Sediment resuspension events induced by the wake wash of deep-draft vessels

Hydrodynamics and sediment resuspension events, induced at the shoreline by a deep-draft vessel passing nearby, are described. Measurements (pressure, currents and turbidity) were obtained at 4 Hz, on a lower beach ~50 m from a channel where large car ferries operate in Wootton Creek, Isle of Wight. The study focuses on a representative 8-min 32-s-long record, during which two large vessels passed the channel section. At the shore, the passage of each vessel induced a long-period water-level drawdown, followed by a water-level oscillation (seiche) of similar period, and the short-period waves of the wake. Both drawdowns were the main constituents of the prevailing wave pattern. The second drawdown was the largest in amplitude, in response to a higher speed of the ferry, and the influence of the seiche which had been activated during the preceding event. Two successive peaks of turbidity were observed shortly after this drawdown. Analyses of current velocity and direction indicate that the sediments resuspended originated from the shallower upper beach. Anthropogenically induced erosion of the foreshore is predicted at Wootton Creek.     

Southwestward intrusion of korea strait bottom cold water observed in 2003 and 2004

Hydrographic surveys were carried out four times in the western channel of the Korea Strait in March and August 2003 and in June and November 2004. The bottom cold water, which was lower than 10°C, appeared in the channel trough except in March 2003. It flowed southwestward along the shelf of Korean coasts in August 2003 and in November 2004. The width and the maximum speed of the intrusion current were about 20 km and approximately 25 cm s^-1, respectively, off Ulsan, Korea. The volume transport of the bottom cold water was estimated 0.019 Sv (Sv≡10⁶ m³ s^-1) in August 2003 and 0.026 Sv in November 2004.     

Crustal structure of the Southwest Subbasin,South China Sea,from wide-angle seismic tomography and seismic reflection imaging

The Southwest Subbasin (SWSB) is an abyssal subbasin in the South China Sea (SCS), with many debates on its neotectonic process and crustal structure. Using two-dimensional seismic tomography in the SWSB, we derived a detailed P-wave velocity model of the basin area and the northern margin. The entire profile is approximately 311-km-long and consists of twelve oceanic bottom seismometers (OBSs). The average thickness of the crust beneath the basin is 5.3 km, and the Moho interface is relatively flat (10–12 km). No high velocity bodies are observed, and only two thin high-velocity structures (~7.3 km/s) in the layer 3 are identified beneath the northern continent-ocean transition (COT) and the extinct spreading center. By analyzing the P-wave velocity model, we believe that the crust of the basin is a typical oceanic crust. Combined with the high resolution multi-channel seismic profile (MCS), we conclude that the profile shows asymmetric structural characteristics in the basin area. The continental margin also shows asymmetric crust between the north and south sides, which may be related to the large scale detachment fault that has developed in the southern margin. The magma supply decreased as the expansion of the SWSB from the east to the west.     

Temporal Variability of Total Ozone in the Asian Region Inferred from Ground-Based and Satellite Measurement Data

This paper reports investigation data on the temporal variability of total ozone content (TOC) in the Central Asian and Tibet Plateau mountain regions obtained by conventional methods, as well as by spectral, cross-wavelet, and composite analyses. The data of ground-based observation stations located at Huang He, Kunming, and Lake Issyk-Kul, along with the satellite data obtained at SBUV/SBUV2 (SBUV merged total and profile ozone data, Version 8.6) for 1980–2013 and OMI (Ozone Monitoring Instrument) and TOU (Total Ozone Unit) for 2009–2013 have been used. The average relative deviation from the SBUV/SBUV2 data is less than 1% in Kunming and Issyk-Kul for the period of 1980–2013, while the Huang He Station is characterized by an excess of the satellite data over the ground-based information at an average deviation of 2%. According to the Fourier analysis results, the distribution of amplitudes and the periods of TOC oscillations within a range of over 14 months is similar for all series analyzed. Meanwhile, according to the cross-wavelet and composite analyses results, the phase relationships between the series may considerably differ, especially in the periods of 5–7 years. The phase of quasi-decennial oscillations in the Kunming Station is close to the 11-year oscillations of the solar cycle, while in the Huang He and Issyk-Kul stations the TOC variations go ahead of the solar cycle.     

