Performance of hemi-cylindrical and rectangular submerged breakwaters

A parametric experimental study is conducted to compare the reflection and transmission characteristics of submerged hemi-cylindrical and rectangular rigid and water-filled flexible breakwater models. The results show that, for the rigid breakwaters, rectangular models are more effective than hemi-cylindrical ones in terms of reduction of transmitted waves. As for the flexible breakwaters, the hemi-cylindrical models may give better wave reflection than rectangular ones. However, the energy loss induced by the rectangular breakwaters is much larger and more significant to result in an overall better efficiency in terms of reduction in wave transmission. The effects of internal pressure show that the lowest pressurized flexible models considered in this work are the most effective in the reduction of the transmitted wave height. Higher wave reflection, lower wave transmission and higher energy loss are obtained consistently at the lower submergence depth ratio.     

Mathematical modeling of turbulent jets of deep-water sewage discharge into coastal basins

The basic properties of the dynamic model of a turbulent jet formed by a deep-water sewage discharge into the stratified environment of coastal regions are considered. The model developed was used to estimate the parameters of a floating-up jet of deep wastewater discharge from Sand Island into the basin of Mamala Bay (Hawaii) depending on the season and discharge operation mode. The estimates of the float-up depths of the jet and the initial dilution of the jet were estimated on the basis of model calculations using experimental data on the vertical profiles of the water temperature and salinity under the actual conditions of stratification in the study region. It is shown that the further propagation of the wastewater jet depends on tidal events and internal waves generated by tides. The appearance of turbulent jets at the sea surface was recorded. The model estimates of the parameters of the wastewater discharge were compared with the results of experimental measurements. Good agreement was found, which indicates that the physical mechanisms of the propagation of turbulent jets in a stratified medium are adequately described by the model.     

The Equatorial Atlantic Mid-Ocean Channel: An Ultra High-Resolution Image of Its Burial History Based on TOPAS Profiles

Multibeam bathymetric and ultra high-resolution seismic data reveal that the distal course of the Equatorial Atlantic Mid-Ocean Channel (EAMOC) extends further east and south than was previously known, and is controlled by the presence of morphologic highs related to the Fernando de Noronha Fracture Zone. Distal course of the EAMOC is buried by sediments, and does not have bathymetric expression on the seafloor. The channel fill consists of three seismic sequences, suggesting that the recent geological evolution of the channel is composed of successive phases of decreasing sedimentary activity that finally resulted in its complete burial. Tectonic and volcanic activity related to the Fernando de Noronha Fracture Zone and Ridge, together with the effect of strong pulses of the Antarctic bottom water current during the upper Pliocene are suggested to have contributed to the progressive burial and the final abandonment of the EAMOC.     

Circalittoral Macrobenthic Assemblages of Strymonikos Gulf (North Aegean Sea)

Abstract. Six macrobenthic assemblages of the circalittoral zone found in Strymonikos Gulf, North Aegean Sea, are described and compared with the corresponding ones from other Mediterranean and Atlantic areas. For the delimination of these assemblages and the evaluation of the major environmental gradients governing their distribution, several numerical techniques were used.     

A time-varying parameter model of a body oscillating in pitch

Among the assumptions upon which linear time-invariant models of floating bodies are based is that the body motions are so small that any change in the body’s angular position can be disregarded. However, it is often a major design requirement of a wave energy conversion device that the response amplitude is large, thereby invalidating one of the assumptions of the linear model. In particular, the immersed geometry of a body undergoes considerable variation when it is moved in pitch. With regard to this we investigate the difference in performance between a quasi-linear model in which the change of immersed surface is modelled by time-varying parameters and a basic linear model in which the immersed surface is time-invariant. The time-varying parameter model is realized by interpolation between the appropriate parameter values of a set of linear time-invariant (LTI) models derived for the different immersed surfaces that occur at discrete body displacements. It is shown that the responses predicted using the time-varying parameter model are closer to those measured experimentally than those of a standard frequency-domain model. Particular improvement occurs when the responses are large, such as at or near the resonance frequency. A problem which may limit the general use of the model is also discussed.     

