicate a shift in the bacterial community with depth across the different redox zones inferred from pore water chemistry data. The PLFA 10me16:0, which has been attributed to the bacterial genera Desulfobacter in many marine sediments, showed the greatest isotopic depletion, decreasing from − 20 to − 35‰ over the first meter of sediment. Pore water chemistry suggested that sulfate reduction was absent or minimal over this same sediment interval. However, 10me16:0 has been shown to be produced by recently discovered anaerobic ammonium oxidizing (anammox) bacteria which are known chemoautotrophs. The increasing depletion in δ¹³C of 10me16:0 with the unusually lower concentration of ammonium and linear decrease of nitrate concentration is consistent with a scenario of anammox bacteria mediating the oxidation of ammonium via nitrite, an intermediate of nitrate reduction.     

A major element,PGE and Re–Os isotope study of Middle Atlas (Morocco) peridotite xenoliths: Evidence for coupled introduction of metasomatic sulphides and clinopyroxene

We present major element and PGE (platinum-group-element) abundances in addition to Re–Os isotope data for 11 spinel-facies whole rock peridotites from a single maar from the Middle Atlas Mountains, Morocco.Major element systematics of these xenoliths are generally correlated with indices of depletion. FeO–MgO systematics appear to suggest spinel-facies melting in the range of 5 to 25%. However, Al₂O₃ abundances in these xenoliths appear elevated relative to primitive mantle (Prima). The Al₂O₃ abundances in conjunction with other major elements require distinct re-enrichment of the Middle Atlas continental mantle root due to melt/rock reaction and precipitation of amphibole and/or clinopyroxene from passing silicate melts akin to MORB or OIB that evolved in reverse direction along the melting curves in e.g. FeO–MgO space. Sc and V confirm the range of apparent depletion and also indicate that the currently preserved fO₂ in these peridotites is distinctly different from fO₂ conditions observed in subduction zones.The majority of these xenoliths have low Os and Ir (I-PGEs) concentrations relative to Prima and modelled sulphide- and clinopyroxene-depleted residues of mantle melting under low fO₂, mid-ocean ridge-like conditions. Moreover, Pt and Pd (P-PGE) abundances are elevated when compared to their expected abundances after substantial melt extraction. Importantly, the systematically low Ir abundances in the majority of samples show well-correlated trends with Al₂O₃, MgO and Cu that are inconsistent with established melting trends. Os isotopes in the Middle Atlas xenoliths range from ¹⁸⁷Os/¹⁸⁸Os = 0.11604 to 0.12664 although most samples are close to chondritic. The Os isotope ratios are decoupled from ¹⁸⁷Re/¹⁸⁸Os but, together with Re abundances, also exhibit a good correlation with Al₂O₃, MgO and Cu.The major element, I-PGE and Os isotope correlations suggest that the initial melt depletion led to the exhaustion of sulphide and clinopyroxene (20 to 30%) without significant stabilization of I-PGE-rich alloys. During later modal metasomatism of the refractory Middle Atlas continental mantle root with silicate melts akin to MORB or OIB the introduction of clinopyroxene/amphibole reduced the volume of the melt inducing sulphur saturation in these melts causing precipitation of secondary sulphides. This coupled crystallization of pyroxenes and sulphides (chalcopyrite) resulted in the two-component mixing systematics exhibited by I-PGEs, Os isotopes with major elements and Cu preserved in the Middle Atlas continental mantle root.     

新疆西天山高硫化型京希-伊尔曼德金矿床的识别标志及其找矿意义

经过详细的野外地质勘查、热液蚀变及蚀变矿物学研究，流体包裹体和同位素研究，首次将西天山京希－伊尔曼德金矿床确定为高硫化型浅成低温热液金矿床。该矿床的主要识别标志为：发育以多孔状石英为特征的硅化蚀变带和高级泥化蚀变带；成矿流体性质为低盐度[W(NaCl)为0.3-4.2%]、低pH值（3－4）和高氧化态；氧同位素δ（^18O)为1.7 ‰-4.3‰,δ(D)为－60‰--80‰。金主要富集在高级泥化带和中心硅化蚀变带内。系统研究和总结了成矿地质－地球化学制约因素以及区域、靶区和勘探区尺度的找矿标志。