In situ time resolved synchrotron powder diffraction study of thaumasite

Structural changes during dehydration and subsequent decomposition in thaumasite Ca₃Si(SO₄)(CO₃)(OH)₆·12 H₂O were studied by in situ synchrotron powder diffraction between 303 and 1,098 K. Evolution of the crystal structure was observed through 28 structure refinements, by full profile Rietveld analysis performed in the P6₃ space group, between 300 and 417 K, whereupon the thaumasite structure was observed to breakdown. Within this temperature range, the cell parameters of thaumasite increased as a function of temperature in a nearly linear fashion up to about 393 K, at which temperature, a slight slope change was observed. Above 400 K, the thermogravimetric analysis revealed that the dehydration process proceeded very rapidly while the refined occupancy of water molecules dropped below a critical level, leading to instability in the thaumasite structure. At a same time, a remarkable change in the unit cell parameters occurring at about 417 K indicated that the crystal structure of thaumasite collapsed on losing the crystallization water and it turned amorphous. This result indicated that the dehydration/decomposition of thaumasite was induced by the departure of the crystallization water. At about 950 K, anhydrite and cristobalite crystallized from the thaumasite glass.     

Water‐bottom multiple attenuation by Kirchhoff extrapolation

Despite being less general than 3D surface‐related multiple elimination (3D‐SRME), multiple prediction based on wavefield extrapolation can still be of interest, because it is less CPU and I/O demanding than 3D‐SRME and moreover it does not require any prior data regularization. Here we propose a fast implementation of water‐bottom multiple prediction that uses the Kirchhoff formulation of wavefield extrapolation. With wavefield extrapolation multiple prediction is usually obtained through the cascade of two extrapolation steps. Actually by applying the Fermat’s principle (i.e., minimum reflection traveltime) we show that the cascade of two operators can be replaced by a single approximated extrapolation step. The approximation holds as long as the water bottom is not too complex. Indeed the proposed approach has proved to work well on synthetic and field data when the water bottom is such that wavefront triplications are negligible, as happens in many practical situations.     

Low multipath antennas for GNSS-based attitude determination systems applied to high-altitude platforms

High-altitude platforms (HAPs) are a flexible and attractive technology for providing innovative wireless services. These aerial platforms can be successfully employed for mobile or broadband communications and for disaster monitoring or response. However, one of the open issues is whether HAP stations can provide reliable services without temporal outages owing to stratospheric winds that can cause positional and attitude instabilities thus affecting the communication system operation. To counteract this issue, one possible solution is to use reconfigurable antennas whose pointing direction can be adjusted depending on the platform spatial orientation. However, this would require real-time three-axial attitude data. As a possible solution, this paper will review the potential of GNSS-based attitude determination systems with reference to HAP stations. In particular, it will be shown how the use of a particular class of low multipath and lightweight antennas can provide a high degree of accuracy without altering the avionic ballast.     

Improved dynamic correction method in seismic analysis of both classically and non‐classically damped structures

A step‐by‐step approximate procedure taking into consideration high‐frequency modes, usually neglected in the modal analysis of both classically and non‐classically damped structures, is presented. This procedure can be considered as an extension of traditional modal correction methods, like the mode‐acceleration method and the dynamic correction method, which are very effective for structural systems subjected to forcing functions described by analytical laws. The proposed procedure, herein called improved dynamic correction method, requires two steps. In the first step, the number of differential equations of motion are reduced and consequently solved by using the first few undamped mode‐shapes. In the second step, the errors due to modal truncation are reduced by correcting the dynamic response and solving a new set of differential equations, formally similar to the original differential equations of motion. The difference between the two groups of differential equations lies in the forcing vector, which is evaluated in such a way as to correct the effects of modal truncation on applied loads. Copyright © 2001 John Wiley & Sons, Ltd.     