Population structure of Haliotis rubra from South Australia inferred from nuclear and mtDNA analyses

1Introduction ThemajorityofAustralia’sabalonefisheryex ports(5.135kt,worth＄216millionin2002～2003,ABARE2004)consistofblacklipabalone(HaliotisrubraLeach,1814).AssuchH.rubrais consideredasanimportantmarineresourcewithin Australia.Likemanyabalonespecieswor…     

Geology of the Continental Margin of Enderby and Mac. Robertson Lands, East Antarctica: Insights from a Regional Data Set

In 2001 and 2002, Australia acquired an integrated geophysical data set over the deep-water continental margin of East Antarctica from west of Enderby Land to offshore from Prydz Bay. The data include approximately 7700 km of high-quality, deep-seismic data with coincident gravity, magnetic and bathymetry data, and 37 non-reversed refraction stations using expendable sonobuoys. Integration of these data with similar quality data recorded by Japan in 1999 allows a new regional interpretation of this sector of the Antarctic margin. This part of the Antarctic continental margin formed during the breakup of the eastern margin of India and East Antarctica, which culminated with the onset of seafloor spreading in the Valanginian. The geology of the Antarctic margin and the adjacent oceanic crust can be divided into distinct east and west sectors by an interpreted crustal boundary at approximately 58° E. Across this boundary, the continent–ocean boundary (COB), defined as the inboard edge of unequivocal oceanic crust, steps outboard from west to east by about 100 km. Structure in the sector west of 58° E is largely controlled by the mixed rift-transform setting. The edge of the onshore Archaean–Proterozoic Napier Complex is downfaulted oceanwards near the shelf edge by at least 6 km and these rocks are interpreted to underlie a rift basin beneath the continental slope. The thickness of rift and pre-rift rocks cannot be accurately determined with the available data, but they appear to be relatively thin. The margin is overlain by a blanket of post-rift sedimentary rocks that are up to 6 km thick beneath the lower continental slope. The COB in this sector is interpreted from the seismic reflection data and potential field modelling to coincide with the base of a basement depression at 8.0–8.5 s two-way time, approximately 170 km oceanwards of the shelf-edge bounding fault system. Oceanic crust in this sector is highly variable in character, from rugged with a relief of more than 1 km over distances of 10–20 km, to rugose with low-amplitude relief set on a long-wavelength undulating basement. The crustal velocity profile appears unusual, with velocities of 7.6–7.95 km s⁻¹ being recorded at several stations at a depth that gives a thickness of crust of only 4 km. If these velocities are from mantle, then the thin crust may be due to the presence of fracture zones. Alternatively, the velocities may be coming from a lower crust that has been heavily altered by the intrusion of mantle rocks. The sector east of 58° E has formed in a normal rifted margin setting, with complexities in the east from the underlying structure of the N–S trending Palaeozoic Lambert Graben. The Napier Complex is downfaulted to depths of 8–10 km beneath the upper continental slope, and the margin rift basin is more than 300 km wide. As in the western sector, the rift-stage rocks are probably relatively thin. This part of the margin is blanketed by post-rift sediments that are up to about 8 km thick. The interpreted COB in the eastern sector is the most prominent boundary in deep water, and typically coincides with a prominent oceanwards step-up in the basement level of up to 1 km. As in the west, the interpretation of this boundary is supported by potential field modelling. The oceanic crust adjacent to the COB in this sector has a highly distinctive character, commonly with (1) a smooth upper surface underlain by short, seaward-dipping flows; (2) a transparent upper crustal layer; (3) a lower crust dominated by dipping high-amplitude reflections that probably reflect intruded or altered shears; (4) a strong reflection Moho, confirmed by seismic refraction modelling; and (5) prominent landward-dipping upper mantle reflections on several adjacent lines. A similar style of oceanic crust is also found in contemporaneous ocean basins that developed between Greater India and Australia–Antarctica west of Bruce Rise on the Antarctic margin, and along the Cuvier margin of northwest Australia.