Fluctuations of Outlet and Valley Glaciers in the Southern Andes (Argentina) during the Past 13,000 Years

In the southern Argentine Andes, ten advances of valley glaciers were used to reconstruct the late-glacial and Holocene glacier history. The accumulation areas of these glaciers lie in the Precordillera and are thus independent of fluctuations of the South Patagonian Icefield. Like the Viedma outlet glacier, the valley glaciers advanced three times during late-glacial time (14,000–10,000 yr B.P.). The youngest advance correlates with the Younger Dryas Stade, based on two minimum AMS¹⁴C dates of 9588 and 9482 yr B.P. The second oldest advance occurred before 11,800 yr B.P. During the first half of the Holocene, (ca. 10,000–5000 yr B.P.), advances culminated about 8500, 8000–7500, and 5800–5500 yr B.P. During the second half of the Holocene, advances occurred between ca. 4500 and 4200 yr B.P., as well as between 3600 and 3300 yr B.P. In the Río Cóndor valley three subsequent advances have been identified.     

Application of a spectral correction method for measurements of covariances with fast-response sensors in the atmospheric boundary layer up to a height of 130 m and testing of the corrections

Measurement of meteorological quantities with fast-response sensors by means of the eddycorrelation technique allows calculation of turbulent transport without too severe demands with regard to stationarity and homogeneity. However, the measurement system causes frequency-dependent errors due to measuring height, averaging interval, sampling rate and mean wind speed. A correction method (Moore, 1986) was applied to measurements taken on a 130 m tower located at the German North Sea coast. The errors for 10-min averages, obtained at a height of 10 m were between 20 and 30%, mainly caused by the inertia of the sensors, increasing to between 30 and 60% at 130 m height due to a loss of low-frequency parts of the spectra because of the averaging interval. The corrections to the obtained data were validated by comparing the cospectra calculated from the data with the spectra used for the computation of the correction factors.     

The Bayesian approach to an internally consistent thermodynamic database: theory, database, and generation of phase diagrams

An internally consistent thermodynamic dataset has been derived for 148 endmember phases (145 solids and 3 fluids) comprising the elements Li, Na, K, Be, Mg, Ca, Ti, Cr, Mn, Fe, Zn, Al, Si, C, H, and O. This has been achieved by simultaneous treatment of phase property (like standard enthalpy of formation, standard entropy, molar heat capacity, molar volume, thermal expansivity, bulk modulus etc.) and reaction reversal data by the Bayesian method. The theory underlying the approach, and the computational methods involved, are briefly outlined. (For the benefit of readers unfamiliar with inference statistics, the basic concepts of the Bayes method are also presented in such a way that they can be grasped intuitively.) Although not yet addressed, this method can be extended to refine the thermodynamic mixing properties of crystalline solutions. The sources of the input data, culled from the literature, are summarized in the Appendix. The resulting database is succinctly documented in this paper. It includes the enthalpies of formation and entropies, their uncertainties, and the correlation among them. The database allows calculation of P-T, T-X _CO2, P-X _CO2, and T-f _O2 sections, with error propagation into the computed phase diagrams on a routine basis. A user-friendly computer program has been written to generate such phase diagrams. It is public domain software. The software and the thermodynamic database (which includes a complete documentation of the thermodynamic data above and beyond those listed (Table 2, here) may be downloaded from the web site http://homepage.ruhr-uni-bochum.de/niranjan.chatterjee/Index.htm. Examples of computed phase diagrams are given to illustrate the quality of the data and the capabilities of the software. Received: 11 March 1998 / Accepted: 11 June 1998     

Thermal evolution of an extensional detachment as constrained by organic metamorphic data and thermal modeling: Graz Paleozoic Nappe Complex (Eastern Alps)

