Effect of core porosity on stability and run-up of breakwaters

The commonly used formulae like Hudson's [(1959), Laboratory investigations of rubblemound breakwaters. WES report, Vicksburg], Iribarren's or Vander meer's [(1988), Rockslopes and gravel beaches under wave attack. Ph.D. thesis, Delft University of Technology, The Netherlands], do not give us the design cross section of a rubblemound breakwater for varying core porosity values. The paper presents the results of the experimental study carried out to compute the effects of core porosity on the stability and run-up characteristics of rubblemound breakwaters. Regular waves were made to attack the structure, with different core porosity values in a normal direction. The porosity of the armour and the secondary layers was neglected. It was observed that as core porosity increased the stability also increased considerably within the limits of the experimental data values. This may be due to large inflow and energy dissipation within the core of the structure. The run-up on the rubblemound slope was found to decrease with the increase in the porosity for the same reason.     

Measurement of the redox speciation of iron in seawater by catalytic cathodic stripping voltammetry

Catalytic cathodic stripping voltammetry (CSV) preceded by adsorptive collection of complexes of 1-nitroso-2-napthol (NN) can be used to determine iron in seawater. It is shown here that iron(II) is effectively masked in the presence of 2,2-dipyridyl (Dp) so that iron(III) is measured selectively. The concentration of iron(II) is then calculated as the difference between the concentrations of reactive iron (Fe_R) in the absence and presence of 2 μM Dp, Fe_R being defined as that which was complexed by 20 μM NN at pH 6.9 in the presence of 1.8 mM H₂O₂ and 5 ppm sodium dodecyl sulphate. A 30 min reaction time was allowed for Dp to react with iron(II) in seawater prior to the determination of reactive iron(III) using the same conditions as used for Fe_R. Detection limits of 0.08 nM, 0.077 nM and 0.12 nM were obtained for Fe_R, iron(III) and iron(II), respectively, using a 60 s deposition time.The method was utilised to determine the redox speciation of iron in the northern North Sea. Concentrations of Fe_R ranged between 0.8 and 3.5 nM with nutrient-like depth profiles. Iron(II) was found to be present at concentrations up to 1.2 nM, the highest concentrations occurring in the upper 20 m of the water column.     

Risk of dike failure due to flow slides

Flow slides may affect the stability of dikes. A flow slide is an instability of a submerged slope caused by liquefaction of loose, (medium) fine sand. Whether a flow slide will occur depends on the properties of the sand, which are a function of its density, and the geometry of the slope, as determined by wave and current induced scour and sedimentation. The influence of sand properties and the geometry parameters on the risk of flow slides are discussed. The application of a flow slide prediction method to an example and a risk analysis is briefly discussed.     

A comparative study of some directional sea models

Current specification of the ocean wave environment for the design of offshore platforms does not adequately describe the directional nature of a real seaway. The strong wave frequency dependent nature of the directional behavior of observed seas is often over-simplified for design. A general formulation encompassing a wide range of directional sea models is presented. Parameter values used in some of the more popular directional sea models are examined. Approximate expressions for the two frequency dependent parameters in a modified Longuet-Higgins cosine wave spreading model are presented. A general procedure which allows an engineer to estimate parameters for alternate wave spreading models is discussed. To illustrate this procedure an empirically based modified cosine spreading model is used as the basis to estimate frequency dependent parameters for circular normal and wrapped Gaussian wave spreading models. A comparison of the contours of the various directional sea models and the prediction of the root-mean-square velocity distribution is presented.     

Morphodynamics of a bar-trough surf zone

A field study was made of the distinguishing morphodynamic processes operating in a surf zone which perennially exhibits accentuated bar-trough topography (the “longshore-bar-trough” and “rhytmic-bar-and-beach” states as described by Wright and Short, 1984). Characteristic features of the morphology include a shallow bar with a steep shoreward face, a deep trough, and a steep beach face. This morphology, which is favored by moderate breaker heights and small tidal ranges, strongly controls the coupled suite of hydrodynamic processes. In contrast to fully dissipative surf zones, the bar-trough surf zone is not at all saturated and oscillations at incident wave frequency remain dominant from the break point to the subaerial beach. The degree of incident wave groupiness does not change appreciably across the surf zone. Infragravity standing waves which, in dissipative surf zones, dominate the inshore energy, remain energetically secondary and occur at higher frequencies in the bar trough surf zone. Analyses of the field data combined with numerical simulations of leaky mode and edge wave nodal—antinodal positions over observed surf-zone profiles, indicate that the frequencies which prevail are favored by the resonant condition of antinodes over the bar and nodes in the trough. Standing waves which would have nodes over the bar are suppressed. Sediment resuspension in the surf zone appears to be largely attributable to the incident waves which are the main source of bed shear stress. In addition, the extra near-bottom eddy viscosity provided by the reformed, non-breaking waves traversing the trough significantly affects the vertical velocity profile of the longshore current. Whereas the bar is highly mobile in terms of onshore—offshore migration rates, the beach face and inner regions of the trough are remarkably stable over time.     

Extension of the Narmada — Son lineament on the continental margin off Saurashtra,Western India as obtained from magnetic measurements

Magnetic total intensity values and bathymetric data collected on the continental margin off Saurashtra were, used to prepare magnetic anomalies and bathymetric contour maps. The magnetic anomalies are considered to have been caused by the Deccan Trap flood basalts which underlie the Tertiary sediments. Interpretation of the magnetic data using two-dimensional modelling method suggests that the magnetic basement is block faulted and deepens in steps from less than 1.0 km in the north to about 8.0 km towards the southern portion of the study area. The WNW-ESE trending faults identified in the present study extend across the Saurashtra continental margin between Porbandar and Veraval and appear to represent a major linear tectonic feature. The relationship of these fault lineaments with the regional tectonic framework have been discussed to indicate that they conform better as the northern boundary faults of the Narmada rift graben on the continental margin off Saurashtra.     

Isolation and characterisation of pristane metabolites formed in vivo by rainbow trout

Pristane (2,6,10,14 -tetramethylpentadecane) occurs ubiquitously in the marine environment. This hydrocarbon may be of biogenic or petrogenic origin.¹ Recently it has been shown that residual amounts of this branched alkane increased in marine organisms after an oil spill.^2,3 The lack of data on the fate of pristane in fish, added with the fact that this compound was considered by some authors as a non-metabolisable substance in vertebrates, including man,⁴ led us to investigate the capability of fish to metabolise pristane. In this study, urinary and fecal excretion, tissue distribution and metabolism of ³H-pristane were analysed in Salmo gairdneri R. after a single intragastric dose. In addition to unchanged hydrocarbon, various labelled compounds have been isolated and identified in liver, bile, faeces, urine and surrounding water, demonstrating that pristane was first oxidised to alcohols (pristanol and pristane-diol) and to acid (pristanic acid). The elimination of these compounds occurred in the form of conjugated products (primarily glucuronides) as well as free metabolites.