The composition of back-arc basin lower crust and upper mantle in the Mariana Trough: A first report

Abstract The Mariana Trough is an active back-arc basin, with the rift propagating northward ahead of spreading. The northern part of the Trough is now rifting, with extension accommodated by combined stretching and igneous intrusion. Deep structural graben are found in a region of low heat flow, and we interpret these to manifest a low-angle normal fault system that defines the extension axis between 19°45' and 21°10'N. A single dredge haul from the deepest (∼5.5 km deep) of these graben recovered a heterogeneous suite of volcanic and plutonic crustal rocks and upper mantle peridotites, providing the first report of the deeper levels of back-arc basin lithosphere. Several lines of evidence indicate that these rocks are similar to typical back-arc basin lithosphere and are not fragments of rifted older arc lithosphere. Hornblende yielded an ⁴⁰Ar/³⁹Ar age of 1.8 ± 0.6 Ma, which is interpreted to approximate the time of crust formation. Harzburgite spinels have moderate Cr# (<40) and coexisting compositions of clinopyroxene (CPX) and plagioclase (PLAB) fall in the field of mid-ocean ridge basalt (MORB) gabbros. Crustal rocks include felsic rocks (70-80% SiO₂) and plutonic rocks that are rich in amphibole. Chemical compositions of crustal rocks show little evidence for a 'subduction component', and radiogenic isotopic compositions correspond to that expected for back-arc basin crust of the Mariana Trough. These data indicate that mechanical extension in this part of the Mariana Trough involves lithosphere that originally formed magmatically. These unique exposures of back-arc basin lithosphere call for careful study using ROVs and manned submersibles, and consideration as an ocean drilling program (ODP) drilling site.     

Resolution of GPR bowtie antennas: An experimental approach

Since target reflections directly depend on the emitted pulse characteristics, a key factor for carrying out a successful GPR survey is to know as much as possible about the transmission features of the antennas used. This information is very important in order to choose the right antennas and set the appropriate configuration parameters for a specific survey. With this in mind this paper deals with the development of a set of laboratory experiments on the resolution capabilities of three bowtie antennas at frequencies of 500, 800 and 1000 MHz. Results from these measurements give a first estimation of the resolution of the antennas under test, showing the advantage of performing experiments rather than relying only on theoretical assumptions. The results are also expressed in terms of the central wavelength for each antenna and compared with some theoretical estimations proposed in the specialized bibliography.     

Reconstruction of Tsunami Inland Propagation on December 26, 2004 in Banda Aceh, Indonesia, through Field Investigations

This paper presents the results from an extensive field data collection effort following the December 26, 2004 earthquake and tsunami in Banda Aceh, Sumatra. The data were collected under the auspices of TSUNARISQUE, a joint French-Indonesian program dedicated to tsunami research and hazard mitigation, which has been active since before the 2004 event. In total, data from three months of field investigations are presented, which detail important aspects of the tsunami inundation dynamics in Banda Aceh. These include measurements of runup, tsunami wave heights, flow depths, flow directions, event chronology and building damage patterns. The result is a series of detailed inundation maps of the northern and western coasts of Sumatra including Banda Aceh and Lhok Nga. Among the more important findings, we obtained consistent accounts that approximately ten separate waves affected the region after the earthquake; this indicates a high-frequency component of the tsunami wave energy in the extreme near-field. The largest tsunami wave heights were on the order of 35 m with a maximum runup height of 51 m. This value is the highest runup value measured in human history for a seismically generated tsunami. In addition, our field investigations show a significant discontinuity in the tsunami wave heights and flow depths along a line approximately 3 km inland, which the authors interpret to be the location of the collapse of the main tsunami bore caused by sudden energy dissipation. The propagating bore looked like a breaking wave from the landward side although it has distinct characteristics. Patterns of building damage are related to the location of the propagating bore with overall less damage to buildings beyond the line where the bore collapsed. This data set was built to be of use to the tsunami community for the purposes of calibrating and improving existing tsunami inundation models, especially in the analysis of extreme near-field events.     

Effects Of Changing Surface Heat Flux On Atmospheric Boundary-Layer Flow Over Flat Terrain

We examine the unsteady response of a neutral atmospheric boundary layer (ABL) of depth h and friction velocity u _* when a uniform surface heat flux is applied abruptly or decreased rapidly over a time scale t<inf>θ</inf> less than about h /(10u _*). Standard Monin–Obukhov (MO) relationships are used for the perturbed eddy viscosity profile in terms of the changes to the heat flux and mean shear. Analytical solutions for changes in temperature, mean wind and shear stress profile are obtained for the surface layer, when there are small changes in h /|L_MO| over the time scale t_MO~|L _MO|/(10u_*) (where L _MO and t _MO are the length and time scales, respectively). They show that a maximum in the wind speed profile occurs at the top of the thermal boundary layer for weak surface cooling, i.e. a wind jet, whereas there is a flattening of the profile and no marked maximum for weak surface heating. The modelled profiles are approximately the same as those obtained from the U.K. Met Office Unified Model when operating as a mesoscale model at 12-km horizontal resolution. The theoretical model is modified when strong surface heating is suddenly applied, resulting in a large change in h /|L _MO| (>>1), over the time scale t _MO. The eddy structure is predicted to change significantly and the addition of convective turbulence increases the shear turbulence at the ground. A low-level wind jet can form, with convective turbulence adding to the mean momentum of the flow. This was verified by our laboratory experiment and direct numerical simulations. Additionally, it is shown that the effects of Coriolis acceleration diminish (rather than as suggested in the literature, amplify) the formation of the wind jets in the situations considered here. Hence, only when the surface heat flux changes over time scales greater than 1/f (where f is the Coriolis parameter) does the ABL adjust monotonically between its equilibrium states. These results are also applicable to the ABL passing over spatially varying surface heat fluxes.     