An improved processing sequence for uncorrelated Chirp sonar data

Chirp sonar systems can be used to obtain high resolution seismic reflection images of the sub-seafloor during marine surveys. The exact knowledge of the Chirp signature allows the use of deterministic algorithms to process the data, similarly to that applied to Vibroseis data on land. Here, it is described an innovative processing sequence to be applied to uncorrelated Chirp data, which can improve vertical and lateral resolution compared to conventional methods. It includes application of a Wiener filter to transform a frequency-modulated sweep into a minimum-phase pulse sequence. In this way, the data become causal and can undergo predictive deconvolution to reduce ringing and enhance vertical resolution. Afterwards, FX-deconvolution and Stolt migration can be applied to obtain an improved imaging of the subsurface. The result of this procedure is a seismic reflection image with higher resolution than traditional ones, which are normally represented using the envelope function of the signal. This technique can be particularly useful for engineering-geotechnical surveys and archaeological investigations that require a fine detail imaging of the uppermost meters of the sub-seafloor.     

Elasticity of CaIrO<Subscript>3</Subscript> with perovskite and post-perovskite structure

Compression behaviors of CaIrO₃ with perovskite (Pv) and post-perovskite (pPv) structures have been investigated up to 31.0(1.0) and 35.3(1) GPa at room temperature, respectively, in a diamond-anvil cell with hydrostatic pressure media. CaIrO₃ Pv and pPv phases were compressed with the axial compressibility of β _a > β _c > β _b and β _b > β _a > β _c, respectively and no phase transition was observed in both phases up to the highest pressure in the present study. The order of axial compressibility for pPv phase is consistent with the crystallographic consideration for layer structured materials and previous experimental results. On the other hand, Pv phase shows anomalous compression behavior in b axis, which exhibit constant or slightly expanded above 13 GPa, although the applied pressure remained hydrostatic. Volume difference between Pv and pPv phases was gradually decreased with increasing pressure and this is consistent with the results of theoretical study based on the ab initio calculation. Present results, combined with theoretical study, suggest that these complicate compression behaviors in CaIrO₃ under high pressure might be caused by the partially filled electron of Ir⁴⁺. Special attention must be paid in case of using CaIrO₃ as analog materials to MgSiO₃, although CaIrO₃ exhibits interesting physical properties under high pressure.     

Dynamical downscaling of future sea level change in the western North Pacific using ROMS

The future regional sea level (RSL) rise in the western North Pacific is investigated by dynamical downscaling with the Regional Ocean Modeling System (ROMS) with an eddy-permitting resolution based on three global climate models—MIROC-ESM, CSIRO-Mk3.6.0, and GFDL-CM3—under the highest greenhouse-gas emission scenario. The historical run is forced by the air-sea fluxes calculated from Coordinated Ocean Reference Experiment version 2 (COREv2) data. Three future runs—ROMS-MIROC, ROMS-CSIRO, and ROMS-GFDL—are forced with an atmospheric field constructed by adding the difference between the climate model parameters for the twenty-first and twentieth century to fields in the historical run. In all downscaling, the RSL rise along the eastern coast of Japan is generally half or less of the RSL rise maxima off the eastern coast. The projected regional (total) sea level rises along the Honshu coast during 2081–2100 relative to 1981–2000 are 19–25 (98–104), 6–15 (71–80), and 8–14 (80–86) cm in ROMS-MIROC, ROMS-CSIRO, and ROMS-GFDL, respectively. The discrepancies of the RSL rise along the Honshu coast between the climate models and downscaling are less than 10 cm. The RSL changes in the Kuroshio Extension (KE) region in all downscaling simulations are related to the changes of KE (northward shift or intensification) with climate change.     

