Stress indications in the Bohemian Massif: Reinterpretation of borehole televiewer data

Summary This paper presents the first results of stress determinations in the Bohemian Massif utilizing televiewer data from deeper boreholes. The televiewer survey was originally carried out by Geological Survey Ostrava for the purpose of studying fractures and bedding in coal basins to depths of 2 km. A reinterpretation of the amplitude logs reveal a large number of stress-induced borehole elongations (breakouts) which occur in a direction perpendicular to the maximum horizontal principal stress (S_H). The breakout analysis in the Upper Silesian, Meno and Kladno Basins indicates a dominant NW-SE direction of S_H which is consistent with the pattern of stress orientation in Western Europe. The NE-SW trend observed in the Plze Basin is less reliable. A model for stress magnitude determinations is formulated as a linear programming problem. If the a priori information on rock strength properties is limited, it reduces to explicit formulas for stress regime estimates. The model is applied to data from the Upper Silesian Basin for which a compressional stress regime is derived.     

Metamorphic inheritance of Rheic passive margin evolution and its early‐Variscan overprint in the Teplá‐Barrandian Unit,Bohemian Massif

Rift‐related regional metamorphism of passive margins is usually difficult to observe on the surface, mainly due to its strong metamorphic overprint during the subsequent orogenic processes that cause its exposure. However, recognition of such a pre‐orogenic evolution is achievable by careful characterization of the polyphase tectono‐metamorphic record of the orogenic upper plate. A multidisciplinary approach, involving metamorphic petrology, P–T modelling, structural geology and in situ U‐Pb monazite geochronology using laser‐ablation split‐stream inductively coupled plasma mass spectrometry, was applied to unravel the polyphase tectono‐metamorphic record of metapelites at the western margin of the Teplá‐Barrandian domain in the Bohemian Massif. The study resulted in discovery of three tectono‐metamorphic events. The oldest event M1 is LP–HT regional metamorphism with a geothermal gradient between 30 and 50 °C km^?1, peak temperatures up to 650 °C and of Cambro‐Ordovician age (c. 485 Ma). The M1 event was followed by M2‐D2, which is characterized by a Barrovian sequence of minerals from biotite to kyanite and a geothermal gradient of 20–25 °C km^?1. D2‐M2 is associated with a vertical fabric S2 and was dated as Devonian (c. 375 Ma). Finally, the vertical fabric S2 was overprinted by a D3‐M3 event that formed sillimanite to chlorite bearing gently inclined fabric S3 also of Devonian age. The high geothermal gradient of the M1 event can be explained as the result of an extensional, rift‐related tectonic setting. In addition, restoration of the deep architecture and polarity of the extended domain before the Devonian history – together with the supracrustal sedimentary and magmatic record – lead us to propose a model for formation of an Ordovician passive continental margin. The subsequent Devonian evolution is interpreted as horizontal shortening of the passive margin at the beginning of Variscan convergence, followed by detachment‐accommodated exhumation of lower‐crustal rocks. Both Devonian shortening and detachment occurred in the upper plate of a Devonian subduction zone. The tectonic evolution presented in this article modifies previous models of the tectonic history of the western margin of the Teplá‐Barrandian domain, and also put constraints on the evolution of the southern margin of the Rheic ocean from the passive margin formation to the early phases of Variscan orogeny.     

Comparing mixing-length models of the diabatic wind profile over homogeneous terrain

Models of the diabatic wind profile over homogeneous terrain for the entire atmospheric boundary layer are developed using mixing-length theory and are compared to wind speed observations up to 300 m at the National Test Station for Wind Turbines at Høvsøre, Denmark. The measurements are performed within a wide range of atmospheric stability conditions, which allows a comparison of the models with the average wind profile computed in seven stability classes, showing a better agreement than compared to the traditional surface-layer wind profile. The wind profile is measured by combining cup anemometer and lidar observations, showing good agreement at the overlapping heights. The height of the boundary layer, a parameter required for the wind profile models, is estimated under neutral and stable conditions using surface-layer turbulence measurements, and under unstable conditions based on the aerosol backscatter profile from ceilometer observations.     