Temporal variations in bedload transport rates: The effect of progressive bed armouring

The quantitative bedload transport data that are presently available confirm that the generalized bedload transport rate-stream power relationship is applicable to natural streams. However, the bedload transport rate is not solely dependent upon hydraulic parameters, but also upon the inter-relationship between bed material characteristics and flow properties. Segregation of the surficial bed material, as expressed through the development of an armour coat, limits the availability of transportable material. Under such circumstances observed bedload transport rates are less than the predicted values. The effect which the development of an armoured surface has upon the bedload transport rate is described with reference to bedload and bed material sampling in the Borgne d'Arolla, Valais, Switzerland. The data refer to two periods when the resumption of baseflow conditions following flood events which were of a sufficient magnitude to transport all but the coarsest (0·3–0·5 m) particles on the streambed, provided the opportunity for the bed to adjust to a comparatively stable flow regime. Observed and predicted bedload transport rate-stream power relationships are compared. The theoretical relationship does not adequately describe conditions in some gravel-bed channels, since it fails to take into account the effect which armouring may have upon the supply of transportable material.     

Precipitation as a proxy for climate variables: application for hydrological modelling

It has been proposed that linear regression curves can be used to estimate monthly climate variables from observed precipitation. This approach was explored by applying the MGB hydrological model to the Paraná Basin (Brazil). Linear regressions were obtained for 54 climate gauges, and most of them showed at least six months of significant correlation between monthly climate variables (sunlight hours and relative humidity) and precipitation. The regression equations were applied to 5201 raingauges to estimate monthly climate variables and evapotranspiration, and the results were compared with a scenario using long-term climate averages only. The main differences occurred in wetter periods, where negative correlations between monthly precipitation and evapotranspiration were obtained when using precipitation as a proxy. Long-term changes in the hydrological regime were assessed and showed that the effect of precipitation on relative humidity and sunlight hours seems to have a minor effect on the alterations observed in river discharge in the Paraná Basin.     

Hydrogeological investigation in Santiago Island (Cabo Verde) using magnetotellurics and VLF methods

A geoelectromagnetic research was carried out in the Santa Cruz region (Santiago Island, Cabo Verde) during June 2004. The survey comprised MT soundings and VLF profiles. The main purpose of the MT profile, carried out across three important valleys associated with freshwater aquifers, was to study the tectonic structures correlated to seawater infiltration. The VLF method was used inside of the valleys for investigating shallow structures related to the aquifer contamination by seawater.Numerical modelling shows that the ocean effect is not important for MT data collected at periods shorter than 1 s. The MT data were inverted using a two-dimensional approach, to obtain the sub-superficial electrical conductivity distribution. The VLF data were processed applying the Karous–Hjelt filters to obtain the equivalent current distribution and inverted using 2-D approach. The results obtained in one of the most important valleys show anomalous current concentration/low resistivity (<20 Ω m) areas at depths greater than 40 m that may correspond to an increase in seawater content.The MT data modelling show that the deep zones beneath the valley are strongly fractured representing good pathways for seawater circulation. The depth of the conductive zones increases from south to north, suggesting a northward decreasing of the seawater infiltration effect. This observation correlates very well with in situ geochemical observations.     

Seismotectonics of south-west Dominican Republic using recent data

The Dominican Republic has a high level of seismic activity, and a new seismic network has been installed to improve the detection of earthquakes. The network has been operated by Instituto Politécnico Loyola since 2012. It uses six new stations of its own, as well as 17 other stations publically available. In this study, we investigate in particular the south-west of the country where no seismic stations have been operating before. We find an area, SE of the Enriquillo Plantain Garden fault (responsible for the 2010 Haiti M7.0 earthquake), with a high seismic activity (M?=?2–4) compared to the surrounding area. This shallow seismicity (except two events around 40 km depth) is not seen in any global catalogs, and it does not seem to be associated with any known faults. However, the region has been under rapid recent uplift since margins between hills and valleys are filled with massive alluvial fans. We made 24 new fault plane solutions using P-polarities and S/P amplitude ratios. The solutions show mainly reverse mechanisms and the P-axis directions are mainly NNE oriented, which is in agreement with a published strain direction from GPS measurements. We conclude that the main cause of the seismicity in our study area is the push of the Beata Ridge against Enriquillo basin and the rest of the Gonave microplate, reflected in the mainly reverse focal mechanisms.