Coseismic Fault Slip of the September 16, 2015 <Emphasis Type="Italic">Mw</Emphasis> 8.3 Illapel,Chile Earthquake Estimated from InSAR Data

The complete surface deformation of 2015 Mw 8.3 Illapel, Chile earthquake is obtained using SAR interferograms obtained for descending and ascending Sentinel-1 orbits. We find that the Illapel event is predominantly thrust, as expected for an earthquake on the interface between the Nazca and South America plates, with a slight right-lateral strike slip component. The maximum thrust-slip and right-lateral strike slip reach 8.3 and 1.5 m, respectively, both located at a depth of 8 km, northwest to the epicenter. The total estimated seismic moment is 3.28 × 10²¹ N.m, corresponding to a moment magnitude Mw 8.27. In our model, the rupture breaks all the way up to the sea-floor at the trench, which is consistent with the destructive tsunami following the earthquake. We also find the slip distribution correlates closely with previous estimates of interseismic locking distribution. We argue that positive coulomb stress changes caused by the Illapel earthquake may favor earthquakes on the extensional faults in this area. Finally, based on our inferred coseismic slip model and coulomb stress calculation, we envision that the subduction interface that last slipped in the 1922 Mw 8.4 Vallenar earthquake might be near the upper end of its seismic quiescence, and the earthquake potential in this region is urgent.     

The Seismotectonics of the Po Plain (Northern Italy): Tectonic Diversity in a Blind Faulting Domain

We present a systematic and updated overview of a seismotectonic model for the Po Plain (northern Italy). This flat and apparently quiet tectonic domain is, in fact, rather active as it comprises the shortened foreland and foredeep of both the Southern Alps and the Northern Apennines. Assessing its seismic hazard is crucial due to the concentration of population, industrial activities, and critical infrastructures, but it is also complicated because (a) the region is geologically very diverse, and (b) nearly all potential seismogenic faults are buried beneath a thick blanket of Pliocene–Pleistocene sediments, and thus can be investigated only indirectly. Identifying and parameterizing the potential seismogenic faults of the Po Plain requires proper consideration of their depth, geometry, kinematics, earthquake potential and location with respect to the two confronting orogens. To this end, we subdivided them into four main, homogeneous groups. Over the past 15 years we developed new strategies for coping with this diversity, resorting to different data and modeling approaches as required by each individual fault group. The most significant faults occur beneath the thrust fronts of the Ferrara-Romagna and Emilia arcs, which correspond to the most advanced and buried portions of the Northern Apennines and were the locus of the destructive May 2012 earthquake sequence. The largest known Po Plain earthquake, however, occurred on an elusive reactivated fault cutting the Alpine foreland south of Verona. Significant earthquakes are expected to be generated also by a set of transverse structures segmenting the thrust system, and by the deeper ramps of the Apennines thrusts. The new dataset is intended to be included in the next version of the Database of Individual Seismogenic Sources (DISS; http://diss.rm.ingv.it/diss/, version 3.2.0, developed and maintained by INGV) to improve completeness of potential sources for seismic hazard assessment.     

Large Earthquakes at the Ibero-Maghrebian Region: Basis for an EEWS

Large earthquakes (M_w > 6, I_max > VIII) occur at the Ibero-Maghrebian region, extending from a point (12ºW) southwest of Cape St. Vincent to Tunisia, with different characteristics depending on their location, which cause considerable damage and casualties. Seismic activity at this region is associated with the boundary between the lithospheric plates of Eurasia and Africa, which extends from the Azores Islands to Tunisia. The boundary at Cape St. Vincent, which has a clear oceanic nature in the westernmost part, experiences a transition from an oceanic to a continental boundary, with the interaction of the southern border of the Iberian Peninsula, the northern border of Africa, and the Alboran basin between them, corresponding to a wide area of deformation. Further to the east, the plate boundary recovers its oceanic nature following the northern coast of Algeria and Tunisia. The region has been divided into four zones with different seismic characteristics. From west to east, large earthquake occurrence, focal depth, total seismic moment tensor, and average seismic slip velocities for each zone along the region show the differences in seismic release of deformation. This must be taken into account in developing an EEWS for the region.     

An Overview of the 28 October 2012 M<Subscript>w</Subscript> 7.7 Earthquake in Haida Gwaii,Canada: A Tsunamigenic Thrust Event Along a Predominantly Strike-Slip Margin

The boundary between the Pacific and North America plates along Canada’s west coast is one of the most seismically active regions of Canada, and is where Canada’s two largest instrumentally recorded earthquakes have occurred. Although this is a predominantly strike-slip transform fault boundary, there is a component of oblique convergence between the Pacific and North America plates off Haida Gwaii. The 2012 M_w 7.7 Haida Gwaii earthquake was a thrust event that generated a tsunami with significant run up of over 7 m in several inlets on the west coast of Moresby Island (several over 6 m, with a maximum of 13 m). Damage from this earthquake and tsunami was minor due to the lack of population and vulnerable structures on this coast.     