Following Early Cretaceous nappe stacking, the Eastern Alps were affected by late-orogenic extension during the Late Cretaceous. In the eastern segment of this range, a Late Cretaceous detachment separates a very low- to low-grade metamorphic cover (Graz Paleozoic Nappe Complex, GPNC) above a low- to high-grade metamorphic basement. Synchronously, the Kainach Gosau Basin (KGB) collapsed and subsided on top of the section.Metamorphism of organic material within this section has been investigated using vitrinite reflectance data and Raman spectra of extracted carbonaceous material. In the southern part of the GPNC, vitrinite reflectance indicates a decrease in organic maturity towards the stratigraphic youngest unit. The remaining part of the GPNC is characterized by an aureole of elevated vitrinite reflectance values and Raman R2 ratios that parallels the margins of the GPNC. Vitrinite reflectance in the KGB shows a steep coalification gradient and increases significantly towards the western basin margin. The observed stratigraphic trend in the southern GPNC is a result of deep Paleozoic to Early Cretaceous burial. This maturity pattern was overprinted along the margins by advective heat and convective fluids during Late Cretaceous to Paleogene exhumation of basement rocks.During shearing, the fault zone was heated up to ca. 500 °C. This overprint is explained by a two-dimensional thermal model with a ramp-flat fault geometry and a slip rate of 1 to 1.5 cm/year during 5 Ma fault movement. The collapse basin above the detachment subsided in a thermal regime which was characterized by relaxing isotherms.     

Granular solid dynamics with eutaraxy and hysteresis

Acta Geotechnica - The dynamics of grain fabrics is captured by means of a hidden state variable , named eutaraxy, which quantifies the propensity for a heat-like micro-seismicity due to disturbing...     

A novel time-series station in the Wadden Sea (NW Germany): First results on continuous nutrient and methane measurements

In autumn 2002 a time-series station was installed in the tidal inlet between the Islands of Langeoog and Spiekeroog (Southern North Sea, NW Germany) to continuously measure physical, chemical, and meteorological parameters, even during extreme weather conditions (gale-force storms, drifting ice). Inside the pole of the station sensor tubes are installed in direction of the prevailing tidal currents. The tubes are equipped with hydrographic sensors (pressure, temperature, conductivity) and allow retrieval of water for nutrient analysis by automated instruments located inside the pole. Dissolved methane and the nutrients ammonia, nitrite, nitrate, phosphate, and silicate are measured at the station.     

Why chromatic imaging matters

During the last two decades, the first generation of beam combiners at the Very Large Telescope Interferometer has proved the importance of optical interferometry for high-angular resolution astrophysical studies in the near- and mid-infrared. With the advent of 4-beam combiners at the VLTI, the u ? v coverage per pointing increases significantly, providing an opportunity to use reconstructed images as powerful scientific tools. Therefore, interferometric imaging is already a key feature of the new generation of VLTI instruments, as well as for other interferometric facilities like CHARA and JWST. It is thus imperative to account for the current image reconstruction capabilities and their expected evolutions in the coming years. Here, we present a general overview of the current situation of optical interferometric image reconstruction with a focus on new wavelength-dependent information, highlighting its main advantages and limitations. As an Appendix we include several cookbooks describing the usage and installation of several state-of-the art image reconstruction packages. To illustrate the current capabilities of the software available to the community, we recovered chromatic images, from simulated MATISSE data, using the MCMC software SQUEEZE. With these images, we aim at showing the importance of selecting good regularization functions and their impact on the reconstruction.     

Mechanisms of partly flooded loose sand deposits

Partly flooded loose sand deposits are left back from lignite mining, particularly in east Germany. After flooding, gas inclusions in macropores enhance the pore pressure increase by total stress cycles without drainage, and this can cause the transition into a kind of suspension. Thus, natural and technical changes of surface loads triggered flow slides in chain reactions of sometimes catastrophic extent. Such collapsible deposits were and are stabilized by blast-induced liquefaction and densification. Successive collapse fronts in flooded grain skeletons are seismogeneous, and this appears as wavering in the near-field and leads to power-law spectra in the far-field. Apart from this evidence of mild fractality, the wild fractality of chain reactions eludes mathematical treatment. Therefore, uncommon methods of geotechnical design, operations and monitoring are required.     

Observations of Lunar Transient Phenomena (LTP) in 1972 and 1973

A list of reports of Lunar Transient Phenomena (LTP) which have been observed in 1972 and 1973 by an international group of amateur astronomers is given. From 907 monitoring observations (1972: 526, 1973: 381) 92 LTP (74 reliable, 18 possible individual sightings) have been reported (1972: 52, 1973: 40) including parallel observations of the same event. The LTP were brightenings, shadings, flashes, colours, moving clouds and brightness diminutions of stars before occultations. 45 LTP events may be expected to be real in a catalogue of criteria for the reliability of observations. Sixteen events have been reported by several independent observers. A short examination of the temporal distributions of monitoring observations and recorded LTP is given.