Noril’sk–Talnakh Cu–Ni–PGE deposits: a revised tectonic model

The Norilsk mining district is located at the northwest margin of the Tunguska basin, in the centre of the 3,000×4,000 km Siberian continental flood basalt (CFB) province. This CFB province was formed at the Permo-Triassic boundary from a superplume that ascended into the geometric centre of the Laurasian continent, which was surrounded by subducting slabs of oceanic crust. We suggest that these slabs could have reached the core–mantle boundary, and they may have controlled the geometric focus of the superplume. The resulting voluminous magma intruded and erupted in continental rifts and related extensive flood basalt events over a 2–4 Ma period. Cu–Ni–PGE sulfide mineralization is found in olivine-bearing differentiated mafic intrusions beneath the flood basalts at the northwestern margin of the Siberian craton and also in the Taimyr Peninsula, some 300 km east of a triple junction of continental rifts, now buried beneath the Mesozoic–Cenozoic sedimentary basin of western Siberia. The Norilsk-I and Talnakh-Oktyabrsky deposits occur in the Norilsk–Kharaelakh trough of the Tunguska CFB basin. The Cu–Ni–PGE-bearing mineralized intrusions are 2–3 km-wide and 20 km-long differentiated chonoliths. Previous studies suggested that parts of the magma remained in intermediate-level crustal chambers where sulfide saturation and accumulation took place before emplacement. The 5–7-km-thick Neoproterozoic to Palaeozoic country rocks, containing sedimentary Cu mineralization and evaporites, may have contributed additional metal and sulfur to this magma. Classic tectonomagmatic models for these deposits proposed that subvertical crustal faults, such as the northeast-trending Norilsk–Kharaelakh fault, were major trough-parallel conduits providing access for magmas to the final chambers. However, geological maps of the Norilsk region show that the Norilsk–Kharaelakh fault offsets the mineralization, which was deformed into folds and offset by related reverse faults, indicating compressional deformation after mineralization in the Late Triassic to Early Jurassic. In addition, most of the intrusions are sills, not dykes as should be expected if the vertical faults were major conduits. A revised tectonic model for the Norilsk region takes into account the fold structure and sill morphology of the dominant intrusions, indicating a lateral rather than vertical emplacement direction for the magma into final chambers. Taking into account the fold structure of the country rocks, the present distribution of the differentiated intrusions hosting the Norilsk-I and Talnakh–Oktyabrsky deposits may represent the remnants of a single, >60 km long, deformed and eroded palm-shaped cluster of mineralized intrusions, which are perceived as separate intrusions at the present erosional level. The original direction of sill emplacement may have been controlled by a northeast-trending paleo-rise, which we suggest is present at the southeastern border of the Norilsk–Kharaelakh trough based on analysis of the unconformity at the base of the CFB. The mineralized intrusions extend along this rise, which we interpret as a structure that formed above the extensionally tilted block in the metamorphic basement. Geophysical data indicate the presence of an intermediate magma chamber that could be linked with the Talnakh intrusion. In turn, this T-shaped flat chamber may link with the Yenisei–Khatanga rift along the northwest-trending Pyasina transform fault, which may have served as the principal magma conduit to the intermediate chamber. It then produced the differentiated mineralized intrusions that melted through the evaporites with in situ precipitation of massive, disseminated, and copper sulfide ore. The Norilsk–Kharaelakh crustal fault may not relate to mineralization and possibly formed in response to late Mesozoic spreading in the Arctic Ocean.Editorial handling: P. Lightfoot     

Microstructure observations in the upper layer of the South China Sea

A general pattern for turbulent mixing in the upper layer of the South China Sea (SCS) is presented based on TurboMAP measurements in April and May 2010. The turbulence level decreased significantly overall from north to south, and weakened from east to west in the northern SCS. The average dissipation rate north of 18°N reaches 1.69 × 10^?8 W/kg, approximately six times larger than that south of 18°N. The mean mixing efficiency in the SCS is 0.2, with a maximum of 0.31 near the Luzon Strait. At one repeatedly occupied station located in the central deep basin, the dissipation rate varies diurnally in the mixed layer and pycnocline due to diurnal heating and cooling by solar radiation and local barotropic tide, respectively.