Topographic effects observed at Amatrice hill during the 2016-2017 Central Italy seismic sequence

The estimate of seismic site effects by experimental approaches is based on different assumptions aimed at simplifying the complex actual site conditions and related uncertainties.However,the reliability of the results can increase if the experimental data is focused on quite strong seismic sequences and the on-site acquisition of a large number of signals is deemed strategic for the assessment of the expected phenomena.Based on these considerations,the ground motion at the Red Zone sector of Amatrice hill,violently struck by the 2016-2017 Central Italy seismic sequence,was analyzed via an observational approach.A large set of weak motions(moment magnitude Mw 2.5-3.9)was analyzed in this study by means of standard(SSR)and horizontal to vertical(HVSR)spectral ratio techniques.The results from the experimental analysis of the site effects by using weak motion and noise signals show a significant amplification at the top of Amatrice hill with a remarkable polarization of the motion and changes in spectral shapes according to the topographic setting of the relief.     

Wave equation datuming applied to marine OBS data and to land high resolution seismic profiling

One key step in seismic data processing flows is the computation of static corrections, which relocate shots and receivers at the same datum plane and remove near surface weathering effects. We applied a standard static correction and a wave equation datuming and compared the obtained results in two case studies: 1) a sparse ocean bottom seismometers dataset for deep crustal prospecting; 2) a high resolution land reflection dataset for hydrogeological investigation. In both cases, a detailed velocity field, obtained by tomographic inversion of the first breaks, was adopted to relocate shots and receivers to the datum plane. The results emphasize the importance of wave equation datuming to properly handle complex near surface conditions. In the first dataset, the deployed ocean bottom seismometers were relocated to the sea level (shot positions) and a standard processing sequence was subsequently applied to the output. In the second dataset, the application of wave equation datuming allowed us to remove the coherent noise, such as ground roll, and to improve the image quality with respect to the application of static correction. The comparison of the two approaches evidences that the main reflecting markers are better resolved when the wave equation datuming procedure is adopted.     

Volcanic soil formation in Calabria (southern Italy): The Cecita Lake geosol in the late Quaternary geomorphological evolution of the Sila uplands

This paper focuses on the main morphological, physical, chemical and mineralogical features of an andic-like soil, widely outcropping in the Sila upland plateau of Calabria (southern Italy), and its potential role in tephrostratigraphy. A multidisciplinary and multiscale approach allowed identification of this soil as a “masked” distal archive of volcanic products, developed on granite rocks and sediments with a coeval pyroclastic input during pedogenesis. The study demonstrates that the contribution of volcanic parent materials can be successfully hypothesized and assessed even in the absence, limited extent or poor preservation of primary eruptive products. The soil has an Andisol-like appearance, despite laboratory data that do not match the entire suite of diagnostic criteria for the Andisol taxonomic order. Geomorphological, stratigraphic and pedologic results, coupled with tephrostratigraphic and radiometric data, concur to suggest a Late Pleistocene(?) to Holocene age of the Andisol-like soil. In particular, the rhyolitic chemical composition of small-sized glass fragments (identified by SEM–EDS analyses) indicates soil genesis contributed by volcanic ash, probably sourced from Aeolian Arc explosive activity spanning the last 30 ka. Accordingly, the evidence of limited relict clay illuviation and the specific type of pedogenesis allowing the development of andic properties (in turn related to the neoformation of clay minerals from the weathering of volcanic glass) are consistent with a climatic shift from a seasonally-contrasted to a constantly humid pedoenvironment. This change can be ascribed to the Lateglacial(?) or Early–Middle Holocene to Late Holocene transition. Calibrated AMS ¹⁴C dates performed on charcoal fragments sampled from three representative soil profiles, provide Late Holocene ages (3136 ± 19, 343 ± 16 and 92 ± 24 yr BP), in accord with archaeological finds. On the basis of the consistent stratigraphic position, lateral continuity and wide extent, the soil can be considered a good pedostratigraphic marker in the Sila highlands and is informally defined as the “Cecita Lake geosol”. It supplies valuable time constraints for the underlying (occasionally overlying) deposits and/or soils. Moreover, it allows regional-scale morphostratigraphic correlations and detailed reconstruction of Late Pleistocene–Holocene geomorphic events in Calabria, a very suitable region for distal tephra deposition in the central Mediterranean peri-volcanic area. The effects of high-energy volcanic eruptions are interfingered with or superimposed by other geomorphic processes and climatic or anthropogenic signals.