Ground water flow analysis of a mid-Atlantic outer coastal plain watershed, Virginia, U.S.A

Models for ground water flow (MODFLOW) and particle tracking (MODPATH) were used to determine ground water flow patterns, principal ground water discharge and recharge zones, and estimates of ground water travel times in an unconfined ground water system of an outer coastal plain watershed on the Delmarva Peninsula, Virginia. By coupling recharge and discharge zones within the watershed, flowpath analysis can provide a method to locate and implement specific management strategies within a watershed to reduce ground water nitrogen loading to surface water. A monitoring well network was installed in Eyreville Creek watershed, a first-order creek, to determine hydraulic conductivities and spatial and temporal variations in hydraulic heads for use in model calibration. Ground water flow patterns indicated the convergence of flow along the four surface water features of the watershed; primary discharge areas were in the nontidal portions of the watershed. Ground water recharge zones corresponded to the surface water features with minimal development of a regional ground water system. Predicted ground water velocities varied between < 0.01 to 0.24 m/day, with elevated values associated with discharge areas and areas of convergence along surface water features. Some ground water residence times exceeded 100 years, although average residence times ranged between 16 and 21 years; approximately 95% of the ground water resource would reflect land use activities within the last 50 years.     

Octahedral cation ordering in olivine at high temperature. I: in situ neutron single-crystal diffraction studies on natural mantle olivines (Fa12 and Fa10)

Crystallographic determinations on natural olivine single crystals of mantle composition and origin, carried out by in situ neutron diffraction at high temperature, show that the octahedrally co-ordinated Fe²⁺ and Mg cations undergo two successive trends of cation ordering with increasing temperature. An initial slight preference of Fe²⁺ for site M1, up to a temperature of about 850?°C, is followed by a reverse-ordering reaction with a site preference exchange between the two cations. The cross-over between the two regimes of ordering, corresponding to a situation of complete disorder, occurs at about 900?°C. Above this temperature Fe²⁺ progressively and strongly segregates into site M2 up to 1300?°C, the practical limit of the experimental setup utilized in the experiments. Care was taken to ensure that no chemical changes occurred in the crystals (i.e. oxidation), as testified by Mössbauer spectroscopy determinations carried out before and after the heat treatment. The cation-ordering behaviour is reflected in temperature-dependent changes of geometrical and atomic displacement parameters occurring in the octahedral sites M1 and M2. A thermodynamical explanation of this behaviour is proposed in terms of a prevailing vibrational contribution to entropy.     

A canonical theory for short GPS baselines. Part IV: precision versus reliability

This contribution is the last of four parts and deals with the link between baseline precision and ambiguity reliability. It is shown analytically how and to what extent the baseline-ambiguity correlation is related to the gain in baseline precision, to the volume of the ambiguity search space, and to the impact of potential integer ambiguity biases. Also, an ambiguity DOP measure is introduced together with its closed-form formulae for the three different single-baseline models. Received: 16 July 1996 / Accepted: 14 November 1996     

Diurnal variability of upper ocean temperature and heat budget in the southern Bay of Bengal during October–November, 1998 (BOBMEX-Pilot)

Time-series data on upper-ocean temperature, Vessel-Mounted Acoustic Doppler Current Profiler (VM-ADCP) measured currents and surface meteorological parameters have been obtained for the first time in the southern Bay of Bengal at 7‡N, 10‡N, and 13‡N locations along 87‡E during October–November, 1998 under BOBMEX-Pilot programme. These data have been analysed to examine the diurnal variability of upper oceanic heat budget and to estimate the eddy diffusivity coefficient of heat in the upper layer. Diurnal variation of near-surface temperature is typical at northern location (13‡N) with a range of 0.5‡C while the diurnal range of temperature is enhanced to 0.8‡C at the central location (10‡N) due to intense solar radiation (1050 W/m²), clear skies and low wind speeds. At the southern location (7‡N), the diurnal variation of temperature is atypical with the minimum temperature occurring at 2000 hrs instead of at early morning hours. In general, the diurnal curve of temperature penetrated up to 15 to 20 m with decreasing diurnal range with depth. The VM-ADCP measured horizontal currents in the upper ocean were predominantly easterly/northeasterly at southern location, north/northerly at central location and northwesterly at northern location, thus describing a large-scale cyclonic gyre with the northward meridional flow along 87‡E. The magnitudes of heat loss at the surface due to air-sea heat exchanges and in the upper 50 m layer due to vertical diffusion of heat are highest at the southern location where intense convective activity followed by overcast skies and synoptic disturbance prevailed in the lower atmosphere. This and the estimated higher value (0.0235 m²/s) of eddy diffusivity coefficient of heat in the upper ocean (0–50 m depth) suggest that 1-D processes controlled the upper layer heat budget at the southern location. On the other hand, during the fair weather conditions, at the central and northern locations, the upper layer gained heat energy, while the sea surface lost (gained) heat energy at northern (central) location. This and lower values of eddy diffusivity coefficient of heat (0.0045 and 0.0150 m²/s) and the northward intensification of horizontal currents at these locations suggest the greater role of horizontal heat advection over the 1-D processes in the upper ocean heat budget at these two locations.     

The Development of Laser Ablation ICP-MS and Calibration Strategies: Examples from the Analysis of Trace Elements in Volcanic Glass Shards and Sulfide Minerals

This contribution presents a review of the recent developments in laser ablation inductively coupled plasma-mass spectrometry. We describe the important developments which have occurred in the laser systems used, leading to a spatial resolution of around 20 (im, and give an overview of the major instrument developments which have affected the geological applications of laser ablation ICP-MS. We describe the calibration of laser ablation for the analysis of trace elements in two different matrices: volcanic glass shards and sulfide minerals. We show how single glass shards can be analysed using the National Institute of Standards and Technology (NIST) glass certified reference materials for calibration and demonstrate the effect of using single spot analyses compared to rastering of the calibration sample. We show the importance of inter-shard variation and demonstrate that averaged single shard analyses produce data which compare well with bulk analyses. The calibration of the laser system for sulfide mineral analysis is discussed and two different strategies are proposed, one using spiked pressed powder pellets of sulfides and the other metal reference materials. We present conclusions and recommendations for the calibration of laser ablation ICP-MS instruments.     

Mean and extreme characteristics of Moscow climate at the end of the 20th century

Characteristics are presented of climate in Moscow, as obtained from instrumental observations since 1879 at the stations of the Timiryazev Agricultural Academy and of Moscow State University’s Meteorological Observatory. Changes in meteorological elements are estimated for the period 1961–1990 along with tendencies of their changes during the 20th century and the first half of the 21st century.     

A radiative-conductive model for the prediction of radiation fog

A conductive-radiative model is used to predict the formation and growth of radiation fog. This is accomplished by solving numerically the heat and mass transport equations in conjunction with an approximate form of the radiative transfer equation. The equations of motion in simplified form are included in the physical system to make use of Blackadar's (1962) formulation of the exchange coefficient of the boundary layer.It is found for a number of hypothetical test cases that the model gives results which appear to represent real physical conditions. One actual situation is tested. Results show that the model reproduces better than qualitatively those parameters which are obtained from routine observations.