Morphology and tectonics of the Galapagos Triple Junction

We describe the results of GLORIA and SEABEAM surveys, supplemented by other marine geophysical data, of the Galapagos Triple Junction where the Pacific, Cocos and Nazca plates meet. The data allowed detailed topographic and tectonic maps of the area to be produced. We located each spreading axis with a precision of about 1 km. All three plate boundaries change character as the triple junction is approached to take on morphologies typical of slower spreading axes: the fast-spreading East Pacific Rise develops the morphology of a medium-spreading rise, and the medium-spreading Cocos-Nazca Rise takes on the appearance of a slow-spreading ridge. The axis of the East Pacific Rise was found to be completely continuous throughout the survey area, where it runs along the 102°05 W meridian. The Cocos-Nazca axis, however, fails to meet it, leaving a 20-km-wide band of apparently normal East Pacific Rise crust between its tip and the East Pacific Rise axis. As a consequence there must be considerable intra-plate deformation within the Cocos and Nazca plates. A further 40 km of the Cocos-Nazca axis is characterised by oblique faulting that we interpret to be a sign of rifting of pre-existing East Pacific Rise crust. We infer that true sea-floor spreading on the Cocos-Nazca axis does not begin until 60 km east of the East Pacific Rise axis. Other areas of similar oblique faulting occur on the Pacific plate west of the triple junction and along the rough-smooth boundaries of the Galapagos Gore. We present a model involving intermittent rifting, rift propagation, and sea-floor spreading, to explain these observations.     

Hotspots and a clumpy disc: variability of brown dwarfs and stars in the young σ Ori cluster

The properties of accretion discs around stars and brown dwarfs in the σ Ori cluster (age 3 Myr) are studied based on near-infrared (IR) time series photometry supported by mid-IR spectral energy distributions (SEDs). We monitor ∼30 young low-mass sources over eight nights in the J and K band using the duPont telescope at Las Campanas. We find three objects showing variability with J -band amplitudes  ≥0.5 mag  ; five additional objects exhibit low-level variations. All three highly variable sources have been previously identified as highly variable; thus, we establish the long-term nature of their flux changes. The light curves contain periodic components with time-scales of  ∼0.5–8 d  , but have additional irregular variations superimposed – the characteristic behaviour for classical T Tauri stars. Based on the colour variability, we conclude that hotspots are the dominant cause of variations in two objects (#19 and #33), including one likely brown dwarf, with spot temperatures in the range of 6000–7000 K. For the third one (#2), a brown dwarf or very low-mass star, inhomogeneities at the inner edge of the disc are the likely origin of variability. Based on mid-IR data from Spitzer , we confirm that the three highly variable sources are surrounded by circum-(sub)-stellar discs. They show typical SEDs for T Tauri-like objects. Using SED models, we infer an enhanced scaleheight in the disc for the object #2, which favours the detection of disc inhomogeneities in light curves and is thus consistent with the information from variability. In the σ Ori cluster, about every fifth accreting low-mass object shows persistent high-level photometric variability. We demonstrate that estimates for fundamental parameters in such objects can be significantly improved by determining the extent and origin of the variations.     

A two-stage evolution of Visakhapatnam-Paradip shelf,east coast of India,from magnetic studies

A detailed analysis of bathymetry and magnetic data of Visakhapatnam-Paradip shelf, east coast of India revealed three major structural lineaments over the shelf/slope of the area. Models derived from the anomalies associated with the trends indicate that trend A represents horst and graben type continental basement while trend B is due to a series of dyke intrusions. Trend C off Chilka lake forms the northward extension of 85°E lineation from deep sea Bengal Fan. A two stage evolution of the eastern continental margin of India has been inferred from the study of this part of the margin, viz., the rift stage evidenced by dyke intrusions of reverse polarity located within the inner part of the shelf and post-rift stage characterized by vertical tectonics in the form of a horst and graben type continental basement. The hotspot related aseismic 85°E ridge further complicated the tectonics of this part of the area.     

Field Investigation of a New Recharge Approach for ASR Projects in Near‐Surface Aquifers

Aquifer storage and recovery (ASR) is the artificial recharge and temporary storage of water in an aquifer when water is abundant, and recovery of all or a portion of that water when it is needed. One key limiting factor that still hinders the effectiveness of ASR is the high costs of constructing, maintaining, and operating the artificial recharge systems. Here we investigate a new recharge method for ASR in near‐surface unconsolidated aquifers that uses small‐diameter, low‐cost wells installed with direct‐push (DP) technology. The effectiveness of a DP well for ASR recharge is compared with that of a surface infiltration basin at a field site in north‐central Kansas. The performance of the surface basin was poor at the site due to the presence of a shallow continuous clay layer, identified with DP profiling methods, that constrained the downward movement of infiltrated water and significantly reduced the basin recharge capacity. The DP well penetrated through this clay layer and was able to recharge water by gravity alone at a much higher rate. Most importantly, the costs of the DP well, including both the construction and land costs, were only a small fraction of those for the infiltration basin. This low‐cost approach could significantly expand the applicability of ASR as a water resources management tool to entities with limited fiscal resources, such as many small municipalities and rural communities. The results of this investigation demonstrate the great potential of DP wells as a new recharge option for ASR projects in near‐surface unconsolidated aquifers.     

TESTING OF ENERGY DISSIPATING CLADDING CONNECTIONS

Properly designed precast concrete cladding could potentially provide lateral stiffness, ductility, and energy dissipation for an overall building structure, especially during earthquakes. This paper describes a set of advanced connections that take advantage of the interaction between facade panels and structure (mainly due to horizontal interstorey drift) to dissipate energy, thereby reducing the response of the main structure. The results of an experimental program to characterize the hysteretic behaviour of advanced connections are presented. Design equations for the advanced connections are then calibrated against the test results, and the corresponding design charts are presented. It is anticipated that this research will lead to innovative ways of viewing the entire cladding system of a building.     

GPS for real-time earthquake source determination and tsunami warning systems

We identify the key design aspects of a GPS-based system (and in the future, GNSS-based systems) that could contribute to real-time earthquake source determination and tsunami warning systems. Our approach is based on models of both transient and permanent displacement of GPS stations caused by large earthquakes, while considering the effect of GPS errors on inverted earthquake source parameters. Our main conclusions are that (1) the spatial pattern, magnitude, and timing of permanent displacement of GPS stations can be inverted for the earthquake source and so predict the 3D displacement field of the ocean bottom, thus providing the initial conditions for tsunami models, and (2) there are no inherently limiting factors arising from real-time orbit and positioning errors, provided sufficient near-field GPS stations are deployed. This signal could be readily exploited by GPS networks currently in place, and will be facilitated by the IGS Real-Time Project as it comes to fruition.     

The Use of LiDAR in Digital Surface Modelling: Issues and Errors

Modelling and extracting 3D geographical data presents numerous challenges that require continual research to attempt to evolve an efficient, reliable and accurate solution. LiDAR data capture and analysis has become a preferred acquisition choice for elevation data because the resulting quality and level of detail far exceeds traditional methods for large survey areas. As with any data collection system, LiDAR is prone to errors. Analysing these errors, ascertaining causes and producing error correction strategies is vital if accurate and confident results are to be obtained. Eight years of LiDAR datasets (from 1998 to 2005) have been closely analysed for a large coastal area of South Wales. This article provides a detailed and accurate summary of the identified LiDAR data issues and subsequent errors which affect the accuracy of end products such as Digital Surface Models (DSMs).