Impact of Three-Parameter Weibull Models in Probabilistic Assessment of Earthquake Hazards

This paper investigates the suitability of a three-parameter (scale, shape, and location) Weibull distribution in probabilistic assessment of earthquake hazards. The performance is also compared with two other popular models from same Weibull family, namely the two-parameter Weibull model and the inverse Weibull model. A complete and homogeneous earthquake catalog (Yadav et al. in Pure Appl Geophys 167:1331–1342, 2010) of 20 events (M ≥ 7.0), spanning the period 1846 to 1995 from north–east India and its surrounding region (20°–32°N and 87°–100°E), is used to perform this study. The model parameters are initially estimated from graphical plots and later confirmed from statistical estimations such as maximum likelihood estimation (MLE) and method of moments (MoM). The asymptotic variance–covariance matrix for the MLE estimated parameters is further calculated on the basis of the Fisher information matrix (FIM). The model suitability is appraised using different statistical goodness-of-fit tests. For the study area, the estimated conditional probability for an earthquake within a decade comes out to be very high (≥0.90) for an elapsed time of 18 years (i.e., 2013). The study also reveals that the use of location parameter provides more flexibility to the three-parameter Weibull model in comparison to the two-parameter Weibull model. Therefore, it is suggested that three-parameter Weibull model has high importance in empirical modeling of earthquake recurrence and seismic hazard assessment.     

A study on the seismic behavior of a retrofitted building based on nonlinear static and dynamic analyses

This study describes the seismic performance of an existing five storey reinforced concrete building which represents the typical properties of low-rise non-ductile buildings in Turkey. The effectiveness of shear walls and the steel bracings in retrofitting the building was examined through nonlinear static and dynamic analyses. By using the nonlinear static analysis, retrofitted buildings seismic performances under lateral seismic load were compared with each other. Moreover, the performance points and response levels of the existing and retrofitting cases were determined by way of the capacity-spectrum method described in ATC-40 (1996). For the nonlinear dynamic analysis the records were selected torepresent wide ranges of duration and frequency content. Considering the change in the stiffness and the energy dissipation capacities, the performance of the existing and retrofitted buildings were evaluated in terms of story drifts and damage states. It was found that each earthquake record exhibited its own peculiarities, dictated by frequency content, duration, sequence of peaks and their amplitude. The seismic performance of retrofitted buildings resulted in lower displacements and higher energy dissipation capacity depending mainly on the properties of the ground motions and the retrofitting strategies. Moreover, severe structural damage (irreparable or collapse) was observed for the existing building. However, buildings with retrofit alternatives exhibited lower damage levels changing from no damage to irreparable damage states.     

An operational modal analysis method in frequency and spatial domain

A frequency and spatial domain decomposition method （FSDD） for operational modal analysis （OMA） is presented in this paper, which is an extension of the complex mode indicator function （CMIF） method for experimental modal analysis （EMA）. The theoretical background of the FSDD method is clarified, Singular value decomposition is adopted to separate the signal space from the noise space. Finally, an enhanced power spectrum density （PSD） is proposed to obtain more accurate modal parameters by curve fitting in the frequency domain. Moreover, a simulation case and an application case are used to validate this method.     

Erratum to: Geochemical and environmental magnetic characteristics of high arsenic aquifer sediments from Datong Basin,northern China

Geochemical and environmental magnetic studies were carried out to identify the effect of iron oxyhydroxides on arsenic mobilization in high arsenic aquifer system. Using high arsenic sediment samples from two boreholes, specifically drilled for this study, chemical composition and magnetic properties including magnetic susceptibility, saturation remnant magnetization, and isothermal remnant magnetization were measured. Results of correlation analysis of element contents show that arsenic and iron are closely associated with each other (r ² = 0.40, α = 0.05, n = 21). In contrast, the correlation of phosphorus with iron (r = 0.11, α = 0.05, n = 21) and arsenic (r ² = 0.18, α = 0.05, n = 21) was poor, which might result from competitive adsorption of phosphorus and arsenic on the surface of Fe-oxyhydroxides. The high correlation coefficients between arsenic contents and magnetic parameters suggest that the ferrimagnetic minerals including maghemite and hematite are the dominant carrier of arsenic in aquifer sediments. The results of sequential extraction experiments also revealed the association of arsenic with reducible iron oxides, such as maghemite and hematite in aquifer sediments. Therefore, under reducing conditions, reductive dissolution and desorption of arsenic from Fe-oxyhydroxides into the aqueous phase should be the dominant geochemical processes for its enrichment in groundwater at Datong. An erratum to this article can be found at     

Organic tracers in sediments from the coastal zone of Ras Abu el-Darag,Gulf of Suez

Sediment samples from the coastal zone of the Gulf of Suez contain a variety of organic compounds from anthropogenic and natural sources. A total of 12 surface samples of bottom sediments were collected with an Ekman grab sampler along an off-shore transect south of Ras Abu el-Darag. The samples were extracted with a mixture of dichloromethane and methanol (3:1 v/v) after drying and sieving through 250 μm mesh. The extracts were derivatized and analyzed by gas chromatography–mass spectrometry in order to characterize the chemical composition and sources of the organic components. Marine with minor terrestrial biota were the major natural sources of organic tracers and included n-alkanoic acids, sterols and saccharides (5.7–76.7%). Anthropogenic sources, from petroleum related activities, detergent usage for spill cleaning and littering, are indicated by the presence of n-alkanes with carbon preference index ≤1.0, hopanes, steranes, unresolved complex mixture of branched and cyclic hydrocarbons, alkyl nitriles, alkamides and plasticizers. Their total relative concentrations ranged from 23.3 to 97.3% of the total extracts. Petroleum residues from natural seepage may also be part of these hydrocarbons. The levels of anthropogenic inputs decrease from about 94% in coastal zone sediments to about 20% in sediments from the reef front.