A modified multiple tension upward infiltration method to estimate the soil hydraulic properties

Determination of saturated hydraulic conductivity, K_s, and the shape parameters α and n of the water retention curve, θ(h), is of paramount importance to characterize the water flow in the vadose zone. This work presents a modified upward infiltration method to estimate K_s, α and n from numerical inverse analysis of the measured cumulative upward infiltration (CUI) at multiple constant tension lower boundary conditions. Using the HYDRUS‐2D software, a theoretical analysis on a synthetic loam soil under different soil tensions (0, 0–10, 0–50 and 0–100 cm), with and without an overpressure step of 10 cm high from the top boundary condition at the end of the upward infiltration process, was performed to check the uniqueness and the accuracy of the solutions. Using a tension sorptivimeter device, the method was validated in a laboratory experiment on five different soils: a coarse and a fine sand, and a 1‐mm sieved loam, clay loam and silt‐gypseous soils. The estimated α and n parameters were compared to the corresponding values measured with the TDR‐pressure cell method. The theoretical analysis demonstrates that K_s and θ(h) can be simultaneously estimated from measured upward cumulative infiltration when high (>50 cm) soil tensions are initially applied at the lower boundary. Alternatively, satisfactory results can be also obtained when medium tensions (<50 cm) and the K_s calculated from the overpressure step at the end of the experiment are considered. A consistent relationship was found between the α (R² = 0.86, p < 0.02) and n (R² = 0.97, p < 0.001) values measured with the TDR‐pressure cell and the corresponding values estimated with the tension sorptivimeter. The error between the α (in logarithm scale) and n values estimated with the inverse analysis and the corresponding values measured with pressure chamber were 3.1 and 6.1%, respectively. Copyright © 2016 John Wiley & Sons, Ltd.     

SANARIS Project: A Satellite Network for Natural Risk Monitoring

A new satellite communication system specificallydesigned for low-rate data applications has beendeveloped and prototyped. A validation project isproposed to install a pilot network to be operated for6 months. One of the target markets related tovolcanoes, has been selected, so that a group of usersis integrated in the project. A specific applicationfor this market will be developed regarding dataacquisition, processing, storage and dissemination todistant users. The feasibility of using the newsatellite system to provide a new Eutelsat service forlow-rate data applications, will be evaluated from theperformance of the pilot network. The system ofautomatic acquisition, field storage and communicationwith the local control center is already functioning,as well as the circulation of information viaInternet. The development of the application andtransmission via satellite to distant users is stillin an evaluation phase for the volcanoes of Timanfaya(Lanzarote, Canary Island), Vesuvius (Naples) and SeteCidades Caldera (Sao Miguel, Azores Islands).     

Drought impacts on water quality and potential implications for agricultural production in the Maipo River Basin,Central Chile

ABSTRACT

Droughts can have serious negative impacts on the water quality needed for irrigated agriculture. The Metropolitan region of Chile is a relevant producer of high-value crops and is prone to droughts. Standardized Drought Indices were used to characterize meteorological and hydrological droughts for the period from 1985 to 2015. To understand the relationship between droughts and water quality, we evaluated the correlations between daily discharge and surface water quality observations. The threshold level method was used to compare physicochemical parameters during hydrological drought periods with the Chilean water quality thresholds for agricultural uses. A significant (p < 0.05) negative relationship between discharge and electrical conductivity and major ions was found in most of the basin. Hydrological stations located in irrigation districts exceeded the official thresholds for these parameters during hydrological drought periods seriously threatening irrigated agriculture of the region.     

New controversies on Columbus' “cosmographic” ideas

This paper examines the spatial distribution of the functional systems in the different belts of settlements around Budapest. The surburban belts have an important role in the capital's labour market, places of employment and recreation with 45 settlements. The paper reviews the structure of the Budapest agglomeration from the core to the three inner, middle and outer belts comprising the suburbs, the semi-urban settlements, the suburban villages, the satellite towns, and the satellite villages. Then the system of the functional urban centres are reviewed, The author establishes the concept of the main, the division, the district and the settlement group centres in the Budapest agglomeration. The different levels of attached functions, such as international, national, regional and local are also described with each centre type. The areal distribution of the centre system of Budapest is shown in maps too.     

Gravity ideal-body analysis

Summary This short note contributes to the methods of computing the bounds on some properties of the source of measured data.     

Overcoring measurements in the příbram mine area and their relation to the regional stress field

Summary A set of overcoring measurements in deep mines near Píbram is re-interpreted in order to obtain information on the regional component of in situ stress. This is achieved by averaging 17 complete stress tensors measured at the deepest level of the mine, at a depth of 1240 m. The computations indicate that (1) the mean principal stresses act roughly in the horizontal and vertical directions, and (2) the maximum principal stress is horizontal, acting NW - SE, which was also confirmed by the data from all 42 sites of the mine area. The NW - SE orientation of S_H is consistent with the stress pattern in Western Europe and also with borehole breakouts observed within the Bohemian Massif, but the quality of the stress indicator obtained is poor — the standard deviation of the S_H direction is 26°. High variance of the directional data is discussed with respect to stress redistribution due to the mine workings and the contact separating Proterozoic sediments from the Variscan pluton.